• Journal of Wetlands Research
• /
• v.13 no.2
• /
• pp.231-242
• /
• 2011

Recently, the green spaces in the urban areas were greatly reduced due to urbanization and industrialization. As urban structures such as roads and buildings are built, the amount of impervious area within a watershed increases. High impervious surfaces are the common causes of high runoff volumes as the soil infiltration capacity decreases and the volume and rate of runoff increase thereby decreasing the groundwater recharge. These effects are causing many environmental problems, such as floods and droughts, climate change, heat island phenomenon, drying streams, etc. Most cities attempted to reduce sewer overflows by separating combined sewers, expanding treatment capacity or storage within the sewer system, or by replacing broken or decaying pipes. However, these practices can be enormously expensive than combined sewer overflows. Therefore, in order to improve these practices, alternative methods should be undertaken. A new approach termed as "Low Impact Development (LID)" technology is currently applied in developed countries around the world. The purpose of this study was to effectively manage runoff by adopting the LID techniques. Small Constructed Wetland(Horizontal Subsurface Flow, HSSF) Pilot-scale reactors were made in which monitoring and experiments were performed to investigate the efficiency of the system in removing pollutants from runoff. Based on the results of the Pilot-plant experiments, TSS, $COD_{Cr}$, TN, TP, Total Pb removal efficiency were 95, 82, 35, 91 and 57%, respectively. Most of the pollutants were reduced after passing the settling tank and the vertical filter media. The results of this study can contribute to the conservation of aquatic ecosystems and restoration of natural water cycle in the urban areas.

• Horticultural Science & Technology
• /
• v.18 no.6
• /
• pp.839-844
• /
• 2000

In developing of soil wetting agents using the mixture of polyoxyethylene octylphenyl ether [$C_8H_{17}O$ $(C_2H_4O)_{10}H$, POE] and polyoxyethylene+polypropyleneoxide tridecylether (1:1, w/w, CM-1), the effect of base carriers such as zeolite and vermiculite on changes of concentration of POE and on initial wetting of peat-vermiculite media were determined. The concentration of POE in the treatment of zeolite was higher than that of vermiculite. The treatments of POE+CM-1 with zeolite or vermiculite as carrier were effective in initial water retention of root media having about 510 mL of water per pot, where those of AquaGro and control had 490 mL and 400 mL of water per pot, respectively. In the evaporative water loss, the treatment of zeolite and AquaGro were faster than those of control and vermiculite. The treatment of AquaGro had faster water movement in root media than those of POE+CM-1 regardless of carriers and same trends were observed in the volume of water infiltrating into root media. Also, increasing the amount of POE+CM-1 resulted in increased water retention capacity, evaporative water loss, water movement in root media and amount of water infiltrating into root media.

• Parasites, Hosts and Diseases
• /
• v.23 no.2
• /
• pp.293-299
• /
• 1985

This study is to verify the protective ability against experimental Naegleria meningoencephalitis by immunization with Naegleria fowleri in mice. Naegleria fewleri, strain 0359, and Naegleria gruberi, strain EGB, were used in this study, and cultured in CGVS medium akenically. Inbred BALB/C mice, weighing about 20g, were immunized by three intraperitoneal injection of $1{\times}10^6$ N. fowleri trophozoites at the interval of one week. This N. fowleri trophozoites antigen was fixed with 5% formaldehyde. N. fowleri trophozoites from culture were homogenized with soiicator at $4^{\circ}C$ as monitored by phase contrast microscopy, and their membrane and cell content preparations were made for the immunization of mice. Their inoculation dose in volume was equivalent to the $1{\times}10^6$ trophozoites in each injection for immunization. And N. gruberi trophosoites, whieh was fixed with 5% formaldehyde, were also used for immunisation. Mice were inoculated intranasally with $5{\times}10^4$ N. fowleri trophozoites in a 511 suspension under anesthesia by as intraperitoneal injection of about 1 mg secobarbiturate. Nervousness, rotation or sluggish behaviour were observed in the mice which were infected with N. fewleri. Necrotic lesion was demonstrated in the anterior portion of brain, especially in the olfactory lobe. The inflammatory cell infiltration with numerous H. fowleri trophozoites was noticed. This pathological changes were more extensive in the control than in the experimental groups. Mice were dead due to experimental primary amoebic meningoencephalitis that developed between 8 days and 23 days after inoculation. Mortality rate of the mice was low in the immunized experimental group. Mean survival time, which is the survival duration of mice from the infection to death, was prolonged significantly in the immunized mice except in the mice immunized with JV, fowleri membrane. Even in the mice immunized with N. gruberi, survival time was delayed. In summary, the effectiveness of immunization is demonstrated in terms of protective immunity against Naegleria meningoencephalitis in mice.

