• 한국초전도저온공학회:학술대회논문집
• /
• 한국초전도저온공학회 2002년도 학술대회 논문집
• /
• pp.185-188
• /
• 2002

In the design of superconducting power equipments such as transformer, cable and fault current limit, knowledge of the dielectric behavior of both liquid and gaseous at very low temperatures is very importance. Especially, Electrical properties of liquid nitrogen($LN_{2}$) and gaseous nitrogen($GN_{2}$) have become of great interest again since the discovery of high temperature superconductors. However, many sources of $LN_{2}$and $GN_{2}$ problems in the test of pancake coil model arising form the deficiency of insulation data. Therefore, this paper describes the results of an experimental study on the ac breakdown voltage($V_{B}$) properties of $LN_2$ and Air under the electrode of simulated HTS pancake coil. The ac breakdown voltage of $GN_{2}$ have been measured by pancake coil-pancake coil gaps over the temperature range of 293 K to 77 K.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2009년도 동계학술발표회 논문집
• /
• pp.361-362
• /
• 2009

High-order harmonics from gaseous atoms driven by an intense femtosecond laser pulse can form an attosecond pulse train. By selecting suitable harmonic generation conditions, the harmonic spectrum can be broad enough to form sub-hundred attoseconds. One serious limitation, however, comes from the inherent attosecond chirp originating from the harmonic generation process. We have proposed to compensate for the positive attosecond chirp by making use of negative group delay dispersion of a metallic x-ray filter or a gaseous medium. We generated 240-as pulses from neon and compressed them to 60 as after propagating through argon, close to the transform-limited duration of 47 as.

• 환경위생공학
• /
• 제14권1호
• /
• pp.24-30
• /
• 1999

A biological filter for treatment of toluene among volatile organic compounds was studied. The investigation was conducted using specially built stainless steel columns packed with granular activated carbon and cold for removal of toluene. The G.A. and mold as filter material was also coated with Pseudomonas putida microorganisms.The biofilter unit was operated in the condition of moisture content vairation at gas loading rate of 12.5 l/min. Gaseous toluene taken from tedlar bag was analyzed by the use of G.C equipped with F.I.d detector. The removal efficiency of gaseous toluene was 95% at average inlet concentration of 950 ppm during bio-degradation operating condition. Effective removal efficiency was obtained with moisture content 27.5% at activated carbon and 32% at mold in this study. The effective operating condition were obtained with pH 6-8, temperature 28-42℃ for microbial degradation at gas loading rate of 12.5 l/min in packed material.

• 대한전기학회논문지
• /
• 제32권7호
• /
• pp.227-233
• /
• 1983

Noticing that action of gaseous phase in insulating oil concerns to the discharging characteristics, I investigated the smalness pressure effects on quantity of the partial discharge and discharging pulse frequency. Tests are carried out between the niddle points in insulating oil at pressure being changed by gradual charge of inert gas Ar. At pressure as low as of 0.1-0.5 torr pulse frequency and maximum partial discharge reach peak while at pressure haigher than 20 torr no pulse is observed. The fact that pulse frequency has peak value at certain presure, which is changed either by charging Ar or by adding oil, implies that the action of gaseous phase depends on pressure. Test results are that partial discharge pulse are governed by pressure of Ar-charged oil, and less partial discharge pulses correspond to smaller bubbles whereas more partial descharge pulses correspond to larger bubbles.

• 설비공학논문집
• /
• 제18권8호
• /
• pp.672-677
• /
• 2006

The steady cooling characteristics of a cryochamber for infrared (IR) detector have been investigated analytically, considering radiation shields. The thermal modeling considers the conduction heat transfer through cold finger, the gaseous conduction due to out-gassing, and the radiation heat transfer. The cooling load of the cryochamber is obtained by using a fin equation. The results obtained indicate that the gaseous conduction plays an important role in determining the steady cooling load. The steady cooling load is increased as the gas pressure is increased. It is also found that the cooling load is substantially decreased with a radiation shield. The most thermal load of a cryochamber occurs through the cold finger.

