• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.23 no.4
• /
• pp.59-64
• /
• 2023

In this paper, It is proposed through the empirical design of a Conducted EMI filter for noise reduction of power used in electronic devices. For the proposed structure, A-type, B-type, C-type, and D-type structures were designed, and conductive noise reduction was confirmed by using an LC network with various X-capacitors, Y-capacitors, and Air-inductors. 10 [μH] was used for L1 and L2, and 4.7 [nF] was used for C1 and C2. L3 for common mode used 13[μH], and C5, C6, C7 were designed using 10[nF]. The measured insertion loss values of the designed EMI filter were -74.4[dB] at 3.2MHz, -75.4[dB] at 4MHz, and -75.3[dB] at 13.56MHz. Therefore, the proposed EMI filter will be able to reduce power supply noise used in various electronic devices.

• Journal of electromagnetic engineering and science
• /
• v.11 no.1
• /
• pp.27-33
• /
• 2011

In this paper, we propose a high gain, current reused ultra wideband (UWB) low noise amplifier (LNA) that uses TSMC 0.18 ${\mu}m$ CMOS technology. To satisfy the wide input matching and high voltage gain requirements with low power consumption, a resistive current reused technique is utilized in the first stage. A ${\pi}$-type LC network is adopted in the second stage to achieve sufficient gain over the entire frequency band. The proposed UWB LNA has a voltage gain of 12.9~18.1 dB and a noise figure (NF) of 4.05~6.21 dB over the frequency band of interest (1~10 GHz). The total power consumption of the proposed UWB LNA is 10.1 mW from a 1.4 V supply voltage, and the chip area is $0.95{\times}0.9$ mm.

• Proceedings of the Korean Institute of Intelligent Systems Conference
• /
• 2005.11a
• /
• pp.335-338
• /
• 2005

로봇 에이전트는 변화하는 환경에서 센서정보를 바탕으로 적절한 행동을 선택하며 동작하는 것이 중요하다. 행동 선택 네트워크는 이러한 환경에서 변화하는 센서정보에 따라 실시간으로 행동을 선택할 수 있다는 점에서, 장시간에 걸친 최적화보다 단시간 내 개선된 효율성에 초점을 맞추어 사용되어 왔다. 하지만 행동 선택 네트워크는 초기 문제에 의존적으로 설계되어 변화하는 환경에 유연하게 대처하지 못한다는 맹점을 가지고 있다. 본 논문에서는 행동 선택 네트워크의 연결을 LCS를 기반으로 진화 학습시켰다. LCS는 유전자 알고리즘을 통해 만들어진 규칙들을 강화학습을 통해 평가하며, 이를 통해 변화하는 환경에 적합한 규칙을 생성한다. 제안하는 모델에서는 LCS의 규칙이 센서정보를 포함한다. 진화가 진행되는 도중 이 규칙들이 모든 센서 정보를 포함하지 못하기 때문에 현재의 센서 정보를 반영하지 못하는 경우가 발생할 수 있다. 본 논문에서는 이를 해결하기 위해 센서정보 별로 개체를 따로 유지하는 방법을 제안한다. 제안하는 방법의 검증을 위해 Webots 시뮬레이터에서 케페라 로봇을 이용해 실험을 하여, 변화하는 환경에서 로봇 에이전트가 학습을 통해 올바른 행동을 선택함을 보였고, 일반LCS를 사용한 것보다 조건별 개체 유지를 통해 더 나은 결과를 보이는 것 또한 확인하였다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.6
• /
• pp.445-450
• /
• 2012

We have developed an implantable wireless sensor for real time pressure monitoring of blood circulation system. MEMS (micro-electro-mechanical system) technology was adopted as a sensor development method. The sensor is composed of photolithographically patterned inductors and a distributed capacitor in gap between the inductors. A resulting LC resonant system produces its resonant frequency in range of 269 to 284 MHz at 740 mmHg. To read the resonant frequency changed by blood pressure variation, we developed a custom readout system based on a network analyzer functionality. The bench-top testing of the pressure sensors showed good mechanical and electrical functionality. A sensor was implanted into tibial artery of farm pig, and interrogated wirelessly with accurate readings of blood pressure. After 45 days, the sensor's electrical response and histopathology were studied with good frequency reading and biocompatibility.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.3
• /
• pp.1203-1210
• /
• 2017

