• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.4 no.1
• /
• pp.125-129
• /
• 1968

For the study of method for promoting the germination of Korean sod seeds harvseted newly some physical and chemical treatments were tested in this experiment. The summarized results of these tests are as follows: 1. Storage of wet seed in low temperature of 0~$2^{\circ}C$ during 2~30 days was seemed the most effective treatment for promoting the germination of sod seed. 2. The treatment that Soaking and mixing up the seeds in cone sulphuric acid about one and half minutes and then washing off in the water promoted fairly the germination of sod seeds. 3. Better germination of sod seeds was found in the light than in the dark or soil. 4. Cutting the top of seed and crushing of seed coat with sand seemed to promote slightly the germination of sod seeds. 5. No promoting effect for germination of sod seeds was found with treatments of Gibberellin, $NH_4$ $NO_3$ and NAA.

• Asian Journal of Turfgrass Science
• /
• v.10 no.3
• /
• pp.263-270
• /
• 1996

This experiment was conducted to investigate the loss of various herbicides by means of vola-tility from the turfgrass field and the hare ground with the different soil moisture contents and temperatures. Different herbicides were applied at the rates of 375 g a.i. /l0a of pendimethalin,250 g a.i. /l0a of napropamide, and 96.4 g a.i. /l0a of dicamba with 200 \ulcorner/10a of spray volume in the turfgrass(Zoysia japonica cut off 5cm) grown in pots(265.8 $cm^2$) and bared soil. The pots were placed in the growth chamber with 10,000 lux of light intensity(12h per day) at 25 and 35˚C for 7days. Amberlite XAD polymeric resin(20/50 mesh) was used as sampling media for herbicide airborne residues. Air flow was maintained at 10 \ulcorner /min by vacuum pump regulated with a factory calibrated flow meter. Herbicide airborne residues were extracted from the XAD resin with 300 ml of 1:1 acetone and hexane. The extracts were concentrated by rotary evaporation at 35˚C and dissolved in 1 ml MeCN for HPLC analysis. The airborne losses of the herbicide applied in the turfgrass and bare soil increased as the temperature and soil moisture contents were increased, regardless of the kinds of herbicide. Higher airborne residues was observed in the turfgrass pots than the bare soil pots. Pendimethalin and dicamba with higher vapor pressure gave rise to the increased loss of airborne herbicides, showing that 6.26 and 6.4% of average airborne loss in pendimethalin and dicamba, respectively, compared to 0.56% in napropamide. The amount of airborne losses in turfgrass was highest at one day after application and then a declined trend was observed as the time was prolonged. Key words. Herbicides, Turfgrass field, Bare ground, Volatility.

• Journal of Conservation Science
• /
• v.35 no.1
• /
• pp.19-31
• /
• 2019

To study the cleaning effects and post-treatment stability assessment of various methods of cleaning textiles with metal thread, six naturally-soiled historical textiles with metal thread were investigated at the Metropolitan Museum of Art, New York. Prior to the cleaning of fabricated gold, silver, and copper thread that had been glued onto a paper substrate, the artificial deterioration was carried out in a controlled environment with light(UV and daylight), and temperature and humidity factors which would weaken and damage the samples. A synthetic soil mixture was applied to the samples to imitate soil found on the historic and archaeological textiles with metal thread; the cleaning effect and post-treatment assessment were investigated by use of three textile cleaning methods: mechanical cleaning, wet cleaning, and solvent cleaning. While investigating the naturally-soiled textiles with metal thread, it was determined that the soil colors and sizes of contaminating particles of each textile were different due to the diversity of original environmental factors and conditions. After cleaning with kneaded rubber, Stoddard solvent, n-decane or n-hexane, a bright, clean effect was apparent. Kneaded rubber was successful in picking up both large and small particles, but its stickiness caused some of the metal leaf to peel off. Stoddard solvent produced a good cleaning effect, but after use of n-hexane and n-decane in the cleaning process, a white layer of residue remained on the textile's surface. Wet cleaning was not effective and the rapid humidity changes between wet and dry conditions caused the edges of the paper substrate to lose their original shape.

