• Journal of Dental Rehabilitation and Applied Science
• /
• v.23 no.2
• /
• pp.145-155
• /
• 2007

The advent of osseointegration and advances in biomaterials and techniques have contributed to increased application of dental implants in the restoration of maxillary partial edentulous patients. Often, in these patients, soft and hard tissue defects result from a variety of causes, such as infection, trauma, and tooth loss. These create an anatomically less favorable foundation for ideal implant placement. Reconstruction of the atrophic maxillary alveolar bone through a variety of regenerative surgical procedures has become predictable; it may be necessary prior to implant placement or simultaneously at the time of implant surgery to provide a restoration with a good long-term prognosis. Regenerative procedures are used for horizontal and vertical ridge augmentation. Many different techniques exist for effective bone augmentation. The approach is largely dependent on the extent of the defect and specific procedures to be performed for the implant reconstruction. It is most appropriate to use an evidenced-based approach when a treatment plan is being developed for bone augmentation cases. The cases presented in this article clinically demonstrate the efficacy of using a autogenous block graft, guided bone regeneration, ridge split, immediated implant placement technique on the atrophic maxillary area.

• Journal of Dental Rehabilitation and Applied Science
• /
• v.36 no.4
• /
• pp.289-295
• /
• 2020

Improving implant esthetics is very difficult, especially in cases where unaesthetic problems are related to implants in the maxillary anterior dentition. A 69-year old male patient was referred by a prosthodontist for periodic pus discharge and an unaesthetic implant prosthesis (maxillary right lateral incisor). The implant was placed too deeply and showed soft tissue volume deficiency and a long clinical crown. After a clinical and radiographic examination, implant submergence and alveolar ridge augmentation were performed to enhance the aesthetics instead of an explantation. The treatment plan was as follows: extraction the adjacent teeth with tooth mobility, secondary caries, and poor prognosis; placement an additional dental implant with hard and soft tissue grafting; fabrication a fixed bridge using implant abutments. A fixed esthetic prosthesis using implants was fabricated, and the patient was satisfied with the prosthesis. A ridge augmentation with implant submergence may be an alternative for solving the problems of unaesthetic implant restorations in the esthetic zone.

• The Journal of the Korean dental association
• /
• v.51 no.12
• /
• pp.643-649
• /
• 2013

The aim of this study was to achieve the healing of peri-implantitis defects and the hard tissue regeneration using the augmentation of a xenograft on defect site. Two patients were treated with the surgical approach. With a full muco-periosteal flap elevation, the implant surfaces were exposed and taken the debridement of granulation tissue around the abutment. Each surface of the abutments was prepared with the air-abrasive device (PerioFlow$^{(R)}$) for decontamination. Bovine-derived bone mineral (Bio-Oss collagen$^{(R)}$) was then used to fill the defects, and no membrane was placed on the grafting site. Radiographs and clinical photo was taken to compare from baseline status. Within the limits of the present case, this case shows the significance of the surgical treatment of peri-implantitis. And this also verifies the stability of bovine-derived bone mineral and effectiveness of Air-abrasive device (PerioFlow$^{(R)}$).

• Journal of Dental Rehabilitation and Applied Science
• /
• v.23 no.4
• /
• pp.303-312
• /
• 2007

Recently several studies have been developed not only to apply bone materials to bony defect, but also to use osteogenic and osteoinductive materials to form bone more effectively. In 1998 Mark et al applied gel formation of PRP(platelet-rich plasma) in bony transplantation for mandibular reconstruction as one of the method of stimulating bone formation in maxillofacial area, which is contain of varies growth factors. After he reported that PRP accelerate bone formation, which is used in varies bone transplantation and augmentation with a good result. Especially there are amount of growth factors in PRP, and PRP increase angiogenesis, cell division, and mesenchymal cell growth. Moreover it is capable of osteoconduction, hemostatitis, anti-infection, forming the shape at transplantation, ease of handling, and recipient site stability. So it is known that success rate is high in bone transplantation. However PRP need tissue adhesive to make plasma to solid form. Thrombin and calcium chloride, component of PRP, is extracted from autogenic donor. So it is expensive to extract and there is possibility of hepatitis, AIDS, and hematogenous metastasis. After all, tissue adhesive have the limitation and danger of use. So we are willing to introduce that we had get some idea after using PRF(platelet-rich fibrin) in the various hard and soft tissue bony defect, which is self extracted simply and contain growth factors.

