• Journal of the Korean Society of Propulsion Engineers
• /
• v.8 no.1
• /
• pp.81-84
• /
• 2004

A water-cooled calorimeter chamber with 8 cooling channels based on KSR-III sub-scale chamber has been designed and manufactured. One dimensional empirical correlation has been used at the design stage and full three-dimensional CFD analysis has been conducted to confirm the cooling condition for hot fire test is safe. Predicted heat flux is accurate around the nozzle throat when the thermal resistance of carbon deposit is considered. However relatively large difference is observed in chamber part.

• Journal of the Korean Society of Visualization
• /
• v.14 no.2
• /
• pp.25-30
• /
• 2016

The wafer temperature and its uniformity inside the LPCVD chamber were analyzed. The temperature uniformity at the end of the wafer load depends on the heat-insulating cap. The finite difference method was used to investigate the radiation and conduction heat transfer mechanisms, and the temperature field and heat diffusion in the LPCVD chamber was visualized. It was found that the temperature uniformity of the wafers could be controlled by the size and distance of the heat-insulating cap.

• Transactions of the Korean hydrogen and new energy society
• /
• v.27 no.1
• /
• pp.42-48
• /
• 2016

This study presents an experiment investigation on natural convection heat transfer of air-cooling Proton exchange membrane fuel cells (PEMFCs) in a enclosure system for unmanned aerial vehicles (UAVs). Considered are replacing fuel cell stack with Aluminum block for heat generating inside a enclosure chamber. The volume ratio of fuel cell stack and chamber for simulation to the actual size of aerial vehicle is 1 to 15. The parameters considered for experimental study are the environmental temperature range from $25^{\circ}C$ to $-60^{\circ}C$ and the block heat input of 10 W, 20 W and 30 W. Effect of the thermal conductivity of the block and power level on heat transfer in the chamber are investigated. Experimental results illustrate the temperature rise at various locations inside the chamber as dependent upon heat input of fuel cell stack and environmental temperature. From the results, dimensionless correlation in natural convection was proposed with Nusselt number and Rayleigh number for designing air-cooling PEMFC powered high altitude long endurance (HALE) UAV.

• Journal of the Institute of Convergence Signal Processing
• /
• v.23 no.3
• /
• pp.123-128
• /
• 2022

A lot of research is being done to develop a high-efficiency heat pump to save energy, and research to reduce or eliminate the phenomenon of frost occurring in the outdoor unit coil is also being conducted at the same time. In order to conduct a study that does not cause frost on the outdoor unit of the heat pump regardless of the season, a constant temperature chamber like a general room that can be tested under the same conditions as in the natural state was built. The experiment was conducted by providing an environment similar to the natural state to the outdoor unit of the heat pump installed in the constant temperature chamber. As a result, the lower the outdoor temperature, the lower the efficiency of the heat pump. It wat confirmed that the lower the value, the longer it is.

• Journal of computational fluids engineering
• /
• v.12 no.4
• /
• pp.7-13
• /
• 2007

Numerical analysis is carried out for combined heat transfer in an indirected NIR(Near Infrared Ray) heating chamber. Reynolds number and shapes of absorbed cylinder are known as important parameters on the combined heat transfer effects. Reynolds number based on the outer diameter of the cylinder is varied from $10^3$ to $3{\times}10^5$. Four difference heat transfer regimes are observed: forced convection and radiative heat transfer on the outer surface of the cylinder, pure conduction in the cylinder body, pure natural convection and radiation between lamp surface and inner surface of the cylinder, and radiation from the lamp. Flow and temperature characteristics are presented with iso-contour lines for the absorbed circular and elliptic cylinders to compare their differences. The convective and radiative heat transfer fluxes are also compared with different Reynolds numbers. As usual, Reynolds number is an important factor to estimate increasing convective heat transfer as it increases. The shape of absorbed cylinder results overall heat transfer rates remain unchanged.