• Journal of Practical Agriculture & Fisheries Research
• /
• v.11 no.1
• /
• pp.125-135
• /
• 2009

Shading with silver-coated strips in combination with water spraying over the roof was more effective than others in lowering air-temperatures while the soil temperatures were more efficiently lowered by the silver-coated PE film in combination with water-flowing treatment on the soil surface. Significantly better growth and higher yield of spinach were recorded in the plots having lower soil termperatures. Whitewash spray with lime mixture resulted in higher yield of spinach as compared to the white water-soluble painting, possibly because of the better light penetration toward the end of the growing season by the natural weather off phenomenon.

• Journal of Astronomy and Space Sciences
• /
• v.18 no.3
• /
• pp.239-248
• /
• 2001

Far-ultraviolet IMaging Spectrograph (FIMS) is the main payload of the first Korean scientific satellite, KAISTSAT-4, which will be launched in 2002. Among the optical parts, parabolic cylinder mirror does not have any heritage from previous astronomical missions, so the manufacturing and testing process itself is a challenging issue. We describe the method of manufacturing and measuring of the off-axis parabolic cylinder mirror and our initial experiments to establish the entire manufacturing process. Using the method, the profile error can meet the specification of $lambda$ per cm which is closely related with the astronomical performances. In case of the surface roughness, temperature controlled pitch polishing reduces $R_{q}$ under 1 nm implying that scattering in the entire spectral range of FIMS is less than 2% of the incident UV light.

• Korean journal of applied entomology
• /
• v.55 no.4
• /
• pp.453-457
• /
• 2016

This study investigates the hatching periods and hatchability of the eggs of Pochazia shantungensis at different collection times from 2011 to 2014, and the effect of temperature on the growth of P. shantungensis nymphs in an area of its outbreak. The hatchability of P. shantungensis eggs varies with their collection time; their hatchability in late November was higher than that in March of the next year, but no difference was observed in their hatching periods. The hatching periods of the eggs were 51.2, 31.3, 24.8, 19.4, 17.1, and 19.4 days at 15, 18, 21, 24, 27, and $30^{\circ}C$, respectively. The hatchability was above 70% at temperatures ranging from 18 to $27^{\circ}C$. The hatching time of the overwintered eggs in the Gurye region in Korea was reduced by 9 days from 2011 to 2014. The hatching rate was relatively higher when the average temperature in the winter season was relatively warmer. The dvelopmental periods of the first to fifth nymphs were 82.8, 58.0, 45.8, and 39.6 days at 18, 21, 24, and $27^{\circ}C$, respectively, at the relative humidity of 40~70%, and a photoperiod off 14 h light:10 h dark. The higher the temperature, the shorter the developmental period. At $30^{\circ}C$, all life stages after the fourth nymph died. Thus, the optimum growth temperature was estimated to be $27^{\circ}C$. For all life stages from the egg to the fourth nymph, the relationship between the temperature and developmental rate was expressed by the linear equation Y = 0.0015 X - 0.014. The lower developmental threshold was $9.3^{\circ}C$ and the effective cumulative temperature was 693.3 degree-days. The lower developmental threshold of approximately $3.8^{\circ}C$ was the lowest at the fourth nymph stage.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.34 no.2
• /
• pp.165-171
• /
• 2010

The Homogeneous Charge Compression Ignition (HCCI) engine concept allows for both NOx and particulate matter to be reduced simultaneously, and it is a promising way to meet the next environmental challenges. Unfortunately, HCCI combustion often increases CO and HC emissions. The development of oxidation catalyst (OC) requires high conversion efficiency for CO and HC at low temperature. Conventional oxidation catalyst technologies may not be able to convert these emissions because of the saturation of active catalytic sites. The OC used in this study was 600 cpsi cordierite. Three kinds of OC with different amounts of Pt and Pd were used. The influence of the space velocity (SV), $H_2O$ and $O_2$ concentration was also studied. All types of OCs were found to have over 90% CO conversion efficiencies at $170^{\circ}C$. When in the presence of water vapor, CO conversion was increased, but $C_3H_8$ conversion was decreased. The performance of the OC was not influenced by initial the HC concentration. The 2Pt/Pd catalyst was better in terms of thermal aging than the Pt-only catalyst. The $LOT_{50}$ of both fresh and aged OC was increased with increasing SV and with the presence of $H_2O$.

