• Tunnel and Underground Space
• /
• v.28 no.1
• /
• pp.97-110
• /
• 2018

The application of sprayed waterproofing membrane with high adhesion and ductility is considered to be promising as a measure for repair and reinforcement of a tunnel structure. Therefore, a powder-type and one-component membrane prototype with high tensile and bond strengths was made in this study. Then, its reinforcement effect on a shield segment was evaluated by carrying out a series of full-scale loading tests of segment specimens on which the membrane was sprayed. From the tests, it was confirmed that the initial cracking loads increased by approximately 34% due to cracking retardation by membrane coating. Even though the increase of failure loads were not so high as cracking loads, the strain-softening behaviors were observed from specimens coated by the membrane. Therefore, it is expected that the membrane coated on the inner surface of a lining might be effective in preventing its brittle failure.

• Journal of Korean Society of Steel Construction
• /
• v.26 no.5
• /
• pp.407-418
• /
• 2014

As a continuing work of previously conducted standard tension tests, full-scale flexural tests were conducted in this study to assess the structural performance the CJP groove welded joints connecting thick HSA800 plates. Two welding electrodes were available at the time of this experimental research; one was GMAW-based electrode A and the other FCAW-based electrode B. Three full-scale box-type beam specimens with single bevel- and V-groove CJP welded joints were fabricated from 60mm and 25mm thick HSA800 plates according to the AWS-prequalified groove welded joint details. In designing the specimens, all possible limit states like local and lateral torsional buckling were carefully controlled in order to induce flexural plastic yielding or eventual joint fracture. All the CJP joints made by both welding electrodes showed satisfactory performance and were able to transfer the tensile flange forces higher than that corresponding to the measured tensile strength of HSA800 flange plates. However, it should be noted that, during fabrication, serious concerns about the welding efficiency and workability of the GMAW-based electrode were raised by a certified welder. The fracture occurred at the unbeveled (or vertical) interface between the weldment and the base metal when the GMAW-based electrode was used in the single-bevel joint, implying the possibility of insufficient melting. Thus, the FCAW-based electrode B is again recommended as the choice of welding electrode for HSA800 plates. The limited test data of this study implies that the V-groove CJP joint should be used in favor of the single bevel CJP joint, if possible.

• Journal of Korean Society of Environmental Engineers
• /
• v.31 no.10
• /
• pp.919-926
• /
• 2009

Enrichment of anaerobic ammonium oxidation (ANAMMOX) bacteria is the essential step for operating full-scale ANAMMOX bioreactor because adding a significant amount of seeding sludge is required to stabilize the ANAMMOX reactor. In this study, the enrichment of ANAMMOX bacteria from an activated sludge using sequencing batch reactor was conducted and verified by analyzing changes in the microbial community structure. ANAMMOX bacteria were successfully enriched for 70 days and the substrate removal efficiencies showed 98.5% and 90.7% for $NH_4\;^+$ and $NO_2\;^-$ in the activity test, respectively. The phylogenetic trees of Planctomycetes phylum showed that the diverse microbial community structure of an activated sludge was remarkably simplified after the enrichment. All 36 clones, obtained after the enrichment, were affiliated with ANAMMOX bacteria of Candidatus Brocadia (36%) and Candidatus Anammoxoglobus (64%) genera. The quantification using real-time quantitative PCR (RTQ-PCR) revea ed that the 16S rDNA concentration of ANAMMOX bacteria was 74.8% compared to the granular ANAMMOX sludge obtained from an upflow ANAMMOX sludge bed reactor which had been operated for more than one year. The results of molecular analysis supported that the enriched sludge could be used as a seeding sludge for a full-scale ANAMMOX bioreactor.

• Journal of Korean Society of Rural Planning
• /
• v.14 no.2
• /
• pp.43-54
• /
• 2008

As almost community facilities in korean rural village have being showed signs of decrepitude, and have a lot of problems on scale and function, it hasn't made full use of almost community facilities. To resolve these problems, it is time to make different plan considered of elements, scale and function in community facilities. In this study, after being researched the present condition and interviewed local residents on target 25 administrative districts, it was sought diverse problems about community facilities and researched satisfaction measurement, activity of local residents. With Being based on this, we also drove from essential element about community facilities in korean rural village and sorted problems of community facilities as general disposition-structure-outdoor facilities-behavioral use. Therefore, it was applied to study area and ascertained the existence of problem. Thus, we found out the improving way for appropriate community facilities in korean rural village. It will be useful to make different plan for community facilities in korean rural village.

• International Journal of High-Rise Buildings
• /
• v.3 no.1
• /
• pp.35-48
• /
• 2014

In designing a 300 meter high skyscraper expected to be the tallest building in Japan, an earthquake-ridden country, we launched on the full-scale performance based design to ensure redundancy and establish new specifications using below new techniques. The following new techniques are applied because the existing techniques/materials are not enough to meet the established design criteria for the large-scale, irregularly-shaped building, and earth-conscious material saving and construction streamlining for reconstructing a station building are also required: ${\bullet}$ High strength materials: Concrete filled steel tube ("CFT") columns made of high-strength concrete and steels; ${\bullet}$ New joint system: Combination of outer diaphragm and aluminium spray jointing; ${\bullet}$ Various dampers including corrugated steel-plate walls, rotational friction dampers, oil dampers, and inverted-pendulum adaptive tuned mass damper (ATMD): Installed as appropriate; and ${\bullet}$ Foundation system: Piled raft foundation, soil cement earth-retaining wall construction, and beer bottle shaped high-strength CFT piles.

