• 한국복합재료학회:학술대회논문집
• /
• 한국복합재료학회 2005년도 춘계학술발표대회 논문집
• /
• pp.235-239
• /
• 2005

In this research, we investigated the frequency characteristic of low-velocity impact induced damage signals on graphite/epoxy composite laminates using high-speed fiber Bragg grating(FBG) sensor system. Appling the FBG sensors to damage assessment, we need to study the response of FBG sensors as the damage signals of the different incident angles because FBG shows different directional sensitivity. In order to discriminate an impact induced damage signal from that of undamaged case, drop impacts with different energies were applied to the composite panel with different incident angle to the FBG sensor. Finally, detected impact signals were compared using frequency distributions of wavelet detail components in order to find distinctive signal characteristics of composites delamination.

• 대한기계학회논문집
• /
• 제10권1호
• /
• pp.1-6
• /
• 1986

본 논문에서는 제트유동에 놓인 튜우브 집합체의 진동 발생구조를 깊이 파악하고 일반성 있게 사용할 수 있는 설계 지침을 마련하기 위하여 보다 광법위 하게 수행된 파라미터 연구 내용을 다루었다

• 한국자동차공학회논문집
• /
• 제2권5호
• /
• pp.93-100
• /
• 1994

Friction-induced vibration characteristics of automotive brake lining pad are investigated on the basis of experimental observations from a pin-on-disk type friction-induced vibration experimental apparatus. The measured responses of the experimental apparatus show limit cycles of quasi-harmonics type and beat phenomena due to the velocity dependence of friction force. To deduce the friction coefficient vs. relative velocity Lienard method is adopted with least square fit. It shows Scurve which characterizes a quasi-harmonic vibration. The calculation of amplitudes and friquencies of the limit cycles is done using slowly changing phase and amplitude method. The theoretical and numerical results show fairly good agreements with those of experiments.

• 한국가시화정보학회지
• /
• 제17권1호
• /
• pp.53-59
• /
• 2019

Particle image velocimetry is performed in order to analyze flowfield induced by a dielectric barrier discharge plasma actuator. The velocity vector fields are obtained for the two different input voltage conditions; the voltage 3 and 5 kV at the frequency 10 kHz. The obtained flowfields show that the air is accelerated and its speed increase almost linearly over the covered electrode. The amount of momentum induced by the DBD plasma actuator is estimated from the obtained velocity fields, and the estimated values reasonably agree with the previous experiment.

• KSBB Journal
• /
• 제29권1호
• /
• pp.67-71
• /
• 2014

Planaria were recently reported to be a simple and sensitive model to investigate the mechanistic aspect of seizure and to screen potential anticonvulsants. Using planarian model, we analyzed the pharmacological effect of ukgansan (UGS), an oriental herbal medicine containing seven medicinal herbs, on the planarian locomotor velocity (pLMV) and glutamate-induced seizure-like activity (pSLA). To test whether D. japonica is suitable for studying anti-seizure agents, we investigated the effect of glutamate on pLMV and pSLA in D. japonica. In the present study we first confirmed that pSLA in D. japonica was induced by L-glutamate. Glutamate significantly produced pSLA in a dose dependent manner, but did not affect pLMV. These glutamate-induced paroxysms were decreased by antiepileptic drug, topiramate. A similar inhibitory effect on glutamate-induced pSLA was observed after the treatment of UGS. The present results suggest that UGS and its active constituents possess useful substance inhibiting seizure in planarian and that D. japonica provides a convenient model to search active herbs containing anti-seizure activity.

• Ocean Systems Engineering
• /
• 제12권3호
• /
• pp.301-333
• /
• 2022

Herein, we report meaningful and selective review of the progress made on 'Vortex Induced Vibration (VIV)' and 'Vortex Induced Motion (VIM)' of 'Structures of Specific Shapes (SoSS)' subjected to steady uniform flow and of relevance to/in marine structures. Important and critical elements of the numerical methods, experimental methods, and physical ideas are listed and analysed critically and the limitations of the current state of art of VIV/VIM are discussed in-detail. Our focus and aim are to analyse the existing researches with respect to the application in analyses, design and production of marine structures and the reported reviews centre on these only. We identify the critical and important issues that exist in the current literature and utilise these issues to highlight the challenges that need to be tackled to design and develop new age marine structures that can exist and operate safely in the areas of dominance by the VIV/VIM. Finally, we also identify some areas for future scope of research on VIV/VIM.