Switched-inductor (SL) Z-source three-level inverter is a novel high power topology. The SL based impedance network can boost the input dc voltage to a higher value than the single LC impedance network. However, as all the neutral-point-clamped (NPC) inverters, the SL Z-source three-level inverter has to balance the neutral-point (NP) potential too. The principle of the inverter is introduced and then the effects of NP potential unbalance are analyzed. A NP balancing method is proposed. Other than the methods for conventional NPC inverter without Z-source impedance network, the upper and lower shoot-through durations are corrected by the feedforward compensation factors. With the proposed method, the NP potential is balanced and the voltage boosting ability of the Z-source network is not affected obviously. Simulations are conducted to verify the proposed method.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.21 no.1
• /
• pp.10-18
• /
• 2016

In this study, an efficient clamp is proposed to reduce the switch voltage stress of a forward converter. The proposed clamp consists of a conventional LC snubber, a tertiary winding, and a diode. When the switch is turned OFF, the magnetizing inductor energy of the transformer is recovered directly into the flyback output, which is the tertiary winding and diode network, instead of circulating in the LC snubber. Therefore, switch voltage stress and circulating current caused by the magnetizing inductor energy are reduced. This condition improves the efficiency of the forward converter with limited switch voltage stress. A theoretical analysis and the design guidelines of the proposed converter are provided. Experimental results are also reported.

• Journal of Internet Computing and Services
• /
• v.8 no.1
• /
• pp.25-31
• /
• 2007

The development of efficient Quality of Service (QoS) routing algorithms in high speed networks is very difficult since divergent services require various quality conditions, If the QoS parameter we concern is to measure the delay on that link, then the routing algorithm obtains the Least Delay (LD) path, Meanwhile, if the parameter is to measure of the link cast, then it calculates the Least Cost (LC) path. The Delay Constrained Least Cast (DCLC) path problem of the mixed issues on LD and LC has been shown to be NP-hard. The path cost of LD path is relatively mere expensive than that of LC path, and the path delay of LC path is relatively higher than that of LD path in DCLC problem. In this paper. we propose the algorithm based on estimated path for the DCLC problem and investigate its performance, It employs a new parameter which is probabilistic combination of cost and delay, We have performed empirical evaluation that compares our proposed algorithm with the DCUR in various network situations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.18 no.2 s.117
• /
• pp.213-218
• /
• 2007

In this paper, we propose the design and fabrication on high frequency CMOS VCO for DS-UWB(Direct-Sequence Ultra-WideBand) applications using 0.18 ${\mu}m$ process. The complementary cross-coupled LC oscillator architecture which is composed of PMOS, NMOS symmetrically, is designed for improving the phase noise characteristic. The resistor is used instead of current source that reduce the 1/f noise of current source. The high-speed buffer is needed for measuring the output characteristic of VCO using spectrum analyzer, therefore the high-speed inverter buffer is designed with VCO. A fabricated core VCO size is $340{\mu}m{\times}535{\mu}m$. The VCO is tunable between 7.09 and 7.52 GHz and has a phase noise lower than -107 dBc/Hz at 1-MHz offset over entire tuning range. The measured harmonic suppression is 32 dB. The VCO core circuit draws 2.0 mA from a 1.8 V supply.

• Korean Journal of Materials Research
• /
• v.7 no.3
• /
• pp.175-179
• /
• 1997

bliniaturization oi microwave circuit components is an important issue with the development in the mobile communication. Capacitors, inductors anti hybrid devices of these are building blocks of electric circuits, and the fabrication of these devices using thin film technology will influence on the miniaturization of electronic devices In this paper, we report the successful fabrication of the inductors, capacitors and LC hybrid devices using a ferroelectric and a ferromagnetic oxide thin iilm. Au, stable at high temperatures in oxidizing ambient, is patterned by lift-off process, and oxide thin films are deposited by ion beam sputtering and chemical vapor deposition. These devices are characterized by a network analyzer in 0.5-15GtIz range We got the inductance of 5nH, capacitance oi 10, 000 pF and resonant frequencies of $10^{6}-10^{9}Hz$.

• Journal of Power Electronics
• /
• v.7 no.1
• /
• pp.13-20
• /
• 2007

LLC resonant converters display many advantages over the conventional LC series resonant converter such as narrow frequency variation over wide range of load and input variation and zero voltage switching even under no load conditions. This paper presents analysis and design consideration for the half bridge LLC resonant converter. Using the fundamental approximation, the gain equation is obtained, where the leakage inductance in the transformer secondary side is also considered. Based on the gain equation, the practical design procedure is investigated to optimize the resonant network for a given input/output specifications. The design procedure is verified through an experimental prototype of the 115W half-bridge LLC resonant converter.