• Journal of the Korean Ceramic Society
• /
• v.49 no.2
• /
• pp.142-145
• /
• 2012

In order to investigate the surface SHG, (110) pure STO single crystals were exposed to a reducing atmosphere to induce the reduction of the Ti ion and the release of oxygen from the lattice compensating the reduction of the Ti ions. The anisotropy and asymmetry of SHG intensity explains a slight shrinkage. The incoming fundamental wave was polarized either in the $p$-in or $s$-in to the plane of incidence for the reflection geometry. The SH polarization diagram could be described by the electric dipole and/or quadrupole contribution of reduced STO single crystal surface.

• KOREAN JOURNAL OF PACKAGING SCIENCE & TECHNOLOGY
• /
• v.9 no.1
• /
• pp.19-24
• /
• 2003

We study on the phase diagram of the polymer blend. For this purpose, one PS (polystyrene) and two PI(polyisoprene) were employed whose molecular weights were low enough to make the experimental determinations possible. The weight-average molecular weight(Mw) of PS was 2514, and Mws of two PIs were 2700. Interaction energy density (IED) of the Flory-Huggins lattice theory was defined as a function of temperature and composition, and the consequent equations for the binodal, and critical points were derived. By fitting the experimental binodal points to the derived binodal curve with a nonlinear regression method, the expression for the IED was determined. And the expression for the IED obtained from this study was compared with those reported in the literatures. Also were discussed the importance of accuracy in the expression the IED, and the IED's dependency on the temperature, composition and molecular weights.

• Proceedings of the KIEE Conference
• /
• 2011.07a
• /
• pp.698-699
• /
• 2011

This paper analyzes the switching surge in distribution system with photovoltaic (PV) generation system. The change of overvoltage by PV generation system is analyzed using lattice diagram. To verify the analysis results, the distribution system with PV generation system is modeled using EMTP-RV and the various simulations are performed.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.17 no.1
• /
• pp.58-67
• /
• 1992

Optical absorption and photoluminescences(PL) of MgGa2Se4 and MgGa2Se4 : Co2+ single crustals were guown by the Bridgman method have been investigated in the visible and near-in frared regions. The optical absorption spectrum showed three absorption peak at 760 nm(13158nm, -1, 1.63eV), 1640nm(6097cm-1, 0.75eV).and 2500nm(4000cm-1,0.49eV) which are assigned the electronic transitions between the ground state and excited states of Co2+ ions with Td sym-metry in MgGa2Se4 host lattice. In PL spectrum the visible emission bands as well as the infrared emission band in these single cuystals are obserned. The visible emission bands are explained due to the radiative transitions of electrons from quasi continusly distributed tarps below the bottom of the conduction band to acceptor levels above the top of the valence band in the proposed energy level scheme. At the same time, it is considered that the infrated emission bands are attributed to electron transitions from the deep levels to the acceptor levels. The mechanism of the optical transition os well explained in terms of the energy diagram of MgGa2Se4.

• Journal of the Optical Society of Korea
• /
• v.17 no.3
• /
• pp.262-268
• /
• 2013

We study the focusing properties of a two-dimensional square-lattice photonic crystal (PC) comprising silica and germanium partitioned cylinders in air background. The finite difference time domain (FDTD) method with periodic boundary condition is utilized to calculate the dispersion band diagram and the FDTD method incorporating the perfectly matched layer boundary condition is employed to simulate the image formation. In contrast to the common square PCs in which the negative refraction effect occurs in the first photonic band without negative phase propagation, in our suggested model system, the frequency with negative refraction exists in the second band and in near-infrared region. In this case, the wave propagates with a negative phase velocity and the evanescent waves can be supported. We also discuss the dependency of the image resolution and its location on surface termination, source location, and slab thickness. According to the simulation results, spatial resolution of the proposed PC lens is below the radiation wavelength.