• Applied Chemistry for Engineering
• /
• v.10 no.1
• /
• pp.58-66
• /
• 1999

The catalytic oxidation of vinyl chloride was investigated over $CrO_x$ impregnated on $Al_2O_3$ at temperature between 200 and $400^{\circ}C$. The major carbonaceous products were CO and $CO_2$, and the selectivity of $CO_2$ was gradually increased with increasing reaction temperature, while that of CO was dropped consequently. This suggests that CO is the first product which is further oxidized to $CO_2$ in the oxidation of vinyl chloride over $CrO_x/Al_2O_3$. The addition of HCl in the feed didn't affect the conversion of vinyl chloride, but the selectivity of $CO_2$ decreased by adding HCl. It implies that HCl inhibits, the complete oxidation of vinyl chloride to $CO_2$. When oxidizing vinyl chloride in dry air, significant amounts of $Cl_2$ were observed, while no $Cl_2$ was detected in the humid condition. The activities of several catalysts including various precious metals and other transition metal oxides were measured, it was found that the catalytic activity of 12% $CrO_x/Al_2O_3$ was higher than other catalysts except 1% $Pt/Al_2O_3$. The reaction rate of 12% $CrO_x/Al_2O_3$ was 1.2 times lower than that of 1% Pt/alumina, but it was 3 to 8 times more active than other catalysts for vinyl chloride oxidation at $275^{\circ}C$.

• Development and Reproduction
• /
• v.20 no.2
• /
• pp.119-125
• /
• 2016

This study describes results on sexual maturation and characteristics of natural spawned eggs to develop a method for the production of stable, healthy fertilized eggs from captive-reared yellowtail kingfish, Seriola lalandi. A total of 59 yellowtail kingfish were captured off the coast of Jeju Island, after which the broodstock was cultured in indoor culture tank ($100m^3$) until they were 6.1-14.9 kg in body weight. As part of the rearing management for induced sex maturation, the intensity of illumination was maintained at 130 lux. The photoperiod (light/dark; L/D) was set to a 12 L/12 D from October 2013 to January 2014, and 15 L/9 D from February 2014 to June 2014. Feeds comprised mainly EP (Extruded Pellets), with squid cuttlefish added for improvement of egg quality, and was given from April to June 2014. The first spawning of yellowtail kingfish occurred in May 3, 2014, at a water temperature of $17.0^{\circ}C$. Spawning continued until June 12, 2014, with the water temperature set at $20.5^{\circ}C$. Time of spawning was 26 times at this period. The total number of eggs that spawned during the spawning period was $4,449{\times}10^3$. The buoyant rate of spawning eggs and fertilization rate of buoyant eggs during the spawned period were 76.1% and 100%, respectively. The diameters of the egg and oil globule were $1.388{\pm}0.041mm$ and $0.378{\pm}0.029mm$, respectively, which was higher in early eggs than in those from late during the spawned period.

• Korean Journal of Agricultural Science
• /
• v.38 no.4
• /
• pp.753-759
• /
• 2011

Protected crop production has been popular in Korea as well as in other countries. Intensive and continuous monitoring and control of the environment, which is labor- and time-consuming, is critical for stable crop productivity and profitability, otherwise damage could be happened due to unfavorable ambient and soil conditions. In the study, potential utilization of smartphone and remote access application in protected crop production environment was investigated. Tested available remote access applications provided functions of mouse click (left and right buttons), zooming in and out, and screen size and color resolution control. Wi-Fi data communication speeds were affected by signal intensity and user place. Data speeds at high (> -55 dBm), medium (-70~-56 dBm), and low (< -71 dBm) signal intensity levels were statistically different (${\alpha}=0.05$). Means of data communication speed were 6.642, 4.923, and 2.906 Mbps at hot spot, home, and office, respectively, and the differences were significant at a 0.05 level. Smart phone and remote access application were applied successfully to remote monitoring (inside temperature and humidity, and outside precipitation, temperature, and humidity) and control (window and light on/off) of green house environment. Response times for monitoring and control were less than 1 s at all places for high signal intensity (> -55 dBm), but they were increased to 1 ~ 10 s at home and office and to 10 ~ 30 s at hot spot for low signal intensity (< -71 dBm) for Wi-Fi. Results of the study would provide useful information for farmers to apply these techniques for their crop production.