• New & Renewable Energy
• /
• v.16 no.4
• /
• pp.83-91
• /
• 2020

In this study, the reusability of the Fenton oxidation solution was evaluated to reduce the cost of the pretreatment process. Biomass was sequential subjected to Fenton oxidation-hydrothermal treatment and enzymatic hydrolysis to produce monosaccharides. The liquid solution recovered after Fenton oxidation contained OH radicals with a concentration of 0.11 mol/L. This liquid solution was reused for a new Fenton oxidation reaction. After Fenton oxidation, hydrothermal treatment was performed under the same conditions as before, and 9.34-13.63 g/L of xylose was detected. This concentration was slightly lower than that of a fresh Fenton oxidation solution (16.51 g/L) but was higher than that obtained by hydrothermal treatment without Fenton oxidation (2.72 g/L). The degradation rate during hydrothermal pretreatment involving Fenton oxidation was 36.02%, which decreased (29.24-31.05%) slightly when the liquid solution recovered after Fenton oxidation was reused. However, the degradation rate increased compared to that measured from hydrothermal treatment without Fenton oxidation (15.21%). Moreover, the yield after enzyme hydrolysis decreased in the following order: fresh Fenton oxidation-hydrothermal treatment (89.64%) > Fenton oxidation with reused solution-hydrothermal treatment (74.84%) > hydrothermal treatment without Fenton oxidation (32.05%).

• Food Science and Biotechnology
• /
• v.18 no.6
• /
• pp.1435-1438
• /
• 2009

Hydrothermal treatment of rice hull was hydrothermal carried out at 105, 110, $121^{\circ}C$ for 15, 30, 60 min, respectively, using a conventional autoclave. Antioxidant activity of the hydrothermal treated rice hull extract was evaluated by determining total phenol contents (TPC), 1,1-diphenyl-2-picylhydrazyl (DPPH) radical scavenging activity (RSA), reducing power, and ABTS RSA. TPC, DPPH RSA, reducing power, and 2,2-azinobis(3-ethylenebenzothiozoline-6-sulfonic acid) (ABTS) RSA of the extract were significantly increased with increasing treated temperature and time. For example, hydrothermal extracts at $121^{\circ}C$ for 60 min increased the TPC, DPPH RSA, reducing power, and ABTS RSA to 0.840 mg/mL, 64.77%, 1.437, and 92.11%, respectively, while those of the extracts treated at $105^{\circ}C$ for 60 min were 0.508 mg/mL, 51.23%, 0.819, and 45.22%, respectively. The results indicated that hydrothermal treatment of rice hull was very effective to increase phenolic compounds and antioxidant activity of rice hull extract.

• Korean Journal of Materials Research
• /
• v.22 no.8
• /
• pp.397-402
• /
• 2012

Morphological control on hydroxyapatite crystals has attractive prospects in research to clarify the effects of crystal planes on biological performance. Hydrothermal processing is known as a typical type of processing for fabricating well-grown crystals with unique morphology. The purpose of the present study is to examine the feasibility of well-crystallized crystals with oriented structures through hydrothermal treatment of calcite. A single crystal of calcite was applied to hydrothermal treatment in a phosphate solution at $160^{\circ}C$. Rod-shaped hydroxyapatite crystals with micrometer-size were formed on the {100} face of calcite after treatment, while nanometer-sized hydroxyapatite crystals were formed on the (111). The hydroxyapatite crystals formed on each plane were not morphologically changed with increasing treatment periods. An oriented structure of rod-shaped hydroxyapatite was constructed after hydrothermal treatment of {100} planes on the calcite single, while such orientation was not observed on the (111) plane after the treatment. The layer of hydroxyapatite formed on the {100} plane was thicker than that of the (111) plane. The {100} plane of calcite shows a higher reactivity than that of the (111) plane, which results in rapid crystal growth of hydroxyapatite. The difference in the morphology of the formed hydroxyapatite was governed by the reactivity of each crystal plane exposed to the surrounding solution.

• Korean Journal of Materials Research
• /
• v.14 no.12
• /
• pp.876-884
• /
• 2004

This study was to investigate whether the bioactivity of the anodized and hydrothermally treated Ti-6Al-7Nb alloy were affected by the time of hydrothermal treatment. Anodizing was performed at current density 30 $mA/cm^2$ up to 300 V in electrolyte solutions containing $DL-{\alpha}-glycerophosphate$ disodium salt hydrate $(DL-{\alpha}-GP)$ and calcium acetate (CA). Hydrothermal treatment was done at $300^{\circ}C$ for 30 min, 1 hr, 2 hrs, and 4 hrs to produce a thin film layer of hydroxyapatite (HA). The bioactivity was evaluated from HA formation on the surfaces in a Hanks' solution with pH 7.4 at $36.5^{\circ}C$ for 10, 20, and 30 days. Anodic oxide films were porous with pore size of $1\sim4{\mu}m\;and\;3\sim4{\mu}m$ thickness. The anodic oxide films composed with strong anatase peak with presence of rutile peak, and showed the increase in intensity of anatase peak after hydrothermal treatment. It was shown that the intensity of anatase peak increased with increasing the time of hydrothermal treatment but was no difference in rutile peak. The corrosion voltage was the highest in the group of hydrothermal treatment for 2 hrs (Ecorr: -338.6 mV). The bioactivity in Hank's solution was accelerated with increasing the time of hydrothermal treatment.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.15 no.4
• /
• pp.145-151
• /
• 2005

