• The Journal of Engineering Geology
• /
• v.7 no.1
• /
• pp.37-52
• /
• 1997

This paper discribes the practical application of stability analysis on the revetment structures, and four different sections of revetment structures are considered in this study. As a result of stability analysis, the the section of inclined revetment with T.T.P. block shows the highest safety factor against to the sliding failure of cap concrete block, while the section of inclined revetment with rubble stone shows the highest safety factor against to the straight and circular sliding failure. And the safety factors are increased by increasing of the rigidity of covered materials and by decreasing of the slope angle. For the safety factor of overturnning and bearing capacity, the section of inclined revetment structures shows higher safety factors than the section of vertical structures, and the safety factors are increased by decreasing of the slope angle and by increasing of the bottom width of the structures.

• Journal of Environmental Health Sciences
• /
• v.44 no.1
• /
• pp.15-23
• /
• 2018

Objectives: The purpose of this study was to investigate the changes in hazardous pollutant emissions in Korea over the period of 2006-2015. Methods: A survey of hazardous pollutant emissions was conducted through the homepage for 2006-2015. The emission of hazardous chemicals and the health effect was examined using the Annual Report of Air Quality in Korea (2016) and National Health Statistics (2015) as references. Results: Hazardous pollutant emissions increased by 1.1 times over the past decade, and the circulation amount of chemicals was 15% compared to the previous year. $PM_{10}$ concentrations showed a tendency to decrease, but emissions have not declined. In addition, asthma and atopic dermatitis correlated with similar emissions, but allergic disease showed no connection. Conclusion: These results on hazardous pollutant emissions indicate that they have increased. However, no association between emissions and health effects was shown, so more research is needed.

• International Journal of Safety
• /
• v.6 no.2
• /
• pp.38-42
• /
• 2007

As railway signaling system is computerized, the significance on safety demonstration and assessment has been increased. Therefore, railway signaling system should reflect the needs for safety assessment technique. Various studies on safety assessment technique for railway signaling have been made in Europe and standardization of the requirements for safety acceptance has been initiated by IEC. In order to develop and establish the safety assessment techniques for railway signaling in Korea, we try to review safety assessment activities for signaling system via reviewing relevant case studies and consulting with experts. And also we propose the safety assessment activity/methodology for Korean railway signaling system.

• Journal of the Korean Society of Safety
• /
• v.29 no.5
• /
• pp.60-66
• /
• 2014

Depending on the progress of the industrial advances, the use of the thermal oil system in the utility system has been increased, which became an important part in the operation of the plant. However, fire or explosion have occurred due to lack of risk awareness and safety management, more frequently than we know. In this study, by using a questionnaire, actual conditions of safety management in thermal oil system is surveyed and analyzed, it is composed of general, a safety status of the thermal oil system component and the stage of recognition and management in the thermal oil system. These results of this study can be used as basic data to the safety management and the accident prevention of fire or explosion in the workplace.

• Korean Parent-Child Health Journal
• /
• v.8 no.1
• /
• pp.23-36
• /
• 2005

Purpose: The purpose of this study was to determine the effect of an education program promoting attitude, knowledge, and practice of safety for teachers in child care centers. Method: This education was provided at one public health center in Kyunggi Province. One group pretest-post test design was used, and knowledge on safety and emergency care, practice of safety, health belief and self confidence on safety practice were assessed from 74 teachers. Theoretical framework for this program was Pender's health promotion model. Result: After two hours group education session on safety management, knowledge on safety and emergency care was significantly increased and perception on the main cause of injuries was significantly changed. Practice on safety was significantly related to the knowledge, health belief and confidence on safety, and social support. Conclusion: The education program for teachers in child care centers regarding the child safety and emergency care was effective in promoting knowledge and perception on the main cause of injuries of infants.

