• Journal of Bio-Environment Control
• /
• v.28 no.2
• /
• pp.166-171
• /
• 2019

This study was conducted to investigate the effect of gaseous chlorine dioxide ($ClO_2$) concentration and treatment method for maintaining marketability in strawberries 'Maehyang' for export. After harvesting strawberry colored with $60{\pm}5%$ of the skin, and the gaseous $ClO_2$ was applied as four treatments in the cold store set with $10^{\circ}C$ which were as follows: i) non-treatment (Control), ii) $0.2mg{\cdot}L^{-1}$ for 30 minutes, iii) $0.4mg{\cdot}L^{-1}$ for 30 minutes, and iv) continuously exposed at $0.4mg{\cdot}L^{-1}$ during the storage period. Weight loss, firmness, soluble solids content, color, incidence of gray mold, and quality grade of strawberries were investigated every 3 days during 16 days storage in cold store. The weight loss was consistently high at $0.2mg{\cdot}L^{-1}\;ClO_2$ treatment, and the weight loss was lower than other treatments when gaseous $ClO_2$ was continuously treated. Firmness was significantly higher at 0.2 and $0.4mg{\cdot}L^{-1}$ $ClO_2$ treatment on the 13th day of storage. Soluble solids content tended to below in continuous gaseous $ClO_2$ treatment. The colors showed no tendency as affected by concentrations and treatment methods of gaseous $ClO_2$. No gray mold was observed in the continuous gaseous $ClO_2$ treatment until the 13th day of storage. The quality grade was lower in gaseous $ClO_2$ treatment group than in the control. As a result, it was possible to decrease the weight loss and the incidence of gray mold by continuously treating the gaseous $ClO_2$ to strawberry 'Maehyang' for export during the storage period after harvest. However, further research is needed on method to maintain quality grades of fruits.

• Journal of Korean Society for Atmospheric Environment
• /
• v.18 no.4
• /
• pp.317-325
• /
• 2002

An air pollution monitoring station has been operated at Tokchok Island since April 1999 to characterize the background atmosphere in the vicinity of the Yellow Sea. In this study, eight chemical species in PM$_{2.5}$ and three gaseous species were analyzed. A total of 53 samples were collected for the analysis of PM$_{2.5}$ and gaseous species from April, 1999 to April, 2001. The overall mean mass concentration of PM$_{2.5}$ was 20.8 $\mu\textrm{g}$/㎥ and the eight soluble ionic species accounted for about 46.8% of PM$_{2.5}$ mass. Approximately 80% of samples appeared to experience the chloride loss effect. Air pollutant sources of PM$_{2.5}$ measured at Tokchok Island were qualitatively identified by the principal component analysis. It was found that five principal components are secondary aerosol, soil, incineration, phase change of nitrate, and ocean.and ocean.

• Horticultural Science & Technology
• /
• v.34 no.4
• /
• pp.626-633
• /
• 2016

The objective of this study was to assess the effect of precooling and application of gaseous $ClO_2$ on the retention of freshness and quality of 'Maehyang' strawberry fruits intended for export. 'Maehyang' strawberry fruits (Fragaria ${\times}$ ananassa Duch.) were grown in commercial greenhouses and then harvested. Fruits of uniform and medium size at 60% ripeness were selected and assigned to one of four treatment groups: non-treatment (control), precooling only (PO), gaseous $ClO_2$ only (GCO) or precooling combined with gaseous $ClO_2$ (P + C). Weight loss was lowest in the PO treatment and greatest in the GCO treatment after export. Compared to the control and PO treatment groups, strawberry fruits in the GCO treatment group maintained high brightness and high chroma. Six days after shipping, fruits in the P + C treatment group had the highest soluble solids content, even as high as $10.05^{\circ}Brix$; the lowest value was observed in the PO treatment. The incidence rate of gray mold in strawberry fruits was 20% and 17% in the control and the PO treatment, respectively; in the GCO treatment, the incidence rate of gray mold amounted to 10%. No gray mold was observed in the P + C treatment group. These results indicate that gaseous $ClO_2$ treatment combined with precooling (P + C) was effective in maintaining the freshness of 'Maehyang' strawberry fruits intended for export from South Korea to Hong Kong.

