• KSCE Journal of Civil and Environmental Engineering Research
• /
• v.44 no.2
• /
• pp.203-214
• /
• 2024

Ports often suffer pavement damage due to soft ground and heavy equipment operations, leading to issues such as differential settlement and cracks. In this study, we developed port concrete blocks and applied them to a port in two configurations to figure out settlement characteristics. Falling weight deflectometer (FWD) tests on asphalt pavement and block pavements were conducted to figure out deflection and bearing capacity. The block pavement with the cement treated base showed improved bearing capacity with the port operation since lower settlements were detected than asphalt pavement. In the cement treated base, the relative deflection ratio to asphalt concrete pavement was less than 1, indicating enhanced bearing capacity. LiDAR measurements identified multiple settlements in the crushed-stone base due to surface loads after construction. Both relative deflection ratio and LiDAR measurements suggested that block pavement can be widely applied to various port sites with its applicability and bearing capacity of cement-treated base.

• Economic and Environmental Geology
• /
• v.40 no.6
• /
• pp.833-841
• /
• 2007

The groundwater heat pump system(GWHP) is one of the most efficient ground source heat pump system(GSHP) which uses low grade and shallow geothermal energy for cooling and heating purpose. The GWHP system shall be designed properly based on peak block load performance and optimum pumping rate of groundwater comparable to ground coupled heat pump system(GCHP). The optimum pumping rate depends on groundwater temperature at a specific site, size of plate heat exchanger, and total head loss occurred by whole system comprising pumps and pipings. The required optimum flow rates of the system per RT are ranged from 3.8 to 9.8lpm being less than the typical building loop flow of 9.5 to 11.4lpm.

• Aerospace Engineering and Technology
• /
• v.11 no.2
• /
• pp.73-79
• /
• 2012

Because the contact time between satellite and ground station is very limited in LEO (Low Earth Orbit) satellite, all telemetry data generated on spacecraft bus are stored in a mass memory and downlinked to the ground together with real time data during the contact time. The mass memory is initialized in the first system initialization phase and the page status of each memory block is generated step by step. After the completion of the system initialization, the telemetry data are continuously stored and the stored data are played back to the ground by command. And the memory scrubbing is periodically performed for correction of single bit error which can be generated on harsh space environment. This paper introduces the mass memory operation method for telemetry processing of LEO satellite. It includes a general mass memory data structure, the methods of mass memory initialization, scrubbing, data storage and downlink, and mass memory management of primary and redundant mass memory.

• Journal of Environmental Science International
• /
• v.24 no.11
• /
• pp.1363-1370
• /
• 2015

This study was aimed to determine effects of soil organic amendment as plant growing media component on restoration of planting ground. The changes of soil physical and chemical properties and germination and growth of kentucky bluegrass (Poa pratensis L.) were investigated. For treatments, soil was excavated at depth of 0-50 cm (referred as $S_1$) and at depth of 50-100 cm (referred as $S_2$). Then the half amount of $S_1$ soil was mixed with the soil organic amendment (coir dust 40% (v/v), bottom ash 25%, leaf mold 25%, vermiculite 5%, carbonized rice hull 5%) at a rate of 6% (v/v) (referred as $S_1CC$) and also the half amount of $S_2$ soil was mixed with the soil organic amendment at a rate of 6% (v/v) (referred as $S_2CC$) on pot in a 16 cm diameter and 14 cm height. The experiment was replicated 3 times with 3 pots per replication in randomized block design, and 100 seeds were planted per pot. In results, there was no significant difference in soil pH among the treatments with a slight decrease in soil hydraulic conductivity. However, in the $S_1CC$ treatment, positive increases in soil chemical properties, including electrical conductivity, organic matter, phosphoric acid, total nitrogen, exchangeable cation, and cation exchange capacity. Also, the germination rate, plant height, and number of leaves were higher in the $S_1CC$ treatment than those in other treatments. These results suggest that the addition of organic amendment to the soil at depth of 0-50 cm might be proper for restoring planting ground.

