• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.12A
• /
• pp.1209-1216
• /
• 2008

In order to maximize spectrum efficiency and data rate MIMO(Multiple Input Multiple Output) is adopted to wireless system. OFDM-based WiMAX and LTE accommodate MIMO as mandatory technology. STC(Space Time Coding) and SM(Spatial Multiplexing) are used in downlink while in uplink C-MIMO(Collaborative MIMO) is used to improve data throughput. In this paper conventional pairing schemes, RPS(Random Pairing Scheduling) and DPS(Determinant Pairing Scheduling) are analyzed. From the analysis the performance of DPS algorithm is better than that of RPS because DPS measures orthogonal factor between paired users. However, there are potential problems such as hardware complexity and performance. To overcome the issues Power-Based Scheduling(PBS) algorithm is proposed for C-MIMO. PBS can provide higher performance compared to RPS and dramatically reduce hardware complexity compared to DPS

• Journal of electromagnetic engineering and science
• /
• v.14 no.4
• /
• pp.393-398
• /
• 2014

A highly efficient dual-mode linear CMOS stacked-FET power amplifier (PA) is implemented for 3G UMTS and 4G LTE handset applications. High efficiency is achieved at a backed-off output power ($P_{out}$) below 12 dBm by employing an active-bypass amplifier, which consumes very low quiescent current and has high load-impedance. The output paths between high- and low-power modes of the PA are effectively isolated by using a bypass switch, thus no RF performance degradation occurs at high-power mode operation. The fabricated 900 MHz CMOS PA using a silicon-on-insulator (SOI) CMOS process operates with an idle current of 5.5 mA and shows power-added efficiency (PAE) of 20.5%/43.5% at $P_{out}$ = 12.4 / 28.2 dBm while maintaining an adjacent channel leakage ratio (ACLR) better than -39 dBc, using the 3GPP uplink W-CDMA signal. The PA also exhibits PAE of 35.1% and $ACLR_{E-UTRA}$ of -33 dBc at $P_{out}$ = 26.5 dBm, using the 20 MHz bandwidth 16-QAM LTE signal.

• Journal of Korea Society of Industrial Information Systems
• /
• v.15 no.4
• /
• pp.7-15
• /
• 2010

This study proposes a rad o resource management scheme to maximize the performance of the LTE(Long Term Evolution) uplink, using SC-FDMA(Single Carrier-Frequency Division Multiple Access). Rather than the single-cell SC-FDMA system the existing studies are mainly concerning, this study focuses on multi-cell system which needs considering the interaction among cells. Radio resource management is divided into two phases, planning and operation phases. The former is for the master eNB(e-NodeB) to allocate RBs(radio bearer) to eNB, the latter for eNB to assign RBs to the mobiles in the cell. For each phase, an optimization model and greedy algorithm are proposed. Optimization models aim to maximize the system performance while satisfying the constraints for both QoS and RB continuity. The greedy algorithms, like generic ones, move from a solution to a neighboring one having the best objective value among neighboring ones. From the numerous numerical experiments, the performance and characteristics of the algorithms are analyzed. This study is expected to play a volunteering role in radio resource management for the multi-cell SC-FDMA system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.30 no.2
• /
• pp.104-110
• /
• 2019

In this paper, a complementary metal oxide semiconductor(CMOS) power amplifier(PA) integrated circuit operating in the 900 MHz band for long-term evolution(LTE) communication systems is presented. The output matching network based on a transformer was implemented on a printed circuit board for low loss. Simultaneously, to achieve high efficiency of the PA, the second harmonic impedances are controlled. The CMOS PA was fabricated using a $0.18{\mu}m$ CMOS process and measured using an LTE uplink signal with a bandwidth of 10 MHz and peak to average power ratio of 7.2 dB for verification. The implemented CMOS PA module exhibits a power gain of 24.4 dB, power-added efficiency of 34.2%, and an adjacent channel leakage ratio of -30.1 dBc at an average output power level of 24.3 dBm.

• Journal of Communications and Networks
• /
• v.17 no.1
• /
• pp.27-33
• /
• 2015

In this paper, we consider a joint frequency-domain scheduling and user-pairing problem for virtual MIMO in the single carrier frequency division multiple access (SC-FDMA) system, e.g., the uplink transmission for third generation partnership project-long term evolution (3GPP-LTE) standard. Due to the subcarrier adjacency constraint inherent to SC-FDMA, its complexity becomes unmanageable. We propose a greedy heuristic algorithm for PF scheduling so as to deal with the complexity issue in this joint problem. It has been shown that its performance can reach up to 90% of its upper bound.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.1
• /
• pp.21-28
• /
• 2009

