• Journal of Institute of Control, Robotics and Systems
• /
• v.15 no.12
• /
• pp.1169-1174
• /
• 2009

In this paper, a prototype of implementable Sun tracking algorithm for mobile systems powered by alternative energy is proposed. The proposed system uses 2-axis tilt sensor and 3-axis magnetic sensor to measure orientation and posture of the system according to the horizon coordinates system, which are used to compensate tilt effects. Then through astronomical calculation using the present time and position informations obtained from GPS sensors, the calculated azimuth and altitude of the Sun in that location. The position of the Sun is converted to that of the mobile Sun tracking system coordinates and used to control A-axis and C-axis of the system.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.35 no.11A
• /
• pp.1078-1084
• /
• 2010

The tracking performance of a big parabola tracking antenna system for tracking and receiving of the signal from the vehicle is impacted by many factors of the internal and the external of the system. In this paper, we analyze the tracking error due to the radio refraction in the application of the tracking and positioning of the vehicle by using radio frequency. The real measurement data are used for the analysis which had been acquired by using GPS and the tracking systems of C- and S-band frequencies in NARO Space centre. To verify the correlation between the tracking errors measured and the radio refraction, we review the error factors and the accuracies of the tracking systems, and the characteristics of the refractivity. The analysis shows that there are angular errors which are due to the radio refraction and not to be neglected, compared to the accuracies of the tracking systems, in case of low elevation angle less than 10 degrees. Also, the tracking errors depend on the target altitude as well as the elevation angle for the case of the target in the troposphere. It is recommended to correct the tracking angle considering the target altitude and elevation angle for the precise target positioning.

• Journal of Positioning, Navigation, and Timing
• /
• v.2 no.1
• /
• pp.75-80
• /
• 2013

This article presents the design of long range navigation (LORAN)-disciplined oscillator (LDO), employing the timing information of the LORAN system, which was developed as a backup system that corrects the vulnerability of the global positioning system (GPS)-based timing information utilization. The LDO designed on the basis of hardware generates a timing source synchronized with reference to the timing information of the LORAN-C receiver. As for the LDO-based timing information measurement, the Kalman filter was applied to estimate the measurement of which variance was minimized so that the stability performance could be improved. The oven-controlled crystal oscillator (OCXO) was employed as the local oscillator of the LDO. The controller was operated by digital proportional-integral-derivative (PID) controlling method. The LDO performance evaluation environment that takes into account the additional secondary factor (ASF) of the LORAN signals allows for the relative ASF observation and data collection using the coordinated universal time (UTC). The collected observation data are used to analyze the effect of ASF on propagation delay. The LDO stability performance was presented by the results of the LDO frequency measurements from which the ASF was excluded.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.37C no.9
• /
• pp.811-820
• /
• 2012

GNSS signal is vulnerable to jamming signal because of well-known signal structure and weak signal power. For these reasons, the need for analysis of jamming effects and anti-jamming techniques of is increasing. In this paper, a GNSS signal generator is designed which includes a radio wave propagation model for six kind of tactical environments and a body masking model for the reception environment of a vehicle. The radio wave propagation model for downtown, rural, forest, coastline, waste land and snow or ice area is designed using two-ray model. The body masking model is designed the effect which the antenna is affected by the reception environment of a vehicle and radiation pattern from a user configuration. The performance of generated signals from the GNSS signal generator considering reception environment of a vehicle is evaluated by a commercial GPS L1 receiver(NordNav) in normal and jamming environment. Also, the generated GNSS signal is compared to a commercial GPS L1 H/W based RF signal generator(STR4500). The results show that the designed GNSS signal generator in a normal environment compared to the same navigation performance. In jamming environment, it is shown that the body masking effect and GNSS signal acquisition and tracking loss in compliance with the jamming signal are precisely working in the reception environment of a vehicle.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.4
• /
• pp.9-21
• /
• 2008

In this paper, we propose a GNSS-based RF receiver, A high precision localization architecture, and a high sensitivity localization architecture in order to solve the satellite navigation system's problem mentioned above. The GNSS-based RF receiver model should have the structure to simultaneously receive both the conventional GPS and navigation information data of future-usable Galileo. As a result, it is constructed as the multi-band which can receive at the same time Ll band (1575.42MHz) of GPS and El band (1575.42MHz), E5A band (1207.1MHz), and E4B band (1176.45MHz) of Galileo This high precision localization architecture proposes a delay lock loop with the structure of Early_early code, Early_late code, Prompt code, Late_early code, and Late_late code other than Early code, Prompt code, and Late code which a previous delay lock loop structure has. As we suggest the delay lock loop structure of 1/4chips spacing, we successfully deal with the synchronization problem with the C/A code derived from inaccuracy of the signal received from the satellite navigation system. The synchronization problem with the C/A code causes an acquisition delay time problem of the vehicle navigation system and leads to performance reduction of the receiver. In addition, as this high sensitivity localization architecture is designed as an asymmetry structure using 20 correlators, maximizes reception amplification factor, and minimizes noise, it improves a reception rate. Satellite navigation system repeatedly transmits the same C/A code 20 times. Consequently, we propose a structure which can use all of the same C/A code. Since this has an adaptive structure and can limit(offer) the number of the correlator according to the nearby environment, it can reduce unnecessary delay time of the system. With the use of this structure, we can lower the acquisition delay time and guarantee the continuity of tracking.