• 한국세라믹학회지
• /
• 제19권2호
• /
• pp.145-151
• /
• 1982

Many materials such as silica gel, metallic oxide, activated alumina and alkaline earth metal carbonates were employed as filter media for gaseous oxides of ruthenium volatilized during high level radioactive waste processing. The adsorption efficiency of ruthenium on these materials was evaluated. For the purpose of observing behavior of ruthenium oxides, thermogravimetric analysis of ruthenium oxide in a stream of oxygen was carried out. The rate of volatilization was proportional to the square root of oxygen partial pressure, and increased exponentially with temperature. At $650^{\circ}C$, gaseous ruthenium oxides showed a strongly marked effect of deposition. Of all the materials available, calcium oxide proved to be the best that could be used to adsorb ruthenium.

• Journal of Radiation Protection and Research
• /
• 제6권1호
• /
• pp.41-44
• /
• 1981

A method is presented by which precise evaluation of radioactive concentrations in liquid or gaseous effluent released from large nuclear facilities is possible. Calculations have been made of the calibration constants at different energies for a commonly used liquid and gaseous effluent monitors as well. It is expected that the method could be applicable to the particular monitors with different geometrical configuration with simple modifications.

• Journal of Advanced Marine Engineering and Technology
• /
• 제31권3호
• /
• pp.272-281
• /
• 2007

A numerical simulation on nitrogen gas flow in a long parallel plate microchannel was performed to obtain the effect of compressibility and rarefaction on gaseous flow in microchannels. The simulation was based on steady. two dimensional compressible Navier-Stokes and energy equations with noslip and first order slip boundary conditions. The channel was $1.2{\mu}m$ deep and $3000{\mu}m$ long. The Reynolds numbers were in the range of order from $10^{-2}$ to $10^{-1}$. So the flow was assumed to be laminar. The computations were performed on various pressure ratios. The outlet pressure was fixed to atmospheric pressure. The outlet Knudsen number was 0.0585, consequently the flow was in the slip flow regime. The computations were performed with the assumption of isothermal channel walls. The results were compared with the experimental data. The agreement was good.

• 한국안전학회지
• /
• 제9권1호
• /
• pp.146-154
• /
• 1994

A series of numerical calculations are performed in order to investigate the dispersion mechanism of toxic gaseous and solid pollutants in extremely short-term and short range. The calculations are carried out in an open space characterized by turbulent boundary layer. The simulation is made by the use of numerical model, in which a control-volume based finite difference method is used together with the SIMPLEC algorithm for the resolution of the pressure-velocity coupling problem. The Reynolds stresses are solved by two-equation, k-$\varepsilon$ model modified for buoyancy. The major parameters consider-ed in this study are temperature, velocity and Injection height of toxic gases, environmental conditions such as temperature and velocity of free stream air, and topographic factor. The results are presented and discussed in detail. The flow field is commonly characterized by the formation of a strong recirculation zone due to the upward motion of the hot toxic gas and ground shear stress. The driving force of the upward motion is explained by the effect of thermal buoyancy of hot gas and the difference of inlet velocity between toxic gas and free stream.

• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2007년도 춘계학술대회
• /
• pp.784-787
• /
• 2007

A process flowsheet simulation model based on ASPEN PLUS was developed to investigate the effect of co-gasification of coal and rice husk on the gasifier performance and pollutant emissions in IGCC power plant. The analyses were done for an 02-blown, pulverized gasifier using coal and rice husk as feedstock, parameter employed the blending ratio of rice husk in coal were investigated. From the simulation results, it was found that gaseous pollutant emissions were reduced substantially with the increase of the blending ratio of rice husk. An optimum range between 15% and 25% rice husk-to-coal ratio was found to be the optimum point in terms of gaseous pollutant emission per energy output for sui fur and nitrogen compounds.