• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2004년도 하계학술대회 논문집 D
• /
• pp.2332-2334
• /
• 2004

A high bandwidth watt-converter, based on an inexpensive, commercially available, standard IC package, is described that covers a frequency ranges from DC to 100 kHz. The new resistive shunt for a wide-band frequency current measurement of the watt-converter was developed. The converter will use application in accurate power measurement under distorted and high frequency conditions. The advantages of the watt-converter are its simplicity, low cost and fast response time.

• Journal of Electrical Engineering and Technology
• /
• 제8권3호
• /
• pp.472-477
• /
• 2013

An internet-based, real-time GPS synchronized wide-area power system frequency monitoring network(FNET) has been monitoring wide-area power system frequency in continuous time in the United States. This paper analyzes the FNET measurement to the verified disturbances in the US eastern interconnected power system and simulates it using the dynamic system model. By comparing the frequency measurements with its simulation results to the same disturbances in detail, this paper finds that the sequence of monitoring points to detect the frequency fluctuation caused by the disturbances is matched well in the measured data and the simulation results. The similarity comparison index is also proposed to quantify the similarity of the compared cases. The dynamic model based simulation result is expected to compensate for the lack of FNET measurement in its applications.

• 조명전기설비학회논문지
• /
• 제25권2호
• /
• pp.113-119
• /
• 2011

A frequency in electrical power system changes by the load fluctuation in utility grid, has an influence on a connected generator, and ultimately brings a big trouble in the power system. Therefore, a quick measurement of system frequency and governor control of power system is a very important factor in the reliability and the economic feasibility. Electromagnetic frequency relays in the past had the large power consumption and the difficulty of accurate measurement. After Researched and developed digital relays are very affected by the noise and the distortion, and the recently developed Microprocessor relays have problems of expensive device and time when measuring the frequency at 50[ms]. In this study, An improve algorithm that measures the power system frequency quickly and accurately is suggested, simulated by using Matlab and programmed using C code through DSP6713 KIT. This algorithm is tested to the arbitrary voltage waveform input. The results show that the suggested algorithm is effective in the accurate and quick frequency measurements.

• 한국통신학회논문지
• /
• 제29권8C호
• /
• pp.1104-1112
• /
• 2004

본 논문에서는 레이저와 고속 CCD 카메라를 이용하여 대형 구조물의 3차원 거동 계측을 위해 진동 주파수 계측 방식을 확립하였다. 구조물에 부착한 대상판에 변동(fluctuation)이 작은 다이오드 레이저를 투사하고, 고속 CCD 카메라로 촬영한 영상에 고정도 상대측정 알고리즘을 적용하여 구조물의 변위를 측정하였다. 초당 120 프레임의 고속 카메라를 이용하고 변위에 FFT를 취해 진동주파수를 구한 경우, 0에서 40Hz까지 $\pm$0.5% 이내의 진동주파수의 정확도를 얻을 수 있다. 이를 이용하면 대형 구조물에 대해 보다 저렴하고 간단하게 고유진동수의 측정이 가능하다. 또한 GPS를 이용한 상대측위 기법과의 비교를 통해 레이저를 이용한 변위측정의 정확도를 입증함으로써, 제안한 진동주파수 측정 방법의 신뢰도와 경제성을 검증하였다.

• 한국산업융합학회 논문집
• /
• 제22권3호
• /
• pp.251-257
• /
• 2019

This paper proposes a new measurement method using virtual power concept to measure the effective value of 3-phase voltage with variable frequency. The conventional effective value measurement method uses a method of integrating data sampled during one or half cycle of the power voltage and averaging it. In this method, since the effective voltage is calculated every cycle, a time delay occurs in the measured effective voltage and it is s a problem to measure the effective value of a device whose frequency varies from time to time, such as a generator. The proposed 3-phase voltage rms measurement method has an advantage that it can measure accurate voltage RMS value regardless of measurement frequency variation. In particular, there is an advantage in that it is possible to measure a 3-phase effective voltage rather than an average value of the effective voltage of each phase in a 3-phase unbalance voltage. In addition, the validity of the proposed method is verified by using the Psim simulation tool and the experimental results are analyzed by applying the proposed measurement algorithm to the actual three phase synchronous generator voltage measurement experiment.