• Journal of Korean Dental Science
• /
• v.7 no.1
• /
• pp.38-42
• /
• 2014

Bisphosphonate-related osteonecrosis of the jaw (BRONJ) is defined as exposed necrotic bone without evidence of healing for at least 8 weeks in the maxillofacial area in a patient with history of bisphosphonate use. Obtaining complete coverage of the hard tissue by soft tissue in BRONJ patients is especially important. Therefore, managing the mucosa is one of the key factors in a successful outcome, but this is especially hard to achieve in BRONJ patients. Various applications of buccal fat pad in oral reconstruction-including the closure of surgical defects following tumor excision, repair of surgical defects following the excision of leukoplakia and submucous fibrosis, closure of primary and secondary palatal clefts, coverage of maxillary and mandibular bone grafts, and lining of sinus surface of maxillary sinus bone graft in sinus lift procedures for maxillary augmentation-have been studied. Eliminating all potential sites of infection and post-operative infection control is crucial in BRONJ. We present a case using the buccal fat pad pedicle for a stage 3 BRONJ defect. Uneventful total epithelialization of the buccal fat pad regardless of size was noted. In summary, the buccal fat pad has versatile application and various recipient sites for surgical utilization. It is an easy technique, with promising overall success rates. With careful selection and handling, buccal fat graft can resolve problems with soft tissue coverage in stage 2 or 3 BRONJ patients.

• The Journal of the Korean dental association
• /
• v.51 no.12
• /
• pp.650-657
• /
• 2013

The aim of this study was to achieve healing of Peri-implantitis defects and hard tissue augmentation using a bovine-derived bone mineral on the defect site. Two patients were treated with the surgical approach. With a full muco-periosteal flap elevation, the implant surfaces were exposed and granulation tissue removed around the implant and between the threads. Each surface of the contaminated implant was prepared with the air-abrasive device(PerioFlow$^{(R)}$) for decontamination. Bovine-derived bone mineral(Bio-Oss collagen$^{(R)}$) was then used to fill the defects and muco-periosteal flaps sutured to achieve transmucosal healing. Radiographs and clinical photographs were taken before and after 6 months of healing and an estimate of bone fill was assessed. Within the limits of the present case report, a surgical approach in treatment of peri-implantitis defects using a collagen form of bovine bone mineral was visited. Although limited, the two cases showed the stability and biocompatibility of a bovine-derived bone mineral and effectiveness of air-abrasive device(PerioFlow$^{(R)}$) as a decontamination method.

• The korean journal of orthodontics
• /
• v.30 no.3 s.80
• /
• pp.355-365
• /
• 2000

The treatment plan for orthognathic surgery must be based on accurate predictions, and this can be produced the most esthetic results. Treatment of prognathic mandible in adult is usually orthognathic surgery using mandible set back, but mandible with retruded chin point is needed additional chin augmentation. In this case, the directions between mandible and chin point are different therefore, the prediction of soft tissue reactions must be modified. In this study, we materialize the patients who was taken orthognathic surgery due to prognathic mandible, 11each(Group A) was taken only Bilateral Sagittal Sprit Ramus Osteotomy (BSSRO), 9each(Group B) was taken additional advancement genioplasty. The lateral cephalometric radiography taken 8 months later after orthognathic surgery by this patients were used. The results of this study were as follows : 1. The profile of lips was favorable after surgery due to upper lip to I-line became prominent and lower lip tc E-line was retruded. 2. In both group, upper lip moved posteriorly and nasolabial angle was increased. 3. The ratio of the soft tissue profile change in POGs point to skeletal B point movement was $84\%$ in group A and $66\%$ in group B, and there was statistical significance between group A and group B. 4. Vertical movement of hard tissue points is decreased in group A.

