• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2007년도 학술대회 논문집 전문대학교육위원
• /
• pp.119-124
• /
• 2007

This research presented the new zero-current switching pulse width modulation SEPP(Single Ended Push-Pull)high frequency inverter for solving the problem of the zero-current SEPP high frequency inverter circuit which is using widely in the practical application of an induction heating apparatus, the soft switching operation and power control are impossible when the lowest power supply in the zero-current switching pulse width modulation SEPP high frequency inverter. The inverter circuit which is attempted by on-off operation of a switch has the reduction effect of the power loss due to a soft switching and a high frequency switching. And it confirmed that the power regulation is possible continuously from 0.25[kW] until 2.84[kW] in the case the duty rate(D) changes from 0.08 to 0.3 under zero-current switching operating by a dissymmetry pulse width modulating control and the power conversion efficiency comes true the efficiency of 95[%]. Due to the result above, the ZCS PWM SEPP high frequency inverter will be effective as sources of an induction heating apparatus.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1999년도 하계학술대회 논문집 F
• /
• pp.2650-2652
• /
• 1999

To satisfy the demand for small size, light weight. high density power supply, the switching frequency of DC/DC converters has been increased. The PWM control of the conventional SMPS have a switching frequency that a level of the conducted noise spectra contribute to switching frequency band. So the electronic equipment is not only affected from that but is restricted to internal regulation like CISPR, FCC, and VDE. In this paper, we analyzed Bi-FM. Bi-FM is two fixed switching frequency with a modulation frequency. So emission spectrum of Bi-FM control signal is spreaded and spectral power level is reduced. In this paper, we analyze the spectral analysis of Bi-FM control signal and the spectral comparison between the PWM control and Bi-FM control. And we confirm that reduced the spectrum power level through simulation using Pspice and experiment.

• 전기학회논문지
• /
• 제57권7호
• /
• pp.1187-1194
• /
• 2008

This paper presents a high-power electronic ballast for a metal-hallide lamp(MHL) that employs frequency modulation(FM) technique to eliminate acoustic resonance(AR). The proposed ballast consists of a full-bridge rectifier, a power factor correction(PFC) circuit, a full-bridge(FB) inverter, an ignitor using LC resonance and an FM control circuit. Whereas a manual PFC provides advantages in terms of high reliability and low cost for constructing the circuit, it is difficult to supply a stable voltage because of the output voltage ripple that occurs with a period of 120Hz. Although the ballast can be designed with a small size and a light weight if it is driven at a switching frequency between 1 and 100 kHz, AR will occur if the eigen-value frequency of the lamp coincides with the inverter's operation frequency. The operation frequency was modulated in real time according to the output voltage ripple to compensate for the variation in power supplied to the lamp and eliminate AR. Performance of the proposed technique was validated through numerical analysis, computer simulation using PSPICE and by applying it to an electronic ballast for a prototype 1kW MHL.

• 한국조명전기설비학회:학술대회논문집
• /
• 한국조명전기설비학회 2008년도 추계학술대회 논문집
• /
• pp.241-243
• /
• 2008

This research presented the new zero-current switching pulse width modulation SEPP(Single Ended Push-Full)high frequency inverter for solving the problem of the zero-current SEPP high frequency inverter circuit which is using widely in the practical application of an induction heating apparatus, the soft switching operation and power control are impossible when the lowest power supply in the zero-current switching pulse width modulation SEPP high frequency inverter. The inverter circuit which is attempted by on-off operation of a switch has the reduction effect of the power loss due to a soft switching and a high frequency switching. And it confirmed that the power regulation is possible continuously from 0.25[kW] until 2.84[kW] in the case the duty rate(D) changes from 0.08 to 0.3 under zero-current switching operating by a dissymmetry pulse width modulating control and the power conversion efficiency comes true the efficiency of 95[%]. Due to the result above, the ZCS PWM SEPP high frequency inverter will be effective as sources of an induction heating apparatus.

• 한국통신학회논문지
• /
• 제31권3A호
• /
• pp.214-220
• /
• 2006

본 논문에서는 TPC-AMS/FSS-OFDM(transmit power controlled adaptive modulated OFDM with frequency symbol spreading and equalization)시스템을 제안한다. TPC-AMS/FSS-OFDM의 송신기에서 각 S/P(serial-to-parallel)변환된 신호는 직교 확산 코드에 의해 확산 결합되어 송신하고, 수신된 신호는 수신기의 각 주파수 심볼 확산 블록에 의하여 검출되며, 같은 SINR(signal interference to noise ratio)을 얻는다. 이 때 각 주파수 심볼 확산블록에 대해서는 같은 변조 레벨과 송신 전력을 할당할 수 있다. 본 논문에서 제안한 시스템은 전체 송신 전력과 데이터 정보로 전송되는 FBI(feedback information), MLI(modulation level information)를 감소시킴으로서 전체적인 전송속도(throughput)의 성능을 개선할 수 있다.