• 대한전기학회논문지:전력기술부문A
• /
• 제53권7호
• /
• pp.365-374
• /
• 2004

The relay measures the frequency of the power system in order to detect faults and separate them from the system. Many estimation algorithms for the relay have been proposed to accurately measure the frequency. This paper proposes a new frequency measurement method using the digital phase locked-loop(DPLL) for the relay of the power system. The proposed method is configured with a DPLL scheme and verified through computer simulations and experimental tests. In order to cope with noises in the power system, filters are included in the input signal processing part and the frequency comparator. MATLAB is used for computer simulations and an experimental setup with a CPU and an FPGA(Field Programmable Gate Array) is constructed. The loop filter of the DPLL is run in the CPU software In adjust parameters and others are in the FPGA. Experimental tests are performed lot a function generator and the power system. Results show that the proposed method is appropriate to the frequency measurement for the relay.

• 한국소음진동공학회:학술대회논문집
• /
• 한국소음진동공학회 2000년도 춘계학술대회논문집
• /
• pp.1661-1666
• /
• 2000

Nowadays, the two microphone method is accepted as the standard as specified in ASTM E1050-90 for measuring in-duct acoustic properties. However, research results on using the least square method with multiple measurement points and broadband excitation have been reported for enhancing the frequency response of the two microphone method. In this paper, the effects of varying the relative measurement positions on errors in the estimation of the acoustic quantities is studied for the multiple microphone method. Both of the theoretical and experimental results show that, among every possible sensor positioning configurations, the equidistant positioning of sensors yields the smallest error within the effective measurement frequency range. In addition, it is noted that the measurement accuracy can be increased and the effective frequency range can be widened by increasing the number of equidistant sensors. Measurement examples are shown and the results support the findings.

• 한국산업융합학회 논문집
• /
• 제23권5호
• /
• pp.747-756
• /
• 2020

In recent years, measurement in a smart-phone environment is attracting attention in various fields due to its easy set-up process, various functions, convenience and expandability. Even in the field of safety evaluation and maintenance of large-scale infra-structures, the appropriate application of these effective and convenient measurement techniques can be of great help. In this paper, an experimental study was conducted to investigate the effectiveness, problems and complementary methods of applying smart-phone accelerometers to the measurement in infra-structure such as bridges. In model bridge subjected to impact and moving loads, the measured accelerations using a smart-phone and a professional accelerometer were directly compared in time domain. And the statistical and frequency characteristics of the measured signal and transfer function were also examined in frequency domain. The results show that the accuracy of measurement using smart-phone sensor is primarily affected by its incomplete sampling performance. In conclusion, smart-phone sensors cannot be considered suitable for precise assessment, where measurements must be accurate over a wide frequency range, but we can say that the technique is still useful and fairly accurate for some purpose over a limited frequency range, such as the low pass frequency range, which is a major concern for civil structures.

• Journal of the Korean Society for Industrial and Applied Mathematics
• /
• 제4권2호
• /
• pp.143-152
• /
• 2000

As muscular contraction is sustained, the Fourier spectrum of the myoelectric signal is shifted toward the lower frequency. This spectral density is associated with muscle fatigue. This paper describes a quantitative measurement method that performs the measurement of localized muscle fatigue by tracking changes of median frequency based on stationary wavelet transform. Applying to the human masseter muscle, the proposed method offers the much information for muscle fatigue, comparing with the conventional FFT-based method for muscle fatigue measurement.

• 한국전자파학회논문지
• /
• 제7권4호
• /
• pp.279-287
• /
• 1996

주파수 점융율 데이터는 개별 주파수 채널의 실제 이용율에 대한 정보를 제공할 수 있다. 또한 스펙트럼의 예비 용량이 추정될 수 있도록 이들 주파수 대역들의 평균 이용율에 대한 정보를 제공한다. 그러한 추정치는 추가 배분 계획 및 스펙트럼 사용에 대한 새로운 기술의 영향을 평가하는 방법으로 사용될 수 있다. 본 논문에서는 국내에서 개발한 주파수 점유율 측정 시스템과 측정 방법을 제시한다. 그리고, 수도권 5개 지역의 전파감시 결과 데이터를 이용하여 주파수의 점유율을 시간대 및 지역별로 제시한다.