• Journal of Electrical Engineering and Technology
• /
• v.11 no.3
• /
• pp.560-574
• /
• 2016

This paper presents a novel method for power system harmonic estimation based on the Park transform. The proposed method firstly extends the signal to a group of three-phase signals in a-b-c coordinate. Then, a linear fitting based method is adopted to estimate the fundamental frequency. Afterwards, the Park transform is utilized to convert the three-phase signals from a-b-c coordinate to d-q-0 coordinate. Finally, the amplitude and phase of a harmonic component of interest can be calculated using the d-axis and q-axis components obtained. Simulation studies have been conducted using matrix laboratory (MATLAB) and power system computer aided design/electromagnetic transients including direct current (PSCAD/EMTDC). Simulation studies in MATLAB have considered three scenarios, i.e., no-frequency-deviation scenario, frequency-deviation scenario and the scenario in the presence of inter-harminics. The results have demonstrated that the proposed method achieves very high accuracy in frequency, phase and amplitude estimation under noisy conditions, and suffers little influence of the inter-harmonics. Moreover, comparison studies have proved that the proposed method is superior to FFT and Interpolated FFT with the Hanning Window (IpFFTHW). Finally, a popular case in PSCAD/EMTDC has been employed to further verify the effectiveness of the proposed method.

• Proceedings of the Korean Society for Cognitive Science Conference
• /
• 2010.05a
• /
• pp.48-54
• /
• 2010

INTRODUCTION Interaction between temporal events at the millisecond level is important for visual and tactile interaction. OBJECT The aim of the present study is to identify any neural signature, as reflected in event-related potentials (ERP), for the integrative processes when the two sensory modalities are stimulated in synchrony as opposed to when they are stimulated separately. METHOD The basic strategy was to compare ERP signals obtained with simultaneous visual and tactile stimulation with a linear summation of ERP patterns obtained with each modality stimulated separately. Condition were presented, paired with various stimulus-onset-asynchronies (SOA) ranging from - 300 ms (tactile-first) to 300 ms (visual-first), and in trials where only one modality was stimulated alone. RESULT A positive deviation was located in observed ERP at C4 electrode (contralateral to the stimulated hand) at 200-400 ms, in comparison to the predicted ERP. The deviation was present at all SOAs other than -300ms (tactile-first) and 300 ms (visual-first). There was also a positive deviation at occipital leads at the 50-ms SOA (visual-first) trials. DISCUSSION It suggested that neural signatures of cross-modal integration occur within a limited time-window. The deviations were specifically localized at the contralateral somatosensory and visual cortices, indicating that the integration happens at or before the level of the primary cortices.

• Proceedings of the KIEE Conference
• /
• 1979.08a
• /
• pp.119-120
• /
• 1979

A linear state equation of the first order differential form relating the load-frequency dynamic characteristics of interconnected power systems was derived for use in computer simulation. A now solution of the algebraic matrix riccati equation for application in quadratic optimal controllor and least-square state estimator dermination was developed. The program for a dynamic state equation for two interconnected control areas was developed. The optimized load-frequency deviation was analysed and a numerical analysis was tried based on the computer simulation. It was shown that the dynamic response of th loed-frequency could be optimized with weighting factors IR and Q. The result was that the load-frequency and the tie-line deviation were visibly reduced.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2002.10b
• /
• pp.101-102
• /
• 2002

Indicial response characteristics of a rotor supported by a gas-lubricated, spiral-grooved proceeding bearing are studied theoretically to develop a fundamental investigation for the bearing design with considering NRRO characteristics. The trajectory of rotor movement is calculated by applying the non-linear orbit scheme against a prescribed impulse load, then two characteristic quantities are introduced to evaluate the indicial response performance of the bearing, i.e., 'maximum deviation of rotor center' and 'integrated rotor center deviation'. The effects of some design parameters of spiral grooves to these representative quantities are studied so that 'robust' design against impulse load is discussed.