• Journal of Nuclear Fuel Cycle and Waste Technology(JNFCWT)
• /
• v.12 no.1
• /
• pp.69-77
• /
• 2014

Unsaturated hydraulic conductivity of the bentonite-buffer was evaluated using the relative humidity data. The method for calculating unsaturated hydraulic conductivity was deduced from the general analytical equation representing the movement of water in unsaturated media, which was applied to the experimental results of water infiltration tests for identifying the behavior of unsaturated hydraulic conductivity according to the water saturation. Unlike the saturated condition, the hydraulic gradient and water flux were irregularly changed, and the unsaturated hydraulic conductivity was increased with increasing the experimental time. Swelling of bentonite grains due to the water absorption increased the volume and size of pore within bentonite, resulting in the increase of water velocity and unsaturated hydraulic conductivity. This result suggested the necessity of further investigation on the correlation between the swelling degree of bentonite-buffer and unsaturated hydraulic conductivity. The method used in this study can be useful technique for evaluating long-term hydraulic performance of bentonite-buffer in the radioactive waste disposal system.

• Journal of Korea Water Resources Association
• /
• v.36 no.2
• /
• pp.285-300
• /
• 2003

An event-based, kinematic, infiltration-excess, and distributed rainfall-runoff model using weather radar and Geographic Information System(GIS) was developed to acknowledge and account lot the spatial variability and uncertainty of several parameters relevant to storm surface runoff and surface flow The developed model is compatible with raster GIS and spatially and temporally varied rainfall data. To calibrate the model, Monte Carlo simulation and a likelihood measure are utilized; allowing for a range of possible system responses from the calibrated model. Using rain gauge adjusted radar-rainfall estimates, the developed model was applied and evaluated to a limited number of historical events for the Ralston Creek and Goldsmith Gulch basins within the Denver Urban Drainage and Flood Control District (UDFCD) that contain mixed land use classifications. While based on a limited number of Monte Carlo simulations and considered flood events, Nash and Sutcliffe efficiency score ranges of -0.19∼0.95 / -0.75∼0.81 were obtained from the calibrated models for the Ralston Creek and Goldsmith Gulch basins, based on a comparison of observed and simulated hydrographs. For the Ralston Creek and Goldsmith Gulch basins, Nash and Sutcliffe efficiency scores of 0.88/0.10, 0.14/0.71, and 0.99/0.95 for runoff volume, peak discharge, and time to peak, respectively, were obtained from the model.

• Journal of the Korean Society of Physical Medicine
• /
• v.9 no.2
• /
• pp.151-159
• /
• 2014

PURPOSE: The purpose of this study was to evaluate whether light-emitting diodes (LED) irradiation could be effective in a noninvasive, therapeutic device for the treatment of osteoarthritis(OA). METHODS: Twenty-four male Sprague-Dawley rats were divided into four groups: Vehicle control (saline); monosodium iodoacetate-injection (MIA); LED irradiation after MIA injection (MIA-LED); indomethacin-treatment after MIA injection (MIA-IMT). OA was induced by intra-articular injection of 3 mg MIA through the patellar ligament of the right knee. Vehicle control rats were injected with an equivalent volume of saline. The LED was irradiated for 15 min/day for a week after 7 days of MIA treatment. To compare with the effect of LED irradiation, the indomethacin was administrated 20 mg/kg twice a week orally after 7 days of MIA treatment. Knee joints were removed and fixed overnight in 10% neutral buffered formalin and decalcified by EDTA for 2 week before being embedded in paraffin. The assessment of OA induction were monitored by knee movement and radiographic finding. Histologic analysis were performed following staining with hematoxylin and eosin, safranin O-fast green, or toluidine blue, picrosirius red, and histologic changes were scored according to a modified Mankin system. Apoptotic cell in tissue sections was detected using TUNEL method. RESULTS: Radiographic examination could not show the differences between the MIA-treated and the MIA-LED-treated rats. In the histologic analysis, however, LED irradiation prevented cartilage damage and subchondral bone destruction, and significantly reduced mononuclear inflammatory cell infiltration and pannus formation. LED irradiation also reduced apoptosis of cartilage cells, but it prevented apoptosis of infiltrated inflammatory cells in synovium. In addition, LED irradiation showed an increase of collagen production in the meniscus. CONCLUSION: These results suggest that the 840 nm LED irradiation would be a suitable non-thermal phototherapy for the treatment of OA, as a cartilage protection and anti-inflammatory modality.

