• Geomechanics and Engineering
• /
• v.32 no.1
• /
• pp.1-20
• /
• 2023

To predict the consolidation behavior of dredged and reclaimed marine clays exhibiting consolidation settlement with large strains, the finite strain consolidation theory must be used. However, challenges in appropriately applying the theory and determining input parameters make design and analysis studies difficult. To address these challenges, design charts for predicting the consolidation settlement of reclaimed marine clays are developed by a numerical approach based on the finite strain consolidation theory. To prepare the design charts, a sensitivity analysis of parameters is performed, and influencing parameters, such as initial void ratio and initial height, as well as the non-linear constitutive void ratio-effective stresspermeability relation, are confirmed. Six representative Korean marine clays obtained from different locations with different liquid limits are used. The design charts for estimating the consolidation times corresponding to various degrees of consolidation are proposed for each of the six representative clays. The consolidation settlements predicted from the design charts are compared to those in previous studies and at an actual construction site and are found to agree well with them. The proposed design charts can therefore be used to solve problems related to the consolidation of reclaimed marine clays having large strains.

• The Journal of Engineering Geology
• /
• v.33 no.1
• /
• pp.189-200
• /
• 2023

As urbanization and industrialization increase development in downtown areas, damage due to ground settlement continues to occur. Building collapse in urban has a high risk of leading to large-scale damage to life and property. However, there has rarely been studied on measurement data analysis methods when uneven loads are applied to the excavated ground and no prior knowledge of the ground. Accordingly, it was attempted to analyze the relative settlement behavior and correlation by processing the time-series surface settlement of construction sites in the urban. In this paper, the average index of difference in settlement and average of relative difference in settlement are defined and calculated, then plotted in the coordinate system to analyze the relative settlement behavior over time. In addition, since there was no prior knowledge of the ground, a standard to classify the clusters was needed, and the observation points were classified into using k-means clustering and Dunn Index. As a result of the analysis, it was confirmed that all the clusters moved to the stable region as the settlement amount converges. The clusters were segmented. Based on the analysis results, it was possible to distinguish between the independent displacement area and same behavior area by analyzing the correlation between measurement points. If possible to analyze the relative settlement behavior between the stations and classify the behavior areas, it can be helpful in settlement and stability management, such as uplift of the surrounding area, prediction of ground failure area, and prevention of activity failure.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.31 no.5C
• /
• pp.155-162
• /
• 2011

Settlement prediction based on field monitored data, which is used to control subsequent surcharges, is very important in construction management for soft ground improvement with the preloading method. Observational settlement prediction methods, which are suggested for an instantaneous loading, have been widely used in fields. However, they have difficulties in the settlement prediction with subsequent surcharge change. In this paper, a simple method to predict the settlement with subsequent surcharge change is suggested. The suggested method adopts assumptions to simplify the complex field condition and utilizes observational methods. The suggested method is applied to a large consolidation test result, FDM analysis results, and field monitored settlement data to confirm its practicability. From the applications, the suggested method produces reasonable prediction results with various subsequent surcharge changes.

• Journal of the Korean Society for Railway
• /
• v.12 no.2
• /
• pp.183-189
• /
• 2009

The track structure of Gyungbu High Speed Railway line from Daegu to Busan is concrete track. It has a very strict specification for residual settlement because of its rigid type structural characteristics. The residual settlement of it comes from the residual settlement of the subgrade and the ground. The residual settlement of railway subgrade composed of crushed rock and soil might be major parts of total residual settlement depending on the field compaction qualities. Therefore, it is a key to minimize the residual settlement of the subgrade for a successful concrete track construction. In this paper, total 31 large scale compaction tests were performed to understand the compaction behaviors of the crushed rock-soil mixture. The test specimens were constituted with soil, crushed shale and mudstone taken from two sites under construction. The compaction tests were performed with the variations of rock types, #4 sieve passing contents, maximum particle size, and moisture contents. The influence of those factors on maximum dry unit weights of crushed rock-soil mixture was evaluated.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.9
• /
• pp.33-40
• /
• 2008

This paper describes the performance of ground improvement project using prefabricated vertical drains of condition, in which approximately 10m dredged fill overlies original soft foundation layer in the coastal area composed of soft marine clay with high water content and high compressibility. From field monitoring results, excessive ground settlement compared with predicted settlement in design stage developed during the following one year. In order to predict the final consolidation behavior, recalculation of consolidation settlements and back analysis using observed settlements were conducted. Field monitoring results of surface settlements were evaluated, and then corrected because large shear deformation occurred by construction events in the early stages of consolidation. To predict the consolidation behavior, material functions and in-situ conditions from laboratory consolidation test were re-analyzed. Using these results, height of additional embankment is estimated to satisfy residual settlement limit and maintain an adequate ground elevation. The recalculated time-settlement curve has been compared with field monitoring results after additional surcharge was applied. It might be used for verification of recalculated results.