• 한국연소학회:학술대회논문집
• /
• 2000.12a
• /
• pp.212-216
• /
• 2000

Combustion phenomenon in scale-downed combustor is investigated. As the combustor volume decreases surface to volume ratio increases. for increased surface to volume ratio means increased heat loss and this increased heat loss affects reaction in combustion chamber. Plastic mini combustor is made. Stoichiometricaly premixed Hydrogen I air gas is used as fuel. Initial chamber pressure and chamber size are varied and the effects are evaluated. Peak pressure decreases with the decrease in chamber height. As initial chamber pressure decreases peak pressure decreases. And this change is more important than scale down effect till the chamber height of 1mm. With this result and further information following the experiments design parameter for micro engine can be established.

• Journal of the Korean Society of Combustion
• /
• v.5 no.2
• /
• pp.63-68
• /
• 2000

Combustion phenomenon in scale-downed combustor is investigated. As the combustor scale decreases surface to volume ratio increases and chamber size approaches quenching distance. As the combustor scales down surface to volume ratio increases resulting increased heat loss. And this heat loss can affect quenching and instability of the flame. To investigate this effect plastic mini combustor is made. Stoichiometricaly premixed Hydrogen / air gas is used as fuel. Initial chamber pressure and chamber size are varied and the effects are evaluated. Peak pressure decreased with the decrease in chamber height. As initial chamber pressure decreases peak pressure decreases and this change is more important than scale down effect till the chamber height of 1mm. With this result and further information following the experiments design parameter for micro engine can be established.

• Transactions of the Korean Society of Mechanical Engineers
• /
• v.17 no.1
• /
• pp.153-161
• /
• 1993

Heat transfer processes in the combustion chamber of a pebble bed regenerative heat exchanger for MHD power generation has been analyzed numerically for heating, evacuation argon heating periods individually. The calculated result well explain the measured temperature change at the top of the pebble bed. The analytical result point out that the length of evacution period and the geometry optimization both for the combustion chamber and the heat storage bed are very important factors for the improvement of thermal performance in MHD power generation.

• Journal of Korean Medical classics
• /
• v.30 no.3
• /
• pp.109-131
• /
• 2017

Objectives : The purpose of this paper is to study the origin, mechanism, category of Chest bind with static blood(血結胸), the relation to the syndrome of Heat entering the blood chamber(熱入血室證), and the comparison with Chest bind(結胸). Methods : Sikuquanshu(四庫全書), a comprehensive range of medical books, and Shanghanlun(傷寒論) annotation books were searched by 'Chest bind with static blood' keyword and analyzed. Results & Conclusions : 1. The syndrome of Chest bind with static blood is first brought up by ZhuGong(朱肱) and it can be derived from the syndrome of Heat entering the blood chamber or can be shown in upper middle lower energizer Stagnated Blood Syndrome(上中下焦蓄血證, SBC). Ever since the publication of Shanghanquanshengji(傷寒全生集), its category was expanded and prescriptions for the SBC were used. 2. In comparison, the cause of Chest bind with static blood is associated with blood heat(血熱), largely connected with blood, mental illness appeared, lesions are usually chest and sides, and the cause of Chest bind is associated with intermingled water heat (水熱) or phlegm heat(痰熱), not connected with blood, mental illness not appeared, lesions are from the beneath the heart to lower abdomen. 3. The syndrome of Chest bind with static blood derived from the syndrome of Heat entering the blood chamber can appear along side with the Liver Meridian associated with blood chamber or appear in chest, the syndrome appeared in upper energizer SBC can be shown in the chest due to gravity, the one appeared in middle energizer SBC can be shown in the chest due to the same level, the one appeared in lower energizer SBC can be shown in the chest due to the constitutional predisposition of YangQi(陽氣) uprise.

• Journal of the Institute of Convergence Signal Processing
• /
• v.24 no.3
• /
• pp.140-146
• /
• 2023

A lot of research is being done to develop a high-efficiency heat pump to save energy. Among them, research to reduce or eliminate the phenomenon of frost occurring in the outdoor unit coil are being conducted at the same time. A constant temperature chamber that can be tested under the same conditions as natural conditions was constructed to conduct research that does not cause frost on the outdoor unit of the heat pump regardless of the season. The outdoor unit of the heat pump installed in the constant temperature chamber was simulated under the same natural conditions. As a result, it was confirmed that the mass flow rate of the refrigerant decreased as the outdoor temperature decreased, and the dryness of the refrigerant also increased linearly with the outdoor temperature.