• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2007년도 추계 학술논문 발표대회
• /
• pp.27-30
• /
• 2007

Recently, use of light-weight panel is increasing in building. Styrofoam sandwich panel is inexpensive and it is excellent in insulation ability and constructability. But styrofoam of panel inside is low ignition point. Consequently, when panel is fired, it is occur in poisonous gas. On the other hand, light-weight foamed concrete is excellent in insulation ability, fire resistance due to inner pore. Properties of light-weight concrete is influenced by foaming agent type. Accordingly, this study investigate in insulation property of according to foaming agent type in order to using light-weight foamed concrete instead of styrofoam. As a results, Non-heating zone temperature of light-weight foamed concrete of using AP, FP are lower than light-weight foamed concrete of using AES. Light-weight foamed concrete of using AES, FP are satisfied with fire performance of two hours at foam ratio 50, 100. Light-weight foamed concrete of using AP is satisfied with fire performance of two hours at AP ratio 0.1, 0.15. Insulation property is better closed pore by made AP, FP than open pore by made AES.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 가을 학술발표회 논문집
• /
• pp.413-416
• /
• 2003

Experimental tests on the high strength self-compacting concrete with light-weight fine aggregate and light-weight coarse aggregate(LHSSC) were performed with slump-flow, reaching time to the slump-flow of 500mm, V-funnel dropping time and U-box difference level and compressive strength. LHSCC with light-weight fine aggregate of 75% and light-weight coarse aggregate of 100% was only satisfied with the property conditions of second self-compacting concrete(SCC), like as flowability, resistance to segregation and filling ability. The 28-day compressive strength of LHSCC indicated above 300kgf/$\textrm{cm}^2$ in all concrete mixtures, and it was increased to increase the replacement ratio of light-weight fine aggregate or to decrease the replacement ratio of light-weight coarse aggregate. Therefore, for satisfying the properties of fresh SCC and hardened concrete with above 350kgf/$\textrm{cm}^2$, it would expected that the replacement ratio of light-weight fine aggregate and light-weight coarse aggregate will be determined with 50~75% and 25~50%, respectively.

• 한국건설순환자원학회논문집
• /
• 제2권4호
• /
• pp.321-327
• /
• 2014

경량골재콘크리트는 구조물의 자중경감을 목적으로 경량골재를 적용하여 제조한 콘크리트로 구조물의 고층화 및 대형화에 효과적으로 대응할 수 있는 장점이 있다. 하지만 경량골재는 다공체이므로 화재와 같은 고온에 노출되는 경우 수증기압이나 열응력에 의해 골재 주변으로 응력이 집중될 가능성이 커 폭렬이 발생하기 쉽다. 본 연구는 구조용 경량골재를 사용한 1종 경량골재콘크리트의 함수율과 내화특성과의 관계를 검토코자 하며, 실험결과 압축강도와 함수율이 높은 경량골재콘크리트는 폭렬의 가능성이 높기 때문에 흡수율이 작은 골재의 사용이나 폭렬방지를 위한 대책이 필요하다.

• 한국건축시공학회:학술대회논문집
• /
• 한국건축시공학회 2006년도 춘계학술논문 발표대회 제6권1호
• /
• pp.23-26
• /
• 2006

The study about the concrete to use recently a light weight aggregate, processed actively. And concrete pumping with a high pressure pump has been popularized, the mechanical development, such as high pressure pumps or pipes, is progressing rapidly. Concrete placing by pumping has the advantage of the reduction of the construction period with workability, easiness of work and the increase of placing, but the quality variation of concrete is caused by pumping is seldom considered, including the increase of the pipe length by high-rising and large-sizing, there by the loss of the unit quantity of water, with pumpability or workability deteriorated. In this research, we will compare and analyze before pumping and after pumping samples of ready-mixed light weight concrete. The result of study as follow. The case of a light weight concrete which the low slump is more decrement compared with high slump light weight concrete in after pumping samples. After pumping the water by pressure of a pump was absorbed to the aggregate inside, and it showed an increase of compression strength about $5{\sim}20%$.

• 한국농공학회논문집
• /
• 제46권2호
• /
• pp.93-103
• /
• 2004

In trench excavation, essential factor of earth-retaining temporary work structure should be easy taking to pieces and movement, and dead weight must be less. This paper studies about the light weight material and application as earth-retaining structure to prevent the slope failure of sand soil ground caused by the variation of groundwater level in trench excavation. That is, light weight earth-retaining structural is proposed and a simulation with FEM on application of proposed structural in sandy soil is presented. The results are summarized as follows; (1) The study proposed FRP H-shaped pannel for the light weight member, and also presented estimation method about stability. (2) Mechanical property (bending moment, shear force, axial force, displacement) were changed according to groundwater level, but these values had been within enough safety rate and allowable stress. Therefore, proposed light weight pannel with FRP is available for bracing structure in trench excavation.

