• Journal of the Korean Society of Systems Engineering
• /
• v.8 no.1
• /
• pp.63-75
• /
• 2012

For the definition of development project, this paper proposes an integrated design model for the project 3P's(Products, Process, and People) architecture solutions balancing the originating requirements as well as the design targets of product, process, and IPDT. The model is suggested to develop the integrated design method with trade-off analysis and alternatives evaluation of products, processes, and IPDT using QFD.

• Journal of Power System Engineering
• /
• v.13 no.6
• /
• pp.76-81
• /
• 2009

Thermal desorption systems are designed to remove organic compounds from solid matrices such as soils, sludges and filter cakes without thermally destroying them. It is a separation technology, not a destruction technology. Since it is a thermal process, there is a common belief that temperature is the only significant parameter to be monitored. While it is true that better removal efficiencies are usually achieved at higher temperatures, other factors must be considered. Since the process is governed by mass transfer, heating time and the amount of mixing are also key parameters in optimizing removal efficiency. Thermal desorption have been successfully used for just about every organic contaminant found to date. It has also been used to remove mercury. In the present study, the numerical simulation has been performed to investigate the characteristics of heat transfer of LTTD(low temperature thermal desorption). The commercial software, AMESIM was applied for analyzing the heat transfer process in the LTTD.

• Aerospace Engineering and Technology
• /
• v.2 no.2
• /
• pp.115-123
• /
• 2003

In this paper, in order to guarantee successful operation of KSR-III TVC actuator in the presence of excessive external disturbances, a relief valve is designed as a key component of the actuator. It is shown that the relief valve can resolve the stability problems which occur due to actuator failure in the presence of excessive disturbance torques on the actuator. Six degree-of-freedom simulation shows that relief valves with low operating pressure and low LOHM parameter may be better is stability and performance of the TVC actuator system.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2006.11a
• /
• pp.946-949
• /
• 2006

This study is a trial to make a design chart of sound insulation for multiple panel. Dilatational frequency, ${\Large f}_d$ becomes a key factor for optimal design since it acts like a turning point in sound insulation performance of such panels. Hence, in tuning the ${\Large f}_d$ optimally, elastic modulus of core material and thickness of the skin panel is designated to parameters. Based on these parameter, a design chart of sound insulation for multiple panel is made. Its applicability is proved by the case study of High noise reduction panel.

• Proceedings of the KIPE Conference
• /
• 2017.11a
• /
• pp.47-48
• /
• 2017

This paper presents a low-cost portable lithium battery parameter measuring and estimating the solution. In this method, lithium battery characteristics are monitored during discharging and charging cycles. The battery profile is analyzed, and its key parameters are estimated by GNU Octave running on Raspberry Pi Zero, a mini computer. The proposed method can measure and estimate the battery parameters for SOC and DOD estimation with reasonable accuracy as well as portability features.

• Communications for Statistical Applications and Methods
• /
• v.23 no.1
• /
• pp.47-55
• /
• 2016

Stratified cluster sampling has been widely used for effective parameter estimations due to reductions in time and cost. The probability proportional to size (PPS) sampling method is used when the number of cluster element are significantly different. However, simple random sampling (SRS) is commonly used for simplicity if the number of cluster elements are almost the same. Also it is known that the ratio estimator produces a good performance when the total number of population elements is known. However, the two stage cluster estimator should be used if the total number of elements in population is neither known nor accurate. In this study we suggest a composite estimator by combining the ratio estimator and the two stage cluster estimator to obtain a better estimate under a certain population circumstance. Simulation studies are conducted to compare the superiority of the suggested estimator with two other estimators.

• Journal of electromagnetic engineering and science
• /
• v.7 no.3
• /
• pp.116-121
• /
• 2007

Novel design of a wideband monopole antenna for DVB-H service is presented. The proposed antenna is designed based on a monopole antenna. It consists of folded monopole and parallel parasitic element. The folded segment of the folded monopole makes the antenna shorter. The length of the parasitic element obtains additional resonance frequencies. The gap distance between the folded monopole and the parasitic element is a key parameter to control impedance matching for wideband operation. The antenna has wide band performance, good impedance and radiation characteristics from 470 MHz to 870 MHz. The measured return loss for operating frequencies over DVB-H band is better than 10 dB. Good radiation patterns are also obtained. The measured results are compared with calculated results using Ansoft HFSS(High Frequency Structure Simulator).

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.5
• /
• pp.438-443
• /
• 2008

In this paper, segmenting and classifying low contrast defects on flat panel display is one of the key problems for automatic inspection system in practice. Problems become more complicated when the quality of acquired image is degraded by the illumination irregularity. Many algorithms are developed and implemented successfully for the defects segmentation. However, vision algorithms are inherently prone to be dependent on parameters to be set manually. In this paper, one morphological segmentation algorithm is chosen and a technique using frequency domain analysis of input images is developed for automatically selection the morphological parameter. An extensive statistical performance analysis is performed to compare the developed algorithms.

• International Journal of Aeronautical and Space Sciences
• /
• v.2 no.1
• /
• pp.44-54
• /
• 2001

This paper describes the antenna alignment method of the tracking antenna system for LEO satellite. The purpose of the antenna alignment is to reduce the angular error due to the structural alignment and the monopulse null point alignment error. The angular error of 3 axis tracking system is the key performance parameter that should be minimized to accurately track satellite movement. The angular error is analyzed via a simulation and boresight measurement. The simulation is done with formulas to be derived from vector concept for 3-axis movement. The formulas of the structural alignment are verified by comparing the formula result with the field measurement. Also, the angular error due to monopulse null shift is obtained via boresight measurement. Based on the analyzed and measured results, the antenna alignment was performed and was verified via tracking test of operating LEO satellite.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.2A
• /
• pp.196-201
• /
• 2010

Measurement of Quality of Service (QoS) parameters and its statistical analysis becomes a key issue for Mobile WiMAX service providers to manage the converged network efficiently and to support end-to-end QoS. In this paper, we investigate the population distribution of end-to-end one-way delay which is the most important QoS parameter in Mobile WiMAX networks. The samples are analyzed with Chi-Square Goodness-of-Fit test, Kolmogorov-Smirnov (K-S), and Anderson-Darling (A-D) test to verify the distribution of parent population. The relation with confidence level and the minimum number of sample size is also performed for logistic distribution. The statistical analysis is a promising approach for measuring the performance Mobile WiMAX networks.