• Journal of Periodontal and Implant Science
• /
• v.54 no.2
• /
• pp.108-121
• /
• 2024

Purpose: The aim of this study was to compare changes in soft and hard tissue and the histologic composition following early implant placement in sites with alveolar ridge preservation or spontaneous healing (SH), as well as implant performance up to 1 year after crown insertion. Methods: Thirty-five patients with either intact buccal bone plates or dehiscence of up to 50% following single-tooth extraction of incisors, canines, or premolars were included in the study. They were randomly assigned to undergo one of three procedures: deproteinized bovine bone mineral with 10% collagen (DBBM-C) covered by a collagen matrix (DBBM-C/CM), DBBM-C alone, or SH. At 8 weeks, implant placement was carried out, and cone-beam computed tomography scans and impressions were obtained for profilometric analysis. Patients were followed up after the final crown insertion and again at 1 year post-procedure. Results: Within the first 8 weeks following tooth extraction, the median height of the buccal soft tissue contour changed by -2.11 mm for the DBBM-C/CM group, -1.62 mm for the DBBM-C group, and -1.93 mm for the SH group. The corresponding height of the buccal mineralized tissue changed by -0.27 mm for the DBBM-C/CM group, -2.73 mm for the DBBM-C group, and -1.48 mm for the SH group. The median contour changes between crown insertion and 1 year were -0.19 mm in the DBBM-C/CM group, -0.09 mm in the DBBM-C group, and -0.29 mm in the SH group. Conclusions: Major vertical and horizontal ridge contour changes occurred, irrespective of the treatment modality, up to 8 weeks following tooth extraction. The DBBM-C/CM preserved more mineralized tissue throughout this period, despite a substantial reduction in the overall contour. All 3 protocols led to stable tissues for up to 1 year.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2009.11a
• /
• pp.18.2-18.2
• /
• 2009

Ceramics have some properties that are unmatched by other kind of materials like metals or polymers. The ability of high thermal and chemical resistance and in case of being superior in specific mechanical properties makes the ceramic materials suitable for arange of applications. The microstructure and morphology of a material arguably permit the use of many advanced application otherwise difficult to achieve.Porous structures have some important applications in biomedical and environmental field. For human hard tissue reconstruction and augmentation procedure suitable biomaterials are used with a desirable porosity. A range of porous bioceramics were fabricated with tailored design to meet the demand of specific applications. Channeled and interconnected porosity was introduced in alumina, zirconia, and hydroxyapatite or tri calcium phosphate ceramics by different methods like multi-pass extrusion process, bubble formation in viscous slurry,slurry dripping in immiscible liquid, sponge replica method etc. The detailed microstructural and morphological investigations were carried out to establish the unique features of each method and the developed systems. For environmental filters the porous structures were also very important. We investigated a range of channeled and randomly porous silicon based ceramic composites to enhance the material stability and filtration efficiency by taking advantage of the material chemistry of the element. Detailed microstructural and mechanical characterizations were carried out for the fabricated porous filtration systems.

• Restorative Dentistry and Endodontics
• /
• v.33 no.1
• /
• pp.39-44
• /
• 2008

The treatment of esthetic areas with single-tooth implants represents a new challenge for the clinician. In 1993, a modification of the forced eruption technique, called "orthodontic extrusive remodelling," was proposed as a way to augment both soft- and hard-tissue profiles at potential implant sites. This case report describes augmentation of the coronal soft and hard tissues around a fractured maxillary lateral incisor associated with alveolar bone loss, which was achieved by forced orthodontic extrusion before implant placement. Through these procedures we could reconstruct esthetics and function in a hopeless tooth diagnosed with subgingival root fracture by trauma.