• Membrane Journal
• /
• v.29 no.5
• /
• pp.263-275
• /
• 2019

In the present study, thickness of MOR zeolite membranes was controlled by changing seed size, seeding amount, and aging time of hydrothermal solution, and then effect of membrane thickness on pervaporative ethanol dehydration for 90 wt.% ethanol-water mixture was investigated. First, nanosize MOR zeolite seeds with a diameter of 20 to 30 nm was successfully prepared by planetary milling a laboratory synthesized MOR zeolites and the coating amount was controlled by seed concentration and infiltration volume of coating solution during vacuum-assisted seeding. As seeding amount decreased, membrane thickness was reduced up to around $4{\mu}m$. The MOR zeolite membrane having a thickness of $4{\mu}m$ showed a water/ethanol separation factor of 760 and water flux of $1.0kg/m^2h$. The excellent water flux was due to the reduced membrane thickness which was derived from the nanosize seed. Therefore, it could be concluded that membrane thickness control by using nanosize seed can be a crucial factor to improve pervaporative water flux of MOR zeolite membrane.

• Journal of Korean Society on Water Environment
• /
• v.39 no.2
• /
• pp.142-152
• /
• 2023

Infiltration is a process by which precipitation infuses into subsurface soils. The process determines the surface flow and baseflow volume, and it is one of most important hydrological processes regarding nonpoint source pollution management. Therefore, the Ministry of Environment has developed a guideline to determine the impervious area ratio to understand the hydrological process in administrative districts and watersheds. The impervious area ratio can be determined using land use or land cover maps. Three approaches were explored to determine the impervious area ratio in 25 districts in Seoul. The impervious area ratio was determined by employing the Land registration map and Land property data in the first approach, Land property map in the second approach, and Land cover map in the third approach. The ratio ranged from 38.96% to 83.01% in the first approach, 38.98% to 83.02% in the second approach, and 37.62% to 76.63% in the third approach. Although the ranges did not provide any significant differences in the approaches, some districts displayed differences up to 9.48% by the approach. These differences resulted from the fact that the data were land use or land cover, especially in the area of airport, residential complex area, and school sites. In other words, division of the pervious and impervious areas in an individual plot was not allowed in the Land registration map, while it was allowed in the Land cover map. Therefore, it was concluded that there is a need to revise the guideline so that a reasonable impervious area ratio can be determined in the districts.

• Composites Research
• /
• v.36 no.3
• /
• pp.180-185
• /
• 2023

This paper investigates the impact of fiber dispersion on the internal structure and mechanical strength of SiC_f/SiC composites manufactured using spread SiC fibers. The fiber volume ratio of the specimen to which spread SiC fiber was applied decreased by 9%p compared to the non-spread specimen, and the resin slurry impregnated between the fibers more smoothly, resulting in minimal matrix porosity. In order to compare the fiber dispersion of each specimen, a method was proposed to quantify and evaluate the separation distance between fibers in composite materials. The results showed that the distance between fibers in the spread specimen increased by 2.23 ㎛ compared to the non-spread specimen, with a significant 42.6% increase in the distance between fiber surfaces. Furthermore, the 3pt bending test demonstrated a 49.3% higher flexural strength in the spread specimen, accompanied by a more uniform deviation in test data. These findings highlight the significant influence of SiC fiber dispersion on achieving uniform densification of the SiC_f/SiC matrix and increasing mechanical strength.

• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.28 no.6B
• /
• pp.697-707
• /
• 2008

The grid-based KIneMatic wave STOrm Runoff Model (KIMSTORM) by Kim (1998) predicts the temporal variation and spatial distribution of overland flow, subsurface flow and stream flow in a watershed. The model programmed with C++ language on Unix operating system adopts single flowpath algorithm for water balance simulation of flow at each grid element. In this study, we attempted to improve the model by converting the code into FORTRAN 90 on MS Windows operating system and named as ModKIMSTORM. The improved functions are the addition of GAML (Green-Ampt & Mein-Larson) infiltration model, control of paddy runoff rate by flow depth and Manning's roughness coefficient, addition of baseflow layer, treatment of both spatial and point rainfall data, development of the pre- and post-processor, and development of automatic model evaluation function using five evaluation criteria (Pearson's coefficient of determination, Nash and Sutcliffe model efficiency, the deviation of runoff volume, relative error of the peak runoff rate, and absolute error of the time to peak runoff). The modified model adopts Shell Sort algorithm to enhance the computational performance. Input data formats are accepted as raster and MS Excel, and model outputs viz. soil moisture, discharge, flow depth and velocity are generated as BSQ, ASCII grid, binary grid and raster formats.