• 한국연소학회지
• /
• 제17권1호
• /
• pp.48-57
• /
• 2012

Laminar lifted propane coflow-jet flames diluted with nitrogen were experimentally investigated to determine heat-loss-related self-excitation regimes in the flame stability map and elucidate the individual flame characteristics. There exists a critical lift-off height over which flame-stabilizing effect becomes minor, thereby causing a normal heat-loss-induced self-excitation with O(0.01 Hz). Air-coflowing can suppress the normal heat-loss-induced self-excitation through increase of a Peclet number; meanwhile it can enhance the normal heat-lossinduced self-excitation through reducing fuel concentration gradient and thereby decreasing the reaction rate of trailing diffusion flame. Below the critical lift-off height. the effect of flame stabilization is superior, leading to a coflow-modulated heat-loss-induced self-excitation with O(0.001 Hz). Over the critical lift-off height, the effect of reducing fuel concentration gradient is pronounced, so that the normal heat-loss-induced self-excitation is restored. A newly found prompt self-excitation, observed prior to a heat-loss-induced flame blowout, is discussed. Heat-loss-related self-excitations, obtained laminar lifted propane coflow-jet flames diluted with nitrogen, were characterized by the functional dependency of Strouhal number on related parameters. The critical lift-off height was also reasonably characterized by Peclet number and fuel mole fraction.

• Fibers and Polymers
• /
• 제6권1호
• /
• pp.19-27
• /
• 2005

High-speed melt spinning of syndiotactic polystyrene was carried out using high and low molecular weight poly­mers, HM s-PS and LM s-PS, at the throughput rates of 3 and 6 g/min. The effect of take-up velocity on the structure and properties of as-spun fibers was investigated. Wide angle X-ray diffraction (WAXD) patterns of the as-spun fibers revealed that the orientation-induced crystallization started to occur at the take-up velocities of 2-3 km/min. The crystal modification was a-form. Birefringence of as-spun fibers showed negative value, and the absolute value of birefringence increased with an increase in the take-up velocity. The cold crystallization temperature analyzed through the differential scanning calorimetry (OSC) decreased with an increase in the take-up velocity in the low speed region, whereas as the melting temperature increased after the on-set of orientation-induced crystallization. It was found that the fiber structure development proceeded from lower take-up velocities when the spinning conditions of higher molecular weight and lower throughput rate were adopted. The highest tensile modulus of 6.5 GPa was obtained for the fibers prepared at the spinning conditions of LM s-PS, 6 g/min and 5 km/min, whereas the highest tensile strength of 160 MPa was obtained for the HM s-PS fibers at the take-up velocity of 2 km/min. Elongation at break of as-spun fibers showed an abrupt increase, which was regarded as the brittle-duc­tile transition, in the low speed region, and subsequently decreased with an increase in the take-up velocity. There was a uni­versal relation between the thermal and mechanical properties of as-spun fibers and the birefringence of as-spun fibers when the fibers were still amorphous. The orientation-induced crystallization was found to start when the birefringence reached -0.02. After the starting of the orientation-induced crystallization, thermal and mechanical properties of as-spun fibers with similar level of birefringence varied significantly depending on the processing conditions.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1985년도 하계학술회의논문집
• /
• pp.215-218
• /
• 1985

In this paper, The electron drift velocity was measured from an experimental study of the open end heat pipe system by induced current method as alkali metal vapour was generated in ordinary region of a drift tube. The test condition was alkali metal vapour range from 3.6 to 20.1(Torr), temperature of 667 to 755(K), and E/N of $1{\times}10^{-16}$ to $1{\times}10^{-15}(v.cm^2)$. The results of this study were obtained essentially the same as the extrapolated prediction curve for electron drift velocity in the alkali metal Vapour of J. Lucas et 31 with range of E/N: $1{\times}10^{-17}$ to $1{\times}10^{-16}(v.cm^2)$, and the electron drift velocity was obtained the result an increase in alkali to E/N range from E/N $2.8{\times}10^{-17}$ to $5.6{\times}10^{-16}(v.cm^2)$ (E/N From 2.8 to 50 Td).

• Wind and Structures
• /
• 제32권4호
• /
• pp.309-319
• /
• 2021

The vortex-drift pattern over a girder surface, actually demonstrating the complex fluid-structure interactions between the structure and surrounding flow, is strongly correlated with the VIVs but has still not been elucidated and may be useful for modeling VIVs. The complex fluid-structure interactions between the structure and surrounding flow are considerably simplified in constructing a vortex model to describe the vortex-drift pattern characterized by the ratio of the vortex-drift velocity to the oncoming flow velocity, considering the aerodynamic work. A spring-suspended sectional model (SSSM) is used to measure the pressure in wind tunnel tests, and the aerodynamic parameters for a typical streamlined closed-box girder are obtained from the spatial distribution of the phase lags between the distributed aerodynamic forces at each pressure point and the vortex-excited forces (VEFs). The results show that the ratio of the vortex-drift velocity to the oncoming flow velocity is inversely proportional to the vibration amplitude in the lock-in region and therefore attributed to the "lock-in" phenomena of the VIVs. Installing spoilers on handrails can destroy the regular vortex-drift pattern along the girder surface and thus suppress vertical VIVs.