• 한국군사과학기술학회지
• /
• 제5권2호
• /
• pp.149-158
• /
• 2002

Static Characteristics of the system, such as weight, center of gravity etc., are inspected and regulated through the whole design process of a light weight torpedo system, and the nominal condition of the characteristics is prescribed for standardization of manufacturing and fabrication. It is possible that a real system or assembled system has different static characteristics from that of the nominal condition. It is required to evaluate the tolerance of the static characteristics within which the performance of the system should not be contaminated by the static characteristics. In this paper, an evaluation method of the tolerance is described for light weight torpedo systems. The method is to check on the performance and related critical parameters of light weight torpedoes. The checking items are composed of general conditions of underwater mobile systems such as stability and dynamic sensitivity and specified performance requirements for light weight torpedoes.

• 한국강구조학회 논문집
• /
• 제17권1호통권74호
• /
• pp.33-43
• /
• 2005

본 논문은 스틸스터드로 구성된 골조에 경량기포모르터를 타설 양생하여 제작한 경량합성벽체의 반복가력 전단실험에 의한 에너지 소산능력과 압축내력 실험을 통한 압축성능의 평가에 대한 연구이다. 경량기포모르터의 유무, 경량기포모르터의 비중(0.6, 0.8, 1.0, 1.2), 마감재(경량기포모르터, OSB, 석고보드) 및 브레이스의 유무, 벽체의 단위(1단위-$900mm{\times}2,400mm$, 2단위-$1,800mm{\times}2,400mm$)를 변수로 하여 실시하였던 경량합성벽체의 전단내력 평가 실험 가운데 반복 실험 결과를 동일 조건의 단조 실험과 비교하였다. 또한 기존 스틸하우스벽체와 경량합성벽체의 압축내력도 실험을 통해 조사하였다. 반복가력 실험결과, 단조가력 실험체의 거동과 약간의 차이를 보이고 있으며 이는 벽체에 채운 경량기포모르터의 비중에 따른 차이라고 생각된다. 압축내력 실험결과, 기존형 실험체에 비하여 경량기포모르터를 타설한 실험체의 최대내력은 2~2.5배, 초기강성은 2~3배 정도 증가하였다.

• 한국강구조학회 논문집
• /
• 제19권5호
• /
• pp.455-462
• /
• 2007

본 논문은 스틸스터드로 구성된 골조에 경량기포 모르터를 충전하여 제작한 경량합성벽체의 압축 실험을 통한 압축 성능의 평가에 대한 연구이다. 경량기포 모르터의 비중(80, 120), 마감재(경량기포 모르터, OSB, 석고보드) 및 패널의 고정 방식을 변수로 하여 실험체를 제작 실험하였다. 선행 연구결과와 고정부를 개선시킨 경량합성 벽체의 압축성능에 대해 실험을 통해 조사한 결과, 상세개선으로 인한 경량합성패널의 압축 최대하중은 1.07배, 초기강성은 24배 이상 성능이 크게 향상되었다. 비중과 마감재가 동일한 실험체의 경우에는 최대하중은 2.7배, 초기강성은 15배 이상 압축으로 인한 성능이 크게 향상됨을 알 수 있다. 국내설계기준에 의해 계산한 최대하중값과 실험값은 비교적 잘 일치하였다.

• 한국정보통신학회논문지
• /
• 제12권3호
• /
• pp.485-492
• /
• 2008

유비쿼터스 환경에서의 컴퓨팅 기기들은 초경량 컴퓨팅 환경으로서 사용자들이 컴퓨터의 존재를 인지할 수 없도록 사용자 신체나 주변 환경에 내장되며, 크기가 작고, 적은 기능을 가진 많은 컴퓨터를 여러 곳에 분포하여 네트워크로 통신한다. 초경량 컴퓨팅 환경에서는 사용자들에게 서비스를 제공하기 위해 사용자의 정보를 교환하는 일이 많으며, 사용자의 정보를 보호하기 위해서는 보안 기술이 반드시 포함되어야 한다. 본 논문에서는 초경량 컴퓨팅 환경에서 표준화 된 보안 서비스를 제공하는 초경량 환경을 위한 보안 서비스 지원을 위한 API를 연구하고 설계한다. 초경량 환경의 보안 서비스 지원을 위한 API는 일반적인 컴퓨팅 환경에서와 같이 데이터 암호화, 데이터 인증, 키 관리 등의 보안 서비스를 제공하며, 초경 량 컴퓨팅 환경에 맞는 RC5와 SHA1 알고리즘 사용, 효율적인 메모리 관리를 위해 각 서비스를 라이브러리화하여 필요시마다 라이브러리를 할당/해제하는 등의 초경량 컴퓨팅 환경의 문제점을 해결할 수 있도록 설계, 구현한다.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2005년도 봄학술 발표회 논문집(II)
• /
• pp.149-152
• /
• 2005

To make artificial light-weight aggregate with EAF-dust and estimate ability to apply to concrete, characteristics of the aggregate were considered in density, weight of unit volume, fineness modulus and so on. And then it was executed to experiments of the concrete mixed with the light-weight aggregate. As it was results that artificial light-weight aggregate with EAF-dust was heavier and more watertight than with only clay, concrete weight of unit volume was heavier than with expended clay aggregate. But it was regarded that concrete with EAF-dust artificial aggregate was able to field application as light-weight concrete because concrete of the weight of unit volume was lighter and compress strength and workability were similar to normal concrete.