• Journal of electromagnetic engineering and science
• /
• 제4권2호
• /
• pp.72-78
• /
• 2004

In this paper, we evaluate the performance of the digital modulation schemes described in the APCO Project 25 FDMA specifications which can be used for applying the ultra-narrowband technology to the current domestic simple two-way radio systems, and discuss difficulties in the DSP implementation of the systems. We analyze the effect on the systems' BER performance of receiver non-matched filter and frequency-offset between the transmitter and receiver oscillators. And we present a frequency offset compensation method for improving the system performance. The results of performance analysis showed that the CQPSK of APCO Project 25 using non-matched filter degraded the BER by 0.5～1.0 ㏈ comparing with PI/4 DQPSK using matched filter. In the event of 2 % frequency offset, about 1 ㏈ performance loss was produced at the BER of $$10^{-3}TEX>. With the frequency-offset compensation method implemented in the systems using phase recovery scheme of PSK synchronization detection, the performance degradation of about 1.0 ㏈ was occurred at the BER of $$10^{-3}TEX> for 10 % of frequency offset. The proposed method can be used for the improvement of system performance.

• 한국철도학회논문집
• /
• 제15권3호
• /
• pp.244-250
• /
• 2012

본 논문에서는 차세대 고속철도 구동 인버터 시스템의 고조파로 인한 전자기적 소음을 줄이기 위해 RCF-PWM(Random Carrier Frequency Pulse Width Modulation)을 적용한 인버터 구동시스템을 개발하였다. RCF-PWM 방식은 인버터 스위칭 주파수를 전력용 반도체의 최대 스위칭 주파수와 최소 스위칭 주파수 사이에서 임의적으로 변화시키며 PWM을 수행하는 방법이다. 본 연구의 타당성을 확인하기위해서 RCF-PWM이 적용된 차세대 고속전철 시스템을 설계하여 MATLAB/Simulink 기반의 시뮬레이터를 개발하고 이를 이용하여 일정한 스위칭 주파수를 사용하는 정규적인 SVPWM 방식과 RCF-PWM 방식의 시험결과를 비교 분석하였다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1997년도 하계학술대회 논문집 F
• /
• pp.2058-2061
• /
• 1997

A main research topic in PWM inverter drive system is to reduce the generated acoustic noise. One method to reduce the acoustic noise is to cause the switching pattern to be random. This RPWM(Random Pulse Width Modulation) technique for voltage controlled inverters is a kind of good solutions for reduction of acoustic noise and suppression of vibration. This paper describes a carrier frequency modulated real-time RPWM inverter. Changing the carrier frequency randomly, the power spectrum of tile acoustic noise was spread over the wide-band area. And experimental results showed that emitted noise is much more comportable and less annoying

• 한국광학회:학술대회논문집
• /
• 한국광학회 1990년도 제5회 파동 및 레이저 학술발표회 5th Conference on Waves and lasers 논문집 - 한국광학회
• /
• pp.73-78
• /
• 1990

1.3${\mu}{\textrm}{m}$ DFB with absorption grating of 1.55${\mu}{\textrm}{m}$ InGaAsP layer was fabricated. This new type of DFB laser shows self-plusation for DC operation. At low level of injection the relation between the pulsation frequency and the injection current shows similar behavior with the relaxation oscillation of ordinary laser and at high level of injection the pulsation frequency decreases compared to the relaxation oscillation. Period doubling, period 3 and 4 were observed for AC modulation. In case of period doubling the waveform shows only one pulse within a period without any accompanying subsidiary pulses and the oscillation frequency was quite stable. The pulse widths as short as 58.5 ps was achieved with AC modulation. We propose the time division multiplexing application of this kind of DFB laser.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2001년도 Proceedings ICPE 01 2001 International Conference on Power Electronics
• /
• pp.98-103
• /
• 2001

In case that electronic ballast employing a valley-fill passive power factor correction (PFC) circuit is used for feeding fluorescent lamps, a new method to reduce crest factor of the lamp current is studied in this paper. In order to reduce crest factor to lower value, a pulse frequency modulation technique based on the waveform of the dc-link voltage which is predetermined by the passive PFC circuit, is taken into the switching control action of the electronic ballast. An equation-based analysis between the crest factor of lamp current and the effect of varying the inverter switching frequency is comprehensively performed.