• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.9 no.5
• /
• pp.1066-1072
• /
• 2005

The effects of La concentration in PLZT (z/30/70) thin film prepared by sol-gel method are investigated for the NVFRAM application. As the La concentration increases, the dielectric constants at 10 kHz increase from 450 to 600, while the loss tangent and the leakage current density at 100 kV/cm decrease from 0.075 to 0.025 and from $5.83{\times}10^{-7}\;to\;1.38{\times}10^{-7}\;A/cm^2,$ respectively. In the results of hysteresis loops measured at 175 kV/cm, the remanent polarization and the coercive field decrease from 20.8 to $10.5{\mu}C/cm^2$ and from 54.48 to 32.12 kV/cm, respectively, with the increase of La concentration from 0 to $10mol\%.$ After applying for $10^9$ cycles of square pulses with ${\pm}5V$ height, the remanent polarization of the PLZT (10/30/70) thin film decreases $40\%$ from the initial state, while that of the PLZT (10/30/70) thin film decreases $64\%.$.

• Journal of Bio-Environment Control
• /
• v.14 no.3
• /
• pp.218-231
• /
• 2005

This paper reviews the engineering approach needed to support humans during their long-term missions in space. This approach includes closed plant production systems under microgravity or low pressure, mass recycling, air revitalization, water purification, waste management, elimination of trace contaminants, lighting, and nutrient delivery systems in controlled ecological life support system (CELSS). Requirements of crops f3r space use are high production, edibility, digestibility, many culinary uses, capability of automation, short stems, and high transpiration. Low pressure on Mars is considered to be a major obstacle for the design of greenhouses fer crop production. However interest in Mars inflatable greenhouse applicable to planetary surface has increased. Structure, internal pressure, material, method of lighting, and shielding are principal design parameters for the inflatable greenhouse. The inflatable greenhouse operating at low pressure can reduce the structural mass and atmosphere leakage rate. Plants growing at reduced pressure show an increasing transpiration rates and a high water loss. Vapor pressure increases as moisture is added to the air through transpiration or evaporation from leaks in the hydroponic system. Fluctuations in vapor pressure will significantly influence total pressure in a closed system. Thus hydroponic systems should be as tight as possible to reduce the quantity of water that evaporates from leaks. And the environmental control system to maintain high relative humidity at low pressure should be developed. The essence of technologies associated with CELSS can support human lift even at extremely harsh conditions such as in deserts, polar regions, and under the ocean on Earth as well as in space.

• Journal of the Korean Vacuum Society
• /
• v.9 no.4
• /
• pp.411-418
• /
• 2000

$Al_2O_3$ thin films of 300 nm thickness were deposited at room temperature using DC reactive sputtering with variation of the $O_2$ content in the sputtering gas from 30% to 70%. Regardless of the $O_2$ content in the sputtering gas, the sputtered $Al_2O_3$ films were amorphous and exhibited the refractive index of 1.58. When the $O_2$ content in the sputtering gas was higher than 50%, the $Al_2O_3$ films exhibited excellent transmittance of about 98% at 550 nm wavelength. However, the transmittance decreased to about 94% for the $Al_2O_3$ films deposited with the sputtering gas of the 30% and 40% $O_2$contents. The optimum dielectric properties (dielectric constant of 10.9 and loss tangent of 0.01) was obtained for the $Al_2O_3$ film deposited with the sputtering gas of the 50% $O_2$ content. When the $O_2$ content in the sputtering gas was within 40% to 60%, the $Al_2O_3$ films exhibited no shift of flatband voltage $V_{FB}$ in C-V curves and exhibited leakage current density lower than $10^{-5}\textrm{A/cm}^2$ at 150 kV/cm.

