• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.05a
• /
• pp.759-763
• /
• 2004

High frequency noise of fuel pump has does claimed by user. But high frequency of fuel pump can't heat in the car. But this noise Is an offensive noise outside car. In this study is noise reduction used to mass law. Especially high frequency (for example BPF(blade pass frequency)) is influenced of this law. In detail used to transmission and add to mass according to mass law, reduced particular noise. As a result high frequency is down until can't perception.

• 한국신재생에너지학회:학술대회논문집
• /
• 2005.06a
• /
• pp.117-122
• /
• 2005

This paper proposes an inverter for the grid-connected photovoltaic system based on the transformer-less inverter. This system consists of a high frequency converter bridge, high frequency transformer, diode bridge rectifiers, a DC filter, a low frequency inverter bridge, and an AC filter. The high frequency converter bridge switching at 20kHz is used to generate bipolar PWM pulse, and the high frequency transformer raise its voltage twice, which is subsequently rectified by diode bridge rectifiers to result in a full-wave rectified sine wave. Finally, it is unfolded by a low frequency inverter bridge to result in a 60Hz sine wave power output. Even though the high frequency link system needs more power semiconductors, a reduced size, light weight, and saved parts cost make this system more comparative than the other systems due to elimination of 60Hz transformer.

• Journal of Acupuncture Research
• /
• v.25 no.4
• /
• pp.11-29
• /
• 2008

Objectives : The purpose of this study was to observe the effects of acupuncture and electro-acupuncture at $LI_4$ on intestinal motility in rat. Methods : We made over-activated state of intestinal motility with carbachol and suppressed state of intestinal motility with loperamide in rat and carried out needle retention acupuncture, low frequency electro-acupuncture and high frequency electro-acupuncture at $LI_4$ or sham point in rat devided into pre-treatment group and post-treatment group. and we resulted as follow for measuring charcoal travel rate to observe intestinal motility. Results : 1. Any of needle retention acupuncture, low frequency electro-acupuncture and high frequency electro-acupuncture at $LI_4$ have no significant influences on intestinal motility of rat in normal state. 2. All of the pre-treatment and post-treatment of needle retention acupuncture, low frequency electro-acupuncture and high frequency electro-acupuncture didn't significantly decrease intestinal motility in rat which over-activated with carbachol. 3. Pre-treatment of needle retention acupuncture and high frequency electro-acupuncture significantly increased intestinal motility in rat which suppressed with loperamide. 4. Post-treatment of needle retention acupuncture, low frequency electro-acupuncture and high frequency electro-acupuncture significantly increased intestinal motility in rat which suppressed with loperamide. Conclusions : These results suggest that acupuncture on $LI_4$ have preventive effect and therapeutic effect on suppressed intestinal motility, and especially high frequency electro-acupuncture is more effective.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.20 no.1
• /
• pp.51-58
• /
• 2015

In order to decrease the size of a switch mode power supply, high switching frequency can be an efficient way to reduce the size of passive components in the converter. In this paper, a 500-kHz high-frequency LLC resonant converter is proposed with an accurate design method of magnetizing inductance, as well as the relationship between the switching frequency and the size of the passive components. Simulation and experimental results are presented to verify the proposed methods and equations, including the temperature data of each passive and active device of the converter. Using those results, dominant power losses in the prototype converter under 500-kHz high-frequency operation are investigated, compared with the results from a 100-kHz converter. In addition, operating waveforms and power conversion efficiency will be shown to obtain design considerations for the high switching frequency LLC resonant converter.

