• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2005.07a
• /
• pp.533-534
• /
• 2005

Temperature-dependent current-voltage characteristics of organic light-emitting diodes(OLEDs) were studied in a device structure of ITO/TPD/$Alq_3$/Al. The OLEDs were based on the molecular compounds, N,N'-diphenyl-N,N'-bis(3-methylphenyl)-l,1'-diphenyl-4,4'-diamine(TPD) as a hole transport and tris(8-hydroxyquinoline) aluminum($Alq_3$) as an electron transport and emissive material. The current-voltage characteristics were measured in the temperature range of 10K and 300K. We analyzed an electrical conduction mechanism of the OLEDs using space-charge-limited current(SCLC) and Fowler-Nordheim tunneling.

• Progress in Superconductivity and Cryogenics
• /
• v.18 no.2
• /
• pp.18-20
• /
• 2016

The study of superconducting fault current limiter (SFCL) is continuously being studied as a countermeasure for reducing fault-current in the power system. When the fault occurred in the power system, the fault-current was limited by the generated impedance of SFCLs. The operational characteristics of the flux-offset type SFCL according to turn ratios between the primary and the secondary winding of a reactor were compared in this study. We connected the secondary core to a superconductor and a SCR switch in series in the suggested structure. The fault current in the primary and the secondary winding of the reactor and the voltage of the superconductor on the secondary were measured and compared. The results showed that the fault current in the load line was the lowest and the voltage applied at both ends of the superconductor was also low when the secondary winding of the reactor had lower turn ratio than the primary. It was confirmed based on these results that the turn ratio of the secondary winding of the reactor must be designed to be lower than that of the primary winding to reduce the burden of the superconductor and to lower the fault current. Also, the suggested structure could increase the duration of the limited current by limiting the continuous current after the first half cycle from the fault with the fault current limiter.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.31A no.8
• /
• pp.46-52
• /
• 1994

DC and AC current crowding effects for microwave and high speed bipolar transistors are investigated in detail using a new and accurate measurement technique based on Z-parameter equationa. Using the new measurement technique dc and ac current crowding effects have been explained clearly in bipolar junction transistors. To model ac crowding effects a capacitive element defined as base capacitance (C$_b$), called ac crowding capacitance is added to base resistance in parallel thereby treating the base resistance(R$_b$) as base impedance Z$_b$. It is shown that base resistance decreases with increasing collector current due to dc current crowding and approaches to a certain limited value at high collector current due to current crowding and approaches to a certain limited value at high collector currents regardless of the emitter size. It is also observed that due to ac current crowding base capacitance increases with increasing collector current. To quantigy the ac crowding effects for SPICE circuit simulation the base capacitance(C$_b$) including the base depletion and diffusion components has been modeled with an analytical expression form.

• Proceedings of the KIEE Conference
• /
• 1995.07c
• /
• pp.1350-1352
• /
• 1995

This paper discribed the characteristic of I-t cross-over-point between current limited-fuse and explusion fuse(Bay-O-Net Fuse) and fuse protection in pad-mounted transformer that was generated internal faults and the short circuit of secondary side(load side). In the I-t cross-over-point, current limited fuse was melted when transient recovery voltage was raised rapidly.

• Progress in Superconductivity and Cryogenics
• /
• v.15 no.4
• /
• pp.30-33
• /
• 2013

The studies of superconducting fault current limiter (SFCL) for reduction of the fault current are actively underway in the worldwide. In this paper, we analyzed the characteristics of a new type SFCL using the conventional transformer and superconducting elements combined mutually. The secondary and third windings of this SFCL were connected the load and the superconducting element, respectively. The electric power was provided to load connected to secondary windings of the transformer in normal state of power system. On the other hand, when the fault occurred in power system, the fault current was limited by closing the line of third winding of the transformer. At this time, the ripple phenomenon of the fault was minimized by opening the fault line in secondary winding of a transformer in power system. The sensing of the fault state was performed by the CT(current transformer) and then turn-on and turn-off switching behavior of the SFCL was performed by the SCR(silicon-controlled rectifier). As a result, the proposed SFCL limited the fault current within a half-cycle efficiently. We confirmed that the fault current limitation rate was changed according to the winding ratio of a transformer.

