• 한국전기전자재료학회논문지
• /
• 제26권6호
• /
• pp.472-477
• /
• 2013

This paper carried out the comparative analysis on ground impedance of a carbon block and a copper rod. Two types of grounding electrode were compared ; a carbon block (L : 1 m, ${\Phi}$ : 245 mm) buried at a depth of 0.8 m and a three-linked copper rod (L : 1 m, ${\Phi}$ : 10 mm) of equilateral triangles with 1 m spacing. Ground impedance depending on applied current source was evaluated by the application of a sine wave current with 60 Hz ~ 3.5 MHz, a fast-rise pulse with rising time of 200 ns, a standard lightning impulse of $8/20{\mu}s$ and a 600 Hz square wave. Ground impedance for both electrodes were almost the same value below 100 kHz, and increased rapidly afterwards. The maximum ground impedance appeared $400{\Omega}$ at around 1.5 MHz. Ground impedance of the carbon block was lower at the square wave and was higher at fast-rise pulse than that of the copper rod. Also, ground impedance as ages showed no difference for the last 8 months. From the results, it is likely that ground performance for both electrodes shows no difference against commercial frequency and lightning impulse current, while the copper rod shows better performance against a fast-rise pulse with rise-time of a few hundred ns.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2011년도 춘계학술대회 논문집
• /
• pp.1502-1508
• /
• 2011

Ground anchor expands the hollow wall of settled part and has the structure which resists the designed tensile load by the bearing pressure generated by the wedge of the anchor body pressing in the expanded part. Such ground anchor has been recognized for stability and economicality since 1960s in technologically advanced nations such as Japan and Europe, and in 1970s, the Japan Society of Soil Engineering has established and announced the anchor concept map. The ground anchor introduced in Korea, however, has the structural problem where the tensile strength is comes only from the ground frictional force due to expansion of the wedge body. In an interval where the ground strength is locally reduced due to fault, discontinuation or such, this is pointed out as a critical weakness where the anchor body of around 1.0m must resist the tensile load. Also, in the installation of concrete block, the concentrated stress of concrete block constructed on the uneven rock surface causes damage, and many such issues in the anchor head have been reported. Thus, in this study, by using the expanded bit for precise expansion of settled part, the ground anchor system was completed so that the bearing pressure of ground anchor can be expressed as much as possible, and the bearing plate was inserted into the ground to resolve the existing issues of concrete block. Through numerical analysis and pullout test executed for verification of site applicability, the pullout-behavior characteristics of anchor was analyzed.

• 한국전산유체공학회:학술대회논문집
• /
• 한국전산유체공학회 2006년도 추계 학술대회논문집
• /
• pp.193-198
• /
• 2006

It takes a lot of time and effort to generate grids for numerical analysis of problems with ground effect because the relative attitude and height of airfoil should be maintained to the ground as well as the inflow. A low Mach number preconditioned turbulent flow solver using the overlap grid technique has been developed and applied to the ground effect simulation. It has been validated that the present method using the multi-block grid gives us highly accurate solutions comparing with the experimental data of the RAE 101 airfoil in an unbounded condition. Present numerical method has been extended to simulate ground effect problems by using the overlapped grid system to avoid tedious work in generating multi-block grid system. An extended method using the overlapped grid has been verified and validated by comparing with results of multi-block method and experimental data as well. Consequently, the overlapped grid method can provide not only sufficiently accurate solutions but also the efficiency to simulate ground effect problems. It is shown that the pressure and aerodynamic centers move backward by the ground effect as the airfoil approaches to the ground.

• 대한조선학회논문집
• /
• 제58권2호
• /
• pp.84-89
• /
• 2021

Recently, shipyards are making many efforts to reduce the number of the mounted blocks by increasing the block size. This is to improve productivity and reduce related costs by minimizing block movement and shortening the building period. However, as the blocks become larger, the weight increases considerably. If the target block has a damage due to an unexpected accident during block lifting, it may seriously cause a problem of the reusability of the block. In this study, a large-sized block of the offshore structure weighing 480 tons was lifting with a total of seven sling belts, and one sling belt was broken while it was moving, resulting in a situation in which a part of the edge of the block collided with the ground. The aim of this paper is to verify the structural integrity of the block that directly collides with the ground in the form of free fall due to the sling breakage. Considering that the hook loads acting on several sling belts holding the block are redistributed when a sling belt is broken, the hook loads were recalculated at the angle just before the sling breakage. These loads were used to check the safety of the sling belts. In addition, FE analysis was performed by calculating the amount of impact from the free fall condition, obtaining the impact area by using Hertz's contact theory, and then applying the impact load to the area.

• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2009년도 춘계학술발표대회 논문집
• /
• pp.170-175
• /
• 2009

Apartment housing block has been spreaded according to rapid economic development and urbanization in Korea. A parking lot is located at underground, artificial ground is inevitably created in apartment housing block. Artificial ground creates different thermal environment compared to natural ground, because the composition and coverage of artificial ground are diverse. In this study, the effect of the artificial ground on building thermal environment will be disscussed by simulation. Considering the result of simulation, surface albedo is more important for building energy performance. A purpose of this study is to examine how the characteristic of surface effect to thermal environment, and to develop design method for sustainable outdoor space.

