• Journal of the Korean Vacuum Society
• /
• v.22 no.3
• /
• pp.162-167
• /
• 2013

An epitaxial layer structure for heterojunction p-InGaP/N-InAlGaP solar cell has proposed. Simulation for current density-voltage characteristics has been performed on p-InGaP/N-InAlGaP structure and the simulation results were compared with p-InGaP/p-GaAs/N-InAlGaP structure and homogeneous InGaP pn junction structure. The simulation result showed that the maximum output power and fill factor have greatly increased by replacing n-InGaP with N-InAlGaP. The thicknesses of p-InGaP and n-InAlGaP were optimized for the epitaxial layer structure of p-InGaP/N-InAlGaP.

• Journal of the Semiconductor & Display Technology
• /
• v.4 no.1 s.10
• /
• pp.43-48
• /
• 2005

Metaloganic chemical vapor deposition, also known as metalorganic vapor phase epitaxy has become one of the main techniques for growing thin, high purity films for compound semiconductors such as GaAs, InP, and InGaAsP. In this study, the distribution of growth rate and composition of InGaAsP, InGaP, and InGaAs films are studied using computational method. The influences of process parameters such as pressure, temperature and precursors' partial pressure on the growth rate and composition distributions are analyzed. The film growth rate is increased in the upstream part according to the increase of temperature but not in the downstream part. The Ga composition in InGaAsP film shows an asymptotic behavior for temperature variation but As composition varies significantly within the temperature range considered in the present study. The overall film growth rates of InGaP, InGaAs and InGaAsP are decreased with increasing the Ga/In ratios of the source gases. Pressure variation does not seem to be a significant parameter to the film growth. Film growth characteristics of tertiary films such as InGaP and InGaAs show similar trends to the quaternary film, InGaAsP.

• Journal of the Korean Institute of Navigation
• /
• v.16 no.2
• /
• pp.21-27
• /
• 1992

Shortening the lasing wavelength(particularly below infrared ; the visible region) of laser diodes is very attractive because it can provide a wide range of applications in the fields of optical information, measurement, sensor, the development of medical instrument, and optical communication through plastic fibers. According to the recent researches on the field, InGaAsP/GaAs was suggested as a material for red-light laser. In this study, in order to grow InGaAsP/GaAs epitaxial layer on InGaAsP/GaAs by LPE, we used GaP and InP two phase solution technique for 670nm and 780 nm region, respectively. Through the X-ray diffraction measurement for the epitaxial layer grown from the experiments, we found that the lattice mismatch of $In_{0.46}Ga_{0.54}As_{0.07}P_{0.93}$/GaAs and $In_{0.19}Ga_{0.81}As_{0.62}P_{0.38}$/GaAs was about +0.3% and +0.1%, respectively.

• Proceedings of the IEEK Conference
• /
• 1998.06a
• /
• pp.401-404
• /
• 1998

Recently, InGaP/GaAs HBTs have been much interested as a potential replacement for AlGaAs/GaAs HBTs because of their superior device and material properties. In this paper, DC characteristics of InGaP/GaAs HBTs and the temperature dependance as well as the reliability were investigated comparing with AlGaAs/GaAs HBTs. As a results InGaP/GaAs HBTs produced the superior performance to AlGaAs/GaAs HBTs.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.6
• /
• pp.282-288
• /
• 2017

In this paper, GaAs/AlGaAs multi-layer structure was grown by liquid phase epitaxy with graphite sliding boat, which can be used as a device structure of a photocathode image sensor. The multi-layer structure was grown on an n-type GaAs substrate in the sequence as follows: GaAs buffer layer, Zn-doped p-type AlGaAs layer as etching stop layer, Zn-doped p-type GaAs layer, and Zn-doped p-type AlGaAs layer. The Characteristics of GaAs/AlGaAs structures were analyzed by using scanning electron microscope (SEM), secondary ion mass spectrometer (SIMS) and hall measurement. The SEM images shows that the p-AlGaAs/p-GaAs/p-AlGaAs multi-layer structure was grown with a mirror-like surface on a whole ($1.25mm{\times}25mm$) substrate. The Al composition in the AlGaAs layer was approximately 80 %. Also, it was confirmed that the free carrier concentration in the p-GaAs layer can be adjusted to the range of $8{\times}10^{18}/cm^2$ by hall measurement. In the result, it is expected that the p-AlGaAs/p-GaAs/p-AlGaAs multi-layer structure grown by the LPE can be used as a device structure of a photoelectric cathode image sensor.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.15 no.7
• /
• pp.713-721
• /
• 2004

This paper presents a high Performance LNA based on InGaP/GaAs HBT for 5.4㎓ WAM band applications. During the past days, InGaP/GaAs HBT has been being used for mainly high power amplifiers, but InCaP/GaAs is recognized as a suitable device for RF single chip. At this point, the research about a high performance LNA based on InGaP/GaAs HBT must be preceded, and in this paper, a excellent linearity and noise characteristics LNA based on InGaP/GaAs HBT is desisted and fabricated. The LNA is integrated in new of 0.9${\times}$0.9$\textrm{mm}^2$ single chip with high Q spiral inductors and MIM capacitors. The proposed LNA is biased at current point for optimum noise figure and gain characteristics, futhermore, excellent linearity is achieved. The proposed LNA shows 13㏈ gain, 2.1㏈ noise figure, and excellent linearity in terms of IIP3 of 5.5㏈m.

