• 제목/요약/키워드: Internal check

검색결과 412건 처리시간 0.021초

NDT 기법을 이용한 가공배전선로 내부 열화 진단장치 개발 (Development of Diagnostic Device for Internal Degradation in Distribution Line Using NDT Mathod)

  • 현득창
    • 한국전기전자재료학회논문지
    • /
    • 제28권8호
    • /
    • pp.539-543
    • /
    • 2015
  • At present, the development of a detection device in order to prevent accidents due to wire deterioration in the distribution lines is required. Distribution line is not possible to check the internal state in a normal way because it is covered with the coating. Accordingly, various eddy current techniques that is the non-destructive test (NDT) techniques have been applied to solve this problem. In this paper, we have seen examining the characteristic change of the eddy current sensor according to the simplified shape of the sensor in order to solve the problems for the simplified shape that is generated when the simulation for the shape of the eddy current sensor.

Introduction of Conventional Stress Analysis Method based on Kowalski's Formula at Internal Thread Undercut

  • Yoon, Jaehuy;Kang, Youngsu;Lee, Inchul;Park, Sangjoon
    • International Journal of Aerospace System Engineering
    • /
    • 제2권2호
    • /
    • pp.54-57
    • /
    • 2015
  • The purpose of this paper is to provide the method of conventional stress analysis for a pressurized hydraulic cylinder with internal thread undercut. In the case of hydraulic cylinder with thread undercut, several loads and stresses occur during operating. So, the thread undercut can be most critical section has to be considered in detail for strength check. In this paper, the conventional stress analysis method at internal thread undercut of hydraulic cylinder based on Kowalski's formula is introduced. The method is verified by comparing to FEM analysis results using ANSYS.

Tailoring the second mode of Euler-Bernoulli beams: an analytical approach

  • Sarkar, Korak;Ganguli, Ranjan
    • Structural Engineering and Mechanics
    • /
    • 제51권5호
    • /
    • pp.773-792
    • /
    • 2014
  • In this paper, we study the inverse mode shape problem for an Euler-Bernoulli beam, using an analytical approach. The mass and stiffness variations are determined for a beam, having various boundary conditions, which has a prescribed polynomial second mode shape with an internal node. It is found that physically feasible rectangular cross-section beams which satisfy the inverse problem exist for a variety of boundary conditions. The effect of the location of the internal node on the mass and stiffness variations and on the deflection of the beam is studied. The derived functions are used to verify the p-version finite element code, for the cantilever boundary condition. The paper also presents the bounds on the location of the internal node, for a valid mass and stiffness variation, for any given boundary condition. The derived property variations, corresponding to a given mode shape and boundary condition, also provides a simple closed-form solution for a class of non-uniform Euler-Bernoulli beams. These closed-form solutions can also be used to check optimization algorithms proposed for modal tailoring.

The Relationships Between Control Measures and Absenteeism in the Context of Internal Control

  • Bayram, Metin;Burgazoglu, Huseyin
    • Safety and Health at Work
    • /
    • 제11권4호
    • /
    • pp.443-449
    • /
    • 2020
  • Background: The study tries to show the effect of Occupational Health and Safety (OHS) legislation implemented via plan-do-check-act methodology on accident and sickness absenteeism. Methods: The data for the study gathered via a questionnaire from a large-sized organization operates in production and maintenance of passenger coaches in February-March 2019 in Turkey. The data analyzed via structural equation model analysis. Results: The results showed that there are statistically meaningful relationships between OHS protective measures, training and informing of employees, and employee participation and accident and sickness absenteeism. In addition, a meaningful relationship between internal control and accident and sickness absenteeism was determined. Statistically meaningful relationships between emergency measures, and health surveillance and internal control, and accident and sickness absenteeism could not be determined. Conclusion: It is concluded that the actions implemented by organizations to reduce absenteeism should be as per OHS legislation.

