• 전기전자학회논문지
• /
• 제18권1호
• /
• pp.19-24
• /
• 2014

We report stable, wideband, flat-topped, 10 GHz optical frequency comb generation from a semiconductor-based mode-locked ring laser with an intra-cavity high finesse Fabry-Perot etalon. We demonstrate a stable 10 GHz comb with greater than 200 lines within a spectral power variation below 1 dB, which is the largest value obtained from a similar mode-locked laser in our knowledge. Greater than 20 dB of the spectral peak to deep ratio at 0.02 nm resolution, ~92 femtosecond timing jitter over 1 kHz to 1 MHz range, and non-averaged time traces of pulses confirm very stable optical frequency comb lines.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 C
• /
• pp.1376-1378
• /
• 1999

Most conventional protection relays are based on processing information in the spectrum that is close to or at power frequency. It is, however, widely known that faults on transmission lines produce frequency components of a wide range In this respect, this paper describes the basis of a Protection technique for transmission lines which utilises high-frequency components. Fault-generated signals caused by post-fault and the signal derived from stack tuner is connected to the coupling capacitor of CVT. Digital signal processing is then applied to the captured information to determine whether the fault is inside or outside the Protected zone, and to discriminate the fault type on transmission line.

• 한국전기전자재료학회논문지
• /
• 제11권10호
• /
• pp.773-777
• /
• 1998

This paper presents the results of measured permittivity of PCB sheet material in the frequency range of 0.1 ~ 2[㎓] and temperature range of 25~ 85[>$^{\circ}C$]. Microstrip lines with different physical length are implemented to measure the attenuation and phase shift of the signals through these lines. The loss factor of glass-epoxy and teflon could by calculated with the measured dielectric constant and the attenuation. From the experiment, the glass-epoxy was more influenced by temperature and frequency than teflon. The average dielectric constants of glass-epoxy and teflon within the measured frequency range are 4.48 and 2.18, respectively.

• Journal of Plant Biotechnology
• /
• 제29권2호
• /
• pp.135-138
• /
• 2002

대두 85개 재조합순계주의 미숙배로부터 얻은 자엽절편을 MS salt, B5비타민, 40 mg$^{-1}$ 2,4-dichlorophenoxyacetic acid (2,4-D) 및 30 g$^{-1}$ sucrose로 조성된 체세포배유도배지 (SIM, somatic induce medium)에 치상하여 5주간 배양하였다. 10%이하의 체세포배형성빈도는 36계통에서, 11~49%의 형성빈도는 37계통에서, 50~80%의 형성빈도는 9계통에서 그리고 90% 이상의 형성빈도는 3계통에서 각각 관찰되었다. 90% 이상의 체세포배형성빈도와 자엽당 6.36개의 체세포배를 형성하는 계통으로는 KM1010, KM1032 및 KM1064이었으며, 3계통에서 얻은 일차배를 동일배지상에서 계대배양하면서 2차배 증식방법으로 1년 이상 증식 유지하였다. 체세포배를 성숙배지와 식물체전환배지 (Komatsuda 1992)에 옮겼을 때 약 25% 정도가 정상식물체로 생육하였다.

• 생명과학회지
• /
• 제12권1호
• /
• pp.67-76
• /
• 2002

Agrobacterium(LBA4404/pBI1121)을 이용하여 형질전환된 애기장대 (Arabidopsis thaliana)를 대상으로 T2, T3, F3세대에서의 도입된 외래 유전자의 비활성화 현상을 조사하였다. Kanamaycin저항성 개체들의 GUS유전자 발현을 분석한 결과, T2세대에서 조사된 12계통 중 5계통에서 GUS 비활성 개체가 관찰되었다 (GUS유전자 비활성율 2.3%). Multi copy T-DNA 계통을 조사한 결과, GUS 비활성 정도가 더욱 심해짐이 관찰되었다 (5.8%). T3 세대에서 single copy T-DNA 계통들은 1.3%의 GUS 비활성율을 보인 반면, multi-copy T-DNA 계통에서의 비활성율은 12.6%로 급격히 증가하였다. 유사한 현상이 형질전환 식물체와 정상개체를 교배하여 생산된 F2 계통에서도 관찰되었다 (비활성율 9.9%). 본 실험으로 식물체에 도입된 외래 유전자가 후대에서의 전이과정동안 점진적으로 비활성화되고, 이 현상은 multi copy T-DNA 계통에서 훨씬 심각함이 밝혀졌다.