DFT-spread OFDM(Discrete Fourier Transform-Spread Orthogonal Frequency Division Multiplexing) is very effective for solving the PAPR(Peak-to-Average Power Ratio) problem. Therefore, the SC-FDMA(Single Carrier-Frequency Division Multiple Access) which is basically same to the DFT spread OFDM was adopted as the uplink standard of the 3GPP LTE ($3^{rd}$ Generation Partnership Project Long Term Evolution). Unlike the ordinary OFDM system, the SC-FDMA using DFT spreading method is vulnerable to the ICI(Inter-Carrier Interference) problem caused by the phase noise and IQ(In-phase/Quadrature) imbalance and effected FDE(Frequency Domain Equalizer). In this paper, the ICI effects from the phase noise and IQ imbalance which can be problems in uplink transmission are analyzed according the back-off level of HPA. Next, we propose the equalizer algorithm to remove the ICI effects. This proposed equalizer based on the FDE can be considered as up-graded and improved version of PNS(Phase Noise Suppression) algorithm. This proposed equalizer effectively compensates the ICI resulting from the phase noise and IQ imbalance. Finally, through the computer simulation, it can be shown that about SNR=14 dB is required for the $BER=10^{-4}$ after ICI compensation when the back-off is 4.5 dB, $\varepsilon=0.005$, $\phi=5^{\circ}$, and $pn=0.06\;rad^2$.

• Journal of the Korean Society of Marine Environment & Safety
• /
• v.29 no.7
• /
• pp.902-909
• /
• 2023

This study evaluated the performance test of a small-sized LTE-Maritime(LTE-M) transceiver that was developed and promoted to expand the use of intelligent maritime traf ic information services led by the Ministry of Oceans and Fisheries with the aim of supporting the prevention of maritime accidents. Accoriding to statistics, approximately 30% of all marine accidents in Korean water occur with ships weighing less than 3 tons. Therefore, the blind spots of maritime safety must be supplemented through the development of small-sized transceivers. The small transceiver may be used in fishing boats that are active near coastal waters and in water leisure equipment near the coastline. Therefore, verifying whether sufficient performance and stable communication quality are provided is necessary, considering the environment of their real usage. In this study, we reviewed the communication quality goals of the LTE-M network and the performance requirements of small-sized transceivers suggested by the Ministry of Oceans and Fisheries, and proposed a test plan to appropriately evaluate the performance of small-sized transceivers. The validity of the proposed test method was verified for six real-sea areas with a high frequency of marine accidents. Consequently, the downlink and uplink transmission speeds of the small-sized LTE-M transceiver showed performances of 9 Mbps or more and 3 Mbps or more, respectively. In addition, using the coverage analysis system, coverage of more than 95% and 100% were confirmed in the intensive management zone (0-30 km) and interesting zone (30-50 km), respectively. The performance evaluation method and test results proposed in this paper are expected to be used as reference materials for verifying the performance of transceivers, contributing to the spread of government-promoted e-navigation services and small-sized transceivers.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.52 no.5
• /
• pp.33-47
• /
• 2015

Cellular Network assisted device-to-device (D2D) communication has been growing to reduce the overload of eNodeB and mitigate the frequency shortage. However, by sharing the uplink frequency resource with the cellular network, the interference between cellular and D2D is increased. In this paper, we propose an advanced receiver for full suppression cancellation (FSC) to reduce the interference between cellular and D2D. The proposed receiver can suppress and cancel the interference by integrating the interference rejection combining (IRC) technique with successive interference cancellation (SIC). We perform a system level simulation based on the 20-MHz bandwidth of the 3GPP LTE-A system. Simulation results show that the proposed receiver can improve SINR, throughput and spectral efficiency compared to conventional receivers.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11C
• /
• pp.1106-1112
• /
• 2009

The SC-FDMA(single carrier-frequency division multiple access) was recently adopted as the uplink multiple access scheme from 3GPP LTE(3rd Generation Partnership Project Long Tenn Evolution) due to its low PAPR (Peak-to-averaged power ratio). The bandwidth of IFDMA(interleaved FDMA), one of the sub-carrier mapping methods of SC-FDMA, gets narrower as the roll-off factor of RRC(root raised cosine) filter decreases from 1 to 0, whereas its PAPR can increase significantly. In practice, to increase the power efficiency of an amplifier, signals with high PAPR undergo the process of clipping. Clipping of signals may cause regeneration of high-frequency components as well as distortion of signals. The current paper deals with the effect of clipping on the spectrum and BER of IFDMA signals with RRC filters.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.27 no.2
• /
• pp.208-211
• /
• 2016

Device-to-Device communication(D2D) enables devices in proximity to communicate directly without going through the network infrastructure. In particular, D2D communications in a cellular network can improve the spectral efficiency by allowing the reuse of cellular resources. However, it is not easy to maintain the channel quality of the D2D links and to protect the cellular links from the D2D interferences, since the resource allocations for the cellular users will change with time due to the time-varying nature of the cellular channels. To mitigate the performance degradation of D2D links, we propose to exploit unlicensed bands as auxiliary resources when the D2D links share the uplink cellular resources. The effectiveness of the proposed scheme is verified through simulations.