• Korean Journal of Weed Science
• /
• v.31 no.3
• /
• pp.240-249
• /
• 2011

The potential of juglone a plant naphthoquinone as a natural herbicide on new target, 7-keto-8-amino pelargonic acid synthetase (KAPAS) in the early step of biotin biosynthesis pathway, was performed in vitro and in vivo. Juglone effectively inhibited KAPAS activities in vitro and the $IC_{50}$ was $9.5{\mu}M$. Foliar application of juglone showed very good herbicidal activity to the eight-tested weed species. Among them, Solanum nigrum was completely controlled at a concentration of $250{\mu}g\;mL^{-1}$ with main symptoms of desiccation or burndown. Digitaria sanguinalis and Aeschynomene indica were also sensitive to juglone treatment. All eight weed species were controlled by 90~100% at a concentration of $500{\mu}g\;mL^{-1}$. However, soil application of juglone to Digitaria sanguinalis did not show any herbicidal symptoms. Cellular leakage from cucumber leaf squares treated with juglone increased depending on the concentrations increased from 6.25 to $100{\mu}M$ after 24 hours incubation with or without light. However, chlorophyll loss in cucumber leaf squares was negligible. Biotin supplements significantly rescued the inhibition of germination rate of Arabidopsis thaliana seeds previously inhibited by the juglone. Our results suggest that the juglone is a possible environmental friendly herbicide candidate with a new target KAPAS inhibiting activity.

• Journal of the korean academy of Pediatric Dentistry
• /
• v.32 no.4
• /
• pp.657-661
• /
• 2005

Various chemotherapeutic agents have been recommended for pulpotomy of primary teeth, and there are formocresol, ferric sulfate, and calcium hydroxide. Of those, formocresol has fixation effect of pulp tissue and high clinical success rate, so it is most commonly used agent. But formocresol has strong cytotoxic effects, thus many articles reported displacement and loss of permanent successor, amelogenesis imperfecta, mutation by general absorption, possibility of cancer induction. Recently, it has been reported that leakage by imperfect temporary sealing when FC-soaked cotton was inserted into the root canal caused necrosis of surrounding tissues. and that necrosis of alveolar bone related to the use of excessive formocresol. In this case, 2nd primary molar of upper left jaw was treated using formocresol in local clinic, but extracted because of lasting pain. Furthermore, symptoms didn't disappear so patient was refered to us. The patient was 8-year-old male, had foul odor from oral cavity and circular alveolar bone necrosis around the permanent successor' crown. Thus sequestrectomy was operated and observed through 19 months after operation, we found normal root development of permanent successor but no complete regeneration of alveolar bone defect and attached gingiva. Lesion of periodontal tissues by formocresol is irreversible, so we have to confirm the indication in using formocresol and pay attention to complete temporary sealing.

• Korean journal of applied entomology
• /
• v.26 no.3 s.72
• /
• pp.171-178
• /
• 1987

Pathogenic isolates of Alternaria mali produced host-specific toxin(AM-toxin) in liquid culture. The toxin was also released by germinating spores of the fungus. The physiological event of apple leaves induced by germinating spores was an increased loss of electrolytes from susceptible leaves. This reaction was evident soon after spore inoculation, indicating that the leakage was caused by AM-toxin from germinating spores. Typical symptoms were developed only in susceptible leaves of apple within 48hr after inoculation with pathogenic spores. Similar symptoms occurred on susceptible leaves when non-pathogenic isolates plus AM-toxin were used.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.5
• /
• pp.819-824
• /
• 2016

The accelerated thermal aging of CSPE (chlorosulfonated polyethylene) was carried out for 33.64 and 67.27 days at 110[$^{\circ}C$], equivalent to 40 and 80 years of aging at 50[$^{\circ}C$], respectively. These samples were referred to as CSPE-0y, CSPE-40y and CSPE-80y, respectively. As the accelerated thermally aged years of the CSPE increase, the insulation resistance[$\Omega$] at 20[Hz], 500[Hz], and 2[KHz], and the percent elongation [%EL] of the CSPE decrease. However, the dissipation factor($tan{\delta}$) at 20[Hz], 500[Hz], and 2[KHz], the apparent density[$g/cm^3$], the glass transition temperature and the melting temperature of the CSPE were increased. The period of time that the voltage has to be applied until electric breakdown of the CSPE-0y is longer than that of the CSPE-40y, and the CSPE-80y, but the dielectric strength of the CSPE-80y is lower than that of the CSPE-0y and the CSPE-40y. The differential temperatures after the AC and DC voltages are applied to CSPE-0y, CSPE-40y and CSPE-80y are 0.026~0.028[$^{\circ}C$], 0.030~0.042[$^{\circ}C$], 0.018~0.045[$^{\circ}C$], respectively. The variations of temperature for the AC voltage are higher than those for the DC voltage when an AC voltage is applied to CSPE-0y, CSPE-40y and CSPE-80y. It is found that the dielectric loss owing to the dissipation factor[$tan{\delta}$] is related to the electric dipole conduction current. It is ascertained that the ionic (electron or hole) leakage current is increased by the separation of the branch chain of CSPE polymer from the main chain of the polyethylene as a result of thermal stress due to accelerated thermal aging as well as by conducting ions such as $Na^+$, $Cl^-$, $Mg^{2+}$, $SO_4^{2-}$, $Ca^{2+}$ and $K^+$ after seawater soaking.

