• 한국물환경학회지
• /
• 제21권5호
• /
• pp.496-499
• /
• 2005

Power Plant is requested, by environmental bodies and fisherman, to correct the pollution of coastal area due to the outflow of foam from the outlet of the power plants. Foam wastewater cause a lot of environmental problems, expecially in aesthetic points of view. Therefore, It is needed to be collect from the stream into nearby ocean, and the collected foams should be treated before being discharged into nearby ocean. The most effective and feasible treatment method researched for the effective treatment of foam wastewater generated at the power plants. The result of the test is confirmed with collecting Foam wastewater by inhalation force. The treatment pilot ($3m^3/hr$) collected wastewater was operated by Biological degradation method(Aerobic/anaerobic Processes) for approximately two months. It was removed SS, COD, nutrient(T-P, T-N), etc. The System is expected successfully by Minimizing the operating costs such as electricity, repair expenses, chemicals and supplies expenses.

• 한국양식학회지
• /
• 제16권4호
• /
• pp.216-222
• /
• 2003

In a simulated seawater aquaculture system, effects of different operating factors like the superficial air velocity (SAY), hydraulic residence time (HRT), protein concentration and foam overflow height on the removal of total suspended solids (TSS) by a foam fractionator, with 20 cm diameter and 120 cm height, were investigated. This experiment was performed on batch and consecutive modes for different combinations of the tested factors, using synthetic wastewater. In 5 consecutive trials, TSS concentration in culture tank water decreased faster, when the foam fractionator was operated at higher SAV and lower HRT. In batch trials, with increasing SAV, TSS removal rate increased, but decreased with increasing HRT. Higher protein concentration in the bulk solution resulted in higher TSS removal rate. TSS concentration in the collected foam condensates increased but the foam overflow rate decreased with increasing foam overflow height. Foam fractionation was effective for removing TSS in seawater aquaculture systems and its performance largely depended on the operating parameters, especially superficial air velocity.

• 생태와환경
• /
• 제49권3호
• /
• pp.187-196
• /
• 2016

본 연구는 감조하천과 연결된 하수처리장 방류구에서 발생하는 거품의 형성기작 해석과 저감기술의 실험적용을 위하여 2015년 3월부터 2016년 7월까지 수행하였다. 거품은 방류구와 하천 수면 사이의 낙차에 의한 공기연행과 거품확산방지막에 의한 내부축적이 원인이었다. 특히 썰물 때와 방류량이 많을 때에 거품성장이 가장 활발하였다. 이를 해결하기 위하여 방류수로와 방류구에 각각 미세스크린 망과 수중방류 인공수로장치를 각각 설치한 후 실험하였다. 거품 저감효과는 각각 약 85.0~92.0%, 70.7~85.6% 범위였다. 또한, 거품뿐만 아니라 소음 등 부가적인 문제점도 해결할 수 있었고, 무엇보다도 민원예방에 기여할 것으로 본다. 본 연구는 단일 하수처리장을 대상으로 하였으나, 국내 다른 하수처리장의 유사한 사례에도 응용될 수 있을 것으로 사료된다.

• Ocean and Polar Research
• /
• 제25권3호
• /
• pp.269-275
• /
• 2003

Effects of different operating factors including superficial air velocity (SAV), hydraulic residence time (HRT), protein concentration, and foam overflow height on protein removal by a foam fractionator in simulated seawater aquaculture system were investigated. This experiment was conducted on batch and consecutive modes at different combinations of the affecting factors. The foam fractionator had a diameter of 20cm and a height of 120cm and the experiment was conducted with synthetic wastewater. In 5 consecutive trials, protein concentrations in culture tank water decreased faster when the foam fractionator was operated at higher SAVs and lower HRTs. In batch trials, protein removal rates increased with an increase in SAV but decreased with an increase in URT. Higher protein concentrations in the bulk solution resulted in higher protein removal rates. Protein concentrations in the collected foam condensates increased but the foam overflow rates decreased with the increase of foam overflow heights. The results of this experiment indicate that foam fractionation would be an effective way for protein removal in seawater aquaculture systems and the performance of the foam fractionator depends largely on the operating parameters, especially SAV.

• 대한환경공학회지
• /
• 제38권11호
• /
• pp.627-634
• /
• 2016

본 연구에서는 탄소폼 흡착소재를 이용하여 산업도금폐수로부터 중금속을 흡착 제거한 후 탈착용액을 이용하여 제거된 중금속을 용출하고 회수하는 과정의 특성을 평가해 보고자 하였다. 용액의 조성에 따른 복합 중금속의 탈착 특성을 살펴본 결과 증류수 조건에서는 용출이 관측되지 않았으며, 탈착용액으로 HCl과 $H_2SO_4 $를 이용한 경우 높은 중금속 농도를 나타내었다. 탈착 용액을 이용함과 더불어 물리적 기술인 초음파 처리를 이용한 경우 중금속의 용출이 증진되는 것을 확인하였으며, 초음파 장치의 출력이 높고 반응 시간이 길수록 효율도 증가하는 것으로 나타났다. 탄소폼 흡착소재를 구리도금 세척수 처리에 적용시켜본 결과 200 반응기부피(Bed volume) 동안 안정적인 제거 성능을 나타내었으며, 흡착된 구리는 탈착용액을 이용하여 용출시킨 후 직류 전원 장치를 이용하여 회수할 수 있었다. 또한 구리가 회수된 탈착용액은 재이용 효율은 84.2%로 나타났다.

