• Journal of the Korean Institute of Telematics and Electronics T
• /
• v.35T no.2
• /
• pp.86-92
• /
• 1998

In this paper, it is derived the system design parameters for the J-STD-018 of the PCS mobile station(MS) minimum performance using DS/CDMA analyzed the system performance due to the receiver components. The simulation shows the selectivity is -70.96dB at 1.25MHz frequency offset from the carrier frequency while the MS noise figure to satisfy J-STD-018 is 10dB and the input 3rd harmonics intercept point of the MS class I and MS class II-V is -9.5dBm and -14dBm respectively. When the interference power level at the receiver is small, the receiver has better performance as we increase the gain of LNA. However, when the interference level at the receiver is large, the receiver performance is decreased by the effect of the spurious. Thus, the effectiveness of LNA On/Off switching technique is proved as to reduce the effect of the spurious.

• Proceedings of the KIEE Conference
• /
• 2008.10b
• /
• pp.137-138
• /
• 2008

This paper proposes the modified image contrast enhancement technique for small-sized display of mobile handset. Sample images are user interface images, in which scaled up wVGA($800{\times}480$) from qVGA($320{\times}240$) that we can see easily in mobile handset. The display size of mobile handset is relatively small, so the goal of this paper is to simplify image contrast enhancement algorithm based on conventional HE (Histogram Equalization) algorithm and improve computational effectiveness to minimize power consumption in real hardware IC. In this paper, we adopt HE technique, which is classical and widely used for image contrast enhancement. At first, the input frame image is partitioned to temporal sub-frames and then analyzes gray level histogram of each sub-frame. In case that the analyzed histogram of some sub-frames deviates so much from reference level (it means that the sub-frame image components consist of too bright ones or dark ones), apply DHE(Dynamic Histogram Equalization) algorithm. In the other case, apply classical Histogram Linearization (or Global HE) algorithm. Also we compare the HE technique with gamma LUT (Look-Up Table) method, which is known as the simplest technique to enhance image contrast.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.10 no.2
• /
• pp.103-112
• /
• 1990

This study examines the characteristics of soil behavior which includes many uncertainties in seismic design, evaluates the dynamic soil properties and studies the soil-structure interaction to generalize the applicability and economy of the available sites. An example analysis is performed for soil-structure system response assuming a containment structure built on site which includes soil layers using both elastic halfspace analysis and FEM analysis against the seismic loads from the actual design. This exercise is performed as a part of the safety analysis and economic assessment of the nuclear power plant built on soils. It includes the preparation of computer program capable of incorporating large nonlinearity in the analysis, resonable evaluation procedures to determine input soil data. Nonlinear FEM analysis of Seed and Idriss model is found suitable for the accurate analysis of dynamic response of soils. Linear FEM analysis using dynamic soil properties at strain level obtained by one-dimensional seismic response, and elastic half-space analysis using dynamic soil properties at strain level under static loads are recommended to evaluate the dynamic soil properties.

• Journal of the Korean Regional Science Association
• /
• v.32 no.4
• /
• pp.19-38
• /
• 2016

This study investigates the effects of real exchange rate (RER) on firm level mark-up and export. Using firm level data in Daegu-Gyeongbuk manufacturing industries during 2006-2013, we find that firms adjust their markup in response to the RER changes and this adjustment is heterogeneous with respect to firm and industry characteristics. In particular, an increase in markup following the RER depreciation is greater for firms with lower intermediate input import and higher industry concentration. However, productive firms in this region increase their export, instead of markup, during the RER depreciation. This implies that the productive firms in the region may not retain significant market power: They do not change the final price in local currency to increase selling volume during the RER depreciation (the export price in foreign currency decreases).

• Journal of Korea Port Economic Association
• /
• v.17 no.1
• /
• pp.27-51
• /
• 2001

The purpose of this paper is to investigate the productive efficiency of world container ports by using the DEA (Data Envelopment Analysis) method and raw data from previous research in measuring the international competitiveness of world container ports. Ports have to cope with rapid changes in shipping environments. In order for a port to compete in the global market, it must provide port services promptly and accurately. Basically, there are two approaches to measuring the international competitiveness of a container port. First, there is the traditional productivity analysis method, which analyzes productivity based on the container port's facilities (efficiency, selectivity, land availability), and by its general capacity (handling ability, storage capacity, terminal productivity). Second there is multi-attribute utility analysis, which considers several elements including the reasons for selecting particular container ports and factors determining international competitiveness. This paper follows the first method (traditional productivity analysis) and extends the limitation of previous studies by using the DEA method newly, and suggesting: the relative productive efficiency of container ports. The main results of this paper are as follows: First, the results of the DEA analysis in terms of world container ports matches that of a previous study (Jun et al., 1993) at a level of 35%. The low ratio is due to the constrained set of input-output elements, the result of only twenty container ports being analyzed in this paper. Second, the result of the DEA analysis in terms of North-East Asia's container ports matches with that of a previous study (Ha, 1996) at a level of 100 percent. Therefore we can conclude that the DEA analysis is the best measurement method for international competitiveness. Policy implications for this study are as follows: First, when port authorities want to measure the international competition power of container ports and enhance their productive efficiency, they should consider the traditional method and newly introduce the DEA method. Second, according to the analysis results of the DEA method, pen authorities should recommend benchmarking ports as reference ports in order to enhance the productive efficiency of container ports that show an efficiency score of below 1.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.3 no.3
• /
• pp.569-577
• /
• 1999

A wideband RF receiver for satellite mobile communications system was fabricated and evaluated of performance in low noise amplifier and high gain amplifier. The low noise amplifier used to the resistive decoupling and self-bias circuits. The low noise amplifier is fabricated with both the RF circuits and the self-bias circuits. Using a INA-03184, the high gain amplifier consists of matched amplifier type. The active bias circuitry can be used to provide temperature stability without requiring the large voltage drop or relatively high-dissipated power needed with a bias stabilized resistor. The bandpass filter was used to reduce a spurious level. As a result, the characteristics of the receiver implemented here show more than 55 dB in gain, 50.83 dBc in a spurious level and less than 1.8 : 1 in input and output voltage standing wave ratio(VSWR), especially the carrier to noise ratio is a 43.15 dB/Hz at a 1 KHz from 1537.5 MHz.