• Journal of Korean Society for Atmospheric Environment
• /
• v.11 no.2
• /
• pp.185-190
• /
• 1995

Recently, because of the worse of the air pollution, the excessive airtught of building and the inferiority of air conditioning system, the development of high efficiency air purification technology was enlarged to the environmental improvement of an indoor or a harmful working condition. The air purification technology has used chemical filters or charcoal filters or charcoal to remove hazardouse gaseous pollutants (SO$_{x}$, NO$_{x}$, NH$_{3}$, etc.) by air pollutant control technology, but they have many problems of high pressure loss, short life, wide space possession, and treatment of secondary wastes. For these reason, the object of reasearch shall be hazardous gaseous pollutants removal by the surface discharge induced plasma chemical process that is A.C. discharge of multistreams applied A.C. voltage and frequency between plane induced eletrode and line discharge eletrode of tungsten, platinum or titanium with a high purified alumina sheet having a film-like plane. As a result, the control performance for hazardous gaseous pollutants showed very high efficiency in the normal temperature and pressure. Also, after comtact oxidation decomposition of harmful gaseous pollutants, the remainded ozone concentration was found much lower than that of ACGIH or air pollution criteria in Korea.rea.

• Journal of the Korean institute of surface engineering
• /
• v.51 no.4
• /
• pp.249-255
• /
• 2018

High temperature and low temperature gaseous nitriding was performed in order to study of the surface hardening and wear properties of the nitrided AISI 410 Martensitic stainless steels. High temperature gaseous nitiridng (HTGN) was carried out using partial pressure $N_2$ gas at $1,100^{\circ}C$ for 10 hour, and Low temperature gaseous nitiridng (LTGN) was conducted in a gas mixture of NH3 and N2 at $470^{\circ}C$ for 10 hour. The nitrided samples were characterized by microhardness measurements, optical microscopy and scanning electron microscopy. The phases were identified by X-ray diffraction and nitrogen concentration was analyzed by GD-OES. The HTGN specimen had a surface hardness of about $700HV_{0.1}$, $350{\mu}m$ of case depth. A ${\sim}50{\mu}m$ thick, $1,250HV_{0.1}$ hard nitrided case formed at the surface of the AISI 410 steel by LTGN, composed nitrogen supersaturated expanded martensite and ${\varepsilon}-Fe_{24}N_{10}$ iron nitrides. Additionally, the results of the wear tests, carried out LTGN specimen was low friction coefficient and high worn mass loss of ball. The increase in wear resistance can be mainly attributed to the increase in hardness and to the lattice distortion caused by higher nitrogen concentration.

• Bulletin of the Korean Chemical Society
• /
• v.32 no.12
• /
• pp.4258-4264
• /
• 2011

The total mercury concentration ($Hg_T$) of surface snow samples collected along a ~1500 km transect in east Queen Maud Land was determined using inductively coupled plasma sector field mass spectrometry to address the behavior of Hg on the Antarctic Plateau. Due to the volatile nature of mercury, measures were taken against Hg loss from standard solutions by choosing appropriate container material and stabilizing agents. Glass bottles with Teflon-lined caps were superior to Teflon and polyethylene containers in protecting against Hg loss, but addition of gold chloride ($AuCl_3$) or bromine chloride (BrCl) was necessary to ensure preservation of Hg. As Hg loss was also observed in snowmelt samples, our analysis may underestimate the actual amount of HgT in the snow. Even so, the measured HgT was still very low (< 0.4-10.8 pg $g^{-1}$, n = 44) without a signal of depositional enhancement accompanying photo-oxidation of atmospheric elemental mercury in austral midsummer. Moreover, the dynamic variation along the traverse implies spatial and temporal heterogeneity in its source processes.