• Asian-Australasian Journal of Animal Sciences
• /
• v.19 no.1
• /
• pp.31-34
• /
• 2006

The experiment was conducted to determine the effects of cutting interval and cutting height on the yield and nutrient composition of hedge lucerne (Desmanthus virgatus) when grown on a sandy soil in the Northeast of Thailand. The cutting intervals compared were 30, 40 and 50 days between harvests and the cutting heights 30, 40 and 50 cm above ground level. The experiment was a $3{\times}3$ factorial layout in a randomized complete block design with 4 replications-giving a total of 36 plots each $3{\times}3m^2$. Harvested plant material was weighed, dried and the ground subsamples taken for analyses of crude protein (CP), crude fiber (CF), ash, ether extract (EE) and nitrogen-free extract (NFE). At the last harvest the hedge lucerne samples were separated to determine leaf to stem ratios and then analyzed for nutrient composition in the leaf and stem. Results showed that increasing the cutting interval (i.e. advancing age of maturity) increased dry matter and nutrient yields significantly. In terms of nutrient content, it also increased the crude fiber, ash, ether extract and nitrogen free extract percent in the plant. However, crude protein percent was markedly decreased as the cutting interval increased. Increasing cutting height had no effect on dry matter yield and yields of nutrients, but in terms of nutrient content, it increased crude protein and ash content, but decreased crude fiber content. The percent EE and NFE in the plant was unaffected by cutting height. From the results presented it is clear that cutting a stand of hedge lucerne every 40 to 50 days will achieve greater dry matter and nutrient yields than cutting more frequently, at 30 days. The cutting height at harvest, whether 30, 40 or 50 cm above ground level had no effect on dry matter or nutrient yields of hedge Lucerne. Hedge lucerne therefore offers the Thai poultry farmer a useful alternative protein supplement for poultry diets rather than relying on the more expensive soybean meal. As it can be readily and successfully grown on a range of soil types and climates throughout Thailand, hedge lucerne also offers the Thai farmer a valuable additional source of income.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.22 no.3
• /
• pp.285-291
• /
• 2004

GPS photogrammetry or the GPS/INS photogrammetry, which are based on the direct measurement of the projection centers and attitude at the moment of camera exposure time through loading the GPS receiver or INS in aircraft. Both photogrammetric methods can offer us to acquire the exterior orientation parameters with only minimum ground control points, even the ground control process could be completely skipped. Consequently, we can drastically reduce the time and cost for the mapping process. In this thesis, test flight was conducted in Suwon area to evaluate the performance of accuracy and efficiency through the analysis of results among the three photogrammetric methods, that is, traditional photogrammetry, GPS photogrammetry and GPS/INS photogrammetry. Test results shows that a large variety of advantages of GPS photogrammetry and GPS/INS photogrammetry against traditional photogrammetry is to be verified. Especially, the number of ground control points for the exterior orientation could be saved more than 70～80%, respectively.

• Asian-Australasian Journal of Animal Sciences
• /
• v.21 no.2
• /
• pp.204-213
• /
• 2008

