• Journal of the Microelectronics and Packaging Society
• /
• v.27 no.4
• /
• pp.97-105
• /
• 2020

Recently, as the data speed and operating frequencies of Ethernet keeps increasing, electro magnetic interference (EMI) also becomes increasing. The generation of such EMI will cause malfunction of near electronic devices. In this study, EMI filters were applied to reduce the EMI generated by DC-DC SMPS (switching mode power supply), which is the main cause of EMI generation of Ethernet switch. As the EMI filter, MLCCs with excellent withstanding voltage characteristics were used, which had advantages in miniaturization and mass production. Two types of EMI MLCC filters were used, which are X-capacitor and X, Y-capacitor. X-capacitor was composed of 2 MLCCs with 10 nF and 100 nF capacity and 1 Mylar capacitor. Y-capacitor was consisted of 6 MLCCs with a capacity of 27 nF. When only X-capacitor was applied as EMI filter, the conductive EMI field strength exceeded the allowable limit in frequency range of 150 kHz ~ 30 MHz. The radiative EMI also showed high EMI strength and very small allowable margin at the specific frequencies. When the X and Y-capacitors were applied, the conductive EMI was greatly reduced, and the radiation EMI was also found to have sufficient margin. In addition, X, Y-capacitors showed very high insulation resistance and withstanding resistance performances. In conclusion, EMI X, Y-capacitors using MLCCs reduced the EMI noise effectively and showed excellent electrical reliability.

• The Journal of Engineering Geology
• /
• v.31 no.4
• /
• pp.701-718
• /
• 2021

Geological field surveys and a series of laboratory tests were conducted to obtain data related to landslides in Sancheok-myeon, Chungju-si, Chungcheongbuk-do, South Korea where many landslides occurred in the summer of 2020. The magnitudes of various factors' influence on landslide occurrence were evaluated using logistic regression analysis and an artificial neural network. Undisturbed specimens were sampled according to landslide occurrence, and dynamic cone penetration testing measured the depth of the soil layer during geological field surveys. Laboratory tests were performed following the standards of ASTM International. To solve the problem of multicollinearity, the variation inflation factor was calculated for all factors related to landslides, and then nine factors (shear strength, lithology, saturated water content, specific gravity, hydraulic conductivity, USCS, slope angle, and elevation) were determined as influential factors for consideration by machine learning techniques. Minimum-maximum normalization compared factors directly with each other. Logistic regression analysis identified soil depth, slope angle, saturated water content, and shear strength as having the greatest influence (in that order) on the occurrence of landslides. Artificial neural network analysis ranked factors by greatest influence in the order of slope angle, soil depth, saturated water content, and shear strength. Arithmetically averaging the effectiveness of both analyses found slope angle, soil depth, saturated water content, and shear strength as the top four factors. The sum of their effectiveness was ~70%.

• The Journal of Engineering Geology
• /
• v.31 no.4
• /
• pp.589-601
• /
• 2021

Artificial recharge technology is a method for solving problems such as groundwater level drop and ground subsidence caused by groundwater withdrawal. This study investigated the applicability of using the hydraulic conductivity of an aquifer to predict injection test results for aquifer restoration. Pumping and injection tests were performed under the same conditions as those for the artificial injection facility located in Icheon, Gyeonggi-do. The hydraulic conductivity of the aquifer, which plays a decisive role in restoring the groundwater level, was derived from the pumping test. A numerical model of a simplified on-site aquifer was constructed, and a transient analysis was applied with the same conditions as the pumping test. The correlation between the measured and the resulting model values is strong (R² = 0.78). The injection test was performed in a sedimentary layer composed of silt sand and clay sand. From the results of the injection test, an empirical formula was derived using Theim's formula, which is a common well analysis solution to determine the parameters of the aquifer from time-level data. The model values from the empirical formula have a high degree of correlation (R² = 0.99) with measured values. Under specific conditions, for areas where it is difficult to conduct an injection test, the formula from this study, which relies on the hydraulic conductivity of the aquifer determined through the pumping test, may be used to predict reliable injection rates for groundwater restoration.

