• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2015년도 전력전자학술대회 논문집
• /
• pp.155-156
• /
• 2015

This paper proposes a high efficiency wireless power transfer system with an asymmetric 4-coil resonator. It presents a theoretical analysis, an optimal design method, and experimental results. In the proposed asymmetric 4-coil system, the primary side consists of a source coil and two transmitter coils which are called intermediate coils, and in the secondary side, a load coil serves as a receiver coil. In the primary side, two intermediate coils boost the apparent coupling coefficient at around the operating frequency. Because of this double boosting effect, the system with an asymmetric 4-coil resonator has a higher efficiency than the conventional symmetric 4-coil system. The prototype operates at 90 kHz ofswitching frequency and has 200 mm of the power transmission distance between the primary side and the secondary side. An AC-DC overall system efficiency of 96.56% has been achieved at 3.3 kW of output power.

• Journal of information and communication convergence engineering
• /
• 제2권3호
• /
• pp.153-156
• /
• 2004

A planar active retrodirective four-element array with subharmonic phase conjugation mixers based on anti-parallel diode pairs (APDPs) is proposed. As compared to previous phase conjugation mixers using twice RF frequency for LO frequency, the proposed conjugation mixers need only half RF frequency so that it can be easily applied for millimeter-wave applications. Receiving, transmitting, local oscillator, and intermediate frequencies are 5.79, 5.81, 2.9 GHz, and 10 MHz. Monostatic RCS and Bistatic RCS measurements at source locations of $0^{\circ},\;-20^{\circ},\;and\;28^{\circ}$ show good agreement with the calculated data.

• 한국통신학회논문지
• /
• 제31권9C호
• /
• pp.914-920
• /
• 2006

본 논문은 직교 주파수 분할 다중화(OFDM) 통신 시스템에서 최대 전력 대 평균 전력의 비 (PAPR)를 감소하기 위해서 사용되는 새로운 부분 전송 시퀀스(PTS) 기법을 제안한다. 제안하는 방법에서는 역 푸리에 변환(IFFT)을 두 부분으로 나누어 실행한다. 첫 번째 부분에서는 IFFT를 중간까지만 수행하여 입력 심볼 시퀀스를 중간 신호 시퀀스로 변환한다. 두 번째 부분은 중간 신호 시퀀스를 여러 개의 서브 시퀀스로 분할한 후 각각에 대해서 나머지 IFFT를 완료하고 PAPR을 감소하기 위한 위상 벡터를 선택한다. 본 논문에서 제안하는 PTS 기법은 기존의 PTS 기법과 유사한 PAPR 감소 성능을 보이지만 계산 복잡도를 감소시킨다.

• 조명전기설비학회논문지
• /
• 제26권1호
• /
• pp.75-81
• /
• 2012

In this paper, the wireless power transfer system using the magnetic resonance was designed, analyzed by circuit analysis methode and the calculated transfer function was compared with the measured one. The self-resonant coil was made up of the commonly used capacitor which had the lumped capacitance and it enabled the stable magnetic resonance not to be affected by the circumstance. The transmission efficiency of this system was 70[%] at the 15[cm] between the transmission and receiving coil and the measured transfer function was similar to the calculated one, which means the circuit analysis methode is valid in this system. When the intermediate coils were added between the transmission and receiving coil, the transmission efficiency was increased, which produced the increase of transfer distance. In the case of the five intermediate coils adding, the 35[%] transmission efficiency was achived at the 90[cm] distance.

• 지구물리와물리탐사
• /
• 제3권1호
• /
• pp.19-24
• /
• 2000

28 Hz와 100 Hz 지오폰을 사용하여 탄광 채굴공동에 의한 지반침하 지역에서 탄성파자료를 획득하고 지오폰에 따른 탄성파 자료의 주파수 특성을 고찰하였다. 파동의 전파거리가 짧아 고주파수 성분의 감쇠가 적은 근거리 오프셋($1\~10m$) 에서는 100 Hz 지오폰 자료가 28 Hz 지오폰 자료에 비하여 상당히 높은 주파수 성분(최대 300 Hz)을 보유하며 중거리 오프셋($11\~39m$)에서는 28Hz 지오폰 자료의 신호대역 주파수 특성은 근거리 오프셋 자료와 전체적으로 유사하고 100 Hz 지오폰의 경우는 신호로 간주할 수 있는 최대 주파수는 높은 반면 상대적으로 높은 수준의 고주파 잡음이 존재하며, 원거리 오프셋($\geq40\;m$)에서는 150 Hz 이상의 영역에서 신호가 대부분 잡음수준까지 감쇠된 결과를 보여주었다.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2006년도 추계학술대회논문집
• /
• pp.694-698
• /
• 2006