• 한국수산과학회지
• /
• 제37권6호
• /
• pp.498-504
• /
• 2004

Removal of waste generated by Paralichthys olivaceus in the seawater aquarium using a foam separator was investigated. Protein concentration without a foam separator continuously increased until 3 days after stocking and reached at 25 mg/L after 5 days stocking, but protein concentration became lower than the initial protein concentration (2.5 mg/L) with a foam separator. The trends of other fish wastes such as ammonia, total suspended solids (TSS) and chemical oxygen demand (COD) were similar to protein. Dissolved oxygen (DO) in the aquarium decreased below 6.0 mg/L without a foam separator, but with a foam separator the average DO in the aquarium was 7.3 mg/L. Foam separation with the increase of superficial air velocity (SAV) was more effective than that with the fixed SAV. This study showed that wastewater. treatment of seawater aquarium using a foam separator is effective method for a fish waste removal and oxygen supply.

• 생태와환경
• /
• 제49권2호
• /
• pp.124-129
• /
• 2016

본 연구는 하수처리장에서 최종 방류되는 하수처리수의 거품발생 원인분석과 저감방안을 제시하고자 수행되었다. 감조하천의 방류구에서 거품이 발생하는 것은 구조적인 문제점으로 파악되었다. 거품은 낙차에 의한 공기 연행과 확산방지막에 의한 내부축적이 주요한 원인이었다. 이러한 여건을 고려하여, 방류수로와 방류구 종단에서 미세스크린과 수중방류를 통해 거품발생을 완화시킬 수 있는 효과적인 방안을 제시하였다.

• 한국습지학회지
• /
• 제16권4호
• /
• pp.433-441
• /
• 2014

고농도 질소를 함유하고 있는 하수는 하수처리장 처리 효율에 악영향을 미치는 것으로 알려져 있다. 따라서 고농도 질소를 함유한 하수를 처리하기 위한 다양한 연구가 이루어지고 있다. 본 연구에서는 대표적인 고농도 질소를 함유한 하수인 혐기 소화 상징액과 가축분뇨를 대상으로 유기물 분석, foaming 실험 및 실험실 규모 아질산화 반응조 운전을 실시하였다. 유기물 분석 결과 혐기 소화 상징액은 용존성 불활성한 성분, 가축분뇨는 입자성 생물학적 분해가능한 성분이 가장 큰 부분을 차지하는 것으로 나타났다. 아질산화 반응에 적합한 체류시간은 혐기소화 상징액 2일과 가축분뇨 6일이였으며, 이와 같은 적정 체류시간에 차이는 암모니아성 질소 농도 및 유기물 성상차이에 의한 것으로 보인다. 또한 가축 분뇨 반응조 foam은 혐기 소화 상징액 반응조 foam과 비교하여 발생량은 많지만 빠르게 제거되는 특성을 보였다. 본 연구의 결과는 향후 아질산화 반응의 하수처리장 적용 시 기초 자료로 이용할 수 있을 것으로 보인다.

• 상하수도학회지
• /
• 제36권5호
• /
• pp.261-273
• /
• 2022

In this study, we collect water control valves that have had accidents due to existing cracks, etc. are collected, and propose investigation items for strengthening the valve structural safety evaluation through a series of analyzes from valve specifications to physicochemical properties are proposed. The results of this study are as follows. First, there was a large variation in the thickness of the body or flange of the valves to be investigated, which is considered to be very important factor, because it may affect the safety of the valve body against internal pressure and the flange connected with the bolt nut. Second, 60% of the valves under investigation had many voids in the valve body and flange, etc. and the decrease in thickness due to corrosion was relatively large on the inner surface in contact with water rather than the outer surface. It is judged that the investigation of depth included voids is very important factor. Third, all valves to be investigated are made of gray cast iron foam, and therefore it is judged that there is no major problem in chemical composition. It is judged that the chemical composition should be investigated. Fourth, as a physical investigation item, the analysis of metal morphology structure seems to be a very important factor for nodular cast iron from rather than a gray cast iron foam water valve with a flake structure. As it was found to be 46.7~68.8% of the standard recommended by KS, it could have a direct effect on damage such as cracks, and therefore it is judged that the evaluation of tensile strength is very important in evaluating the safety of the valve.

• 한국환경보건학회지
• /
• 제19권4호
• /
• pp.38-43
• /
• 1993

The characteristics of food wastewater treatment in an anaerobic packed bed reactor (APBR) with polyurethane as a packing material and sludge bed reactor (ASBR) was studied. The reactor of 9cm-ID, 150cm-height was fed in a continuous mode from bottom of reactor. For the purpose of constant temperature of reactor, water jacket was installed. The used packing materials was polyurethane sponge foam. Methane which was produced by decomposed organics collected at the top of the reactor for using as a fuel. The substrates used were synthetic, mixed and food wastewater. For the acclimatization of microorganisms, mixed wastewater was used. The major analyses were gas production, COD, pH and volatile acids. Based upon the completed works, the results are as follows: When food wastewater was fed the quantity of produced gas was less than that of synthetic wastewater, but food process saw higher methane content than synthetic process. As well as COD removal efficiency of food process reached at about 85%. In aspect of effluent volatile acid, food process showed low concentration of below 500 mg/l, therefore anaerobic reaction stabled. Conclusively food wastewater used can be digested by anaerobic treatment, especially anaerobic packed bed reactor showed 82% of COD removal, 75% of methane content, 10 l of gas production, and anaerobic sludge bed reactor did 79% of COD removal, 75% of methane content, 81 of gas production at 4 kgCOD/m$^3$day, 36$\circ$C.