• 전자공학회논문지A
• /
• 제32A권3호
• /
• pp.25-37
• /
• 1995

The phenomenological loss equivalence method incorporated into the wideband lossy transmission line model is applied to the characterization of high desity digital transmission lines. The pulse propagation characteristics are analyzed using the calculated frequency characteristics and the discrete Fourier transformation. This approach has been verified by comparing the calculated frequency characteristics with the FEM and the esperimental results. This method is very suitable for computer-aided analysis of high density/high speed interconnection circuits because of the simple calculation as well as the calculation accuracy. We have found that pulse ftransmission speed and dispersion of hgih density digital transmission lines can be optimized by managing the conductor and dielectric losses in addition to the impedance matching.

• 한국조명전기설비학회지:조명전기설비
• /
• 제13권2호
• /
• pp.178-178
• /
• 1999

In recent years, the electromagnetic environments are varied with the increase of power consumption and the spread of household electric appliances. Most of the interests to date have concentrated in the area of human health effects associated with exposure to power frequency electric and magnetic fields, and thus the precise measurement and analysis are required. In this paper, the measurements and analysis of the extremely low frequency(ELF) electric and magnetic fields produced by actual 22.9[kV] distribution lines were performed. The experiments have been carried out by lateral profile, and the theoretical analyses were made by use of FIELDS program for the sate of comparison with the experimental data. Electric and magnetic field intensity were strong under power distribution lines, and were inversely proportional to lateral distance. The profiles of electric and magnetic fields were M and ∩ shapes, respectively, and the measured data were good in agreement with the theoretical results. Both the electric and magnetic field intensity were increased with increasing the measurement height.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 1998년도 춘계학술대회 논문집
• /
• pp.135-138
• /
• 1998

This paper presents the results of measured permittivity of PCB sheet material in the frequency range of 0.1[GHz] - 2[GHz] and temperature range of $25[^{\circ}C]$ - $85[^{\circ}C]$. Microstrip lines with different physical length are implemented to measure the attenuation and phase shift of the signals though these lines. The loss factor of these materials could be obtained with the dielectric constant and the attenuation of the microstrip lines.

• 환경영향평가
• /
• 제13권5호
• /
• pp.243-250
• /
• 2004

Recently, concerns about health risks exposed to electromagnetic fields have been brought in the safety of electric power lines. A number of governmental and international organizations have advised to avoid the magnetic field exposure to the schools and residential areas. Some epidemiologic studies showed that electromagnetic fields should not exceed the exposure limits of 2-3mG to the people living near high-voltage transmission lines. In this study, the principles, ranges and survey methods of the assessment for powerfrequency electromagnetic fields were reviewed from the relevant research papers and documents. The ranges of electromagnetic fields were determined from 50m to 100m and have been defined according to the properties of each electric power lines and a new methodology was suggested in this study. It would be necessary to develop and improve specific assessment methods for various high-voltage transmission lines projects.

• 대한전기학회논문지:전력기술부문A
• /
• 제48권7호
• /
• pp.832-838
• /
• 1999

Recently, there are growing concerns about power frequency electric and magnetic fields coming out from the high voltage transmission lines, because of the wide spread perception of their probable harmful effect on human body. In connection with this trend, this paper describes the electric and magnetic fields measurement result around 154 kV and 345 kV transmission lines, a comparison of measured EMF to calculated one and the correlations between transmission lines currents and measured magnetic fields. Daily maximum and minimum magnetic field quantities under the selected 154 kV and 345 kV transmission lines had been measured for 1 year of 1997 and the average value of magnetic field exposure under the lines were calculated and presented based on the measured data.