• 한국지하수토양환경학회:학술대회논문집
• /
• 한국지하수토양환경학회 2003년도 추계학술발표회
• /
• pp.192-195
• /
• 2003

The hight density sludge process (HDS) is a process that has been developed to achieve greatly increased sludge densities compared to those resulting from conventional pH modification systems. This study was carried out to apprehend variation of sludge properties and removal of metals during recycling of the sludge. The principal neutralization and settlement took place in neutralization beaker and mass cylinder. Sludge was recycled, as a volumetric ratios of 20%, 40% and 60%. The pH was controlled in neutralization tanks near 9.5. The average lime consumption rate was about 10g per L of AMD. The increment of sludge density was correlated with the volumetric ratios of recycled sludge.

• KSBB Journal
• /
• 제25권1호
• /
• pp.67-72
• /
• 2010

In this study, we developed a comprehensive correlation for better prediction of the activated sludge concentration in the relationship between measurement of optical density by the Beer's law and sludge properties. Effects of activated sludge properties, which are sludge types and anaerobic storage time, show that absorbance deviation for sludge properties decreased on wavelength of light source near to 950 nm. We also developed a method to measure limitation with non-linear correlation on the measurement of high concentration by the Beer's law using a double layer probe cell and empirical equations.

• 한국물환경학회지
• /
• 제22권1호
• /
• pp.97-103
• /
• 2006

Excess sludge treatment and disposal currently represent a rising challenge for domestic or wastewater treatment plants due to economic, environmental and regulation factors. Conventional gravity sedimentation process has been widely used in sludge thickening. The operation method of the process is very simple, but the process requires long detention time for sludge thickening, uses polymers, and shows low sludge thickening efficiency. To solve the problems, we studied on DAF (Dissolved Air Flotation) system. We use bulking sludge of a paper manufacturing plant. The effects of parameters such as SVI (Sludge Volume Index), storage time, initial concentration and wet density of excess sludge were examined. The results showed that the more SVI was low, the more sludge was thickened. As storage time goes by, SVI was increased and thickening performance was deteriorated. In order to improve flotation performance at high concentration, high recycling ratio and pressure did not increase the concentration due to thickening limitation. The addition of 0.8 g/L of loess was increased flotation efficiency of 1.41 times.

• Journal of the Korean Wood Science and Technology
• /
• 제15권2호
• /
• pp.99-104
• /
• 1987

Fiber mats were made at various density levels, using fibers from papermill sludge, ricestraw and various mixtures of the two. The paper mill sludges were collected from Moorim Papermill Co, and Jeonjoo Papermill Co. They were soaked in the liquid sulfur compounds, sulfur-tall oil and sulfurpolyester compounds, and made into fiber-reinforced, sulfur-based composition board. Under optimum conditions of fiber mat preparation and saturation with molten sulfur and modified sulfur, the Young's moduls of the manufactured tiber-reinforced composition board are superior to those of conventional wood-based composition boards. For example, the moduli of elasticity of the composition board made from papermill sludge, with a density of 0.40gm/$cm^3$, were greater than 1,400,000psi as compared 800,000psi for high density hardboard(1.28gm/$cm^3$). The modulus of rupture of the best reinforced composition board manufactured was over 9000psi, comparable to 6000psi of high density hardboard. The proposed Bryant and Lee's theory, "Modified Rule of Mixtures" can be applicable to the nonoriented and short fibrous composition board, when it was modified from "Rule of Mixtures" established by Paul an Jones, and supplemented by Smith and Cox's theory, In the Bryant and Lee's theory of $E_c=\frac{1}{3}aE_fV_f+bE_mV_m$, the constants "a" and "b" for the composition boards made from papermill sludge and the mixtures of ricestraw and the sludge were identified to be in the ranges of 3.29~3.54 and -2.47~-2.80 respectively.

• 산업진흥연구
• /
• 제6권4호
• /
• pp.1-9
• /
• 2021

본 연구는 정수슬러지의 활용을 위하여 경량골재를 제조하고, 그 물성을 확인하기 위하여 경량골재의 특성과 그 활용가능성을 확인하는 것이다. 경량골재 원료로써 특성을 알아보기 위하여 화학조성 및 열적 특성에 대하여 검토하였다. 급속소성법을 이용하여 골재를 소성하고 물성을 측정하였다. 정수슬러지는 높은 강열감량을 가지고 있었으며, 높은 내화도를 가지고 있었다. 정수슬러지를 30wt% 첨가하였을 때 1,150~1,200℃의 온도에서 경량화되는 것을 확인할 수 있었고, 1200℃이상의 온도에서 밀도 0.8이하의 초경량골재도 제조할 수 있었다. 일반골재를 대체하여 콘크리트에 적용 시 28일 강도가 200~600kgf/cm²를 갖는 공시체를 얻을 수 있었으며, 여과재 시험 시 일반모래와 동등 이상의 성능을 나타냈다.

