• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.7A
• /
• pp.807-813
• /
• 2004

This paper corresponded to Smart-UAV(Smart Unmanned Aerial Vehicle) technology development, a part of “The 21th Century New-Frontier Development Project” being propelled in accordance with enlarging the necessity of concentration development by selecting our strong technique being able to compete in the international society of knowledge based economy in the 21th century. Also, we designed Ku-band airborne video transceiver system performing to receive the TC(Tele-Command) signal needed to be applicable of Smart-UAV, and send the video and TM(Tele-Metry) signal at the same time. Moreover, we analyzed it in order to satisfy the system request of designed whole communication system, and established the validity on this paper going through by module simulation and manufacture of the whole system.

• Journal of IKEEE
• /
• v.25 no.1
• /
• pp.133-138
• /
• 2021

We propose a Ku-band three-stack CMOS power amplifier to enhance the output power and efficiency. To minimize the dc power consumption, the driver stage is designed using common-source structure. To obtain high output power and utilize a voltage combining method, the power stage is designed using stack structure. To verify the proposed power amplifier structure, we design a Ku-band power amplifier using 65-nm RFCMOS process which provide nine metal layers. The P1dB, power-added efficiency, and gain are higher than 20 dBm, 23 dB, and 25%, respectively, while the operating frequency is 14 GHz-16 GHz.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.2
• /
• pp.19-22
• /
• 2014

In this paper, Ku-band low phase noise oscillator using DSRR structure resonator based on metamaterial was proposed. To improve the phase noise of the oscillator, the proposed resonator consist of a DSRR strcuture based on metamaterial. The proposed resonator have a characteristic of $S_{11}$ is -0.25 dB, and $S_{21}$ in -44.59 dB at 14.67 GHz, respectively. At 14.67 GHz, the proposed Ku-band low phased oscillator achieves a output power of 2.03 dBm, $2^{nd}$ harmonic of -36.04 dBc, and phase noise of -130.63 dBc at the 100 kHz offset, respectively.

• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.513-514
• /
• 2008

A scalable satellite broadcasting system is designed to guarantee quality of multimedia service cooperatively utilizing both Ku Band and Ka band. In the system, video streams are separated into a base layer and an enhancement layer, and are transmitted over the two channels, Ku Band and Ka band, respectively. A basic quality of service using the base layer stream can be provided even when the enhancement layer stream over Ka band channel is unavailable by rain attenuation. A rain fall model is simulated using Barlett-Lewis Pulse model and is used in the operation test of the implemented sacalable satellite broadcasting system.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.11 no.4
• /
• pp.599-609
• /
• 2000

In this paper, sub-harmonically pumped single balanced resistive mixers are presented . Frequency bandwidth is selected for a Ku-band, which is 11.75-12.25GHz for RF, 5.375∼5.625 GHz for LO, and 1 GHz for IF signals. A rat-race hybrid is designed for the accomplishment of single balanced type. A low pass filter (LPF) with photonic band gap(PBG) structure is used for good conversion loss and unwanted harmonics suppression. Two types of mixers are suggested, which are one with no gate bias for no DC power consumption and the other with the IF amplifier for conversion gain. When a LO signal with the power of 6 dBm at 5.5 GHz is injected, a conversion loss of 12.17dB and a conversion gain of 7.83 dB are obtained for each mixer. For the both mixers , LO to RF isolation of 20 dB and LO to IF isolation of 60dB are obtained. With the RF power of -30dBm to -3dBm, the mixer shows linear characteristics region of IF. this mixer can be applied for Ku-band and other microwave communication systems.

• ETRI Journal
• /
• v.26 no.4
• /
• pp.307-314
• /
• 2004

The application of a discrete pseudomorphic high electron mobility transistor (p-HEMT) as a grounded switch allows for the development of low cost phase shifters and phase modulators operating in a Ku band. This fills the gap in the development of phase control devices comprising p-i-n diodes and microwave monolithic integrated circuits (MMICs). This paper describes a discrete p-HEMT characterization and modeling in switching mode as well as the development of a low-cost four-bit phase shifter and direct quadrature phase shift keying (QPSK) modulator. The developed devices operate in a Ku band with parameters comparable to commercially available MMIC counterparts. Both of them are CMOS compatible and have no power consumption. The parameters of the QPSK modulator are very close to the requirements of available standards for satellite earth stations.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.15 no.4
• /
• pp.501-505
• /
• 2015

In this paper, we demonstrated a 4W power amplifier monolithic microwave integrated circuit (MMIC) for Ku-band satellite communication applications. The used device technology relies on $0.25{\mu}m$ GaAs pseudomorphic high electron mobility transistor (PHEMT) process. The 4W power amplifier MMIC has linear gain of over 30 dB and saturated output power of over 36.1 dBm in the frequency range of 13.75 GHz ~ 14.5 GHz. Power added efficiency (PAE) is over 30 %.

• Journal of the Korean Institute of Telematics and Electronics A
• /
• v.33A no.6
• /
• pp.72-80
• /
• 1996

This paper presetns the development of a SSPA operating at KU-band(14~14.5 GHz) in order of replace TWTA used in the terrestria transponder of a satellite communication. The driving stage of SSPA uses internally matched 2W, 4W, 8W FET and the power stage is coupled with two internally matched 8W FET by branch-line cominer. The SSPA is fabricated with oth the RF circuit and the bias circuitry operating temperature compensation, regulation and sequence on aluminum housing. The SSPA testing resutls implemented in this way show 24.8$\pm$1dB small-signal gain, 41dBm P1dB power, a typical two tone C/IM3, -33dBc with single carrier backed off 6dB from p1dB, and gain stability over temeprature (-30~50)$\pm$1dB.

• Proceedings of the Korea Electromagnetic Engineering Society Conference
• /
• 2001.11a
• /
• pp.227-230
• /
• 2001

본 논문은 마이크로파 슈퍼헤테로다인 수신기에서 발생되는 이미지성분을 효과적으로 제거하기위한 Cascode형 FETs구조를 이용한 Ku-Band 이미지 제거용 자기발진믹서을 분석하였다. 자기발진믹서는 두개의 FET에 의해서 동작되며 상위 FET는 유전체공진기에 의해서 발진기로 동작하며, 아래쪽 FET는 믹서로 동작시켰다. 모의실험 결과 초기 게이트바이어스 전압은 $V_{ gsl}$=-0.4V와 $V_{g2}$=-0.4V와 $V_{g2}$V선정 하였으며, 10.75GHz의 발진기 출력은 2.249dBm, 위상잡음은 -137.9dBc/1000KHz, 이미지 제거특성은 약 -26dBc 값을 얻었다.얻었다.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.17 no.5
• /
• pp.629-636
• /
• 2014

In the proposed paper, we designed low phase noise frequency synthesizer for Ku-band. The proposed up-mixing frequency synthesizer consists of narrow local oscillation part and variable frequency oscillation part. To improve the phase noise of frequency synthesizer, we analyze how the configuration of frequency synthesizer affect the phase noise. The implemented frequency synthesizer reduce the phase noise. The phase noise is -95.18dBc/Hz at 7kHz frequency offset in 16GHz and -94.27dBc/Hz at 7kHz frequency offset in 16.125GHz.