• Proceedings of the Korean Society of Tribologists and Lubrication Engineers Conference
• /
• 2002.10b
• /
• pp.283-284
• /
• 2002

Ball bearings (BB) are generally used in spindle of‘ disk drives at present, but they have been known that BB generate high frequency vibration. Fluid dynamic bearings (FDB) having high-rotational accuracy and small vibration characteristics have been developed as next generation spindles. Especially. a ferro fluid bearing (FFB) spindle has the advantage to prevent leakage and dispersion of lubricating oil using a ferro seal. In this study, we measured damping characteristics and frequency characteristics of these bearing spindles using a high-frequency vibration base. High frequency excitation was added to these bearing spindles mounted on the vibration base, and we proved that FFB and FDB spindles have effective damping.

• Journal of the Korean Society of Visualization
• /
• v.9 no.4
• /
• pp.35-40
• /
• 2011

An experimental investigation of the characteristic of non-premixed lifted flames with nozzle hole-tone of high-frequency has been performed. Before the fuel was supplied to nozzle, the fuel was supplied through a burner cavity which was located under the nozzle. The fuel passed through the excitation cavity under the influence of the high-frequency affects the lifted flame characteristics. The measurements were performed in flow range that occurs lifted flame and blow out. When the high-frequency is generated from burner cavity, the lifted length became shorter, and noise reduced comparing to unexcitation case. Additionally, operating flow range was increased and diameter of flame base became smaller with high-frequency effect. Through this experiments, it's ascertained that the high-frequency excitation can be adopted with effective method for flame stability and noise reduction.

• The Korean Journal of Applied Statistics
• /
• v.29 no.3
• /
• pp.505-512
• /
• 2016

The paper is concerned with high frequency financial time series. A weighted hybrid volatility is suggested to compute daily volatilities based on high frequency data. Various realized volatility (RV) computations are reviewed and the weights are chosen by minimizing the differences between the hybrid volatility and the realized volatility. A high frequency time series of KOSPI200 index is illustrated via QLIKE and Theil-U statistics.

• Proceedings of the IEEK Conference
• /
• 2003.07b
• /
• pp.1117-1120
• /
• 2003

In this paper, a 1.5V CMOS high frequency operational amplifier for high frequency signal processing systems is presented. For obtaining the high gain and the high unity gain frequency with the 1.5V supply voltage, the op-amp is designed with simple two stages which are consisting of the rail-to-rail differential input stage and the class-AB output stage. The designed op-amp operates with the 1.5V supply voltage, and shows well the push-pull class-AB operation. The simulation results show the DC open loop gain of 77dB and the unity gain frequency of 100MHz for the 1㏁ ┃ 10pF load. When the resistive load R$_1$. is varied from 1㏁ to 1 ㏀, the DC open loop gain decreases by only 4dB.

• Journal of Power Electronics
• /
• v.11 no.1
• /
• pp.28-36
• /
• 2011

In this paper, a three phase cycloconverter type high frequency AC link inverter is discussed. The configuration consists of a high frequency full-bridge inverter and a high frequency transformer followed by a three phase cycloconverter whose switch is composed of anti-series connected MOSFETs with a common source. A simple digital control strategy based on space vector modulation (SVM) and repetitive control for the cycloconverter is proposed although its input voltage is a high frequency AC pulse. The operation principle of the proposed control strategy is analyzed and the equivalent working modes during one interval are also presented. The effectiveness of the proposed control strategy is verified through Matlab/Simulink simulations and experiments on a 1.45kW prototype.

• Quantitative Bio-Science
• /
• v.37 no.2
• /
• pp.73-79
• /
• 2018

As high frequency (HF, for short) time series is now prevalent in the presence of real time big data, volatility computations based on traditional ARCH/GARCH models need to be further developed to suit the high frequency characteristics. This article reviews realized volatilities (RV) and multivariate GARCH (MGARCH) to deal with high frequency volatility computations. As a (functional) infinite dimensional models, the fARCH and fGARCH are introduced to accommodate ultra high frequency (UHF) volatilities. The fARCH and fGARCH models are developed in the recent literature by Hormann et al. [1] and Aue et al. [2], respectively, and our discussions are mainly based on these two key articles. Real data applications to domestic UHF financial time series are illustrated.