• Journal of the Korean Institute of Navigation
• /
• v.15 no.3
• /
• pp.99-106
• /
• 1991

In order to grow InGaAsP epitaxial layer on GaAs by LPE, an accurate phase diagram for In-Ga-As-P quarternary compounds is required. But the short wavelength InGaAsP/GaAs phase diagram for full wavelength range was not yet reported. In this study, therefore, a theoretical calculation has been carried out by using thermodynamic's equation for InGaAsP/GaAs in order to get the relation between the mole fraction of the sloute and solid phase compounds. And the calculation being compared with the dta of Kawanishi et. al, the result has been shown that his phase diagram obtained by the calculation can apply to growing InGaAsP/GaAs by LPE.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.146-147
• /
• 2012

InP 기판위에 자발성장법으로 성장된 InAs 양자점은 $1.55{\mu}m$ 영역에서 발진하는 양자점 반도체 레이저 다이오드 및 광 증폭기를 제작할 수 있기 때문에 많은 관심을 받고 있다. 광통신 대역의 $1.55{\mu}m$ 반도체 레이저 다이오드 및 광 증폭기 분야에서 InAs/InP 양자점이 많은 관심을 받고 있으나, InAs/GaAs 양자점에 비해 제작이 어려운 단점을 가지고 있다. InAs/InP 양자점은 InAs/GaAs 양자점에 비해 격자 불일치가 작아 양자점의 크기가 크고 특히 As 계 박막과 P 계박막의 계면에서 V 족 원소 교환 반응으로 계면 특성 저하가 발생하여 성장이 까다롭다. As 과 P 간의 교환반응은 성장온도와 V/III 에 의해 크게 영향을 받는 것으로 보고되었다. 그러나, P계 InGaAsP 박막 위에 InAs 성장 시 발생하는 As/P 교환반응에 대한 연구는 매우 적다. 본 연구에서는 InGaAsP 박막 위에 InAs 양자점 성장 시 GI (growth interruption)에 의한 As/P 교환반응이 InAs 양자점의 형상 및 광학적 특성에 미치는 영향을 연구하였다. 시료는 수직형 저압 Metal Organic Chemical Vapor Deposition (MOCVD)를 이용하여 $520^{\circ}C$의 온도에서 성장하였다. 그림1(a) 구조의 양자점은 InP (100) 기판위에 InP buffer layer를 성장한 후 InP와 격자상수가 일치하는 $1.1{\mu}m$ 파장의 InGaAsP barrier를 50 nm 성장하였다. 그 후 As 분위기 하에서 다양한 GI 시간을 주었고 그 위에 InAs 양자점을 성장하였다. 양자점 성장 후 InGaAsP barrier를 50 nm, InP capping layer를 50 nm 성장하였다. AFM측정을 위해 InP capping layer 위에 동일한 GI 조건의 InAs/InGaAsP 양자점을 성장하였고 양자점 성장 후 As분위기 하에 온도를 내려주었다. 그림1(b) 구조의 양자점은 그림1(a) 와 모든 조건은 동일하나 InAs 양자점과 InGaAsP barrier 사이에 GaAs 2ML를 삽입한 구조이다. 양자점 형상 특성 평가는 Atomic force microscopy를 이용하였으며, 광특성 분석은 Photoluminescence를 이용하였다.

• Journal of the Korean Ceramic Society
• /
• v.30 no.3
• /
• pp.206-214
• /
• 1993

Coherent precipitation of Zn3P2 during Zn diffusion in a GaInAsP/InP heterostructure was studied using high-resolution transmission electron microscopy. Zn-diffusion-induced intermixing of Ga and In across the GaInAsP/InP heterointerface provided a Ga-mixed InP region which was nearly lattice-matched with Zn3P2 crystal and thus allowed thecoherent precipitation of Zn3P2. The Zn3P2 precipitates were preferentially nucleated at stacking faults which were formed to relax interfacial strain built up by the intermixing. The precipitates were grown to planar epitaxial layer along (100) plane in the lattice-matched region. The TEM images and diffraction pettern revealed that the tetragonal Zn3P2 crystals were coherently matched to the fcc structured GaInP matrix by the {{{{ SQRT {2} $\times$ SQRT {2} $\times$2 }} arrangement. The precipitation reaction of Zn3P2 was explained by an atomic migration model based on the kick-out mechanism.

• Applied Chemistry for Engineering
• /
• v.30 no.4
• /
• pp.499-503
• /
• 2019

Characteristics of solar cells employing a lattice matched GaInP/GaAs quantum well (QW) structure in a single N-AlGaInP/p-InGaP heterojunction (HJ) were investigated and compared to those of solar cells without QW structure. The epitaxial layers were grown on a p-GaAs substrate with $6^{\circ}$ off the (100) plane toward the <111>A. The heterojunction of solar cell consisted of a 400 nm N-AlGaInP, a 590 nm p-GaInP and 14 periods of a 10 nm GaInP/5 nm GaAs for QW structure and a 800 nm p-GaInP for the HJ structure (control cell). The solar cells were characterized after the anti-reflection coating. The short-circuit current density for $1{\times}1mm^2$ area was $9.61mA/cm^2$ for the solar cell with QW structure while $7.06mA/cm^2$ for HJ control cells. Secondary ion mass spectrometry and external quantum efficiency results suggested that the significant enhancement of $J_{sc}$ and EQE was caused by the suppression of recombination by QW structure.