• Journal of the Korean Electrochemical Society
• /
• v.25 no.1
• /
• pp.1-12
• /
• 2022

Lithium metal is the most promising anode for next-generation lithium-ion batteries due to its lowest reduction potential (-3.04 V vs. SHE) and high specific capacity (3860 mAh/g). However, the dendritic formation under high charging current density remains one of main technical barriers to be used for commercial rechargeable batteries. To address these issues, tremendous research to suppress lithium dendrite formation have been conducted through new electrolyte formulation, robust protection layer, shape-controlled lithium metal, separator modification, etc. However, Li/Li symmetric cell test is always a starting or essential step to demonstrate better lithium dendrite formation behavior with lower overpotential and longer cycle life without careful analysis. Thus, this review summarizes overpotential behaviors of Li/Li symmetric cells along with theoretical explanations like initial peaking or later arcing. Also, we categorize various overpotential data depending on research approaches and discuss them based on peaking and arcing behaviors. Thus, this review will be very helpful for researchers in lithium metal to analyze their overpotential behaviors.

• Journal of Korean Society of Forest Science
• /
• v.112 no.3
• /
• pp.382-392
• /
• 2023

Recent reports have indicated a rapid increase in the frequency of sediment disasters due to climate change and other changes in the geological environment. Given this alarming situation and the recent increase in the frequency of land creep in Korea, systematic and efficient recovery and management of land creep areas is essential. The purpose of this study is to identify disaster vulnerability by conducting a physical exploration of land creep in San 4-1, Jayeon-ri, Gaegun-myeon, Yangpyeong-gun, Gyeonggi-do, and examine stability by identifying the overall geological structure of the affected ground. In addition, drilling surveys are conducted to verify the reliability of the measured data. The results of the study reveal that low specific resistance abnormalities are distributed in the upper part of the soil layer and weathering zone and that this section is a 50-120 m exploration line. It is also confirmed to be a low-hardness ground area where tensile cracks are observed. Therefore, there is a need for research focused on developing measures to reduce economic and social damage within the domestic context by continuously monitoring indicators of land creep and identifying land creep risks.

• Journal of the Korea Society for Simulation
• /
• v.18 no.3
• /
• pp.123-131
• /
• 2009

Wireless networks have several unique features : node mobility, restricted bandwidth, time-variable bandwidth, large latency, and high bit error rates time due to channel fading. These features at wireless networks intend to decrease the performance TCP protocols are used in wireless networks. Lots of studies have been done for finding appropriate wireless transport protocols for current wireless communications. However, related studies have not provided good performance or some protocols have a good performance only in specific circumstances. Thus, these are not suitable for general wireless circumstance. Therefore, we propose a new wireless transport protocol which provides better performance than the previous ones. And we'd like to solve a problem that previous protocols cannot maintain their connections even though they have multiple paths until another path is successfully set up. To solve these problems, a new protocol ATP-M is proposed which is designed on already known TCP-M and ATP protocols. With NS-2 computer simulation, it is shown that this newly proposed protocol has better system throughput than TCP, TCP-M and ATP protocols.

• Journal of the Korean Geotechnical Society
• /
• v.23 no.8
• /
• pp.159-169
• /
• 2007

The behavior of fiber-reinforced cemented sands (FRCS) was studied to improve a brittle failure mode observed in cemented sands. Nak-dong River sand was mixed with ordinary Portland cement and a Polyvinyl alcohol (PVA) fiber. A PVA fiber is widely used in concrete and cement reinforcement. It has a good adhesive property to cement and a specific gravity of 1.3. A PVA fiber has a diameter of 0.1 mm that is thicker than general PVA fiber for reinforced cement. Clean Nak-dong River sand, cement and fiber at optimum water content were compacted in 5 layers giving 55 blows per layer. They were cured for 7 days. Cemented sands with a cement/sand ratio of 4% were fiber-reinforced at different locations and tested for unconfined compression tests. The effect of fiber reinforcement form and distribution on strength was investigated. A specimen with evenly distributed fiber showed two times more strength than not-evenly reinforced specimen. The strength of fiber-reinforced cemented sands increases as fiber reinforcement ratio increases. A fully reinforced specimen was 1.5 times stronger than a specimen reinforced at only middle part. FRCS behavior was controlled not only by a dosage of fiber but also by fiber distribution methods or fiber types.

• Journal of Sericultural and Entomological Science
• /
• v.13 no.2
• /
• pp.123-133
• /
• 1971