This paper presents an optimal design process using beads on a body panel to improve interior noise of a passenger vehicle. Except modification of structural members, it is difficult to find effective countermeasures that can work for the intermediate frequency range from 100 Hz to 300 Hz which lies between the booming and low medium frequency. In this study, it is a major goal to find additional counter-measures for this intermediate frequency range by performing optimal design of beads on body panels. The proposed method for design optimization consists of 4 sub-steps, that is, a) problem definition, b) cause analysis, c) countermeasure development and d) validation. The objective function is minimization of interior noise level. The major design variables are the geometrical shape of a bead and combination of beads on the critical panels. Sensitivity analysis and optimization are performed according to the predefined process for an optimal design. It is verified that the proposed design decreases the level of noise transfer function above 5 dB.

• 천문학회보
• /
• 제42권2호
• /
• pp.53.3-53.3
• /
• 2017

The pilot study of SLGT (Superconducting Low-frequency Gravitational-wave Telescope) is being performed by KKN (KASI-KISTI-NIMS) collaboration. In this presentation, we discuss prospectives of detecting GWs in the low-frequency band (0.1-10 Hz), which is a target frequency band of SLGT, but can be hardly observed by advanced LIGO. IMBHBs (Intermediate Mass Black Hole Binaries) and IMRIs (Intermediate Mass Ratio Inspirals) with total masses of O(1000) up to O(10,000) solar masses are most probable sources between 0.1-10 Hz. We estimate horizon distances and signal to noise ratios of IMBHBs and IMRIs for different SLGT design sensitivities. Based on our calculations, detection rates for IMBHBs and IMRIs with SLGT will be discussed.

• Composites Research
• /
• 제17권3호
• /
• pp.23-28
• /
• 2004

불균등 단면이나 임의의 경계조건을 가진 보나 탑 구조물의 고유진동수를 계산하는 방법은 김덕현에 의해 1960년 후반기에 개발 응용되고 1974년의 한 국제회의에서 발표되었다. 이 논문에는 이 방법을 탄성지지된 3경간연속 철근콘크리트 교량에 적용한 결과가 실려있다. 콘크리트 상판은 특별직교 이방성 판으로 취급되었다. 이 진동해석에 필요한 변위의 영향계수는 여러 방법으로 구할 수 있으나 이 논문에서는 유한차분법이 사용되었다. 기초의 탄성계수와, $D_{22}$, $D_{12}$, $D_{66}$ 강성의 고유진동수에 대한 영향이 철저하게 연구되었다.

• 한국전기전자재료학회논문지
• /
• 제16권7호
• /
• pp.593-598
• /
• 2003

In this paper, 3rd overtone mode energy-trapped filter using modified PbTiO$_3$ system ceramics was manufactured to apply for intermediate frequency(IF) SMD type fillet with splitted electrode and gap size. To investigate the effects of splitted electrode and gap size on filter characteristics of 3rd overtone mode energy-trapped filter, ceramic wafers were fabricated by etching splitted rectangular electrode size(b$\times$d) of b=0.4, 0.6, 0.8, 1mm, d=0.3, 0.4, 0.5, 0.6mm and gap size(c) c=0.2, 0.3, 0.4, 0.6mm, respectively. And then, SMD type ceramic filter were fabricated with the size of 3.7$\times$3.1$\textrm{mm}^2$. SMD type ceramic filter with the size of b=0.8mm, d=0.4mm and gap(c)=0.4mm, which showed insertion loss of 2.951dB, 3dB bandwidth of 54.7kHz and 20dB stop bandwidth of 129.27kHz, was suitable for IF bandpass filter application.

• Tribology and Lubricants
• /
• 제32권4호
• /
• pp.107-112
• /
• 2016

This paper presents a rotordynamic analysis of the reduction gear system applied to the 250 kW super critical CO₂ cycle. The reduction gear system consists of an input shaft, intermediate shaft, and output shaft. Because of the high rotating speed of the input shaft, we install tilting pad bearings, rolloer bearings support the intermediate and output shafts. To predict the tilting pad bearing performance, we calculate the applied loads to the tilting pad bearings by considering the reaction forces from the gear. In the rotordynamic analysis, gear mesh stiffness results in a coupling effect between the lateral and torsional vibrations. The predicted Campbell diagram shows that there is not a critical speed lower than the rated speed of 30,000 rpm of the input shaft. The predicted modes on the critical speeds are the combined bending modes of the intermediate and output shaft, and the lateral vibrations dominate when compared to the torsional vibrations. The damped natural frequency does not strongly depend on the rotating speeds, owing to the relatively low rotating speed of the intermediate and output shaft and constant stiffness of the roller bearing. In addition, the logarithmic decrements of all the modes are positive; therefore all modes are stable.