• Journal of the Korean Institute of Telematics and Electronics S
• /
• v.36S no.1
• /
• pp.123-132
• /
• 1999

In this paper, a quadratic sigmoid neural equalizer(QSNE) is proposed to improve the performance of conventional neural equalizer in terms of bit error probability by using a quadratic sigmoid function as the activation function of neural networks. Conventional neural equalizers which have been used to compensate for nonlinear distortions adopt the sigmoid function. In the case of sigmoid neural equalizer, each neuron has one linear decision boundary. So many neurons are required when the neural equalizer has to separate complicated structure. But in case of the proposed QSNF and quadratic sigmoid neural decision feedback equalizer(QSNDFE), each neuron separates decision region with two parallel lines. Therefore, QSNE and QSNDFE have better performance and simpler structure than the conventional neural equalizers in terms of bit error probability. When the proposed QSNDFE is applied to communication systems and digital magnetic recording systems, it is an improvement of approximately 1.5dB~8.3dB in signal to moise ratio(SNR) over the conventional decision feedback equalizer(DEF) and neural decision feedback equalizer(NDFE). As intersymbol interference(ISI) and nonlinear distortions become severer, QSNDFE shows astounding SNR shows astounding SNR performance gain over the conventional equalizers in the same bit error probability.

• Journal of Communications and Networks
• /
• v.12 no.5
• /
• pp.442-448
• /
• 2010

Cooperative relaying methods have attracted a lot of interest in the past few years. A conventional cooperative relaying scheme has a source, a destination, and a single relay. This cooperative scheme can support one symbol transmission per time slot, and is caned full rate transmission. However, existing fun rate cooperative relay approaches provide asymmetrical gain for different transmitted symbols. In this paper, we propose a cooperative relaying scheme that is assisted with dual relays and provides full transmission rate with the same macro-diversity to each symbol. We also address equalization for the dual relay transmission system in addition to addressing the issues concerning the improvement of system performance in terms of optimal power allocations.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.31 no.9C
• /
• pp.840-845
• /
• 2006

This paper presents a partial response maximum likelihood (PRML) detection method using partial response signal-to-noise ratio (PRSNR) that evaluates the signal quality of asymmetric optical recording channel. It is confirmed that the equalizer maximizing the PRSNR value can be most properly adapted to the asymmetric optical recording channel. The proposed PRML detection using this result has 1.8dB SNR gain at $8.5{\times}10-5$ bit error rate compared to PRML detection using typical adaptive equalizer.

• International journal of advanced smart convergence
• /
• v.9 no.3
• /
• pp.141-144
• /
• 2020

Iterative decision feedback equalizer (IDFE) is a recursive equalization technique that can help to achieve an additional performance gain for the system by combining iterative channel decoding and interference cancellation. In a single carrier-based system, the intersymbol interference (ISI) is a critical problem that must be resolved since it causes frequency selective fading. Based on the idea of sharing the estimated information in the process of iteration, IDFE is considered as an efficient solution to improve the robustness of the system performance on the ISI channel. In this paper, the IDFE is applied on single carrier FDMA (SC-FDMA) system to evaluate the performance under ISI channel. The simulation results illustrate that IDFE helps to improve the performance of the SC-FDMA system, especially with long delay spread channels.

• Journal of Communications and Networks
• /
• v.14 no.3
• /
• pp.273-279
• /
• 2012

In this paper, we propose an iterative interstream interference cancellation technique for system with frequency selective multiple-input multiple-output (MIMO) channel. Our method is inspired by the fact that the cancellation of the interstream interference can be regarded as a reduction in the magnitude of the interfering channel. We show that, as iteration goes on, the channel experienced by the equalizer gets close to the single input multiple output (SIMO) channel and, therefore, the proposed SIMO-like equalizer achieves improved equalization performance in terms of normalized mean square error. From simulations on downlink communications of $2{\times}2$ MIMO systems in high speed packet access universal mobile telecommunications system standard, we show that the proposed method provides substantial performance gain over the conventional receiver algorithms.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.12
• /
• pp.71-79
• /
• 2013

This paper describes a 12.5 Gb/s low-power receiver design with equalizer adaptation. The receiver adapts to channel and chip process variation by adaptation circuit using sampler and serializer. The adaptation principle is explained. It describes technique receiving ground referenced differential signal of voltage-mode transmitter for low-power. The CTLE(Continuous Time Linear Equalizer) having 17.6 dB peaking gain to remove long tail ISI caused channel with -21 dB attenuation. The voltage margin is 210 mV and the timing margin is 0.75 UI in eye diagram. The receiver consumes 0.87 mW/Gb/s low power in 45 nm CMOS technology.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.8A
• /
• pp.785-793
• /
• 2007

This paper presents the digital signal processing submodule of a 100Base-TX Ethernet receiver to support 100Mbps at TP cable channel. The proposed submodule consists of programmable gain controller, timing recovery, adaptive equalizer and baseline wander compensator. The measured Bit Error Rate is less than $10^{-12}BER$ when continuously receiving data up to 150m. The proposed signal processing submodule is implemented in digital circuits except for PLL and amplifier. The performance improvement of the proposed equalizer and BLW compensator is measured about 1dB compared with the existing architecture that removes BLW using errors of an adaptive equalizer. The architecture has been modeled using Verilog-HDL and synthesized using samsung $0.18{\mu}m$ cell library. The implemented digital signal processing submodule operates at 142.7 MHz and the total number of gates are about 128,528.

• Journal of Korea Society of Industrial Information Systems
• /
• v.17 no.7
• /
• pp.9-16
• /
• 2012

In order to extend cell coverage and to cope with shadow areas, a relay-assisted wireless communications system has been widely studied. In this paper, we propose new equalization method for single carrier (SC) frequency domain equalizer (FDE) in amplify-and-forward (AF) relaying multi-path networks to improve the performance at shadow areas. The performance of SC-FDE system in 3-slot based multi-path networks can be improved considerably with the diversity gain which we obtain by equalizing the combined signal from relays by means of the minimum mean square error (MMSE) criteria. We find the weighting coefficients of maximum ratio combining (MRC) and the tap coefficients of MMSE equalizer for SC-FDE in AF relaying multi-path networks. Simulation results show that the proposed system considerably outperforms the conventional SC-FDE system.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.15 no.4
• /
• pp.779-784
• /
• 2020

In this paper, we improved the high frequency noise characteristics of the previously proposed hearing aid circuits for presbycusis, and we designed and fabricated a stereo hearing aid module. The cause of high frequency noise, which occurs in some cases in the previous circuits under high gain conditions, was analyzed through simulations. Two mute switches were added to adjust each boosting gain for right and left ears more accurately by muting the sound of the other ear when adjusting the gain of one ear in the stereo hearing aid module.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.24 no.7A
• /
• pp.1005-1015
• /
• 1999

This paper is concerned with an improvement on IFFT (inverse fast Fourier transform) and FFT based baseband digital implementation algorithm for BPSK (binary phase shift keying)-modulated MC-CDMA (multicarrier-code division multiple access) systems, that is functionally equivalent to the conventional implementation algorithm, while reducing computational complexity and bandwidth requirement. We also derive an equalizer structure for the proposed implementation algorithm. The proposed algorithm is based on a variant of FFT algorithm that utilizes a N/2-point FFT/IFFT for simultaneous transformation and reconstruction of two N/2-point real signals. The computer simulations under additive white Gaussian noise channels and frequency selective fading channels using equal gain combiner and maximal ratio combiner diversities, demonstrate the performance of the proposed algorithm.