• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2001.11a
• /
• pp.247-250
• /
• 2001

We studied optical properties of SiON thin-film in the applications of optical waveguide. SiON thin-film was grown in 300$^{\circ}C$ by PECVD(plasma enhanced chemical vapor deposition) system. The change of SiON thin-film composition and refractive Index was studied as a function of varying NH$_3$ gas flow rate. As NH$_3$ gas flow rate was increased, Quantity of N and refractive index were increased at the same time. By the results, we could form the SiON thin-film to use of a waveguide with refractive index of 1.6. We analyzed the conditions of the thin-film with FTIR(fourier transform infrared) and OES(optical emission spectroscopy). N-H bonding(3390cm$\^$-1/) can be removed by thermal annealing. And we could observe the SiH bonding state and quantity by OES analysis in SiH$_4$

• Journal of the Semiconductor & Display Technology
• /
• v.22 no.2
• /
• pp.35-39
• /
• 2023

Silicon oxide thin films have been deposited by plasma-enhanced chemical vapor deposition in SiH4 and N2O plasma along the variation of the gas flow ratio. Optical emission spectroscopy was employed to monitor the plasma and ellipsometry was employed to obtain refractive index of the deposited thin film. The atomic ratio of Si, O, and N in the film was obtained using XPS depth profiling. Fourier Transform Infrared Spectroscopy was used to analyze structures of the films. RI decreased with the increase in N2O/SiH4 gas flow ratio. We noticed the increase in the Si-O-Si bond angles as the N2O/SiH4 gas flow ratio increased, according to the analysis of the Si-O-Si stretching peak between 950 and 1,150 cm-1 in the wavenumber. We observed a correlation between the optical emission intensity ratio of (ISi+ISiH)/IO. The OES intensity ratio is also related with the measured refractive index and chemical composition ratio of the deposited thin film. Therefore, we report the added value of OES data analysis from the plasma related to the thin film characteristics in the PECVD process.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.53 no.7
• /
• pp.389-396
• /
• 2004

This paper introduces a new algorithm to calculate distortion power using complex THD(Total Harmonic Distortion) index. The proposed algorithm involves FFT(Fast Fourier Transform) to compute real and imaginary THDs of voltage and current. Case studies are presented to show the availability of the proposed method.

• Proceedings of the Optical Society of Korea Conference
• /
• 2001.02a
• /
• pp.218-219
• /
• 2001

본 실험에서는 RF 소자들과 650 nm InGaAIP FP LD를 사용하고 이득스위칭에 의하여 선폭이 35psec 되는 극초단 광펄스를 생성하였다. 또한 이렇게 생성된 극초단 광펄스를 이용하여 언덕형 굴절률 분포를 가지는 다중모드 광섬유의 대역폭을 빠른 푸리에 변환(Fast Fourier Transform)으로 계산하였다 따라서 본 실험에서 이용된 언덕형 굴절률 분포를 갖는 다중모드 광섬유의 대역폭은 670 MHz.km로 측정되었다.

• Textile Coloration and Finishing
• /
• v.20 no.5
• /
• pp.1-6
• /
• 2008

3-(Hydroxyphenyl phosphinyl) propanoic acid (HPPA) has been one of the most commonly used durable flame retardant agents for polyethylene terephthalate (PET) for many years. We intended to explore the application of HPPA to cellulose fabrics as formaldehyde-free phosphorus based flame retardants (FRs) through green chemistry process. The flame retardancy of the flame-retardant treated cellulose fabrics were characterized by using inductively coupled plasma spectroscopy (ICP) and limiting oxygen index (LOI). Structural changes of the treated cellulose fabrics were carried out by thermogravimetric analysis (TGA) and Fourier transform infrared (FT-IR) spectroscopy. To enhance the flame retardancy of HPPA treated cellulose fibers, glycerol polyglycidyl ether (GPE), a crosslinking agent was employed. Both HPPA and GPE treated cotton fabric imparted an LOI value over 26.

• Proceedings of the KIEE Conference
• /
• 1988.07a
• /
• pp.127-129
• /
• 1988

Square-wave current source inverter drives suffer from torque pulsation and speed variation at low speed. Attempts to minimize these problems, CSI PWM strategies have been reported. It is shown that these PWM strategies are based on unnecessarily restrictive modulation laws. In this paper, trapezoidal PWM strategy for CSI is investigated theoratically by double fourier series and we proposed Harmonic Speed ripple Factor(HSF) that is independent of motor parameters and load conditions. Speed ripple are considered in T-PWM and square wave inverter by HSF. We obtain modulation index(M) and carrier ratio (CR) for minimum speed ripple.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.1
• /
• pp.22-32
• /
• 2008

This paper proposes a linearization technique for the 3-level NPC type inverter, which increases the linear control range of Inverter up to the one-pulse inverter. The overmodulation range is divided into two modes depending on the Modulation Index, MI. In overmodulation region I, the reference angles are derived from the fourier series expansion of the reference voltage corresponding to the MI. In overmodulation region II, the holding angles are also derived in the same way. Therefore, it is possible to obtain the linear control and the maximized utilization of PWM inverter output voltage.

• Korean Journal of Optics and Photonics
• /
• v.3 no.1
• /
• pp.16-19
• /
• 1992

The Fourier transform spectra of a grating have been employed to determine the refractive index of a simple lens. The shearing interferometric technique is used for collimation testing of the expanded laser beam and for determining the exact focal plane. The slit attached to micro X-Y translator has been used to measure the distance between two sucessive diffraction orders in the back focal plane of the test lens. The experimental equipment is described and results are presented.

• Structural Monitoring and Maintenance
• /
• v.9 no.4
• /
• pp.373-388
• /
• 2022

A USW based diagnostic procedure is presented for estimating the depth of surface-breaking cracks. The diagnosis is demonstrated on seven lab-scale SFRC beam specimens, which are subjected to the CMOD controlled three-point bending test to create real bending cracks. Then, the recorded multiple ultrasonic signals are examined with the signal processing techniques, including wavelet transform and two-dimensional Fourier transform, to investigate the relationships between the crack depth and two diagnostic indices, namely the attenuation coefficient and dispersion index (DI). Finally, the reliabilities of these indices for depth estimation are verified with the visually measured crack depths as well as the crack features obtained with a digital image processing algorithm. It is found that the DI outperforms the attenuation coefficient in depth estimation, where this index displays good agreement with the visual inspection for 86% of the inspected specimens.

• Journal of the Institute of Electronics Engineers of Korea SD
• /
• v.46 no.5
• /
• pp.32-38
• /
• 2009

FTT(Fast Fourier Transform) processor is widely used in OFDM(Orthogonal Frequency Division Multiplesing) system. Because of the increased requirement of mobility and bandwidth in the OFDM system, they need large point FTT processor. Since the size of memory which stores the twiddle factor coefficients are proportional to the N of FFT size, we propose a new method by which we can reduce the size of the coefficient memory. In the proposed method, we exploit a counter and unsigned multiplier to generate the twiddle factor indices. To verify the proposed algorithm, we design TFCGs(Twiddle Factor Coefficient Generator) for 1024pint FFTs with R2SDF(Radix-2 Single-Path Delay Feedback), $R2^3SDF,\;R2^3SDF,\;R2^4SDF$ architectures. The size of ROM is reduced to 1/8N. In the case of $R2^4SDF$ architecture, the area and the power are reduced by 57.9%, 57.5% respectively.