• Proceedings of the Korea Institute of Applied Superconductivity and Cryogenics Conference
• /
• 1999.02a
• /
• pp.101-105
• /
• 1999

We have performed an EMTDC simulation for the current limiting effects of a superconducting fault current limiter (SFCL). The fault currents in the 154 kV transmission line between the Gaepo and Sungnam substations increased up to 54kA and 60kA during the line-to-line and three phase faults, respectively. The SFCL with 100 $\Omega$ of impedance after quench limited the currents to less than 17 kA within a half cycle. This limited current is well below the upper limit of a circuit breaker, suggesting that the impedance of the SFCL in the transmission line is sufficient.

• Proceedings of the KIEE Conference
• /
• 2002.11d
• /
• pp.64-66
• /
• 2002

Recently. switched reluctance motor is noticed because it is simple in structure and mechanically strong. SRM has great competitive power, and the study is developed about improving the characteristics of SRM. The current density of winding becomes larger in designing SRM that has the characteristics of the low voltage and high current. Hence the current density of SRM of a vehicle is high. And in order that we drive SRM in variable speed and protect the switching device. the current of SRM is limited by chopping. So it is impossible to obtain object value of output characteristics by limited current. In this paper, the author design the shape of SRM from Miller's output equation, and verify the design of SRM by using FEM. The waveform of chopping current is predicted by simulation and concur with experimental result. And the torque is improved by applying overlap current.

• Clinical and Experimental Pediatrics
• /
• v.64 no.9
• /
• pp.436-442
• /
• 2021

This article aimed to summarize the impact and burden of pediatric postintensive care syndrome (PICS-p) in the physical, mental, cognitive, and social health domains after a review of the current pediatric literature in MEDLINE and PubMed. We also aimed to elucidate the limitations of the current evaluation tools used in limited-resource settings. PICS-p can impact a child's life for decades. Most validated tools are time-consuming, require qualifications, and expertise, are often limited to older children, and can evaluate only one domain. A novel, simple, and comprehensive surveillance tool can aid healthcare providers in the early detection and intervention of PICS-p. Further studies should validate and refine the parameters that will enhance the outcomes of pediatric intensive care unit survivors.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.18 no.2
• /
• pp.327-347
• /
• 2024

Edge computing is frequently employed in the Internet of Vehicles, although the computation and communication capabilities of roadside units with edge servers are limited. As a result, to perform distributed machine learning on resource-limited MEC systems, resources have to be allocated sensibly. This paper presents an Improved MADDPG algorithm to overcome the current IoV concerns of high delay and limited offloading utility. Firstly, we employ the MADDPG algorithm for task offloading. Secondly, the edge server aggregates the updated model and modifies the aggregation model parameters to achieve optimal policy learning. Finally, the new approach is contrasted with current reinforcement learning techniques. The simulation results show that compared with MADDPG and MAA2C algorithms, our algorithm improves offloading utility by 2% and 9%, and reduces delay by 29.6%.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.04b
• /
• pp.114-117
• /
• 2002

We have studied the dependence of current-voltage characteristics of Organic Light Emitting Diodes(OLEDs) on temperature-dependent variation. The OLEDs have been based on the molecular compounds. N,N'-diphenyl-N,N'-bis(3-methylphenyl)-1, 1'- biphenyl-4, 4'-diamine (TPD) as a hole transport. tris(8-hydroxyquinolinoline) aluminum (III) ($Alq_3$) as an electron transport and Poly(3,4-ethylenedioxythiophene) (PEDOT:PSS) as a buffer layer. The current-voltage characteristics were measured in the temperature range of 10K and 300K. A conduction mechanism in OLEDs has been interpreted in terms of space-charge-limited current(SCLC) and tunneling region.Ā᐀會Ā᐀衅?⨀頱岒ᄀĀ저會Ā저?⨀⡌ឫഀĀ᐀會Ā᐀㡆?⨀쁌ឫഀĀ᐀會Ā᐀遆?⨀郞ග瀀ꀏ會Ā?⨀〲岒ऀĀ᐀會Ā᐀䁇?⨀젲岒Ā㰀會Ā㰀顇?⨀끩Ā㈀會Ā㈀?⨀䡪ഀĀ᐀會Ā᐀䡈?⨀Ā᐀會Ā᐀ꁈ?⨀硫Ā저會Ā저?⨀샟ගऀĀ저會Ā저偉?⨀栰岒ഀĀ저會Ā저ꡉ?⨀1岒ഀĀ저會Ā저J?⨀惝ග؀Ā؀會Ā؀塊?⨀ග䈀Ā切