• Wind and Structures
• /
• v.14 no.3
• /
• pp.253-283
• /
• 2011

This paper presents the field measurement results of wind effects on a super-tall building (CITIC Plaza, 391 m high) located in Guangzhou. The field data such as wind speed, wind direction and acceleration responses were simultaneously and continuously recorded from the tall building by a wind and vibration monitoring system during two typhoons. The typhoon-generated wind characteristics including turbulence intensity, gust factor, peak factor, turbulence integral length scale and power spectral density of fluctuating wind speed were presented and discussed. The dynamic characteristics of the tall building were determined based on the field measurements and compared with those calculated from a 3D finite element model of the building. The measured natural frequencies of the two fundamental sway modes of the building were found to be larger than those calculated. The damping ratios of the building were evaluated by the random decrement technique, which demonstrated amplitude-dependent characteristics. The field measured acceleration responses were compared with wind tunnel test results, which were found to be consistent with the model test data. Finally, the serviceability performance of the super-tall building was assessed based on the field measurement results.

• Membrane and Water Treatment
• /
• v.8 no.5
• /
• pp.395-409
• /
• 2017

Membrane bioreactor (MBR) is a compact and efficient wastewater treatment and reclamation technology; but, it is limited by membrane fouling. The control of membrane fouling significantly increases operational and maintenance costs. Bacteria and their byproducts - extracellular polymeric substances (EPS) - are major contributors to membrane fouling in MBRs. A recent attempt at fouling mitigation is the development of aerobic granular sludge membrane bioreactor (AGMBR) through the integration of a novel biotechnology - aerobic granulation - and MBR. This paper provides an overview on the development of AGMBR to mitigate membrane fouling caused by bacteria and EPS. In AGMBR, EPS are used up in granule formation; and, the rigid structure of granules provides a surface for bacteria to attach to rather than the membrane surface. Preliminary research on AGMBR using synthetic wastewater show remarkable membrane fouling reduction compared to conventional MBR, thus improved membrane filtration. Enhanced performance in AGMBR using actual municipal wastewater at pilot-scale has also been reported. Therefore, further research is needed to determine AGMBR optimal operational conditions to enhance granule stability in long-term operations and in full-scale applications.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.33 no.2
• /
• pp.104-111
• /
• 1991

In Korea, small-scale reclaimed areas have been suffering from many problems because of the lack of comprehensive developing strategy although considerable investments have been inputed by the public sector since 1970's. For 3 reclaimed sites in Chonnam Province choser as case study areas, the analysis, the second attempt of widely-spanned studies on areal conditions, concentrated on their farming and economic conditions. Its results were as follows ; 1. Although farming pattern has been transferred to the full4ime rice cropping type by the creation of reclaimed paddy field, farming size in the areas has not been increased more than that in existing agricultural areas. This means that agricultural planning should be included in the initial stage of reclamation projects, especially with reference to the substantial enlargement of farming size. 2. Block parcelling of severely fragmented holdings in new and old lands should be carried out, which can make farming activities efficient and farming route shortened. In large-scale reclaimed areas, new village planning could be considered in its central zone for efficent farming. 3. Because soil in the areas contains much more salt and water than that in other areas, new design methodology should be introduced for the efficient use of agricultural machines in reclaimed areas. 4. There are deep-seated economic problems in reclaimed area, which have been caused by very poor level and agriculturally dominated structure of household income. These problems should motivate farmers to give up positive action for qualitative and quantitative improvement in farming.

• Journal of the Society of Naval Architects of Korea
• /
• v.30 no.4
• /
• pp.102-111
• /
• 1993

One of the most important design procedures for large sized structures is the evaluation of fracture strength against fatigue and brittle fractures threatening to occur in their steel members. In this paper, the safety assessment based upon the knowledge about the fracturing characteristics of such ship structures was discussed, which can be estimated from such phenomena as fatigue crack propagation and brittle fractures, as obtained by employing fracture mechanics at the basic design stage. Model tests with a partial structure specimen of full size was carried out to authenticate a question as to whether or not the fracturing characteristics of such sophisticated structures could be estimated with precision from ordinary scale specimen tests, It was shown that the behviour of fatigue crack growth of large sized structures in this study could be predicted from the results of ordinary scale specimen test.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.11 s.104
• /
• pp.1223-1231
• /
• 2005

Recently, the issue of ship nitration due to the large scale, high speed and lightweight of ship is emerging. For pleasantness in the cabin, shipbuilders are asked for strict vibration criteria and the degree of nitration level at a deckhouse became an important condition for taking order from customers. This study proposes a new optimization framework that is NASTRAN external call type optimization method (OptShip) and applies to an optimum design to decrease the nitration level of a deckhouse. The merits of this method are capable of using of global searching method and selecting of various objective function and design variables. The global optimization algorithms used here are random tabu search method which has fast converging speed and searches various size domains and genetic algorithm which searches multi-point solutions and has a good search capability in a complex space. By adapting OptShip to full-scale model, the validity of the suggested method was investigated.