• 대한기계학회논문집B
• /
• 제40권7호
• /
• pp.417-427
• /
• 2016

본 논문은 반 쐐기형 연소실에서 포트 형상에 따른 정상유동 특성을 비교한 연구의 첫 번째로 통상적인 충격식 스월측정기 평가위치인 1.75B에서 입자영상유속계로 반 쐐기형 연소실에 직선형 포트와 나선형 포트를 적용하여 평면유속을 측정하고 비교하였다. 속도분포 분석 결과 직선형 포트에서는 밸브리프트 4 mm 이하, 그리고 나선형 포트에서는 2 mm 이하에서 두 개의 스월이 형성되고 이후 리프트가 증가하면 하나의 스월만 관찰된다. 리프트에 따른 유동체계의 천이점이 포트형상에 따라 상이하여 직선형 포트에서는 리프트 4 mm와 5mm를 경계로 유동 특성이 완전히 바뀌는 반면, 나선형 포트에서는 리프트 증가에 따라 점진적 변화만 관찰된다. 또한 모든 포트에서 1.75B 위치에서 편심도는 측정값이 왜곡되지 않는 범위에 들어오지 않고, 특히 직선형 포트의 편심도가 매우 크다. 동시에 포트형상에 관계없이 ISM 평가와 상응하는 실린더 중심 기준의 평균접선속도는 ISM 평가에서 가정한 속도보다 매우 낮고, 속도분포 특성도 ISM 평가의 가정과 매우 다르다.

• 대한기계학회논문집B
• /
• 제30권2호
• /
• pp.136-143
• /
• 2006

A particle image velocimetry (PlV) technique has been applied to measure the quantitative flow field characteristics behind a road vehicle with/without an air spoiler attached on its trunk and to estimate its effect on the wake. A vehicle model scaled in the ratio of 1/43 is set up in the mid-section of a closed-loop water tunnel. The Reynolds number based on the vehicle length is $10^5$. To investigate the three-dimensional structure of the recirculation zone and vortices, measurements are carried out on the planes both parallel and perpendicular to the free stream, respectively. The results show significant differences in the recirculation region and the vorticity distributions according to the existence of the air spoiler. The focus and the saddle point, appearing just behind the air spoiler, are disposed differently along the spanwise direction. Regarding the streamwise vortices, the air spoiler produces large wing tip vortices. They have opposite rotational directions to C-pillar vortices which are commonly observed in case that the air spoiler is absent. The wing tip vortices generate the down-force and as a result, they can make the vehicle more stable in driving.

• 대한기계학회논문집B
• /
• 제28권4호
• /
• pp.425-432
• /
• 2004

The objective of this study is a qualitative comparison between line-integrated OH chemiluminescence(OH$\^$*/) image and its Abel inverted image to investigate the flame structure at different phase of the oscillating pressure field. PIV(Particle Image Velocimetry) measurements were conducted under non-reacting conditions to see the global flow structure and NOx emission was measured to investigate the effect of fuel-air premixing on combustion instability and emission characteristics. Experiments were carried out in an atmospheric pressure, laboratory-scale dump combustor operating on natural gas. Combustion instabilities in present study exhibited a longitudinal mode with a dominant frequency of ∼341.8㎐, which corresponded to a quarter wave mode of combustor. Heat release and pressure waves were in-phase when instability occurred. Results gave an insight about the location where the strong coherence of pressure and heat release existed. Also an additional information on active control to suppress the combustion instabilities was obtained. For lean premixed combustion, strong correlation between OH$\^$*/ and NOx emissions was expected largely due to the exponential dependence of thermal NOx mechanism on flame temperature.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2004년도 추계학술대회
• /
• pp.1552-1557
• /
• 2004

Characteristics diffusion time of viscoelastic fluids are determined experimental results of terminal velocity by using the falling ball viscometer. The characteristics diffusion time of viscoelastic fluids are determined with help of the sphere device which is installed to return the dropped sphere from the bottom of the test cylinder without disturbing the working fluids. Terminal velocity of th sphere the reason why experimental of characteristics diffusion time that it is have an effect on the time interval of the measuring. Viscous of the fluid the temperature changed in order to have an effect on temperature and terminal velocity of the ball it becomes larger the possibility of knowing. A result of visualization for flow phenomena of around the sphere uses the PIV and the density of the polymer solution which it appears 2000wppm is to a case which is the right and left becomes symmetry to be it will be able to confirm and according to the time interval, to observed velocity vector of same at first drop the sphere.

• 한국가시화정보학회지
• /
• 제1권1호
• /
• pp.64-74
• /
• 2003

An experimental study was carried out to investigate the effect of periodic blowing and suction on a turbulent boundary layer. Particle image velocimetry (PIV) was used to probe the characteristics of the flow. The local forcing was introduced to the boundary layer via a sinusoidally-oscillating jet issuing from a thin spanwise slot. Three forcing frequencies (f$^{+}$=0.044, 0.066 and 0.088) with a fixed forcing amplitude (A$^{+}$=0.6) were employed at $Re_{=690. The effect of the forcing angles ($\alpha$=60$^{\circ}$ , 90$^{\circ}$ and 120$^{\circ}$ ) was investigated under the fixed forcing frequency (f$^{+}$=0.088). The PIV results showed that the wall region velocity decreases on imposition of the local forcing. Inspection of phase-averaged velocity profiles revealed that spanwise large-scale vortices were generated in the downstream of the slot and persist further downstream. The highest reduction in skin friction was achieved at highest forcing frequency (f$^{+}$=0.088) and a forcing angle of $\alpha$=120$^{\circ}$. The spatial fraction of the vortices was examined to analyze the skin friction reduction.

