• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.8 no.2
• /
• pp.239-244
• /
• 2004

In this paper, we have developed a frequency mixer which can be used as a microwave phase conjugator in the LS band retrodirective antenna system. The mixer as a phase conjugator must have an If signal of which frequency is nearly as high as that of an RF signal, so this fact brings difficulty in the combination of input signals and the design of impedance matching circuit. The circuit configuration is chosen to be of the gate mixer using a pseudomorphic HEMT device. The operating frequencies are 4.00 ㎓, 2.01 ㎓, and 1.99 ㎓ for LO, RF, and IF, respectively. Conversion gain is measured to be 12.5 ㏈ and 1 ㏈ compression point -34 ㏈m at the LO power of -7 ㏈m. The mixer fabricated in this research is the single-ended type, where RF leakage signal appears inevitably at the If port because RF and If frequencies are almost the same. The circuit topology suggested here can be applied directly to the design of balanced-type mixers and phase conjugators.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.28 no.11A
• /
• pp.921-928
• /
• 2003

This paper propose a new design of directional couplers with the high directivity. The directional coupler is used to check and verify the power, frequency and antenna reflection of a signal at transmission station for the mobile communications. The performance index of the directional coupler is to which the coupling is strong to reduce the effect on the transmitted power and the directivity is high to suppress the interference of the reflected signals and reduce the nor in the communication. Then, the architectures to gain the high directivity and the studies to get the strong coupling have been proposed However, the conventional architectures lot the high directivity and strong coupling have the directivity by about 20㏈ and the difficulty to achieve the higher directivity than 40㏈ suitable for IMT-2000 [1]. This paper proposes an architecture of the directional coupler which is based on the grounding composed of the strip lines and the comparison results with the conventional directional couplers. The comparison results show that the proposed directional coupler has the directivity more than 40 ㏈ and is adequate for the 2.05GHz IMT-2000

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.2B
• /
• pp.176-183
• /
• 2011

In this paper, we propose the implementation and performance analysis of power line communication based on SISO/MIMO-OFDM which focuses on high speed data transmission in smart grid and future power line grid. We employ Zimmermann frequency model and Middleton Class A model as the multipath power line fading channel and impulse noise channel, respectively. In this paper, in order to improve the three-phase or single-phase PLC performance, we introduce a new MRC (called a&f-MRC) which effectively sums up multiple antenna diversity gain and multipath fading diversity gain. Via simulation, we prove the performance advantage over existing SISO/MIMO systems. In addition, we offer the tradeoff on system design through comparing with MRC, EGC and SC.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.36 no.12C
• /
• pp.764-773
• /
• 2011

Despite enormous performance gain with multi-antenna transmission in the single cell environment, its gain diminishes out in the multi-cell environment due to interference. It is also very hard to solve the efficient downlink beamforming with low complexity in multi-cell environment. First, this paper shows that the asymptotically sum rate optimal downlink beamformings at low and high SNR are maximum ratio transmit (MRT) and zero forcing (ZF) beamforming in the multi-cell system, respectively. Secondly, exploiting the asymptotically optimal downlink beamforming, we develop simple two types of near optimal downlink beamforming schemes having the form of minimum mean squared error (MMSE) beamforming obtained from the dual uplink problem. For each type, three different subclasses are also considered depending on the computational complexity. The simulation results show that the proposed near optimum algorithms provide the trade-off between the complexity and the performance.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.20 no.7
• /
• pp.423-429
• /
• 2019

Recently, a variety of methods for the performance improvement of ultra-high speed wideband wireless transmission systems have been suggested. This paper proposes a space-frequency (SF) block coded single side band (SSB) single carrier (SC)-frequency division multiple access (FDMA) transmission system. In the proposed SSB SC-FDMA system, SF block code is implemented with the complex conjugates, which are formed from discrete Fourier transform (DFT) spreading of pulse amplitude modulation (PAM) signals. As a result, transmit diversity gain can be obtained in the proposed SF block coded SSB SC-FDMA system without any significant increase of the system computational complexity. The simulation result shows that the signal-to-noise power ratio (SNR) performance of the proposed SF block coded SSB SC-FDMA system is approximately 4 dB better than the SNR performance of the conventional SSB SC-FDMA system with single transmit antenna at a symbol error rate (SER) of $10^{-2}$.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.18 no.5
• /
• pp.1243-1248
• /
• 2014

In General, LPI radar's detection probability by ES equipments is lower than that of conventional pulsed radar because of very low transmitting power and high antenna gain etc. LPI radar is a kind of RF stealth technique such as RCS reduction design. Therefore the ultimate goal of LPI radar is detection probability reduction by opponent. If one of the two, RCS value or LPI radar performance is not sufficient, own platform will be found first by opponent. In this paper, some considerations are suggested for detection probability reduction.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.29 no.1
• /
• pp.32-35
• /
• 2018

Massive multiple-input multiple-output (MIMO) transmission is an essential technique for achieving the high bandwidth efficiency required in 5G mobile communication systems. Various forms of arrays can be used as the number of antenna elements increases for massive MIMO transmission. In this letter, we propose a beamforming algorithm applicable to multiuser MIMO transmission using uniform circular arrays. By employing quasi-orthogonal beam pairs obtained from the inter-beam correlation information, we minimize inter-user interference and evaluate the resulting performance gain.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.1A
• /
• pp.58-64
• /
• 2006

A 900-MHz band transceiver has been developed for RFID reader applications. In the transmitter, a GaAs SPST switch is used for high speed switching and low power consumption. In the receiver, a double balanced mixer is used to compress even-harmonic products. The ASK demodulator which consists of an active filter and comparator is used to reject the unwanted in band interferers. The transceiver produces a maximum transmitting power of 30 dBm and exhibits an 5 m communication range with a 6-dBi gain antenna.

• Journal of Communications and Networks
• /
• v.10 no.2
• /
• pp.186-193
• /
• 2008

A two-hop multiple-input multiple-output (MIMO) relay network which comprises a multiple antenna source, an amplify-and-forward MIMO relay and many potential users are studied in this paper. Consider the achievable sum rate as the performance metric, a joint design method for the processing units of the BS and relay node is proposed. The optimal structures are given, which decompose the multiuser MIMO relay channel into several parallel single-input single-output relay channels. With these structures, the signal-to-noise ratio at the destination users is derived; and the power allocation is proved to be a convex problem. We also show that high sum rate can be achieved by pairing each link according to its magnitude. The sum rate of three broadcast strategies, time division multiple access (TDMA) to the strongest user, dirty paper coding (DPC), and beamforming (BF) are investigated. The sum rate bounds of these strategies and the sum capacity (achieved by DPC) gain over TDMA and BF are given. With these results, it can be easily obtained that how far away TDMA and BF are from being optimal in terms of the achievable sum rate.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.10A
• /
• pp.974-983
• /
• 2007

In this paper, a low complexity subcarrier allocation scheme is proposed for multiuser MIMO-OFDM systems with zero-forcing beamformer (ZFBF) so that the total transmit power can be minimized satisfying given target data rate. Since the optimal method requires very high computational complexity, we propose a low complextiy suboptimal method. Using the fact that the effective channel gain is proportional to the orthogonallity of channels of multiplexed users, a user set with the highest orthogonality of channel among users is assigned to each subcarrier in order to minimize required transmit power. The numerical results show that the proposed suboptimal method can reduce computational complexity with little performance loss.