• Corrosion Science and Technology
• /
• 제3권5호
• /
• pp.198-208
• /
• 2004

Although there has been no general agreement on the mechanism of primary water stress corrosion cracking (PWSCC) as one of major degradation modes of Ni-base alloys in pressurized water reactors (PWR's), common postulation derived from previous studies is that the damage to the alloy substrate can be related to mass transport characteristics and/or repair properties of overlaid oxide film. Recently, it was shown that the oxide film structure and PWSCC initiation time as well as crack growth rate were systematically varied as a function of dissolved hydrogen concentration in high temperature water, supporting the postulation. In order to understand how the oxide film composition can vary with water chemistry, this study was conducted to characterize oxide films on Alloy 600 by an in-situ Raman spectroscopy. Based on both experimental and thermodynamic prediction results, Ni/NiO thermodynamic equilibrium condition was defined as a function of electrochemical potential and temperature. The results agree well with Attanasio et al.'s data by contact electrical resistance measurements. The anomalously high PWSCC growth rate consistently observed in the vicinity of Ni/NiO equilibrium is then attributed to weak thermodynamic stability of NiO. Redox-induced phase transition between Ni metal and NiO may undermine the integrity of NiO and enhance presumably the percolation of oxidizing environment through the oxide film, especially along grain boundaries. The redox-induced grain boundary oxide degradation mechanism has been postulated and will be tested by using the in-situ Raman facility.

• 한국지반공학회논문집
• /
• 제15권4호
• /
• pp.185-205
• /
• 1999

유류비축용 지하저장공동의 설계를 위하여 수압파쇄시험에 의한 현지암반내 초기응력 해석이 수행되었다. 부지 내 2개의 경사 시추공에 대해 수행된 금번 시험은 국내 기술진에 의한 지하비축기지 적용의 첫 사례이다. 또한, 경사공 해석기법을 처음으로 도입하여 수직공 해석기법에 의한 결과와 비교, 해석기법의 타당성을 검증함으로써 향후 수압파쇄시험의 적용범위 확대를 기대할 수 있었다. 특히 인근 지역이라도 지형적 또는 지질학적 특성에 따라 초기응력의 크기는 달라질 수 있음을 보여주었으며, 동일 시추공 내에서라도 구조선 등과 같은 뚜렷한 불연속면이 있을 경우초기응력의 방향이 심도에 따라 변화될 수 있음을 보여주었다.

• 한국세라믹학회지
• /
• 제33권2호
• /
• pp.203-213
• /
• 1996

In this study the subcritical crack growth behavior in an Al2O3-SiCw composite has been investigated using in situ fracture technique of applied moment double cantilever beam (AMDCB) specimens indside an SEM. This technique allows the detailed observation of whisker and grain bridging in the crack wake region. The experimental results indicated that the KI-a curve was deviated from the conventional powder law form and that the existed a region where the rate of microcrack growth was decreased with increasing the externally applied stress intensity factor. This behavior could be explained by arising crack growth resistance i.e. R-curve behavior which was associated with crack shielding due to whisker and grain bridging. The R-curve was also analyzed from the KI-a curve data in order to quantify the bridging effect in the Al2O3-SiCw composite.

• 한국자기학회:학술대회 개요집
• /
• 한국자기학회 1997년도 추계연구발표회 논문개요집
• /
• pp.106-107
• /
• 1997

• 한국방사성폐기물학회:학술대회논문집
• /
• 한국방사성폐기물학회 2018년도 춘계학술논문요약집
• /
• pp.117-118
• /
• 2018

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2008년도 춘계 학술발표회 초청강연 및 논문집
• /
• pp.1-6
• /
• 2008

When a saturated clay is sampled in an undisturbed manner from a bore hole, the sample extends vertically and shrinks horizontally under undrained conditions due to stress release. The conventional consolidation test specimen is trimmed from the expanded sample so that its diameter is equal to the inner diameter of the consolidation test ring, this test procedure does not reproduce the actual consolidation behavior. The measurement of sample extension was conducted by means of overcoring method found that the extension strains were 1 to 2%. To simulate the in-situ consolidation behavior, the consolidation test method that uses a specimen with a slightly smaller diameter than the inside diameter of consolidometer so that the specimen expands laterally to the inside of the ring.