• 한국지반공학회:학술대회논문집
• /
• 한국지반공학회 2010년도 추계 학술발표회
• /
• pp.87-96
• /
• 2010

PAP method is a combined measures which consist a anchored retaining wall method with permanent ground anchors and vertical precast concrete panels, step by step on the slope surface. And soil is back filled between slope and vertical precast panels. Therefore, this method is more effective than any other ground anchor reinforcing methods of slope stability, for example cross type concrete block ground anchor or buttress concrete block ground anchor method. Because of increasing effective anchor force and green tree planting.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2006년도 제37회 하계학술대회 논문집 A
• /
• pp.280-281
• /
• 2006

This paper was analyzed fundamental about electrical characteristic of concrete to practical use base of building as Substitution Ground Electrode and Artificial Ground Electrode. 1) Gravel or Sand has a function that makes increase Resistivity of Concrete and Cement has a function that makes decrease Resistivity of Concrete. 2) Moisture Increase Work is so hard because of dry of Block but the Resistivity was decreased when the moisture of Concrete Block was gradually increased. 3) According to the measurement result of moltar and concrete block, ratio relation of Resistance and Resistivity of each block was thirty-fold difference.

• 대한토목학회논문집
• /
• 제34권1호
• /
• pp.175-183
• /
• 2014

본 연구는 점토지반에서 터널의 굴착조건(터널깊이 및 터널직경)과 시공조건(지반손실량), 지반조건(연약점토, 단단한 점토)을 변화시키면서 터널상부에 위치한 구조물의 거동변화를 조사 및 분석한 것이다. 분석에 사용된 구조물은 4층 블록식구조물로서 변형 등에 의한 균열발생과 균열폭의 차이로 인해 구조물의 손상정도를 쉽게 파악할 수 있는 특징이 있다. 다양한 터널 굴착조건 및 시공조건, 지반조건에 대해서 발생할 수 있는 터널상부 블록구조물의 거동상태를 파악하기 위해 수치해석적 매개변수 해석을 수행하였으며, 수치해석은 구조물의 실제크랙 발생을 묘사할 수 있도록 개별요소법(DEM)에 근거하여 수행하였다. 다양한 매개변수 해석으로부터 얻어진 구조물의 거동상태에 대한 결과는 터널 굴착조건 및 시공조건, 점토 지반조건과 상호 연관하여 함께 반영될 수 있도록 도표화 하였으며, 이를 이용하여 향후 점토지반에서 다양한 터널굴착 및 시공조건, 지반조건으로 인해 유발되는 터널 상부구조물의 손상정도를 보다 용이하게 파악할 수 있을 것으로 기대된다.

• 한국지반신소재학회논문집
• /
• 제20권4호
• /
• pp.85-93
• /
• 2021

한반도의 70%는 산지로 구성되어 있으며, 서해와 남해의 수심은 상대적으로 얕은 편이다. 따라서, 공업단지, 주거단지, 항만 및 공항 부지를 위한 대규모 간척사업이 시행되고 있다. 매립지역의 일반적인 문제는 지반이 연약하여 지지력이 부족할 뿐만 아니라 상당한 침하가 발생된다는 것이다. 중공블록은 중·저층 아파트 또는 단층의 공장건물을 건설하기 위해 계획된 느슨한 연약기초 지반보강을 위해 사용된다. 최근 4.0~5.0의 강도를 가진 지진이 서쪽과 남동쪽 해안지역을 따라 발생하고 있다. Lee (2019)는 정적 지지력시험을 통해 얕은 기초보강 중공블록의 장점에 대하여 연구하였다. 이 연구에서 블록 내부에 쇄석으로 채움된 보강된 모래지반의 중공블록 동적거동은 진동대 1000 mm × 1000 mm 시험을 통해 연구하였다. 3가지 지진파인 Ofunato, Hachinohe, Artificial 지진파와 2가지 가속도(0.154g, 0.22g)를 진동대 시험에 적용하였다. 중공블록으로 보강된 지반 위의 구조물 수평변위는 LVDT를 사용하여 측정하였다. 중공블록에 의한 지반보강 효율을 평가하기 위하여 지반의 상대밀도를 45%, 65%, 85%로 각각 구성하였으며, 수평변위를 측정하고 한계수평변위 0.015h(건축물 내진등급기준, 2019)와 비교하였다. 중공블록으로 보강된 모래지반에 대한 진동대 시험 결과에 기반해서 벌집 모양의 중공블록은 블록내부에 쇄석 채움으로서 큰 구속력을 가지며, 중공블록의 내부 및 외부를 따라 발생하는 관입저항력으로 인한 큰 주면마찰력을 갖는 것으로 평가되었다. 이러한 모든 요소들은 진동대 시험 중에 수평변위를 상당이 줄이는 것으로 나타났다. 마지막으로, 중공블록 보강 지반은 지진파와 가속도에 상관없이 중·저층 건물의 얕은기초 보강공법으로 매우 우수함이 입증되었다.

• 대한토목학회논문집
• /
• 제37권5호
• /
• pp.801-813
• /
• 2017

경사고임대의 지지블록에서 발휘되는 수동토압은 지반종류에 따라 발휘되는 토압이 다르다. 영구구조물인 옹벽 설계에서는 수동토압의 안전율을 고려하도록 하고 있으나, 가시설에 설치되는 경사고임대 지지블록에 작용하는 토압은 실제 발휘되는 수동측토압보다 과하게 산정되어 불안전측의 설계가 되고 있다. 본 연구에서는 3차원 수치해석(PLAXIS)을 이용 토사지반에서 경사고임대 지지블록에 발생되는 수동측토압을 산정하였다. 토사지반으로 연약지반과 풍화토지반이 선택되었다. 수치해석결과 각 지반에서 지지블록의 수평변위와 수동측토압 관계 곡선이 산정되었으며 이 곡선상의 항복점이 설계에 적용할 경사고임대 지지체에서의 저항력으로 연약지반에서는 Rankine 수동토압의 약 55.5%, 풍화토지반에서는 약 66%를 보는 것이 안정성 측면에서 바람직한 것으로 나타났다.