• Journal of Advanced Navigation Technology
• /
• v.25 no.1
• /
• pp.40-51
• /
• 2021

In this paper, the design requirements was produced by analyzing domestic and foreign regulations of the vertical takeoff and landing site required to operate the urban air mobility (UAM) system in Korea and the size of the take-off and landing pads were defined, and the configuration of vertiport was proposed. First, for the metropolitan area with high population density, pilot locations of the vertical take-off and landing site were selected based on the demonstration routes suggested by the Ministry of Land, Infrastructure and Transport and analyzed the characteristics of each location and determined the number of possible installations of vertiport by measuring each site. After that, variables necessary for the operation of the vertical takeoff and landing area were set, and the hourly, daily, monthly aircraft operating cycle, the number of acceptable people, and efficiency were calculated according to the number of simultaneous operation and the number of stand. Finally, using CATIA, the configurations of the virtual vertiport was created by applying the design requirements.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.2 no.3
• /
• pp.143-149
• /
• 2007

From the announcement which sees discusses about the spatial modulation which is a basic principle of the induction signal which the instrument landing system provides to the aircraft with instrument landing system, depth made be and became the help which makes understand and character did. Explained the fundamental notions of spatial modulation with precedence, the signal which space is modulated with this together influenced to the aircraft receiver and the azimuth and angle of glide were indicated and until with the principle of operation of the aircraft receiver and the process which is general DDM(difference in depth of modulation) and they related they explained.

• Journal of the Korean Geographical Society
• /
• v.49 no.1
• /
• pp.77-90
• /
• 2014

The purpose of this study is to examine cinematic representations of places in the Korean War films on the event of 1950 'Incheon Landing', focusing on the place representations. 'Incheon Landing' of September 1950 provided a turning point for the Korean War, and the event can be interpreted totally different from the South Korean and the North Korean perspectives. Two films on the same event of the 'Incheon Landing' - a South Korean film, "Incheon Landing Operation"(1965), and a North Korea film, "Wolmido"(1982)- were selected as major sources of analysis and comparison. each director has different intentions. One film was taken from the landing army's viewpoint, whereas the other film was taken from the defender's viewpoint. As a result, one film emphasized the battle as a spectacle of glorious victory from the landing army's viewpoint, while the other film glorified those soldiers killed in the battle as heroes from the defender's viewpoint.

• Journal of Advanced Navigation Technology
• /
• v.26 no.6
• /
• pp.393-403
• /
• 2022

Various studies suggest that the initial operating form of UAM, which is being presented as a solution to the urban traffic problem, will be similar to VTOL aircraft among current aircraft. In a form similar to determining the direction of the runway where fixed-wing aircraft take off and land, the vertiport where take-off and landing of VTOL aircraft takes place determines the flight direction of departure and arrival in consideration of the direction of the wind. Unlike areas where airports are generally built, in the case of downtown areas, it is expected that the characteristics of wind may continuously change depending on the environment of changing terrain or obstacles such as the construction of new buildings. In this study, long-term actual observation data for reviewing the take-off and landing directions at the city center where the location of the vertiport is expected are compared using a wind speed map, and the characteristics of the ground wind and the possibility of change in the direction of the predominant wind depending on the observation period and observation location confirmed.

• Journal of Korean Society of Industrial and Systems Engineering
• /
• v.46 no.4
• /
• pp.331-338
• /
• 2023

ROK Navy Landing Ship Fast(LSF-II) is equipped with special equipment that is not compatible with other combat ships due to special missions. So there are almost no maintenance capabilities except for simple repair parts replacement and maintenance parts. The researcher determined that the way to solve these problems was to apply Performance Based Logistics (PBL), and reviewed the cases of PBL applications abroad and domestically. To confirm the current maintenance capability, we visited LSF-II operation unit to identify maintenance capabilities for each mounted equipment, and interviews with operators and maintenance practitioners confirmed the limitations of outsourcing maintenance and the need to apply PBL. In order to analyze the effect of PBL application, the measure of effectiveness and measure of performance were selected based on the opinions of LSF-II operation/maintenance practitioners and PBL experts and the practical experience of this researcher. A survey was conducted on operation/maintenance practitioners and professional personnel. Based on the survey results, the effect of applying PBL was analyzed using the AHP technique, and an efficient PBL application plan was proposed for LSF-II.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.45 no.6
• /
• pp.490-497
• /
• 2017