• Journal of the Korean Geotechnical Society
• /
• v.37 no.7
• /
• pp.13-23
• /
• 2021

If roads, bridges, buildings, etc. are built on the ground with soft clay or organic soil, there may be a lot of problems in geotechnical engineering such as settlement and stability due to the large settlement and lack of bearing capacity. In extreme cases, it may appear due to shear failure or collapse of the constructed structure, so a ground improvement method is indispensable to increase the strength of the ground and to suppress settlement. In this study, the settlement according to each groundwater level condition was analyzed using the measurement results for the groundwater level conditions, one of the important factors in predicting the settlement in dredged and reclaimed ground, and the groundwater level conditions applied to the settlement analysis were proposed by comparing it with settlement generated 5 years after construction. As a result of the analysis, it is judged that it is reasonable to apply the measured groundwater level during construction and the low water ordinary neap tide (L.W.O.N.T) during load application for the groundwater level in the settlement analysis. In addition, in the case of the dredged and reclaimed ground, it is estimated that the water pressure acting on the clay layer is nonlinear, as the result of the observations of the head of water at the observation points above and below the in-situ clay layer were different.

• Journal of the Korean Geotechnical Society
• /
• v.24 no.10
• /
• pp.83-91
• /
• 2008

Previous settlement prediction methods based on settlement monitoring were developed under instantaneous loading condition and have restriction to be applied to soft ground under ramp loading condition. In this study, settlement prediction method under ramp loading was developed. New settlement prediction method under ramp loading considered influence factors of consolidation settlement such as thickness of clayed layer, quantity of surcharge load and preconsolidation pressure, etc. Geometrical correction method based on hyperbolic method (1991) and correction method based on probability theory were applied to increase accuracy of settlement prediction using field monitoring data after ramp loading. Large consolidation tests for ideally controlled one dimensional consolidation under ramp loading condition were performed and the settlement behavior was predicted based on the monitoring data. New prediction method yielded good result of entire settlement behavior by using data during an early stage of ramp load. Additionally, new prediction method offered better settlement prediction which had final settlement prediction in close proximity and low RMSE(Root Mean Square Error) than previous method such as hyperbolic method did.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2005.03a
• /
• pp.272-279
• /
• 2005

This paper introduces a new method of improvement for marine soft ground, MLPP(Marine Large Pack Pile). The MLPP is a reinforcement technique for the conventional SCP or GCP piles by confining with geotextile pack. A pilot project at Busan New Port site and laboratory model tests were carried out to investigate the settlement reduction and bearing capacity enhancement effect of pack pile. The results of field and laboratory tests show that MLPP method can be a safe and economic alternative method for SCP and GCP.

• International Commerce and Information Review
• /
• v.10 no.1
• /
• pp.139-154
• /
• 2008

This research want to discuss some issues about payment system of America. This research focuses on comparing ACH with Fedwire. Firstly Fedwire is the payment system for only large-dollar transfer(Large-Value Transfer System; LVTS), while ACH(Automated Clearing House)payment mainly applies a consumer account. Secondly ACH transaction is either credit or debit transfer, while Fedwire is only credit transfer. Thirdly the communication system of Fedwire has twoway method, telephonelike communication network, but ACH is oneway store and forward electronic mail. At present LVTS divides into RTGS(Real-Time Gross Settlement) and DNS(Deferred Net Settlement). However Fedwire uses either RTGS(instantaneous for every transaction) or DNS(net net transaction) but ACH uses only DNS(net net transaction). Fourthly ACH is substantially cheaper than the Fedwire payment. lastly security is important in both Fedwire and ACH, it is even more crucial in Fedwire In addition, for each transaction, Fedwire may entail individual instantaneous confirmation to the originator and notification to the receiver, whereas ACH do not.

• Proceedings of the Korean Geotechical Society Conference
• /
• 1999.11b
• /
• pp.35-48
• /
• 1999

The Nakdong River in Korea has formed a delta area .called the Kimhae Plain near the river mouth. Its clay deposit is unusually thick (up to 60m) compared with the clays deposited in other parts of the world. Some parts of the area has been reclaimed with the height of approximately 5 to 7m after installing vertical drains for the development of important new industrial complexes. Settlement measurements were taken during the reclamation works on the soft ground, and it was revealed that the measured settlements were extremely higher than predicted. This paper discusses possible reasons on unusual large settlements from depositional environments of Kimhae clay.