• 터널과지하공간
• /
• 제5권2호
• /
• pp.95-103
• /
• 1995

In this paper the stress redistribution around tunnel face was analyzed by using a three-dimensional finite element model. The effects of in-situ stress levels, excavation sequences, stiffness difference between the hard ground and the weak zone on the stress redistributions were considered. Displacement and stress changes at tunnel crown, side wall, and invert were investigated throughout the sequential excavation. To show ground response, percentage of the displacement and stress variations are used as a function of normalized distance that is between the face and monitoring section. Preceding displacements and stress variations were presented to be adopted in the two-dimensional tunnel analysis.

• 터널과지하공간
• /
• 제18권5호
• /
• pp.343-354
• /
• 2008

시추공을 이용한 초기응력 측정을 위한 새로운 방법을 제안하였다. 이 새로운 개념의 측정법은 기본적으로 응력 해방과 파쇄 기술을 결합한 방법이다. 액화질소와 같은 극저온 액체를 이용하여 시추공 주변의 인장 열응력을 유도하여 시추공 주변의 응력을 해방시킬 수 있다. 종국에는 시추공 주변의 인장 강도가 암반의 인장 강도에 초기 지압으로 존재하는 압축 응력의 합을 초과할 때 시추공벽에 균열을 발생시킨다. 이와 같은 개념을 인장 응력으로부터 초기 응력 수준을 평가하는데 적용하기 위한 이론적 분석을 수행하였다. 또한, 제안한 방법의 유효성을 검토하기 위해 FLAC3D를 이용한 열-역학 상호작용 연속체 해석을 수행하였다. 사전 이론적 검토 및 수치해석으로부터 저온 열균열 발생 현상을 이용한 초기 응력 측정법이 시추공벽에서의 인장 균열 형성을 감시하고 시추공벽에서의 균열 개시 시점의 온도를 기록함으로써 초기 응력을 정밀하게 측정할 수 있음을 확인하였다.

• 한국전기전자재료학회논문지
• /
• 제30권9호
• /
• pp.546-550
• /
• 2017

Ferroelectric properties are governed by domain structures and domain wall motions, so it is of significance to understand domain evolution processes under mechanical stress. In the present study, in situ piezoresponse force microscopy (PFM) observation under compressive stress was carried out for a near-morphotropic PZT. Both $180^{\circ}$ and $non-180^{\circ}$ domain structures were observed from PFM images, and their habit planes were identified using electron backscatter diffraction in conjunction with PFM data. By externally applied mechanical stress, needle-like $non-180^{\circ}$ domain patterns were broadened via domain wall motions. This was interpreted via phenomenological approach such that the total energy minimization can be achieved by domain wall motion rather than domain nucleation mainly due to the local gradient energy. Meanwhile, no motion was observed from curvy $180^{\circ}$ domain walls under the mechanical stress, validating that $180^{\circ}$ domain walls are not directly influenced by mechanical stress.

• 한국세라믹학회지
• /
• 제31권12호
• /
• pp.1449-1458
• /
• 1994

A new analytical model which can discribe the relationship between the bridging stress and the crack opening displacement was proposed to investigate the microstructural effect on the R-curve behavior in a polycrystalline alumina. The crack opening displacement according to the distance behind the stationary crack tip was measured using in-situ fracture technique in an SEM, and then used for a fitting procedure to obtain the distribution of bridging stress. The current model and an empirical power law relation were introduced into the fitting procedure. The results indicated that the bridging stress function and R-curve computed by the current model were consistent with those computed by the power law relation. The microstructural factor, e.g., the distribution of grain size, was also found to be closely related to the bridging stress. Thus, this model explained well the interaction effect between the distribution of bridging stress and the local-fracture-controlling microstructure, providing important information for the systematic interpretation of microfracture mechanism including R-curve behavior of a monolithic alumina.