The author is the first man who tried to use an anesthetic on insect specially for silkworm in orde to evaluate the silkworm health and silk yielding ability and the obtained results are as followings. 1. The necessary ether vapor induction for narcosis on silkworms is varied by the glowth of the silkworm which the larger worm is, the longer induction is required. For instance, it was 2∼3 minutes for the worms of third day fifth instar silkworm in case use of ether anesthetic. 2. The longer anesthetic induction for silkworms, the longer recovery needs from anesthesia. In case five minutes ether vapor induction, silkworms recovered narcosis during in 5∼130 minutes which had varied very much by the health variation. 3. The ether induction caused silkworm to vomit digestive juice from a few per cent of the worms, but the chloroform induction showed majority of the worms to vomit the digestive juice out of mouth. So, the ether was found as better anesthetic for silkworms. 4. When ether induction last more than 20∼30 minutes, the recovered silkworms can eat mulberry, but when it gets more than three hours they can not eat mulberry. And when it last more than ten minutes, the silkworm may eat mulberry leaf, but they can not spinn cocoon properly. 5. In case five minutes ether induction for silkworms on third day fifth instar, the stronger variety is, the rallier recovered from narcosis. 6. The recovering duration from narcosis varies regarding with each worm health which shows Poisson′s distribution even in a same variety silkworm. 7. The female worms recover from narcosis earlier than male worms which means the female worm is stronger than male one. 8. The later recovered silkworm from narcosis spinned more rich cocoon silk and ended with smaller pupae weight. Such a tendency showed until at some recovery duration, then the silk yield droped down on the worms recovered in more longer duration. The author (Choe) had named such a relation curve as "Silk Yield Curve against Silkworm Health." 9. The silk yield or cocoon layer ratio had varied from 13 to 27% even in a same worm varity cocoon which showed serious variation and call attention carefulness for the duplication work of a variety silkworm eggs. 10. Not always the rich silk yielding worm is the best worm during the silkworm selection and it should be considered with the silkworm health evaluation. 11. At present situation, only specific breeding expert is allowed to join in the selection service because of need many years experience by use of visual observation, but the ether anesthesia method may help such an evaluation with more accuracy and easy way even for the people in fresh on the field. 12. The effect of the narcosis on the silkworm for the next generation or hybrid worm will be reported in next publication.

• Resources Recycling
• /
• v.32 no.6
• /
• pp.54-66
• /
• 2023

Titanium's importance as a mineral resource is increasing, but the Korean industry depends on imports. Ilmenite is the principal titanium ore. However, research and development from raw materials have not been investigated yet in detail. Hence, measures to secure a stable titanium supply chain are urgently needed. Accordingly, through beneficiation technology, we evaluated the possibility of technological application for the efficient recovery of valuable minerals. As a result of the experiments, we confirmed that mineral particles existed as fine particles due to weathering, making recovery through classification difficult. Consequently, applying beneficiation technologies, i.e., specific gravity separation, magnetic separation, and flotation, makes it possible to recover valuable minerals such as hematite and rutile. However, there are limitations in increasing the quality and yield of TiO₂ due to the mineralogical characteristic of the hematite and rutile contained in titanium ore. Hametite is combined with rutile even at fine particles. Therefore, it is essential to develop mineral processing routes, to recover iron, vanadium, and rare earth elements as resources. On that account, we used grinding technology that improves group separation between constituent minerals and magnetic separation technology that utilizes the difference in magnetic sensitivity between fine mineral particles. The development of beneficiation technology that can secure the economic feasibility of valuable materials after reforming iron oxide and titanium oxide components is necessary.

• Journal of the Korean Society of Radiology
• /
• v.82 no.2
• /
• pp.382-392
• /
• 2021

Purpose To evaluate the ultrasonographic characteristics of steatocystomas focusing on the features that aid in differentiating them from epidermal inclusion cysts and lipomas. Materials and Methods The ultrasonographic findings of 14 histologically proven steatocystomas in 10 patients were retrospectively reviewed. The following features were assessed: the layer of involvement, shape, margin, echogenicity, posterior acoustic features, and the presence of a visible wall or intralesional striations. The findings were compared with those of subcutaneous lipomas and epidermal inclusion cysts to identify those findings that aid in the differential diagnosis of steatocystomas. Results The majority of steatocystomas appeared as a subcutaneous mass (n = 6, 42.9%) or a mass involving both the dermal and subcutaneous layers (n = 6, 42.9%). Steatocystomas exhibited a well-defined smooth margin (n = 12, 85.7%) and homogeneous echogenicity (n = 9, 64.3%), and showed no specific posterior acoustic features (n = 9, 64.3%). The most important features that differentiated steatocystomas from epidermal inclusion cysts were a homogeneous internal echotexture (p = 0.009) and absent or less prominent posterior acoustic enhancement (p < 0.001). The features that distinguished steatocystomas from lipomas were the margin (p < 0.001), echogenicity (p = 0.034), internal echotexture (p = 0.004), and the absence of intralesional striations (p < 0.001). Conclusion Steatocystomas appeared as well-defined homogeneous masses with mild or absent posterior acoustic enhancement.