• Journal of Advanced Marine Engineering and Technology
• /
• 제35권1호
• /
• pp.89-95
• /
• 2011

이 연구에서는 대표적인 단순물체인 컨테이너선의 거주부를 모델링하여 모형선을 제작하였다. 그리고 거주부 측면에 디플렉터의 설치와 Sunken Deck의 개폐에 따른 거주부 후방의 배기가스 역류방지 효과를 회류수조에서 PIV 기법을 이용하여 계측하였다. 실험 장치는 고속카메라, 레이저, 이미지보드, 대용량컴퓨터로 구성된다. 거주부 후방에서 평균속도벡터와 축방향 속도를 구하여 그 결과를 서로 비교하였다.

• 한국방재학회 논문집
• /
• 제5권1호
• /
• pp.63-68
• /
• 2005

영상 해석을 이용한 유속 측정 방법인 LSIV를 합류점의 수리 모형 실험에 적용하였다. LSIV에 의해 측정된 표면 유속은 유속계에 의해 측정된 평균 유속과 상당히 유사한 결과를 나타내었다. 일반적인 유속계는 순간적인 지점 유속만을 나타내기 때문에 전체적인 유속장을 살피는 데 어려움이 있으나, LSIV는 전체적인 흐름장의 양상을 한 눈에 살펴 볼 수 있는 좋은 도구이다. 특히 합류점이나 교각 주변부와 같이 흐름이 국부적으로 변화가 심한 경우 LSIV는 적절한 실험 도구가 될 수 있을 것이다.

• 한국전산유체공학회지
• /
• 제15권3호
• /
• pp.39-45
• /
• 2010

The turbulent flows in a tunnel mock-up($10L{\times}0.5W{\times}0.25H$ m3 : scale reduction 1/20) with rectangular cross section were investigated. The instantaneous velocity fields of Re = 49,029, 89,571 were measured by the 2-D PIV system which is consisted of double pulsed Nd:Yag laser and the tracer particles in the straight-duct mock-up where the flows were fully developed. The mean velocity profiles were taken from the ensemble averages of 1,000 instantaneous velocity fields. Simultaneously, numerical simulations(RANS) were performed to compare with experimental data using STREAM code. Non-linear eddy viscosity model (NLEVM : Abe-Jang-Leschziner Eddy Viscosity Model) was employed to resolve the turbulent flows in the duct. The calculated mean velocity profiles were well compared with PIV results. In the log-law profiles, the experimental data were in good agreement with numerical simulations all the way to the wake region except the viscous sub-layer (near wall region).

• 한국가시화정보학회지
• /
• 제3권1호
• /
• pp.78-89
• /
• 2005

An experimental study was carried out to investigate the effect of local ultrasonic forcing on a turbulent boundary layer. Stereoscopic particle image velocimetry (SPIV) was used to probe the characteristics of the flow. A ultrasonic forcing system was made by adhering six ultrasonic transducers to the local flat plate. Cavitation which generates uncountable minute air-bubbles having fast wall normal velocity occurs when ultrasonic was projected into water. The SPIV results showed that the wall normal mean velocity is increased in a boundary layer dramatically and the streamwise mean velocity is reduced. The skin friction coefficient (C$_{f}$) decreases 60$\%$and gradually recovers at the downstream. The ultrasonic forcing reduces wall-region streamwise turbulent intensity, however, streamwise turbulent intensity is increased away from the wall. Wall-normal turbulent intensity is almost the same near the wall but it increases away from the wall. In the vicinity of the wall, Reynold shear stress, sweep strength and production of turbulent kinetic energy were decreased. This suggests that the streamwise vortical structures are lifted by ultrasonic forcing and then skin friction is reduced.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2002년도 학술대회지
• /
• pp.771-774
• /
• 2002

Highly sweep leading edge extensions(LEX) applied to delta wings have greatly improved the subsonic maneuverability of contemporary fighters. In this study, systematic approach by PIV experimental method within a circulating water channel was adopted to study the fundamental characteristics of induced vortex generation, development and its breakdown appearing on a delta wing model with or without LEX in terms of four angles of attack($15^{\circ},\;20^{\circ},\;25^{\circ},\;30^{\circ}$) and six measuring sections of chord length($30{\%},\;40{\%},\;50{\%},\;60{\%},\;70{\%},\;80{\%}$). Sideslip effect in case of the LEX was also studied for two sideslip(yaw) angles($5^{\circ},\;10^{\circ}$) at one angle of attack(20). Distribution of time-averaged velocity vectors and vorticity over the delta wing model were compared along the chord length direction. Quantitative comparison of the maximum vorticity featuring the induced pressure distribution were also conducted to clarify the significance of the LEX existence. Animation presentation in velocity distribution was also implemented to reveal the effect of LEX with wing vortex interaction.