• Journal of Korea Society of Digital Industry and Information Management
• /
• v.14 no.4
• /
• pp.93-99
• /
• 2018

This paper presents an implementation method using NDK (Network Developer's Kit) of GNU (GNU is Not Unix) Radio and Multicore DSP (Digital Signal Processor) to implement LTE (Long Term Evolution) SDR (Software Defined Radio) Platform. In order to satisfy 1.4MHz, 3MHz, 5MHz and 10MHz of the bandwidth supported by LTE, USRP (Universal Software Radio Peripheral) X series which is an RF (Radio Frequency) transceiver of Ettus Research was used. To control this, GNU Radio which is an open source software radio toolkit was used. We also used NDK from TI (Texas Instruments) DSP to transfer data between USRP and DSP. Experimental results show throughput results according to each bandwidth, thus confirming the feasibility of implementing LTE SDR Platform using GNU Radio and NDK of TI DSP.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.20 no.11
• /
• pp.2014-2020
• /
• 2016

In general, automatic access control management system using smart door-lock must be always exposed to security vulnerability during wireless communication based on Bluetooth. In particular, important information such as a secrete key can be exposed to the attacker when the authentication protocol has been operating in the wireless section. Therefore important information exchanged in the radio section needs to be properly encrypted. In order to analyze security vulnerability for automatic access control management system of public facilities such as subway vent, GNU Radio platform and HackRF device will be considered and experimented. Proposed experimental system to perform software based power analysis attack could be very effectively applied. As a result, important information such as packet type, CRC, length of data, and data value can be easily decoded from wireless packet obtained from HackRF device on GNU Radio platform. Constructed experimental system will be applied to avoid some security problems.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.9 no.3
• /
• pp.674-680
• /
• 2008

An SDR (Software Defined Radio) system based on general purpose computing platform has benefits of ease of software development process, high degree of software compatibility, and cost-effectiveness of general purpose processors. This paper discusses design and implementation of a dual-mode SDR system that supports both cordless phone and walkie-talky system running on Linux-based general purpose computing platform. For this purpose, we designed modulation and demodulation software on open source-based GNU radio middleware. We also designed a customized RF front-end hardware which performs frequency conversion between RF and IF. The proposed SDR system successfully exhibited its ability to operate both cordless phone and walkie-talky communication on Intel processor-based general purpose computing platform. But experience with the prototype SDR system shows that further research is required for run-time software reconfiguration and efficient integration with conventional TCP/IP protocol stacks.

• Journal of Satellite, Information and Communications
• /
• v.7 no.1
• /
• pp.39-47
• /
• 2012

Currently, most of the frequency spectrum resources are allocated and due to the lack of frequency, low frequency band, optimal for wireless communication environment is not used. Therefore, Cognitive Radio (CR) is a critical issue to solve the spectrum scarcity and to improve frequency spectrum utilization in wireless communication. In this paper, we implement data transmission and receive in a real CR system using the USRP(Universal Software Radio Peripheral) board and GNU Radio package of an open source development kit. Concretely, we detect the Primary User by spectrum sensing, and then we send Primary User information to the database. After receiving the information, because the database already sent optimal transmit power, bandwidth and channel information to CR equipment, CR can communicate without any interference to Primary User.

• Information and Communications Magazine
• /
• v.27 no.8
• /
• pp.37-42
• /
• 2010

최근 학계에서 많이 연구되고 있는 무선인지기술(CR : Cognitive Radio)을 실제 하드웨어로 구현하는 경향이 두드러지고 있다[1,2]. 또한 IEEE 802.22의 표준화가 완료되고 미국의 DTV전환과 함께 무선인지기술이 본격적으로 적용되면서 연구된 결과를 실제 시스템에서 구현하여 입증할 필요성이 증가하고 있다. 본 고에서는 대표적인 오픈소스 하드웨어 플랫폼인 GNU Radio에 대해 설명하고 무선인지기술을 적용한 시스템을 소개한다.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.26 no.5
• /
• pp.694-702
• /
• 2022

This paper shows a small and low-powered wireless communication system based on the ATSC broadcasting system using the ISM frequency band that can be used as a PBS(Personal Broadcasting System). It is designed to demonstrate a channel-adaptive CR(Cognitive Radio) system to provide a better service quality in the unlicensed band where co-channel interference exists. And it achieved very reliable communications by a closed-loop active phased array antenna. This ATSC-based personal broadcasting platform can be modified easily with given flexibility by using GNU Radio as an open-source signal processing platform based on USRP and implementing additional functions in FPGA. In addition, the chosen communication frequency resource can be managed and controlled by the return channel that transmits the channel status and communication parameters between transmission and reception in real-time.