Four ruminally cannulated Holstein cows averaging 43 days in milk (DIM) were used in a $4{\times}4$ Latin square to determine the effect of feeding extruded soybean, ground canola seed and whole cottonseed on ruminal fermentation and milk fatty acid profile. One hundred and twenty lactating Holstein cows, 58 (${\pm}31$) DIM, were assigned to four treatments in a completely randomized block design to study the effects of the three types of oilseeds on production parameters and milk fatty acid profile. The four diets were a control diet (CON) and three diets in which 10% extruded soybean (ESB), 5% ground canola seed (GCS) and 10% whole cottonseed (WCS) were included, respectively. Diets consisted of concentrate mix, corn silage and Chinese wild rye and were balanced to similar concentrations of CP, NDF and ADF. Ruminal fermentation results showed that ruminal fermentation parameters, dry matter intake and milk yield were not significantly affected by treatments. However, compared with the control, feeding cows with the three oilseed diets reduced C14:0 and C16:0 and elevated C18:0 and C18:1 concentrations in milk, and feeding ESB increased C18:2 and cis9, trans11 conjugated linoleic acid (CLA). Production results showed that feeding ESB tended to increase actual milk yield (30.85 kg/d vs. 29.29 kg/d) and significantly decreased milk fat percentage (3.53% vs. 4.06%) compared with CON. Milk protein (3.41%) and solid non-fat (13.27%) from cows fed WCS were significantly higher than from cows fed CON (3.24% and 12.63%, respectively). Milk urea N concentrations from cows fed the ESB (164.12 mg/L) and GCS (169.91 mg/L) were higher than cows fed CON (132.31 mg/L). However, intake of DM, 4% fat corrected milk, energy corrected milk, milk fat and protein yields, milk lactose percentage and yield, somatic cell count and body condition score were not affected by different treatments. The proportion of medium-chain fatty acid with 14 to 16 C units in milk was greatly decreased in cows fed ESB, GCS and WCS. Feeding ESB increased the concentration in milk of C18:1, C18:2, C18:3 and cis9, trans11-CLA content by 16.67%, 37.36%, 95.24%, 72.22%, respectively, feeding GCS improved C18:0 and C18:1 by 17.41% and 33.28%, respectively, and feeding WCS increased C18:0 by 31.01% compared with feeding CON. Both ruminal fermentation and production trial results indicated that supplementation of extruded soybean, ground canola seed and whole cottonseed could elevate the desirable poly- and monounsaturated fatty acid and decrease the medium chain fatty acid and saturated fatty acid content of milk fat without negative effects on ruminal fermentation and lactation performance.

• Journal of the Korea institute for structural maintenance and inspection
• /
• v.25 no.6
• /
• pp.154-160
• /
• 2021

Recently, there have been increasing construction works carried out in urban centers, which are inducing frequent artificial vibration in the vicinity of existing structures due to such construction works. moreover, in case of industrial estates, vibration is induced due to operation of machines in the surrounding areas, thereby causing problems. meanwhile, in case of ordinary concrete that compose structure has low level of damping capability for vibration. accordingly, there are difficulties in blocking a wide range of vibrations delivered to the structures from outside including not only vibrations generated in the structures themselves but also ground vibration. recently, numerous studies are being carried out actively on high-damping system that markedly enhanced the damping performances of structures by utilizing polymer concrete in order to block the vibrations delivered to the structures through ground. therefore, this study compared the performances of polymer concrete with those of ordinary concrete, polyurethane pad and foamed rubber pad in order to review its performances in reducing ground vibration. for this purpose, review of FRF and vibration acceleration as dynamic characteristics was made. after comparative verification on the dynamic characteristics is made when polymer concrete and other aforementioned materials are applied to underground structures, the possibility of application of polymer concrete to structures is reviewed.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2009.10a
• /
• pp.575-577
• /
• 2009

Traditionally, tire made a role of function, which is supporting vehicle load, making brake, transferring, traction etc. So, there are a lot of studying for the tire. especially, tire noise is one of the most important parameter in the car noise. this thesis shows the method how to reduce the tire noise by using the optimal pitch sequence. Because the optimal pitch sequence prevents tire from generating the pure tone while driving the car on the ground.

• Journal of the Korean housing association
• /
• v.13 no.2
• /
• pp.55-64
• /
• 2002

This study aims at the suggestion of possibility that a housing density will maintain properly and that an ecological hill housing will recover a rapport with the ground. That is, both residential planning on the hillside and ecological architecture as a concept for development are chosen for study category, and relationship between the hillside and the hill housing is theorized and then propriety is analysed through application of the ecological planning elements. The results of this study are as follows: 1. Now that the hillside is regarded as an idle land that preserves natural environment and maintains ecosystem, it must be developed on the basis of awareness that nature and human beings exist together. 2. Analysis of geographical factors must be advanced because it is inevitable that the development of the hill housing should be performed properly to the geographical characteristics. 3. Planning elements of ecological residential block which are possible for constructing on the hillside can be developed and applied, on the basis of geographical characteristics, by classifying them into two areas; housing estate, building and unit.