The Main Landing Gear(MLG) of Rotary Wing Aircraft is an essential equipment in Landing System for pilot to perform a flight mission. It supports the fuselage at ground and absorbs the impact from the ground when landing, thereby, these functions sustain operational capability for pilot and crew. However, the A aircraft caused asymmetry and leakage hydraulic when it was stationed on the ground. Therefore, this paper summarizes pilot comments in operation which are classified by cause of occurrence and the troubleshooting process about each comment. It also describes design improvements which was derived from troubleshooting and suggests verification results of flight test.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.36 no.1
• /
• pp.39-47
• /
• 2008

Automatic landing performance of UAV can be enhanced by adding Pseudolite(PL) to GPS. However, it is very hard to install and operate PL with confidence because GPS satellites are moving and the landing zone are usually changeable. The coverage and accuracy of combined GPS and PL can be estimated by using simulator and the correct information is very crucial to UAV operation. In this paper, design, implementation and evaluation of GPS/PL simulator for UAV landing are given. A very realistic coverage estimation is obtained using GIS data and ray launching method with considerations of the transmitter power level, altitude of UAV, number and location of PL. The expected accuracy is estimated using DOP and NSP computed using both GPS and PL. The performance of simulator is evaluated by comparing with the results of a real GPS receiver, and the certified simulator shows the required accuracy for UAV landing can be easily met by proper installation of at least 2 PLs.

• Journal of the Society of Naval Architects of Korea
• /
• v.61 no.2
• /
• pp.125-134
• /
• 2024

The Safe Operating Envelope (SOE) combined with Short-Take-Off and Vertical Landing (STOVL) performance is an essential consideration of a light aircraft carrier for design of hull shape with excellent seakeeping performance in terms of naval air operations as well as traditional naval ship missions such as Transit and Patrol (TAP), and Replenishment at Sea (RAS) and so on. A variety of procedures are systematically combined to determine SOE considering rather complicated missions associated with operation of aircraft onboard. The evaluation of take-off and landing safety missions onboard should consider wind effect on deck and severer seakeeping indices and standards compared with conventional naval ships. In order to support take-off and landing missions, various support activities of the crews are required. So, additional evaluation is needed for indicators such as MSI(Motion sickness Index) and MII(Motion Induced Interruptions), which are quantitative indicators of work ability that appear as a result of motion response. In this study, a standard procedure is developed including the seaworthiness performance indicators, standards, and evaluation procedures that should be considered during design of STOVL aircraft carrier. Analysis results are discussed in terns of air-wake on deck as well as seakeeping indices associated with design parameter changes in view of conceptual design of a light aircraft carrier.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.18 no.3
• /
• pp.226-233
• /
• 2015

Pose estimation is an important operation for many vision tasks. This paper presents a method of estimating the camera pose, using a known landmark for the purpose of autonomous vertical takeoff and landing(VTOL) unmanned aerial vehicle(UAV) landing. The proposed method uses a distinctive methodology to solve the pose estimation problem. We propose to combine extrinsic parameters from known and unknown 3-D(three-dimensional) feature points, and inertial estimation of camera 6-DOF(Degree Of Freedom) into one linear inhomogeneous equation. This allows us to use singular value decomposition(SVD) to neatly solve the given optimization problem. We present experimental results that demonstrate the ability of the proposed method to estimate camera 6DOF with the ease of implementation.

• International Journal of Aeronautical and Space Sciences
• /
• v.17 no.1
• /
• pp.120-131
• /
• 2016

The full results of troubleshooting process related to the flight control system of a tilt-rotor type UAV in the flight tests are described. Flight tests were conducted in helicopter, conversion, and airplane modes. The vehicle was flown using automatic functions, which include speed-hold, altitude-hold, heading-hold, guidance modes, as well as automatic take-off and landing. Many unexpected problems occurred during the envelope expansion tests which were mostly under those automatic functions. The anomalies in helicopter mode include vortex ring state (VRS), long delay in the automatic take-off, and the initial overshoot in the automatic landing. In contrast, the anomalies in conversion mode are untrimmed AOS oscillation and the calibration errors of the air data sensors. The problems of low damping in rotor speed and roll rate responses are found in airplane mode. Once all of the known problems had been solved, the vehicle in airplane mode gradually reached the maximum design speed of 440km/h at the operation altitude of 3km. This paper also presents a comprehensive detailing of the control systems of the tilt-rotor unmanned air vehicle (UAV).