• Journal of electromagnetic engineering and science
• /
• v.17 no.2
• /
• pp.71-75
• /
• 2017

A dual-band tunable-slot-type ground radiation antenna is proposed. The feeding structure consists of a coplanar waveguide and a lumped capacitor to excite currents for first- and second-order resonant modes of the ground. The resonant frequencies of both bands are controlled using a series combination of a capacitor and an inductor. The proposed design may be an attractive choice for mobile devices owing to its compact geometry and tunable operating frequencies. The measurement and simulation results of the proposed antenna show good agreement, indicating good impedance matching and radiation performance.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.26 no.8
• /
• pp.35-41
• /
• 2012

As automation equipment and electronic device progresses, the importance of power quality is more increasing. This paper represents the analysis and suppression about the causes of trouble by the inverter's ON/OFF noise in plant in order to prevent damage resulting in a secondary damage to conduct precise diagnosis and effective noise reduction. The countermeasure as a reduced carrier frequency and the LC resonant filter had been applied and confirmed the effective results to solve the trouble of noise.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2003.07a
• /
• pp.497-501
• /
• 2003

In order to manufacture ceramic capacitors for the industrial electronic parts application using Tape casting method, the dielectric properties as a functions of sintering temperatures and the fabrication conditions of green sheet were investigated to consider the possibility of applications. When the mixing ratio of powder and solvent in slurry was 65:35, the uniform and dense green sheets was obtained. The dielectric constant was increased as the sintering temperature Over 94% of relative density and high were obtained to the specimens sintered at $1000^{\circ}C$. We can find that the device sintered at higher temperature than $1000^{\circ}C$ showed the relative density over 94% and the dielectric constant over 2000.

• Proceedings of the KIPE Conference
• /
• 2010.07a
• /
• pp.214-215
• /
• 2010

본 논문은 공진 인버터를 적용한 HID램프를 구동하기 위한 전자식 안정기를 설계하고 구현하였다. 제안된 전자식 안정기는 스위치 턴온 오프시의 손실을 줄이기 위해서 소프트 스위칭 기법인 ZVS(Zero-Voltage Switching)을 도입하였다. 점등은 LC필터의 공진주파수범위에서 풀브리지 인버터 제어에 의한 공진으로 이루어 진다. 점등후에 컨버터는 저주파수 구형파로 동작한다. 공진 기동시의 LC필터의 공진주파수는 ($f_o$=160kHz)이고, 고조파를 감소시키고 음향공진현상을 피하기 위한 벅컨버터 스위칭 주파수(고주파수 : 50~60kHz 와 저주파수 : 170Hz)를 선택하였다. 실험을 통해 공진 인버터를 적용한 HID램프용 전자식 안정기가 안정적으로 동작함을 확인하였다.

• Proceedings of the KIEE Conference
• /
• 2003.07b
• /
• pp.1235-1237
• /
• 2003

For small capacity rectifier circuits as these for consumer electronics and appli capacitor input type rectifier circuits are gen used. Consequently. various harmonics gen within the power system become a serious pro Various studies of this effect have been pres previously. However. most of these employ swit devices, such as FETs and the like. The absen switching devices makes systems more toleran over -load, and brings low radio noise benefits propose a power factor correction scheme using resonant in commercial frequency without swit devices. In this method. It makes a sinusoidal by widening conduction period using the cu resonance in commercial frequency. Hence, harmonic characteristics can be significantly imp where the lower order harmonics. such as the and seventh orders are much reduced. The resu confirmed by the theoretical and experm implementations.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.14 no.6
• /
• pp.488-495
• /
• 2009

This paper proposes a new AC/DC RPPB(Resonant Piezo-Powered Boost) converter for energy harvesting using a piezoelectric device which converts mechanical vibration energy to electrical energy. The AC/DC RPPB converter can operate with only the harvested energy without an additional power conversion circuit for switching circuit and transfer energy to a load of which the voltage is higher than piezoelectric voltage. With the review of published topologies of the converter for energy harvesting, the operation principle of the AC/DC RPPB converter, and the results of PSPICE simulation and experiment are presented to prove the feasibility of the new converter for the energy harvesting.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.3 no.1
• /
• pp.24-30
• /
• 2010

In this paper, a novel electrically small monopole type resonant antenna is proposed. The very short length monopole (${\iota}{\approx}{\lambda}_g/15$ ) acts as a capacitive element and the slot on the ground structure acts as an inductive element, hence the combined system with these two elements thus form an LC resonator. The equivalent circuit model of the antenna structure was used to analysis and qualify the design correctness. Although the proposed antenna has very small size, it shows good performances. The measured maximum gain and radiation efficiency of the fabricated antenna at the frequency of 2.1 GHz was 3.6 dBi and 77.8 %, respectively.

• Proceedings of the KIEE Conference
• /
• 2002.11d
• /
• pp.204-206
• /
• 2002

For small capacity rectifier circuits such as these for consumer electronics and appliances. capacitor input type rectifier circuits are generally used Consequently. various harmonics generated within the power system become a serious Problem. Various studies of this effect have been presented previously. However. most of these employ switching devices, such as FETs and the like. The absence of switching devices makes systems more tolerant to over -load, and brings low radio noise benefits. We propose a power factor correction scheme using a LC resonant in commercial frequency without switching devices. In this method. It makes a sinusoidal wave by widening conduction period using the current resonance in commercial frequency. Hence, the harmonic characteristics can be significantly improved. where the lower order harmonics. such as the fifth and seventh orders are much reduced. The result are confirmed by the theoretical and expermental implementations.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.4
• /
• pp.506-510
• /
• 2016

A triple-band (TB) oscillator was implemented in the TSMC $0.18{\mu}m$ 1P6M CMOS process, and it uses a cross-coupled nMOS pair and two shunt $4^{th}$ order LC resonators to form a $6^{th}$ order resonator with three resonant frequencies. The oscillator uses the varactors for band switching and frequency tuning. The core current and power consumption of the high (middle, low)- band core oscillator are 3.59(3.42, 3.4) mA and 2.4(2.29, 2.28) mW, respectively at the dc drain-source bias of 0.67V. The oscillator can generate differential signals in the frequency range of 8.04-8.68 GHz, 5.82-6.15 GHz, and 3.68-4.08 GHz. The die area of the triple-band oscillator is $0.835{\times}1.103mm^2$.

• Journal of IKEEE
• /
• v.23 no.2
• /
• pp.407-412
• /
• 2019

Many industrial regions has used and extended the application of LED driver because of many advantage. Specially, due to the simplicity, miniaturization and power density, the flyback converter is selected by a lot of power engineer. Also, the electrolytic capacitor in this converter is used for the constant DC voltage of the converter because of the sufficient capacitance and the economic price. However, because of the characteristics of the electrolytic capacitor and ripple currents on the converter. the expected lifetime of the LED driver is more and more shorted. In this paper, a single-stage CCM PFC flyback converter with the film capacitor is suggested to extended the lifetime of the LED driver. In addition, the proposed converter with the LC filter is decreased the ripple current of the converter output.