• International Journal of Precision Engineering and Manufacturing
• /
• v.3 no.2
• /
• pp.78-86
• /
• 2002

In general, X-ray diffraction method detects the changes of crystal lattice under material surface using the angle of diffraction 2$\theta$. This technique which deals with in the presented paper can be applied to a behavior on the slipped band or the micro crack cause to material degradation. The relation between half-value breadth and cycle numbers shows three stages, which consist of rapid decrease in the initial cycle, slight decrease in the middle cycle, and then rapid decrease in the final cycle. The ratio of half-value breadth has a constant value on B/B$\_$0/ - N diagram under the loading condition except early part of fatigue life. The ratio of half-value breadth B/B$\_$0/ - log N$\_$f/ with respect to number of cycle to failure N$\_$f/ has linear behavior on B/B$\_$0/ - log N$\_$f/ diagram. Therefore, the evaluation of fatigue life by the average gradient has much less mean error than the estimation of fatigue life by log B/B$\_$0/ - log N/N$\_$f/ relation.

• Progress in Superconductivity
• /
• v.3 no.1
• /
• pp.5-12
• /
• 2001

Our experimental research focuses on manipulating pinning deflects to alter the phase diagram of vortex matter, creating new vortex phases. Vortex matter offers a unique opportunity for creating and studying these novel phase transitions through precise control of thermal, pinning and elastic energies. The vortex melting transition in untwinned YB $a_2$C $u_3$ $O_{7-}$ $\delta$/ crystals is investigated in the presence of disorder induced by particle irradiation. We focus on the low disorder regime, where a glassy state and a lattice state can be realized in the same phase diagram. We follow the evolution of the first order vortex melting transition line into a continuous transition line as disorder is increased by irradiation. The transformation is marked by an upward shift in the lower critical point on the melting line. With columnar deflects induced by heavy ion irradiation, we find a second order Bose glass transition line separating the vortex liquid from a Bose glass below the lower critical point. Furthermore, we find an upper threshold of columnar defect concentration beyond which the lower critical point and the first order melting line disappear together. With point deflect clusters induced by proton irradiation, we find evidence for a continuous thermodynamic transition below the lower critical point..

• Journal of the Korean Society for Precision Engineering
• /
• v.17 no.1
• /
• pp.145-152
• /
• 2000

X-ray diffraction method detects change of crystal lattice distance under material surface using diffraction angle 2$\theta$. This technique can be applied to the behavior on slip band and micro crack due to material degradation. The relation between half-value breadth and number of cycle has three stages which constitute rapid decrease in initial number of cycles, slight decrease in middle number of cycles and rapid decrease in final number of cycles. The ratio of half-value breadth takes a constant value on B/B$_{0}$-N diagram with loading condition except early part of fatigue life. The ratio of half-value breadth B/B$_{0}$ with respect to number of cycle to failure N$_{f}$ has linear behavior on B/B$_{0}$-log N$_{f}$ diagram. Therefore, in this paper the estimation of fatigue life by average gradient method has much less estimated mean error than the estimation of fatigue life by log B/B$_{0}$-log N/N$_{f}$ relation.elation.ation.

• Proceedings of the KIEE Conference
• /
• 1993.07b
• /
• pp.990-992
• /
• 1993

Studies have been made to establish what coil design parameters have an important influence on the amplitude of interturn voltages developed in a machine winding subject to steep-fronted surges. The studies are based on a lattice-diagram model of multi conductor transmission line in a machine winding energised by a simple ramp function. Variations in interturn voltages produced by changes in insulation thickness, insulation permittivity, surge wave-front are examined and certain guidelines for avoiding high interturn voltages are evaluated.

• Bulletin of the Korean Chemical Society
• /
• v.12 no.3
• /
• pp.334-342
• /
• 1991

To investigate the phase equilibria and structural properties of microemulsions, we study a simple phenomenological model on the basis of the cubic lattice cell with which the oil- and water-filled cells are connected one another, respectively. The surfactant is assumed to be insoluble in both oil and water, and to be adsorbed at the oil-water interface. The Schulman condition, according to which the lateral pressure of the surfactant layer is compensated by the oil-water interfacial tension, is found to hold to good approximation in the middle-phase microemulsion. Our results show that the oil- and water-filled domains in that microemulsion are about 50-150 $\AA$ across, and depend sensitively on the curvature parameters. The phase diagram is not symmetric in this model. It may be asymmetrized intrinsically by non-equivalency of oil and water. The two- and tree-phase equilibria including critical points and critical endpoints are found.