• Asian Journal of Turfgrass Science
• /
• v.6 no.1
• /
• pp.23-28
• /
• 1992

Urea, the major N source of world agriculture involves a serious urea-N loss through NH$_3$volatilization. Approaches to decrease N loss include using urease inhibitors in view of the environmental protection and the increase of urea-N efficiency. The purpose of laboratory researches was toassess the potential value of urease inhibitors to increase urea-N efficiency in soil and Kentucky blue-grass(Poa Pratensis L.) turf. The activity of urease inhibitors Phenyiphosphorodiamjdate(ppD) and N-(n-butyl) thiophosphoric triamjde(NBPT) measured to break-down ammonia volatilization. The soil and turf used in this project were from the fairway in one of the Korean gof course. The researches were carried out for two weeks to measure the urease activities on urea hydrolysis under four temperatures (10~ 40$^{\circ}C$) and for one week on turfgrass using forced-draft system. Results indicated that Urea-N involves considerable loss through gaseous NH$_3$ by urease activities in plant-soil systems. Urease inhibitors PPD and NBPT have potential value for increasing N use efficiency by reduing NH$_3$ volatilization. NBPT deserves futher evaluation as fertilizer amendment than PPD use of urea in turf industries.

• Journal of Plant Biology
• /
• v.14 no.3
• /
• pp.43-46
• /
• 1971

Losses of nitrogenin the gaseous form were determined with closed systems in the filed under different vegetation types. Ammonia volatilization was greatest from the pine stand, and least from the sod stand, and was greatly reduced in all three sites in the rainy season due to the low temperature. There were only insignificant differences in the nitrogen dioxide volatilization from the soil of the three vegetation types. Losses of ammonia and nitrogen dioxide at various soil depth also showed little variation. Evidently the microbial activity responsible for the $NO_2$ loss was relatively unaffected by the changes in temperature and soil moisture content during the investigation.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.39-39
• /
• 2017

In Asia, sweet potato (Ipomoea batatas) is a very important crop for starch production. Approximately 74.3% of the total sweet potato production quantity is produced in Asia (FAO, 2014) and China is the largest producer of sweet potato. Post-harvest management is particularly important because it is difficult to maintain the quality as well as quantity of sweet potatoes. Despite the importance of post-harvest management, researches on sweet potato have been focused on production-related study such as breeding of new variety, improved techniques of cultivation, so there is limited research on storage after harvest. Curing is a normal practice after sweet potato harvest to promote wound healing and extend postharvest storage life. In Korea, harvested sweet potatoes are usually cured for 4 to 7 days at $30-33^{\circ}C$ and 80-95% relative humidity within one week. Since the optimum storage temperature of sweet potato is regarded as $15-20^{\circ}C$, additional facilities and costs are required to raise the temperature for curing. However, the majority of small farmers do not have the capacity to provide additional facilities and costs. This study was initiated to suggest a new curing method to accelerate the wound healing by applying chemical oxidation to the wound surface of sweet potato. Oxidative stress is known to play an important role in the synthesis of secondary metabolites including lignin. In addition, chemical oxidation can be applied to prevent spoilage caused by microorganisms. Powerful gaseous oxidant with excellent penetration ability and superior sterilization effect was selected for this study. Lignification, weight loss, and spoilage rate of artificially wounded sweet potatoes were investigated after oxidant fumigation. There were clear differences in morphological analysis such as lignification pattern, lignin deposition color, and continuity of lignified cell layers between oxidant-fumigated sweet potatoes and control. These results show that gaseous oxidant can be used to supplement or replace the curing practice, to improve shelf-life as well as curing cost reduction.

• Journal of the Korean institute of surface engineering
• /
• v.54 no.5
• /
• pp.267-277
• /
• 2021

Nitriding layers developed during gaseous nitriding of AISI4115 steels for the application of steel bushing part were investigated. The compound layer thickness of about 10㎛, 0.3mm of case depth under the same conditions, and conventional nitriding, nitrocarburizing, and controlled nitriding were performed in three methods. In the controlled nitriding, K_N was controlled by measuring the hydrogen partial pressure. The nitrided samples were analyzed by micro Vickers hardness test, optical microscopy and scanning electron microscopy. The phases of compound layer were identified by X-ray diffraction and electron backscatter diffraction. The controlled nitriding specimen indicated the highest surface hardness of about 860 HV_0.1. The compound layer of the conventional nitriding and nitrocarburizing specimen was formed with about 46% porous layer and 𝜺 + 𝜸' phase, and about 13% porous layer and about 80% 𝜸' phase were formed on the controlled nitriding specimen. As a result of the Ball-on-disk wear test, the worn mass loss of ball performed on the surface of the controlled nitriding specimen was the largest. The controlled nitriding specimen had the highest surface hardness due to the lowest porous percentage of compound layer, which improved the wear resistance.