• Journal of Korean Society for Atmospheric Environment
• /
• 제21권E2호
• /
• pp.49-56
• /
• 2005

A long-path transmissometer is one of the optical instruments widely used to measure atmospheric light extinction coefficient without enclosing a light beam and perturbing aerosols. Over the past two decades, a number of measurements have been carried out using the long-path transmissometer manufactured by OPTEC, Inc. Calibration of the transmissometer should be performed when any component of the transmissometer system is interchanged or installation condition is changed. For a better calibration of the transmissometer, application of a modified calibration method for the existing neutral density (ND)-filter method was recommended for the computation of the atmospheric transmittance using model MODTRAN 4 in this study. It was revealed that the measured light extinction coefficient from the transmissometer which was calibrated using the existing ND-filter method could be overestimated due to the assumption of the atmospheric transmittance suggested by OPTEC, Inc. The uncertainty of the measured light extinction coefficient from the transmissometer calibrated based on the modified ND-filter method was calculated to be approximately $13Mm^{-1}$.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제11권11호
• /
• pp.5491-5505
• /
• 2017

Use of the Gaussian inverse Wishart PHD (GIW-PHD) filter has demonstrated promise as an approach to track an unknown number of extended targets. However, the partitioning approaches used in the GIW-PHD filter, such as distance partition with sub-partition (DP-SP), prediction partition (PP) and expectation maximization partition (EMP), fails to provided accurate partition results when targets are spaced closely together and performing maneuvers. In order to improve the performance of a GIW-PHD filter, this paper presents a cooperation partitioning (CP) algorithm to solve the partitioning issue when targets are spaced closely together. In the GIW-PHD filter, the DP-SP is insensitive to target maneuvers but sensitive to the differences in target sizes, while EMP is the opposite. The proposed CP algorithm is a fusion approach of DP-SP and EMP, which employs EMP as a sub-partition approach after DP. Therefore, the CP algorithm will be sensitive to neither target maneuvers nor differences in target sizes. The simulation results show that the use of the proposed CP algorithm will improve the performance of the GIW-PHD filter when targets are spaced closely together.

• Biotechnology and Bioprocess Engineering:BBE
• /
• 제9권6호
• /
• pp.428-434
• /
• 2004

Coarse clumping of solid materials within diseased biological cells can have a marked influence on the light scattering pattern. Perturbations in refractive index lead to distinct varia­tions in the cytometric signature, especially apparent over wide scattering angles. The large dynamic range of scattering intensities restricts collection of data to narrow angular intervals be­lieved to have the highest potential for medical diagnosis. We propose the use of an interfer­ence filter to reduce the dynamic range. Selective attenuation of scattering intensity levels is expected to allow simultaneous data collection over a wide angular interval. The calculated angu­lar transmittance of a commercial shortwave-pass filter of cut-off wavelength 580 nm indicates significant attenuation of scattering peaks below ${\~}\;10^{circ}$, and reasonable peak equalization at higher angles. For the three-dimensional calculation of laser light scattered by cells we use a spectral method code that models cells as spatially varying dielectrics, stationary in time. How­ever, we perform preliminary experimental testing with the interference filter on polystyrene microspheres instead of biological cells. A microfluidic toolkit is used for the manipulation of the microspheres. The paper intends to illustrate the principle of a light scattering detection system incorporating an interference filter for selective attenuation of scattering peaks.

• 한국정보통신학회:학술대회논문집
• /
• 한국정보통신학회 2022년도 춘계학술대회
• /
• pp.437-440
• /
• 2022

현대 사회는 4차 산업 혁명과 IoT 기술 등의 발전으로 영상 처리 분야의 활용이 급증하고 있다. 특히, 에지 검출은 이미지 분류, 객체 검출 등 영상 처리 응용에서 필수적인 전처리 과정으로 여러 분야에서 널리 사용되고 있다. 에지를 검출하기 위한 기존의 방법에는 소벨 필터(Sobel edge detection filter), 로버츠 필터(Roberts edge detection filter), 프리윗 필터(Prewitt edge detection filter), LoG(Laplacian of Gaussian) 등이 있다. 하지만 기존의 방법들은 명암도가 낮은 저조도 환경에서 에지 검출 특성이 다소 미흡한 성능을 보인다는 단점이 있다. 따라서 본 논문에서는 저조도 환경에서도 에지 검출 특성을 높이기 위해 명암도 분석에 기반한 에지 검출 알고리즘을 제안한다.

• Current Optics and Photonics
• /
• 제3권6호
• /
• pp.590-596
• /
• 2019

To improve the color gamut of a liquid-crystal display (LCD), we propose a bandpass filter that is added to the backlight unit to optimize the backlight spectrum. The bandpass filter can only transmit red, green and blue light in the visible range, while reflecting the unwanted light. We study the optical properties of the bandpass filter using the transfer-matrix method, and the effect of the bandpass filter on the color gamuts of LCDs is also investigated. When a bandpass filter based on a 5-layer configuration comprising low and high refractive indices ((HL)²H) is used in phosphor-converted white-light-emitting diode (pc-WLED), K₂SiF₆:Mn⁴⁺ (KSF-LED), and quantum-dot (QD) backlights, the color gamuts of the LCDs improve from 72% to 95.3% of NTSC, from 92% to 106.7% of NTSC, and from 104.3% to 112.2% of NTSC respectively. When the incident angle of light increases to 30°, the color gamuts of LCDs with pc-WLED and KSF-LED backlights decrease by 2.9% and 1% respectively. For the QD backlight, the color gamut almost does not change. When the (HL)²H structure is coated on the diffusion film, the color gamut can be improved to 92.6% of NTSC (pc-WLED), 105.6% of NTSC (KSF-LED), and 111.9% of NTSC (QD). The diffusion film has no obvious effect on the color gamut. The results have an important potential application in wide-color-gamut LCDs.