목재옹벽의 내적안정 평가에 관한 연구 (Internal Stability of Timber Framed Earth Retaining Wall)

  • 이광우;김주형;조삼덕
    • 한국지반신소재학회논문집
    • /
    • 제10권2호
    • /
    • pp.81-89
    • /
    • 2011
  • 본 연구에서는 국내 간벌 목재를 사용하여 개발한 목재옹벽에 관한 연구를 수행하였다. 목재옹벽은 일반적으로 중력식 옹벽의 설계방법과 동일한 방법으로 설계하고 있지만, 목재틀 전면벽체의 내적안정성에 대한 검토는 일반적으로 수행하고 있지 않다. 본 연구에서는 조적식 콘크리트 블록 옹벽에 적용하고 있는 NCMA(1997)의 내적 안정성 검토 방법을 목재옹벽에 적용할 것을 제안하였다. 또한, 3종류의 목재틀 전면벽체에 대한 전단시험을 수행하여 내적안정을 검토하고 간단한 설계도표를 제안하였다.

Lymphocγtic Interstitial Pneumonia 1예 (A Case of Lymphocytic Interstitial Pneumonia)

  • 서요안;김상일;김대한;곽진영;이재철;백희종;정진행
    • Tuberculosis and Respiratory Diseases
    • /
    • 제51권4호
    • /
    • pp.390-394
    • /
    • 2001
  • Lymphocytic interstitial pneumonia(LIP) is characterized by a massive infiltration of the interstitium of the lung by mature lymphocytes, plasma cells and reticuloendothelial cells. LIP may be associated with autoimmune diseases including Sj$\check{o}$grens syndrome, SLE, myasthenia gravis, pernicious anemia, autoimmune hemolytic anemia, and HIV or an EB virus infection. There is a possibility of LIP progressing to a pulmonary or systemic lymphoma. The therapeutic response to corticosteroids and/or immunosuppressive drugs varies. Here we report a case of LIP that was diagnosed by an open lung biopsy and clonality study. The patient was a 36 year-old man without autoimmune disease or HIV infection. He was admitted as a result of severe hypoxemia showing $PaO_2$ of 48.3mmHg. The patient was treated with corticosteroids after the diagnosis and had fully recovered without a sequalae or relapse.

  • PDF

Evaluation of Dynamic Delivery Quality Assurance Process for Internal Target Volume Based RapidArc

  • Song, Ju-Young
    • 한국의학물리학회지:의학물리
    • /
    • 제28권4호
    • /
    • pp.181-189
    • /
    • 2017
  • The conventional delivery quality assurance (DQA) process for RapidArc (Varian Medical Systems, Palo Alto, USA), has the limitation that it measures and analyzes the dose in a phantom material and cannot analyze the dosimetric changes under the motional organ condition. In this study, a DQA method was designed to overcome the limitations of the conventional DQA process for internal target volume (ITV) based RapidArc. The dynamic DQA measurement device was designed with a moving phantom that can simulate variable target motions. The dose distribution in the real volume of the target and organ-at-risk (OAR)s were reconstructed using 3DVH with the ArcCHECK (SunNuclear, Melbourne, USA) measurement data under the dynamic condition. A total of 10 ITV-based RapidArc plans for liver-cancer patients were analyzed with the designed dynamic DQA process. The average pass rate of gamma evaluation was $81.55{\pm}9.48%$ when the DQA dose was measured in the respiratory moving condition of the patient. Appropriate method was applied to correct the effect of moving phantom structures in the dose calculation, and DVH data of the real volume of target and OARs were created with the recalculated dose by the 3DVH program. We confirmed the valid dose coverage of a real target volume in the ITV-based RapidArc. The variable difference of the DVH of the OARs showed that dose variation can occur differently according to the location, shape, size and motion range of the target. The DQA process devised in this study can effectively evaluate the DVH of the real volume of the target and OARs in a respiratory moving condition in addition to the simple verification of the accuracy of the treatment machine. This can be helpful to predict the prognosis of treatment by the accurate dose analysis in the real target and OARs.