• 상하수도학회지
• /
• 제14권1호
• /
• pp.62-75
• /
• 2000

Most of biological treatment to remove contaminants in municipal wastewater have been conducted by activated sludge process. But, the process have several probIems such as enormous site needed for construction of treatment facilities, unstable treatment due to limited ability to control load fluctuation, frequent sludge bulking and appearance of lots of surplus sludge. In this study, the experiments were performed through submerging biofilm of PEPP media in existing aeration tank with raw water from municipal wastewater treatment plant and then submerging PVDC and PEPP media, different from shape and chemical peculiarity in anoxic reactor. Throughout the experience, nutrient removal efficiency according to HRT, nitrogen phosphorous removal efficiency, behavior of nitrogen and dewatering efficiency have been compared and analysed with those of activated sludge process. As the results, BOD removal efficiency according to BOD volumetric load and F/M ratio was not found any differency in two processes, but was decreased below 90% as going along the condition of high load in activated sludge process. Kinetic coefficient was $K_{max}=1.162day^{-1}$, $K_s=53.77mg/L$, $Y=0.166mgVSS/mgBOD_{rem}$. and $K_d=0.019day^{-1}$. It was found that the removal efficiency, even though in aerobic condition, in biofilm process equipped anoxic reactor was higher than the one in activated sludge process within the range of 70~80%, and became better as HRT increased. Phosphorous removal efficiency was not found any differency in two processes. In biofilm process, treament efficiency even in conditions of high load was not decreased, because the biomass concentration could be maintained in high condition compared with activated sludge process. As HRT increased, suspended and attached biomass was increased and the other hand, F/M ratio was decreased as biomass' increasing. Biomass thickness was increased. from $10.43{\mu}m$ to $10.55{\mu}m$ as HRT increased and density of biomass within $40.79{\sim}41.16mg/cm^2$. The results also present that the dewatering efficiency of sludge generated in biofilm process was higher than in activated sludge process, and became better as HRT increased.

• Journal of the Korean Wood Science and Technology
• /
• 제22권2호
• /
• pp.37-45
• /
• 1994

The possibility of reusing the paper sludge as a raw material of composition board mixed with cement was investigated. For the measurement of physical and mechanical properties, wood coment board and sludge combinend cement boards were fabricated with the three weigh ratios of paper sludge 10 % (SI), 20 % (S II) and 30 % (S III) to cement weight. For adding the cement hardning, $CaCl_2$ was also added to each mixed paste with the ratio of 1 %, 3 % and 5 % to cement weight, respectively. Crystal formation in paper sludge-, wood-cement composites was observed by scanning electron microscope. The results were summarized as follows. 1. Density and partial compressive strength of each specimens were relatively high in the order of sludge I, sludge II, Korean pine, Italian poplar and sludge III, sludge I, Korean pine, sludge II, Italian poplar and sludge III. 2. The mechanical properties of sludge-cement boards (S I and II) were higher than that of wood-cement boards prepared with Korean pine and Italian poplar. But the mechanical properties of wood-cement boards were improved by the adding of $CaCl_2$. 3. Water absorption and thickness swelling were increased with increase of sludge content to cement weight. 4. In SEM observation, sludge-cement composites showed sufficiently formed crystals but wood-cement composites showed poorly formed crystals.

• 청정기술
• /
• 제8권2호
• /
• pp.61-66
• /
• 2002

알루미늄 제조 공정에서 부산물로 발생되는 적니와 제지슬러지를 이용하여 휘발성 유기화합물을 제거하기 위한 흡착제 개발 연구를 수행하였다. 흡착제의 제조를 용이하게 하기 위해 고밀도폴리에틸렌과 저밀도폴리에틸렌을 이용하였다. 흡착제에 고밀도폴리에틸렌을 사용한 것이 저밀도폴리에틸렌을 사용한 것 보다 비표면적 값이 높아서 흡착량이 증대되었다. 제조된 흡착제의 비표면적 값이 활성탄과 비교하여 상대적으로 매우 낮은 값 ($10^{-2}$에서 $10^{-3}$ 정도)을 가졌는데 이는 흡착제 제조시 제지슬러지를 완전히 분해하는데 충분한 시간을 주지 못하였기 때문으로 생각된다. 그러나 제조된 흡착제의 흡착용량(단위 표면적당 흡착량)은 활성탄에 비하여 약 10배에서 100배 정도의 높은 값을 가졌다. 그러므로 제조된 흡착제가 활성탄과 같은 성능을 갖기 위해서는 비표면적을 증대시키는 것이 중요하다.

• 한국세라믹학회지
• /
• 제51권5호
• /
• pp.492-497
• /
• 2014

Artificial fine aggregates (denoted AFA) were fabricated using spent bleaching clay (denoted SBC) generated from processed vegetable oil and stone sludge (denoted SS) produced from crushed aggregate manufacturing materials for use as functional construction materials. Each raw material was crushed to particle size finer than $150{\mu}m$, and fine spherical pellets of approximately 1 ~ 4 mm in diameter were prepared by a pelletizing process. The physical properties of the AFA were measured with different types of sintering equipment. A new type of vertical furnace that sinters fine aggregates in a fluidized bed at high temperatures was designed and tested. AFA sintered in a rotary kiln at $1125^{\circ}C$ showed a bulk density of $1.5g/cm^3$ and a water absorption of 16%. AFA sintered in the vertical furnace at $1125^{\circ}C$ showed a bulk density of $1.9g/cm^3$ and water absorption of 8.5%. The bulk density of the AFA sintered in the vertical furnace showed a bulk density 27% higher and water absorption 47% lower than those of AFA sintered in the rotary kiln.

• 에너지공학
• /
• 제21권2호
• /
• pp.194-201
• /
• 2012

본 연구에서는 소화가스 효율 향상을 위한 전처리로 전기분해를 이용한 하수슬러지 가용화 연구를 수행하였다. 전기분해 처리시간과 전류밀도가 증가함에 따라 SCOD 농도가 증가하였고, 처리시간 60분에 SCOD, TN, TP가 각각 7.4배, 1.9배, 1.3배로 가장 높은 증가율을 보였다. 하수슬러지 초기 pH별 전기분해 처리효과는 강산성, 강알칼리성에서 가용화율이 높았고, 특히 pH 12에서 32.9%의 높은 가용화율을 보였다. 이상의 결과는 전기분해에 의한 직 간접산화작용으로 인해 슬러지의 플록, EPS 구조가 파괴되어 미생물이 이용가능한 유기물들이 증가되었음을 의미한다.