• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.6
• /
• pp.603-607
• /
• 2008

This paper proposes a fast acquisition method using INS velocity and multiple correlators for high speed vehicles. In order to reduce acquisition time in GPS receiver, the method utilizes inertial velocity information and multiple correlators. Search range of the Doppler frequency is reduced by using INS velocity and the number of cells at one search can be increased by using multiple correlators. By using both multiple correlators and the INS velocity in the acquisition, search space can be greatly reduced. Experimental results show that the method gives faster signal acquisition performance than the conventional method.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.8
• /
• pp.739-745
• /
• 2006

This paper presents performance improvement of the INS velocity-adided GPS carier tracking loop. To this end, INS velocity-aided GPS carrier tracking loop was modeled as a feedfoward and a feedback loop system. In the phase tracking loop, it was shown that the tracking error caused by the dynamic motion of the vehicle can be compensated with the aiding of the INS information irrespective of the loop order and bandwidth. However, the signal trcking error increases as the INS error increases. It was also shown that in order to remove the tracking error caused by INS bias error, more than or equal to 2nd order PLL should be used. Experiments were carried out and the experimental results were compared with the analysis results.

• 제어로봇시스템학회:학술대회논문집
• /
• 1996.10b
• /
• pp.867-870
• /
• 1996

Often an INS has to be aligned in navigation. In these cases it is necessary to obtain some reference information on the state of the aligned INS(Slave) such as its position, its velocity of its angular rate. Usually the reference information is velocity which is supplied by another reference INS. In the alignment state the velocity computed by the reference INS(Master) is compared with that computed by the slave INS and the difference which is indicative of the slave misalignment with respect to the master, is processed by a Kalman filter which estimates misalignment as well as the slave gyro and accelerometer error states. The operation of aligning a slave INS with a master INS comparing quantities computed by both INS is known as transfer alignment. The delivery vehicle performs error these maneuvers enable the TA Kalman filter to separate between the tilt errors and the accelerometer biases which otherwise are unobservable. The basic objective this paper is to study the observability enhancement by ship's maneuvering and matching methods during transfer alignment at sea.

• Journal of Institute of Control, Robotics and Systems
• /
• v.7 no.4
• /
• pp.363-363
• /
• 2001

We study on the velocity matching algorithm for transfer alignment of inertial navigation system(INS) using a robust H₂ filter. We suggest an uncertainty model and a discrete robust H₂filter for INS and apply the suggested robust H₂ filter to the uncertainty model. The discrete robust H₂filter is shown by simulation to have better performance time and accuracy than Kalman filter.

• Proceedings of the Korean Institute of Navigation and Port Research Conference
• /
• v.1
• /
• pp.103-107
• /
• 2006

At present, most efforts tend to develop a INS which is only based linear accelerometers, because of the low cost micro-machining gyroscopes lack of the accuracy needed for precise navigation application and possible achieving the required levels of precise for micro-machining accelerometer. Although it was known in theory that a minimum of six accelerometers are required for a complete description of a rigid body motion, and any configuration of six accelerometers (except for a "measure zero " set of six-accelerometer schemes) will work. Studies on the feasible configuration of GF-INS indicate that the errors of angular velocity resolved from the six accelerometers scheme are diverged with time or have multi solutions. The angular velocity errors are induced by the biases together with the position vectors of the accelerometers, therefore, in order to treat with the problem just mentioned, researchers have been doing many efforts, such as the extra three accelerometers or the magnetometers may be taken as the reference information, the extended Kalman filter (EKF) involved to make the angular velocity errors bound and be estimated, and so on. In this paper, the typical configurations of GF-INS are introduced; for each type GF-INS described, the solutions to the angular velocity and the specific force are derived and the characteristic is indicated; one of the corresponding extend Kalman filters are introduced to estimate the angular errors; parts of the simulation results are presented to verify the validity of the equations of angular velocity and specific force and the performance of extend Kalman filter.

• 제어로봇시스템학회:학술대회논문집
• /
• 2002.10a
• /
• pp.33.1-33
• /
• 2002

The INS provides high rate position, velocity and attitude data with good short-term stability while the GPS provides position and velocity data with long-term stability. By integrating the INS with GPS, a navigation system can be achieved to provide highly accurate navigation performance. For the best performance, time synchronization of GPS and INS data is very important in GPS/INS integrated system. But, it is impossible to synchronize them exactly due to the communication and computation time-delay. In this paper, to reduce the error caused by the measurement time-delay in GPS/INS integrated systems, error compensation methods using separate bias Kalman filter are suggested for both the...

