• 품질경영학회지
• /
• 제22권1호
• /
• pp.152-161
• /
• 1994

In this paper we develop a test for alternatives representing decreasing mean residual life. The test statistic for decreasing mean residual life, $K_{1n}$, is a modified version of Hollander and Proschan's test $V^*$ and critical constants and large sample approximation are shown to make the test readily applicable. Consistency is also shown for the tests based on $K_{1n}$. And small sample powers for four alernatives are obtained.

• 시스템엔지니어링학술지
• /
• 제6권1호
• /
• pp.41-46
• /
• 2010

The ground high/low temperature test objective is to check the normal ground operation of FA-50 aircraft in the extreme ground ambient conditions. The aircraft was exposed in climatic conditions of the basic climatic category according to the MIL-HDBK-310. For verified normal operation in the extreme high temperature, the high temperature test was performed in the hot regional type conditions and accentuated solar radiation heat. This test was performed at the test chamber in ADD where is in Haemi. This paper was described about the test procedure of FA-50 high/low temperature including preparation, testing and results.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2008년도 제30회 춘계학술대회논문집
• /
• pp.107-110
• /
• 2008

엔진의 비행, 구성품 성능 오차, 엔진 시스템 인증 기준에 따라 결정된 시스템 시험영역을 기준으로 하는 터보펌프 가스발생기 연계시험 영역 설정을 하였다. 연계시험 작동점에 해당하는 연소기 압력 모사를 위한 배관 손실계수와 터빈 출력 조정을 위한 스로틀 밸브의 손실계수를 결정하였다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2009년도 춘계학술대회 논문집
• /
• pp.593-598
• /
• 2009

In this study we present results for the design of ground test system for 4 degree of freedom(DOF) control test is one of the smart UAV ground test. This system is equipped with real smart UAV and Z direction DOF and 3 direction rotation DOF, Ensuring safe operation of the Smart UAV is a top priority. To this end, it is required to do structure analysis and test verification to confirm the design margin and safety. Based on the analysis, the ground test system has been redesigned to meet the structural conditions.

• 한국추진공학회:학술대회논문집
• /
• 한국추진공학회 2007년도 제29회 추계학술대회논문집
• /
• pp.325-328
• /
• 2007

본 연구에서는 소형가스터빈의 고공 및 속도시험, 환경시험 등을 수행하기 위해, 러시아의 SCIAM 연구소에 설치된 기존 대형 시험설비를 개량하여, C-9N 시험스탠드를 개발하는 과정에서 수행된 개념적 설계의 내용을 다루고 있다. 본 시험 스탠드는 환경모사 시스템, 항온유지 시스템, 냉각/건조 시스템, 추력측정 시스템, SAR 시스템으로 구성되어 있다.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2007년도 춘계학술대회 논문집
• /
• pp.1671-1674
• /
• 2007

A PSD system has a lot of characteristic for safety. Trust of performance test is very important. But PSD performance test has an effect on trust by proficiency of test staff because it is difficult to automate. In that specially the effort test, manual opening and shutting test and abrasion measurement, test staff is demanded for proficiency. Therefore the paper repeated measurement in same condition and studied proficient factor of examiner according to increased measurement counter. As a result, measurement uncertainty has improved.

• 한국콘크리트학회:학술대회논문집
• /
• 한국콘크리트학회 2003년도 봄 학술발표회 논문집
• /
• pp.197-203
• /
• 2003

Korea Highway Corporation(KHC) began the ambitious KHC Test Road construction project from 1997. It is 7.7km long two-lane highway next to the mainline of Jungbu Inland Expressway. The KHC Test Road construction was completed at the December 2002. It is composed of twenty-five PCC test pavement sections. Section design parameters are (1) concrete slab thickness, (2) base type, (3) base thickness (12, 15, and 18cm), and (4) pavement type. Twenty-five PCC test pavement sections contain 1241 sensors to evaluate the behavior of pavement system under traffic load and environmental change. The behavior of pavement systems will be identified by the observation of sensor measurement and pavement distress survey from test pavement sections. The Test Road research outcome will validate the Korean Pavement Design Guide which is develop by on-going funded research from the Ministry of Construction and Transportation.

• 대한기계학회논문집A
• /
• 제30권2호
• /
• pp.210-218
• /
• 2006

This paper has performed static, fatigue and nondestructive test of tilting' bolster frame for Korean tilting train. From the static test, the structural safety was investigated using Goodman diagram. After the static test, the fatigue test were conducted under tilting load conditions. The fatigue test was conducted for $10\times10^6$ cycles. During the fatigue test, the nondestructive tests using magnetic particle and liquid penetrant were performed at $6\times10^6$cycle and $10\times10^6$cycle. From the crack detection tests, it was known that there was no fatigue crack in the tilting bolster.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2003년도 추계학술대회
• /
• pp.1252-1257
• /
• 2003

This paper present a procedure of meter-out flow control method for dump valve in full-scale airframe test. Emergency stop, which results in dump state, can be happened during full-scale airframe test by several causes. Because servo valve can't control hydraulics actuator in the dump state, pressure in cylinder chamber may rise abruptly and overload can be acted to the test article. In this paper, the procedure and technology of orifice setting are investigated to protect the test article from unexpected loads by dump. The test results show that the presented methods decrease peak loads and improve unloading characteristics of hydraulic actuators in the dump state.

• Journal of the Korean Statistical Society
• /
• 제15권1호
• /
• pp.9-25
• /
• 1986

In this paper we propose a distribution-free rank test for ordered alternatives in a randomized block design and investigate the properties of the proposed test. The proposed test is an extension of the Page test to allow replications in each cell. Some asymptotic properties including ARE's are investigated. A small sample Monte Carlo study was performed to compare the powers of the test considered in this paper for small samples. The results show that our proposed test is robust and efficient in the case of equally-spaced treatment effects.