Color enhancement of African rubies with dark red was carried out by the heat treatment and the hydrothermal treatment method respectively. The heat treatment method brought about an adverse effect causing the color to be deteriorated. However, the hydrothermal treatment method enhanced its color and clarity. The hydrothermal treatment conditions for color enhancement of them were as follows: solvent: 0.9M $Na_2CO_3-1M\;K_2CO_3$, temperature: $450^{\circ}C$, duration: 48 hrs, filling: $30\%$, pressure: 375 atm. As the results of characteristics for African rubies obtained under these conditions, it was known that the amount of $Cr^{3+},\;Fe^{3+},\;Ti^{4+}$ was reduced after the hydrothermal treatment from the ICP/MS and XRF analyses. Also, it was found that the red color from the colorimeter analyses was getting lighter. These results were consistent with the PL analysis showing that the intensity of the luminescence peak generated by the electron transition of $Cr^{3+}$ ion became lower after the hydrothermal treatment compared with the non-treated rubies.

• Journal of the Korean Chemical Society
• /
• v.59 no.3
• /
• pp.238-245
• /
• 2015

The crystallization and morphology change of amorphous titanias by hydrothermal treatment have been investigated. The amorphous titanias were prepared by pure water hydrolysis of two different precursors, titanium tetraisopropoxide (TTIP) and TTIP modified with acetic acid (HOAc) and characterized prior to hydrothermal treatment. In order to avoid complicate situation, the hydrothermal treatment was performed in a single solvent water with and without strong acids at various temperatures. The effects of strong acid, temperature and time were systematically investigated on the transformation of amorphous titania to crystalline TiO₂ under simple hydrothermal condition. Without strong acid the titanias were transformed into only anatase phase nanoparticle regardless of precursor type, temperature and time herein used (up to 250 ℃ and 48 hours). The treatment temperature and time effected only on the crystalline size, not on the crystal phase et al. However, it was clearly revealed that the strong acids such as HNO₃ and HCl catalyzed the formation of rutile phase depending on temperature. HCl was slightly better than HNO₃ in this catalytic activity. The morphology of rutile TiO₂ formed was also a little affected by the type of acid. The precursor modifier, HOAc slightly reduced the catalytic activity of the strong acids in rutile phase formation.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.14 no.2
• /
• pp.73-77
• /
• 2004

The color enhancement for natural Zambian amethyst of low quality was carried out by the hydrothermal treatment method. The hydrothermal treatment conditions were as follows: reaction temperature; $300^{\circ}C$, duration; 30 hrs, filling; 40%, solvent; 6 M-HCI solution. The reddish purple amethyst of high quality was obtained under these conditions. From the result of ICP/AES, it was known that color enhancement was affected by a Fe elemental content to exist in the inside of natural Zambian amethyst. Also, from the result of UY-VIS-NIR, it was shown that the absorption peak at 550 nm after hydrothermal treatment is slightly lower than those of non-treated natural Zambian amethyst. In this study, it was known that hydrothermal treatment method was a way to suitable for increase of commercial value of natural Zambian amethyst.

• The Transactions of the Korean Institute of Electrical Engineers P
• /
• v.58 no.4
• /
• pp.526-531
• /
• 2009

This paper suggests the dehydration and RDF(Refuse Derived Fuel) production of organic sludge, livestock manure and sewerage sludge causing environmental problems, with hydrothermal pre-treatment process. The renewable technology from the organic wastes must involve short treatment time required, reusable energy source, anti-odor and viruses, low cost for the treatment, and well-fertilization. The hydrothermal pre-treatment process promotes to evaporate moisture in the sludge after being shortly treated in a reactor, which is supplied steam and heat by an external boiler, due to the pressure with steam breaks the cell walls of the sludge, so this process removes the internal moisture of the cell. Then, the treated sludge(solid-state) is mixed with waste vinyls called RDF(6,706kcal/kg).

• Journal of Hydrogen and New Energy
• /
• v.20 no.5
• /
• pp.439-446
• /
• 2009

This paper investigates the dehydration and RDF (Refuse Derived Fuel) production of organic wastes, livestock manure and sewerage sludge with pressurized hydrothermal treatment process. The renewable technology for the organic wastes must involve short treatment time required, reusable energy source, anti-odor and viruses, low cost for the treatment, and well-fertilization. The pressurized hydrothermal treatment process promotes to evaporate moisture in the waste after being shortly treated in a reactor, which uses steam and heat supplied by an external boiler. By the pressurized steam, the cell walls of the waste break and effectively release the internal moisture. Then, the dried waste can be mixed with waste vinyls to produce RDF with a higher heating value as high as 6,700 kcal/kg.

• Bulletin of the Korean Chemical Society
• /
• v.24 no.5
• /
• pp.613-616
• /
• 2003

Effect on hydrothermal treatment of lamellar vanadium oxides was investigated and the formation of hexagonal and cubic mesophase was found. This lamellar materials were prepared by mixing of cetyltrimethylammonium-bromide and pH-controlled sodium metavanadate solution. Thermal method and UV/O₃treatment were applied to extract organic template. The structure of resulting product was studied by powder X-ray diffraction and transmission electron microscopy (TEM).