• Journal of Institute of Control, Robotics and Systems
• /
• v.8 no.9
• /
• pp.812-817
• /
• 2002

This paper presents a development of high accuracy aligner and describes a method to find the orientation of a substantially circular disk shaped wafer with at least one flat region on an edge thereof. In the developed system, the wafer is spun one 360 degree turn on a chuck and the edge position is measured by a linear array to obtain a set of data points at various wafer orientation. The rotation axis may differ from wafer center by an unknown eccentricity. The flat angle is found by fitting a cosine curve to the actual data to obtain a deviation. The maximum deviation is then corrected for errors due to a finite number of data points and wafer eccentricity by calculating an adjustment angle from data points on the wafer fiat. After determining the flat angle the wafer is spun to the desired orientation. The wafer eccentricity can be calculated from four of the data points located away from the flat edge region. and the wafer is then centered.

• International Journal of Air-Conditioning and Refrigeration
• /
• v.14 no.3
• /
• pp.118-123
• /
• 2006

A few commonly used correlation equations of the enthalpy of vaporization essential to the analysis of refrigeration cycles are reviewed. A new four-parameter correlation equation is proposed assuming that the enthalpy of vaporization could be represented with a linear form of the temperature and an additional function which slowly decreases as the temperature increases. It is not a common practice to measure the enthalpy of vaporization by experiment; therefore, performance of the new correlation is examined using numeric data from the ASHRAE tables for 22 pure substance refrigerants. The new correlation equation and other existing ones are fitted to the data optimizing the root mean squared deviation. All data points are weighted equally and NBP (normal boiling point) is used as a fixed point since the NBP is important for refrigeration application. The new four-parameter equation yields an average absolute deviation of 0.05% for 22 refrigerants which is smaller than those of other four-parameter equations, such as Guermouche-Vergnaud (0.08%), Aerebrot (0.13%), Radoz-Lyderson (0.08%), and Somayajulu four-parameter equation (0.08%).

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 1998.06a
• /
• pp.337-342
• /
• 1998

A new fuzzy control algorithm for the control of active magnetic bearing (AMB) systems is proposed in this paper. It combines PDC design of Joh et al. [8][9] and Namdani-gype control rules using fuzzy singletons to handle the nonlinear characteristics of AMB systems efficiently. They are named fine mode control and rough mode control , respectively. The rough mode control yields the fastest response for large deviation of the rotor and the fine mode control fives desired transient response for small deviation of the rotor. The proposed algorithm is applied a AMB systems to verify the performance of the method, The comparison of the proposed method to a linear controller using a linearized model about the equilibrium point and PDC algorithm in [7] show the superiority of the proposed algorithm.

• Journal of Photoscience
• /
• v.6 no.4
• /
• pp.159-163
• /
• 1999

The fluorescence quenching of 2-phenyl-5-(4-biphenylyl)-1,3,4-oxadiazole (PBD) and 1,4-di-[2-(5-phenyloxazolyl)]-benzene (POPOP) by aniline has been carried out in different solvent mixtures of dioxane and acetonitrile at room temperature. The quenching is found to be appreciable and a positive deviation from linearity was observed in the Stern-Volmer plot in all the solvent mixtures. Various rate constants for the quenching processes have been determined using a modified Stern-Volmer equation. From the positive deviations of linear Stern-Volmer plots and the dependence of rate constants on the polarity of the solvents, it has been concluded that both static and dynamic quenching processes are responsible for the observed positive deviation in the Stern-Volmer plot.

• Journal of the Korean institute of surface engineering
• /
• v.47 no.1
• /
• pp.48-52
• /
• 2014

Electric conductivities of $LaCl_3$-KCl binary melts have been measured by the Kohlausch bridge method over the range from their liquidus temperatures to about 1280 K. The electric conductivity increased with the content of KCl for all over the composition range of binary melts. The composition dependence of the electric conductivity and molar conductivity for the binary melt showed a non-linear relation from the additivity line, and the deviation showed a maximum value at about 60 mol.% KCl. The deviation implies the existence of complex ion of $LaCl^{4-}$ in the melt. Activation energy for electric conductivity of the binary melts decreased monotonously with increasing content of KCl.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.229-231
• /
• 1988

In this paper, we design adaptive DPCM by the two dimensional linear prediction using the covariance method and propose adaptive algorithm which determines analysis frame size by the compassion of the local standard deviation and the global standard deviation of images.