발전용 밸브누설 음향 진단 및 감시시스템 (Acoustic Valve Leak Diagnosis and Monitoring System for Power Plant Valves)

  • 이상국
    • 한국소음진동공학회:학술대회논문집
    • /
    • 한국소음진동공학회 2008년도 춘계학술대회논문집
    • /
    • pp.425-430
    • /
    • 2008
  • To verify the system performance of portable AE leak diagnosis system which can measure with moving conditions, AE activities such as RMS voltage level, AE signal trend, leak rate degree according to AE database, FFT spectrum were measured during operation on total 11 valves of the secondary system in nuclear power plant. AE activities were recorded and analyzed from various operating conditions including different temperature, type of valve, pressure difference, valve size and fluid. The results of this field study are utilized to select the type of sensors, the frequency band for filtering and thereby to improve the signal-to-noise ratio for diagnosis for diagnosis or monitoring of valves in operation. As the final result of application study above, portable type leak diagnosis system by AE was developed. The outcome of the study can be definitely applied as a means of the diagnosis or monitoring system for energy saving and prevention of accident for power plant valve. The purpose of this study is to verify availability of the acoustic emission in-situ monitoring method to the internal leak and operating conditions of the major valves at nuclear power plants. In this study, acoustic emission tests are performed when the pressurized temperature water and steam flowed through glove valve(main steam dump valve) and check valve(main steam outlet pump check valve) on the normal size of 12 and 18 ". The valve internal leak monitoring system for practical field was designed. The acoustic emission method was applied to the valves at the site, and the background noise was measured for the abnormal plant condition. To improve the reliability, a judgment of leak on the system was used various factors which are AE parameters, trend analysis, frequency analysis, voltage analysis and amplitude analysis of acoustic signal emitted from the valve operating condition internal leak.

  • PDF

중풍(中風) 환자(患者)의 피부(皮膚) 소양증(瘙痒症)에 소풍산(消風散) 투여(投與) 2례(例) (Two Cases of Stroke Patient's Pruritic Dermatoses Treated with Sopung-San(Xiaofeng-San))

  • 김태경;김정열;강경숙;류순현;배형섭;최요섭
    • 대한한방내과학회지
    • /
    • 제23권2호
    • /
    • pp.280-285
    • /
    • 2002
  • Pruritus is [CHECK DEFN] itchy feeling of one's skin. We often face stroke patients who complain about Pruritus. They occasionally fail to fall asleep or have a secondary infection as a result of scratching. For these reasons, severe Pruritus brings down general condition and interferes with recovery. The causes of Pruritus are distributed to from skin diseases and from internal diseases. Especially among the skin diseases, Xerotic Eczema, which is called Senile Eczema causes the dry skin in the elderly, especially lower limb's extensor part. According to the epidemiology, 20% of the old have Xerotic Eczema. In oriental medicine, Pruritus is called Pungsoyang(風瘙痒), Pungyang(風痒), Yangpung(痒風), Sinyang(身痒). The cause of Pruritus is divided into two. One is endogenous factors and the other is exogenous factors. The former are deficiency of blood(血虛), blood fever(血熱), wind-heat due to internal damage(內傷風熱), damp-heat in the liver and gallbladder(肝膽濕熱), endogenous wind stirring in the liver(肝風內動), deticiency syndrome of the spleen(脾虛), deficiency of Yin of the liver and kidneys(肝腎陰虛) and deficiency of the Penetration and Conception Vessels(衝任不足). The latter are wind-cold due to exogenous affection(外感風寒) and wind-heat due to exogenous affection(外感風寒). We report two stroke patients who complained of severe Pruritus They were diagnosed as having Xerotic Eczema by a dermatologist. We regarded their Pruritus as blood fever(血熱) and wind-heat(風熱) and prescribed Sopung-San to these patients. These patients showed significant improvement.

  • PDF

심야용 축열식 전기온풍기의 화재 위험성에 관한 연구 (A study on Fire Hazard of Electric Radiant Heating Systems with Thermal Storage Using Off-peak Electricity)

  • 박민영;문용수
    • 한국화재조사학회지
    • /
    • 제8권1호
    • /
    • pp.41-48
    • /
    • 2006
  • The purpose of this study is to identify the fire danger of the electric radiant heating system and check the way how to use it and the problems that could be possible through a actual case. We carry out an experiment to identify the possibility of the fire in the similar condition of the actual fire case. The results of this study are as follows. It is a possible condition to fire if the air blast of the electric radiant heating system is blocked by some combustible materials such as plastic bags continuously. A temperature sensor and a residual current device are necessary to disconnect the power source. It is also necessary to attach a notice in front of the electric radiant hearing system that shows users the fire danger to forbid the possible fire. Fires could be happened by internal defects of the electronic products. However, we can also find many external reasons to happen fires. Therefore, we need to check all reasons to make fires in the scene of a fire.

  • PDF