• Journal of Positioning, Navigation, and Timing
• /
• v.11 no.2
• /
• pp.59-70
• /
• 2022

In this paper, a GPS/GF-INS integrated navigation system is proposed, in which the high rate attitude aiding signal, the high rate position and velocity aiding of GPS receiver is used for the cube structure of the GF-IMU, effectiveness of the proposed GPS/GF-INS integrated navigation system was shown when the vehicle follows two trajectories, circling and spiraling. Performance evaluation results show that the proposed GPS/GF-INS integrated navigation method gives better navigation outputs when the attitude output of GPS is used and more better navigation outputs are obtained when the rate of GPS aiding signal is higher.

• Journal of Institute of Control, Robotics and Systems
• /
• v.14 no.7
• /
• pp.702-710
• /
• 2008

In this paper, the observability of the INS/GPS integrated system for a land vehicle is analyzed on measurements and different filters with respect to the measurements are designed. In the stationary case, it is shown that horizontal accelerometer biases and vertical attitude errors and gyro biases are unobservable. An 8-state filter is designed based on the observability analysis. When GPS signal is available, a 15-state filter is used with position and velocity measurements. To estimate the INS errors even in the case that GPS signal is blocked a filter is designed in consideration of the non-holonomic constraints of a land vehicle. In this case, the horizontal position and velocity errors and vertical attitude error are unobservable. However, a 12-state filter including the velocity states is designed to estimate the accelerometer biases. When GPS signal recovers, a 9-state filter is used excluding the sensor biases. This paper presents a multi-dimensional filter that switches the four filters according to the usable measurements and maneuver environments. A simulation is carried out to verify the performance of the proposed filter.

• Korean Journal of Applied Biomechanics
• /
• v.28 no.3
• /
• pp.181-185
• /
• 2018

Objective: The purpose of this study was to investigate the effect of types of drive-in initial steps in basketball on technical factors, to provide basic information for the enhancement of basketball skill. Method: Ten men (age: $24.70{\pm}2.26years$; height: $181.00{\pm}5.72cm$; weight: $75.70{\pm}8.23kg$; career length: $10.00{\pm}3.59years$), each with a career length of over five years and no history of injury to the lower extremities within the prior six months, participated in this study. They were asked to perform four types of drive-in movements at $35{\sim}60^{\circ}$, wearing their own shoes, after running from a start line 5 m away and catching a basketball passed by an expert passer. The drive-in movements were measured by eight infrared cameras (Oqus 300, Qualisys, Sweden). Collected raw data were used to calculate total initial step time, displacement, velocity, center of mass (COM) height, and COM velocity. Results: Total initial step displacement and velocity of cross drive-ins (JC, SC) were greater than that of direct drive-ins (JD, SD; p < .05). COM velocity of cross drive-ins (JC, SC) was also greater than that of direct drive-ins (JD, SD; p < .05). Conclusion: Our results indicated that cross drive-ins, regardless of stop step type, are more effective than direct drive-ins. This is because cross drive-ins are technically bold due to less influence from walking violations and double dribble rules in basketball. However, using one-sided movement is too difficult to play in competitive game; therefore, basketball players should develop the ability to choose appropriate movement frequency.

• Journal of Positioning, Navigation, and Timing
• /
• v.8 no.4
• /
• pp.175-181
• /
• 2019

This paper suggests a velocity integration algorithm for Synthetic Aperture Radar (SAR) motion measurement to reduce discontinuity of range error. When using position data from Embedded GPS/INS (EGI) to form SAR image, the discontinuity of the data degrades SAR image quality. In this paper, to reduce the discontinuity of EGI position data, EGI velocity integration is suggested which obtains navigation solution by integrating velocity data from EGI. Simulation shows that the method improves SAR image quality by reducing the discontinuity of range error. INS is a similar algorithm to EGI velocity integration in the way that it also obtains navigation solution by integrating velocity measured by IMU. Comparing INS and EGI velocity integration according to grades of IMU and GPS, EGI velocity integration is more suitable for the real system. Through this, EGI velocity integration is suggested, which improves SAR image quality more than existing algorithms.