• Journal of the Korea Construction Safety Engineering Association
• /
• s.51
• /
• pp.75-83
• /
• 2010

In terms of deregulation requests from business, incidents at construction sites are rapidly increasing after reducing the regular safety training hours. Especially, to prevent incidents through safety trainings for construction site workers, who have lots of hazardous tasks than general manufacturing, is not only to protect property of both the companies and the country but also to increase their profits. That is why there are loud voices regarding that the safety training is a core mandatory to prevent industrial incidents. But, most companies, as soon as the deregulation for safety training is implemented, mitigated conducting safety trainings to prevent incidents. With this, theincidents are currently to be increased and caught in a vicious circle of many incidents at the smaller companies because of their absentmindedness regarding safety training due to their poorness as subcontractors of major companies, comparing to major companies. This study explains that incident factors are roughly divided into technical factor, managerial factor, and educational factor. And, we confirmed that the educational factor led by deficiency safety awareness and knowledge was the major factor.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2023.05a
• /
• pp.371-372
• /
• 2023

If the participants in construction site safety management perform their duties in accordance with the provisions of the Industrial Safety and Health Act, the burden on safety managers would be minimal. However, the lack of specific work guidelines for each participating entity and the greater responsibility of the safety and health general manager than the management supervisor have resulted in safety managers' workload being increased due to the problem of management supervisors' neglect of safety management. In this study, we conducted a survey of the safety manager's duties and related documents during the construction project initiation, early stages, ongoing work, and disaster occurrence/investigation, and conducted interviews to improve and enhance the division of duties.

• Safety and Health at Work
• /
• v.10 no.2
• /
• pp.180-187
• /
• 2019

Background: There is considerable evidence that leadership influences workplace safety, but less is known about the relative importance of different leadership styles for safety. In addition, a leadership style characterized by an emphasis and a focus on promoting safety has rarely been investigated alongside other more general leadership styles. Methods: Data were collected through a survey to which 269 employees in a paper mill company responded. A regression analysis was conducted to examine the relative roles of transformational, transactional (management-by-exception active; MBEA), and safety-specific leadership for different safety behavioral outcomes (compliance behavior and safety initiative behaviors) and for minor and major injuries. Results: A safety-specific leadership contributed the most to the enhanced safety of the three different kinds of leadership. Transformational leadership did not contribute to any safety outcome over and above that of a safety-specific leadership, whereas a transactional leadership (MBEA) was associated with negative safety outcomes (fewer safety initiatives and increased minor injuries). Conclusion: The most important thing for leaders aiming at improving workplace safety is to continuously emphasize safety, both in their communication and by acting as role models. This highlights the importance for leadership training programs aiming to improve safety to actually focus on safety-promoting communication and behaviors rather than general leadership. Furthermore, an overly monitoring and controlling leadership style can be detrimental to attempts at achieving improved workplace safety.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.38 no.5
• /
• pp.125-139
• /
• 1996

This study was performed to provide the design method for soil structure which guarantees proper safety with uncertainty of soil parameters. For this purpose, the effect of uncertainty of soil parameters for slope stability was analyzed by Bishop's simplified method and Monte Carlo simulation(MC). And reliability analysis program, RESFEM, was developed by combining elastic theory, MC, FEM, SFEM, and reliability, which can consider uncertainty of soil parameters. For factor of safety(FS) 1.0 and 1.2 by Bishop's simplified method, the probability of failure(Pf) was analyzed with varying coefficient of variation(c.o.v.) of soil parameters. The Pf increased as c.o.v. of soil parameters increased. This implies that FS is not the absolute index of slope safety, and even if FS is same, it has different Pf according to c.o.v. of soil parameters. The RESFEM was able to express the Pf at each element in slope quantitatively according to uncertainty of soil parameters. The variation of Pf with uncertainty of soil parameters was analyzed by RESFEM, and it was shown that the Pf increased as the c.o.v. of soil parameters increased.

• Journal of the Korean Society for Railway
• /
• v.10 no.5
• /
• pp.492-498
• /
• 2007

For the running safety assessment of Saemaul train passing through curves, an analysis model for multibody system has been developed. By using this model and ADAMS/Rail, sensitivity analyses depending on the variation of parameters related to the derailment coefficients have been conducted. At low speed, the derailment coefficient and the unload ratio of right wheel showed higher than left wheel, while those of left wheel showed higher than right wheel at high speed. According to decrease of curve radius, the derailment coefficient and the unload ratio were increased. When the length of transition curve was increased, the derailment coefficient was increased but there was no change on the unload ratio. According to the increase of cant, the derailment coefficient and the unload rate were increased.