• Journal of the Computational Structural Engineering Institute of Korea
• /
• v.28 no.5
• /
• pp.523-533
• /
• 2015

A reactor containment acts as a final barrier to prevent leakage of radioactive material due to the possible reactor accidents into external environment. Because of the functional importance of the containment building, the SIT(Structural Integrity Test) for containments shall be performed to evaluate the structural acceptability and demonstrate the quality of construction. An initial numerical analysis was performed to simulate the results obtained from the SIT for a prestressed concrete(PSC) structure. But the analysis results by the initial model expected smaller displacements than the measured ones by 30% at some locations. Accordingly, the research and development to improve the initial model to corelate the measured results of the SIT more properly have been performed. In this paper, the effects of the loss of concrete due to duct for tendons and the contact of duct and tendons in un-bonded tendon system are mainly evaluated based on the preliminary analysis results. In addition, the importances of the proper definition of mesh connectivity among structural elements of concrete, liner plates, rebars and tendons are discussed.

• Korean Chemical Engineering Research
• /
• v.48 no.2
• /
• pp.185-192
• /
• 2010

The chemical-looping combustion(CLC) has advantages of no energy loss for separation of $CO_2$ without $NO_x$ formation. This CLC system consists of oxidation and reduction reactors where metal oxides particles are circulating through these two reactors. In the present study, the reaction kinetic equations of iron oxide oxygen carriers supported on bentonite have been determined by the shrinking core model. Based on the reactivity data, design values of solid circulation rate and solids inventory were determined for the rector. Two types of interconnected fluidized bed systems were designed for CLC application, one system consists of a riser and a bubbling fluidized bed, and the other one has a riser and two bubbling fluidized beds. Solid circulation rates were varied to about $30kg/m^2s$ by aeration into a loop-seal. Solid circulation rate increases with increasing aeration velocity and it increases further with an auxiliary gas flow into the loop-seal. As solid circulation rate is increased, solid hold up in the riser increases. A typical gas leakage from the riser to the fluidized bed is found to be less than 1%.

• Journal of Bio-Environment Control
• /
• v.17 no.4
• /
• pp.319-324
• /
• 2008

The sweet pepper (paprika) is one of the most important exported vegetable crops in Korea. This study evaluated the storability of sweet pepper fruits between 2 cultivars with different maturities under different storage conditions. The sweet peppers ('Special' and 'Fiesta') were grown in a rockwool hydroponic system, and harvested two different maturities: half-maturity and full-maturity levels. The sweet pepper fruits were stored in MA(non-ventilated) and non-MA(ventilated) conditions at 4 and $9^{\circ}C$ for 20 days. The storability of sweet pepper fruit was the highest in $4^{\circ}C$ MA conditions that remained 5% carbon dioxide and 10% oxygen during the storage. The ethylene concentration in MA condition showed $2{\sim}8{\mu}l/l$ regardless of storage temperatures, cultivars and maturities. The fruits packaged with non-ventilated film, showed lower weight loss, and higher firmness, and there was no different about decay ratio compared to the fruits packed ventilated film. The coloration of semi-matured fruit that colored 50% before storage progressed faster in non-ventilated packaging condition at $9^{\circ}C$, but their color did not changed as same as level of full-matured fruit. The electrolyte leakages and respiratory rate that estimated degree of chilling injury was highest in non-MA(ventilated) conditions of 'Special' full matured fruit placed at room temperature for 3 days following storage at $4^{\circ}C$ for 20 days. It may be suggested that sweet pepper fruit packed sealed (non-ventilated) film and stored at non-chilling temperature can be maintained better quality for long term storage.