• Journal of Aerospace System Engineering
• /
• v.16 no.4
• /
• pp.10-16
• /
• 2022

Since aviation systems are developed as the complex form of software a hardware, the necessity to apply to relevant guidelines is increasing. It is however uncommon that international development guidelines regarding electronic hardware are applied to current domestic aviation systems. In this paper, we compare and analyze DO-254 and ECSS-Q-ST-60-02C, electronic hardware development guidelines with the case of KASS (Korea Augmentation Satellite System) Performance Suitability, based on the project of SBAS (Satellite Based Augmentation System) development and construction.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.39C no.6
• /
• pp.457-465
• /
• 2014

This paper introduces a test bed for communication protocol schemes of underwater acoustic sensor network, and also shows experimental results obtained from the test bed. As a testing protocol, carrier sense multiple access/collision avoidance (CSMA/CA) is evaluated on underwater acoustic channel. A sensor node is equipped with a DSP control board of ATmega2560 and a commercial underwater modem produced by Benthos. The control board not only manipulates a GPS signal to acquire the information of location and time, but also controls the underwater modem to operate according to the procedure designed for a given testing protocol. Whenever any event takes place such as exchanging control/data packets between underwater modems and acquiring location and timing information, each sensor node reports them through radio frequency (RF) air interface to a central station located on the ground. The four kinds of packets for CSMA/CA, RTS(Request To Send), CTS(Clear to Send), DATA, ACK(Acknowledgement) are designed according to the underwater communication environment and are analyzed through the lake experiment from the point of feasibility of CSMA/CA in underwater acoustic communications.

• Journal of IKEEE
• /
• v.23 no.2
• /
• pp.743-746
• /
• 2019

In this paper we proposed a new ocean radiation automatic monitoring system. The proposed system has the following characteristics: First, using NaI + PVT mixed detectors, the response speed is fast and precision analysis is possible. Second, the application of temperature compensation algorithm to scintillator-type sensors does not require additional cooling devices and enables stable operation in the changing ocean environment. Third, since cooling system is not needed, electricity consumption is low, and electricity can be supplied reliably by utilizing solar energy, which can be installed at the observation deck of ocean environment. Fourth, using GPS and wireless communications, accurate location information and real-time data transmission function for measurement areas enables immediate warning response in the event of nuclear accidents such as those involving neighboring countries. The results tested by the authorized testing agency to assess the performance of the proposed system were measured in the range of $5{\mu}Sv/h$ to 15mSv/h, which is the highest level in the world, and the accuracy was determined to be ${\pm}8.1%$, making normal operation below the international standard ${\pm}15%$. The internal environmental grade (waterproof) was achieved, and the rate of variation was measured within 5% at operating temperature of $-20^{\circ}C$ to $50^{\circ}C$ and stability was verified. Since the measured value change rate was measured within 10% after the vibration test, it was confirmed that there will be no change in the measured value due to vibration in the ocean environment caused by waves.

• Proceedings of the Materials Research Society of Korea Conference
• /
• 2003.11a
• /
• pp.130-130
• /
• 2003

현재, 메탈의 내부식성 코팅막 제조에 사용되고 있는 크로메이트 기반 코팅제는 유독성 물질에 대한 환경 규제에 따라 조만간 사용이 금지 될 예정이다. 본 연구에서는 이러한 유독성 금속 내부식성 코팅제를 대체할 새로운 환경 친화적인 코팅 재료로서 A1OOH 나노졸이 분산된 ZrOCl$_2$ㆍ8$H_2O$-GPS(3-Glycidoxypropyltrimethoxysilane)하이브리드 졸을 제조하고 이의 내 부식성 특성에 대하여 조사하였다. AlOOH 졸이 첨가된 유/무기 하이브리드 졸은 염화 알루미늄을 염기로 침전 시킨 수산화 알루미늄 침전물에ZrOCl$_2$ㆍ8$H_2O$를 10 ~ 20 wt% 첨가하고 열처리한 후 여기에 GPS를 AlOOH에 대하여 4 ~ 6몰 배 첨가하여 제조하였다. 제조된 하이브리드 형 졸은 가시관 투광성이 우수하며 시간에 따른 범도 변화가 거의 없었다. 이 코팅 졸을 아연 도금 강판에 딥 코팅법으로 코팅한 후, 상온~20$0^{\circ}C$에서 열처리하여 염수 시험법으로 하이브리드 졸의 조성 및 열처리 조건에 따른 코팅막의 내부식성 특성을 조사하였다. 또한, 코팅막의 두께를 전자 현미경으로 관찰하였고, 코팅막 경도는 연필 경도계로 조사하였다.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.4C no.6
• /
• pp.310-313
• /
• 2004

Spurred by the constant pressure to achieve miniaturization, researchers have designed many different types of compact antennas. One such type is the slotted patch antenna used for dual band operation. In this paper, we propose a novel method of selecting the feeding point of the antenna, which results in superior antenna performance in terms of return loss. Computer simulations verify the validity of the proposed method.