• Journal of ILASS-Korea
• /
• v.7 no.2
• /
• pp.1-6
• /
• 2002

It is necessary to develope a high frequency diode laser sensor system based on the absorption spectroscopy for the measurement of temperature of the spray flame. DFB diode laser operating near $2.0{\mu}m$ was used to scan over selected $H_2O$ transitions near $1.9{\mu}m\;and\;2.2{\mu}m$, respectively. The measurement sensitivity at wide range of sweep frequency was evaluated using multi-pass cell containing $CO_2$ gas. This diode laser absorption sensor with high temporal resolution up to 10kHz was applied to measure the gas temperature in the spray flame region of liquid-gas 2-phase counter flow flame. The successful demonstration of time series temperature measurement in the spray flame gives us motivation of trying to establish non-intrusive temperature measurement method in the practical spray flame.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.16 no.4
• /
• pp.22-26
• /
• 1979

Microlenses with an extremely small radius of curvature are efficiently use d to couple LED/laser diode light into optica1 fiber. We propose a Tapered lens for the highly efficient coupling of the optical fiber communication light souses into the fiber. Ray optical analysis shows that the maximum coupling efficiency is as high as 90 %, Tapered lens with optimum parameters are fabricated by using heating and pulling technique. Experiment shows that this new technique improves the coupling efficiency by two and four times for LED and laser diode, respectively, as compared with the simple flat - end coupling.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.17 no.5
• /
• pp.1-7
• /
• 1980

In this paper, the theoretical analysis of lateral guiding in stripe geometry DH laser diode is performed. In the analysis, the carrier density profile is modeled as the function of stripe width and the beam width variations related to the stripe width are calculated using the perturbed mode theory. Finally the results of this paper are compared and analyzed with the Hakki's calculated data & kirkby's experimental data.

• Journal of the Optical Society of Korea
• /
• v.8 no.1
• /
• pp.13-16
• /
• 2004

A widely tunable SG-DFB (Sampled Grating Distributed Feedback) laser diode is proposed and its feasibility is confirmed through simulation. The new SG-DFB laser diode is composed of a pair of sampled gratings, some parts of which are gain sections and the other parts of which are phase control sections. It is shown that a few tens of nanometers can be tuned through the adjustment of two currents into the phase control sections. Higher output power is expected compared with a SG-DBR laser diode with similar parameters. The dynamic single mode operation is also observed in the time-domain simulation.

• International Journal of Precision Engineering and Manufacturing
• /
• v.8 no.2
• /
• pp.80-84
• /
• 2007

We propose a new displacement measurement method using a phase modulation homodyne interferometer and a tunable laser diode as a light source to determine an arbitrary length with a resolution in the order of 10 pm. In the proposed instrument, the displacement of a movable mirror in the interferometer can be converted to a frequency shift of the tunable laser diode. We discuss the principles of the proposed method, the instrumentation, and the experimental results, and compare the proposed method with two commercial displacement sensors. The commercial sensors used are a heterodyne interferometer, the interpolation error of which is also measured, and a capacitive sensor.

• Annual Conference of KIPS
• /
• 2000.04a
• /
• pp.846-851
• /
• 2000

4-state 바코드의 정보는 우편번호, 배달순서코드, 고객 정보 등을 수록되며, 판독율 향상을 위한 오류정정 코드워드를 적용할 수 있다. 이 4-state 바코드는 우편물 자동구분처리의 효율화 및 우편물류의 정보표현, 전달, 처리를 효율적으로 지원되도록 개발하고 있다. 본 논문은 우편물 접수 및 처리과정에서 필요로 하는 4-state 고객 바코드 인쇄규격 검증 및 판독시스템 개발에 관한 것으로 4개의 높이로 구성된 바들의 특성과 바의 두께 및 공간 값이 균일한 간격으로 바가 인쇄되는 특징을 고려하여 Laser Diode 배열방법을 적용하였다. 또한, 우편물을 자동으로 이송시키고, 일정한 영역에 배열한 Laser Diode에 의하여 바의 두께, 공간, 높이 값을 정확하게 판독될 수 있도록 한 것이다.

• Journal of the Optical Society of Korea
• /
• v.14 no.1
• /
• pp.38-41
• /
• 2010

We design and fabricate a widely tunable laser diode made of InGaAsP-InP. The diode is monolithically integrated with a wavelength-selective coupled-ring reflector and semiconductor amplifiers. For realization of a compact size device, deeply etched multi-mode interference couplers and square ring resonators composed of total-internal-reflection mirrors are adopted and fabricated using a self-aligned process. It is demonstrated that the laser diode exhibits single mode operation and 16 nm tuning range with side-mode-suppression-ratio exceeding 20 dB.

• Current Optics and Photonics
• /
• v.4 no.3
• /
• pp.238-246
• /
• 2020

The heat distribution in crystals in a 2-㎛ acousto-optic Q-switched Tm:LuAG laser pumped by pulsed-laser-diode (pulsed-LD) intermittent-pumping technology was analyzed using COMSOL software. The thermal lensing effect of the Tm:LuAG crystal can be mitigated by pulsed-LD intermittent-pumping techniques. An experimental setup using this kind of approach achieved maximum output energy of 8.31 mJ, minimum pulse width of 101.9 ns, and highest peak power of 81.55 kW, reached at a Q-switched repetition rate of 200 Hz. It offers significant improvement of performance of the output laser beam, compared to pulsed-LD double-ended pumping technology at the same repetition rate.

• Proceedings of the Optical Society of Korea Conference
• /
• 1990.02a
• /
• pp.79-81
• /
• 1990

Temperature distribution of laser diode chip mounted on ideal heat kink was calculated by numerical analysis. In numerical analysis, infinite difference method and Gauss-Scidel iteration was adopted on the basis of two dimensional heat conduction phenomena. As a result, temperature increase of active medium of laser diode driven at 60mA was calculated to be 1.47$^{\circ}C$

• 제어로봇시스템학회:학술대회논문집
• /
• 2005.06a
• /
• pp.1423-1426
• /
• 2005

Map building is the most important thing for the mobile robots navigation. It requires specific vision system such as CCD camera, range finding system, and many other things. Laser range finder has highly collimated beams can be obtained easily, thus achieving lateral resolution. Laser Diode is used for a continuous laser source. The Automatic Current Control Circuit and the Bias-T is used for mix AC signal with DC bias. This signal is used for driving Laser Diode. The main idea of the calculating distance is detecting phase shift between reference signal and detected signal by photo detector. For the signal processing, the Lock-in amplifier system is addressed in this paper. We used a diffused reflected beam to detect phase shift in this system. But this beam is minuteness signal so it can be easily buried in nose. Lock-in amplifier is used to measure the amplitude and phase of signals which are buried in noise.