• Journal of the Institute of Convergence Signal Processing
• /
• v.12 no.2
• /
• pp.113-118
• /
• 2011

In this paper, we develop a speaker gender classification technique using collaborative sensor fusion for use in a wireless sensor network. The distributed sensor nodes remove the unwanted input data using the BER(Band Energy Ration) based voice activity detection, process only the relevant data, and transmit the hard labeled decisions to the fusion center where a global decision fusion is carried out. This takes advantages of power consumption and network resource management. The Bayesian sensor fusion and the global weighting decision fusion methods are proposed to achieve the gender classification. As the number of the sensor nodes varies, the Bayesian sensor fusion yields the best classification accuracy using the optimal operating points of the ROC(Receiver Operating Characteristic) curves_ For the weights used in the global decision fusion, the BER and MCL(Mutual Confidence Level) are employed to effectively combined at the fusion center. The simulation results show that as the number of the sensor nodes increases, the classification accuracy was even more improved in the low SNR(Signal to Noise Ration) condition.

• Journal of Drive and Control
• /
• v.12 no.4
• /
• pp.60-70
• /
• 2015

A front-end loader (FEL) mounted on an agricultural tractor is one of the most commonly used implements for farm work. However, when the tractor carries material using the bucket attached to the FEL on a sloping ground, the materials can spill or roll back over the operator due to the tilted body, thereby requiring the bucket surface to remain level at a constant value regardless of varying slopes. In this study, an active system for controlling the angle of the FEL bucket on a tractor based on the real-time measurement of ground slopes was developed to enable the bucket to constantly remain level. A FEL simulator operated based on an electro hydraulic proportional valve (EHPV) was constructed in the laboratory to develop a proportional-integral-derivative (PID) controller forming a virtual electronic control unit (ECU) on the computer, which could automatically adjust the bucket angles depending on varying input angles while sending SAE-J1939 associated messages via CAN BUS to the EHPV. The different parameter values for the PID controller due to the gravity effect of the bucket were determined using a manual PID tuning method while assuming that the tractor travels on either an ascending slope or a descending slope. The developed PID control-based self-leveling system showed a mean of steady-state errors of within $1^{\circ}$ and a mean of delayed times of ~ 0.8s when the step input of $+20^{\circ}$ was given, implying that the developed system and control algorithm would be effective in maintaining the bucket angle at a certain value. Future studies include the improvement of the control algorithm to reduce such a time delay as well as the application of the developed algorithm to the FEL mounted on a tractor tested at a testing ground.

• Journal of the Korean Society of Costume
• /
• v.57 no.2 s.111
• /
• pp.69-85
• /
• 2007

Despite the recovery of consumer expenditure and retailing in the Korean economy after 2001, the domestic apparel industry has been aggravated by negative growth in both productivity and production. The purpose of the stud? is to diagnose the develop competitive of the Korean apparel industry and derive implications for this after estimating the efficiency of the Korean apparel companies with Data Envelopment Analysis. Data Envelopment Analysis(DEA) is a methodology based in non-parametric analysis and linear programming. It was developed for measuring the relative efficiency of a set of firms that use inputs to produce outputs. Data used fer input and output variables in the analysis are drawn from financial statement recorded by the Korean Financial Supervisory Service. The initial input data comprise the number fo the employees, fixed assets, general management and selling expenses, and cost of sales. The initial outputs are the operating profit and the gross margin. To summary the results, the efficiencies of the Korean apparel companies has increased yearly in spite of being overabundance of investment in Labour and Capital. According to correlation between input and output variables, the Korean apparel industry has been revamping gradually from labor intensive industries to the capital. The companies need to reduce costs in the results from the number of employees, fixed asset and cost of sales to transform into an efficiently enterprise. The companies owning or obtaining a brand had bitter establish an outsourcing strategic in production, while OEM corporations are called far setting up a manufactory in domestic or abroad. Although the paper is derived some implications with production efficiencies, the relation between apparel companies and brand power, consumption level of consumer, and social trend is remained on a limitation to the study. The next research necessitates a topic with Fashion industry or examining the correlation between brand value, social propensity and profit margin.

• Journal of IKEEE
• /
• v.14 no.2
• /
• pp.51-57
• /
• 2010

A CMOS rail-to-rail high voltage buffer amplifier is proposed to drive the gamma correction reference voltage of large TFT LCD panels. It is operating by a single supply and only shows current consumption of 0.5mA at 18V power supply voltage. The circuit is designed to drive the gamma correction voltage of 8-bit or 10-bit high resolution TFT LCD panels. The buffer has high slew rate, 0.5mA static current and 1k$\Omega$ resistive and capacitive load driving capability. Also, it offers wide supply range, offset voltages below 50mV at 5mA constant output current, and below 2.5mV input referred offset voltage. To achieve wide-swing input and output dynamic range, current mirrored n-channel differential amplifier, p-channel differential amplifier, a class-AB push-pull output stage and a input level detector using hysteresis comparator are applied. The proposed circuit is realized in a high voltage 0.18um 18V CMOS process technology for display driver IC. The circuit operates at supply voltages from 8V to 18V.