• Environmental Engineering Research
• /
• 제23권2호
• /
• pp.205-209
• /
• 2018

The spectral composition of light can affect the growth and biochemical composition of photosynthetic microalgae. This study examined the use of light filtering through a solution of soluble colored additives, a cost-effective method to alter the light spectrum, on the growth and lipid production of an oleaginous microalga, Nannochloropsis gaditana (N. gaditana). Cells were photoautotrophically cultivated under a white light emitting diode (LED) alone (control) or under a white LED that passed through a solution of red and yellow color additive (4:1 ratio) that blocked light below 600 nm. The specific growth rate was significantly greater under filtered light than white light ($0.2672d^{-1}$ vs. $0.1930d^{-1}$). Growth under filtered light also increased the fatty acid methyl ester (FAME) yield by 22.4% and FAME productivity by 80.0%, relative to the white light control. In addition, the content of saturated fatty acids was greater under filtered light, so the biodiesel products had better stability. These results show that passing white light through an inexpensive color filter can simultaneously enhance cellular growth and lipid productivity of N. gaditana. This approach of optimizing the light spectrum may be applicable to other species of microalgae.

• 센서학회지
• /
• 제29권4호
• /
• pp.243-248
• /
• 2020

In this study, we applied transition-frequency modulation to prevent the flickering of light-emitting diodes (LEDs) in visible light communication (VLC). In the VLC transmitter, rectangular waveforms with transition frequencies of four and two in each bit time were used for the high and low bits, respectively, in the non-return-to-zero data. In the VLC receiver, an RC-high-pass filter (HPF) was used to eliminate the interference of the 120 Hz noise light from the adjacent lighting lamps, and an SR-latch circuit was used to recover the transmitted signal using spikes from the output of the RC-HPF. This configuration is useful for constructing VLC systems that are flicker-free and resistant to adjacent noise light interference.

• Journal of Biosystems Engineering
• /
• 제35권6호
• /
• pp.420-425
• /
• 2010

We produced a basic system of sterilization of nutrient solution based on the characteristics of coated filter with the visible light-reactive titanium oxide photocatalyst according to the findings of the first stage. We developed a model system with a proper number and arrangement of filter elements, the visible light-reactive titanium oxide photocatalyst according to findings from the basic performance test. Main results of this study were as followers; The ceramic filters showed the best performance of sterilization of nutrient solution. The visible light-reactive titanium oxide photocatalyst sterilized more effectively the nutrient solution under the sunlight than UV light. The sterilization performance by passing repeatedly through a few filter was more efficient than that by treating simultaneously with a large number of filters. The filter with 15ppi in pore size, 20 mm in thickness, and 3 layers in titanium oxide coating was desirable in the intensity and sterilization performance.

• 한국광학회지
• /
• 제19권4호
• /
• pp.294-301
• /
• 2008

콜레스테릭 액정 컬러 필터의 광학적 특성 분석을 위한 모델링 및 시뮬레이션을 수행하였다. Berreman $4{\times}4$ 행렬법을 사용하여 입사각도별 콜레스테릭 액정 컬러 필터의 반사 스펙트럼을 계산하였고, 이를 광선 추적법에 기초한 조명설계 소프트웨어인 LightTools의 사용자 정의 코팅 파라미터로 입력하였다. LightTools를 이용하여 평면 투과형 콜레스테릭 액정 컬러 필터의 시야각에 따른 색변화를 시뮬레이션 하였다. 5도 간격 이하의 입사각도별 반사 스펙트럼을 LightTools의 사용자 정의 코팅 파라미터로 사용하였을 때, Berreman $4{\times}4$ 행렬법의 결과와 부합하는 결과를 얻을 수 있었다. 또한 반구형 패턴을 갖고 있는 반사형 콜레스테릭 액정 컬러 필터의 시야각에 따른 색변화를 시뮬레이션 하였는데, 본 논문의 시뮬레이션 방법을 비 평면형 구조에도 적용할 수 있음을 확인하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 심포지엄 논문집 정보 및 제어부문
• /
• pp.73-76
• /
• 2007

Photodynamic diagnosis(PDD) is a method to diagnose the possibility of cancer, both by the principle that if a photosensitizer is injected into an organic tissue, it is accumulated in the tissue of a malignant tumor selectively after a specific period, and by a comparison of the intensity of the fluorescence of normal tissue with abnormal tissue after investigating the excitation light of a tissue with accumulated photosensitizer. Since the selection of the wavelength band of excitation light has an interrelation with fluorescence generation according to the selection of a photosencitizer, it plays an important role in POD. This study aims at designing and evaluating light source devices that can stably generate light with various kinds of wavelengths In order to make possible PDD using a photosensitizer and diagnosis using auto-fluorescence. The light source device was a Xenon lamp and filter wheel, composed of an optical output control through Iris and filters with several wavelength bands It also makes the inducement of auto-fluorescence possible because it is designed to generate a wavelength band of 380-400. The transmission part of the light source was, developed to enhance the efficiency of light transmission. To evaluate this light source device, the characteristics of the light output and wavelength band were verified. To validate the capability of this device as PDD the detection of auto-fluorescence using mouse was performed.