• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.4
• /
• pp.263-271
• /
• 2013

A low dropout regulator (LDO) with fast transient responses is presented. The proposed LDO eliminates the trade-off between slew rate and unity gain bandwidth, which are the key parameters for fast transient responses. In the proposed buffer, by changing the slew current path, the slew rate and unity gain bandwidth can be controlled independently. Implemented in $0.18-{\mu}m$ high voltage CMOS, the proposed LDO shows up to 200 mA load current with 0.2 V dropout voltage for $1{\mu}F$ output capacitance. The measured maximum transient output voltage variation, minimum quiescent current at no load condition, and maximum unity gain frequency are 24 mV, $7.5{\mu}A$, and higher than 1 MHz, respectively.

• Journal of the Korean Institute of Telematics and Electronics
• /
• v.23 no.6
• /
• pp.936-943
• /
• 1986

The lasing wavelengths and gain characteristics of the array modes of channel-substrate planar(CSP) lasers are presented. The gain values of array modes are determined from the complex coupling coefficients calculated using the fields of neighborig elements of the array. The computations show that for index guided lasers which have fields that are almost real valued, or have only slight phase curvature, the highest order array mode will have preferred oscillation. The inphase or fundamental mode, which produces only one major lobe in the far-field radiation pattern, will have the lowest modal gain of all array modes. Some of the devices discussed have modal gain differences of less than 10 cm**-1 between the highest and fundamental modes. For optical field confinement factors of about 20%, this gain difference corresponds to avtive layer gains of approximately 50**-1.

• Journal of the Ergonomics Society of Korea
• /
• v.26 no.4
• /
• pp.9-16
• /
• 2007

Input devices of wearable computer are difficult to use, so a lot of alternative pointing devices have been considered in recent years. In order to resolve this problem, this paper proposed a dynamic gain control method which is able to improve the performance of wearable pointing device and showed an experimental result comparing this method with conventional method. Also the effects of methods were compared in terms of device (wearable and desktop). The result of calculating throughputs(index of performance) by Fitts' law showed that the pointing performance in dynamic gain condition was improved 1.4 times more than normal gain.

• Proceedings of the Korea Committee for Ocean Resources and Engineering Conference
• /
• 2000.10a
• /
• pp.216-221
• /
• 2000

This paper deals with the Gain Control in the processing of the underwater acoustic image obtained from side scan sonar(SSS) system. At first, this paper describes the principles of SSS that is a surveying equipment for the underground of the rivers or dams as well as sea floor. Then this paper analyzes the cause and effects of the time varying intensity from the view point of transmission loss and beam pattern. At last, the time varying gain filter that is adopted by the towfish is introduced.

• Journal of electromagnetic engineering and science
• /
• v.6 no.4
• /
• pp.222-228
• /
• 2006

In this paper, the performance of a multiuser diversity system combined with a multi-element transmit antenna system is analyzed under the assumption of independent Rayleigh fading. A measure of system .level performance is an average channel capacity as a function of the number of users and antennas. Average channel capacity is obtained from the instantaneous signal-to-noise ratio(SNR) distribution combined by both transmit diversity(TD) at each link and multiuser diversity at system level. Numerical results show that closed-loop antenna techniques provide an additional gain with multiuser diversity system due to array gain, even though space diversity gain reduces multiuser diversity gain. On the other hand, the space-time block coding(STBC) that provides full order space diversity gain only has a destructive influence on multiuser diversity.

• Proceedings of the KIEE Conference
• /
• 2008.07a
• /
• pp.1722-1723
• /
• 2008

This paper present dynamic stiffness of servo motor using labVIEW PXI module. In speed control loop, we apply proportional gain and integral gain, using PID controller, respectively in servo motor and confirmed dynamic stiffness of servo motor varing each gain. Changing proportional gain and integral gain, confirm what effect in dynamic stiffness are change in frequency response..

• Journal of Power Electronics
• /
• v.11 no.4
• /
• pp.599-605
• /
• 2011

This paper proposes a gain scheduling method that improves the stability of grid-connected systems employing an LCL-filter. The method adjusts the current controller gain through an estimation of the grid impedance in order to reduce the resonance that occurs when using an LCL-filter to reduce switching harmonics. An LCL-filter typically has a frequency spectrum with a resonance peak. A change of the grid-impedance results in a change to the resonant frequency. Therefore an LCL-filter needs a damping method that is applicable when changing the grid impedance for stable system control. The proposed method instantaneously estimates the grid impedance and observes the resonant frequency at the same time. Consequently, the proposed method adjusts the current controller gain using a gain scheduling method in order to guarantee current controller stability when a change in the resonant frequency occurs. The effectiveness of the proposed method has been verified by simulations and experimental results.

• The Transactions of the Korean Institute of Electrical Engineers D
• /
• v.53 no.9
• /
• pp.622-629
• /
• 2004

In practical control systems, the capacity of actuators is limited and this degrades the system performances and it is often a source of instability. To use full capacity of actuators, we adopt the gain scheduled control permitting the over saturation in controls. The basic idea of gain scheduled control is to use a higher gain control when the state variables are smaller and a lower gain control when the state variables are larger. First, we derive a constant H control and a reachable set while satisfying the degree of over saturation. Next, we divide this set into nested subsets and find $H_{\infty}$ controls at rack subsets while satisfying the degree of over saturation. Finally, the control gain is applied according to the status of states. Note that all procedures are done by solving linear matrix inequalities(LMI). Finally, we show the validity and applicability of our proposed control using the simulations of a six-story building subjected to the earthquake excitation.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.5 s.98
• /
• pp.578-585
• /
• 2005

In this paper, we present a schematic method estimating the tracking vibration quantity occurring in the track-following system of an optical recording device. A tracking loop gain adjustment algorithm is introduced to estimate accurately the tracking vibration quantity in spite of the uncertainties of the tracking actuator, Accordingly, the tracking vibration quantity can be estimated from the tracking error, the controller output, the nominal actuator model, and a compensated gain. An optimal tracking controller can be designed from a minimum tracking open-loop gain calculated by the estimated tracking vibration quantity The proposed vibration quantity estimation and controller design method are applied to the track-following system of an optical recording device and are evaluated through the experimental result.

• Korean Journal of Clinical Laboratory Science
• /
• v.45 no.2
• /
• pp.60-65
• /
• 2013

Data from repeated measurements are accomplished through repeatedly processing the same subject under different conditions and different points of view. The power of testing enhances the choice of pertinent analysis methods that agrees with the characteristics of data concerned and the situation involved. Along with the clinical example, this paper compares the analysis of the variance on ex-post tests, gain score analysis, analysis by mixed design and analysis of covariance employable for repeating measure. Comparing the analysis of variance on ex post test, and gain score analysis on correlations, leads to the fact that the latter enhances the power of the test and diminishes the variance of error terms. The concluded probability, identified that the gain score analysis and the mixed design on interaction between "between subjects factor" and "within subjects factor", are identical. The analysis of covariance, demonstrated better power of the test and smaller error terms than the gain score analysis. Research on four analysis method found that the analysis of covariance is the most appropriate in clinical data than two repeated test with high correlation and ex ante affects ex post.