• Magazine of the Korean Society of Agricultural Engineers
• /
• v.16 no.4
• /
• pp.3555-3571
• /
• 1974

This experiment of which aim contribute to plan irrigation system so as to increase forage crop yields, was conducted to estimate evapotranspiration amount of forage crops and to find out system of consumed water in a pasture-ground. The results obtained by this study are as follows: 1. The general weather conditions which, were closely related to the evapotrannpiration of forage crops were nearly same as those of the average year with the exception that temperature of May and June were slightly low. 2. According to the investigation of potential evapotranspirations (P.E) or forage crops and its changes during growing periods, changes of tenday P.E. were high significant according to the harvesting period. P.E of Alfalfa of which yield was the largest was the biggest. Althrough the correlations between P.E. and meteorological factors were irregular oming to three-time harvesting, correlation between ten-day evapotraspiration amount and copper plated pan evaporation or solar radiation was high positive significant. 4. Predicting formulas of P.E. were led by weather factors, and also relatione between P.E. and weather factors were showed as figure. from the these formulas, P.E. may be calculated by weather factors. 5. Predicting formulas of P.E. were led by mean temperature and copper plated pan evaporation, and by mean temperature and solar radiation. As computed values and measured values showed in figure, these formulas were high signiflent. 6. In the total consumed soil water duration of 10 days which, was non-rain period from 12th to 21th of August, Alfalfa was the largest 48.1mm, second, Orchard grass 40.1mm and Fescue 37.6mm, and Ladino clover was the smallest 37.1mm, also, order of each forage crop yield amound. was same to the abov. Order of soil moisture extraction rate of soil layer of all the for forage crops dulation of ten-day was soil layer 1 which was largest, soil layer 2, 3, and 4 Reviewing the the first five-day and the second five day, in the first five-day, order of that of all the forage crops was same to the above, but in the second five-day, that of soil layer 2 or 3 was more than the of soil layer 1.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.20 no.9
• /
• pp.961-966
• /
• 2009

In this paper, a novel voltage-controlled oscillator(VCO) using the metamaterial broadside coupled spiral resonators(BC-DSRs) is presented for reducing the phase noise. For reducing of the phase noise, the series spiral structures have been applied for the signal plane and ground plane at each in order to have the large coupling. Compared with the conventional VCO, the proposed VCO has the larger coupling coefficient constant, which makes a higher Q-factor and has reduced the phase noise of the VCO. The proposed VCO has the phase noise of $-121{\sim}-117.16\;dBc$/Hz at 100 kHz in the tuning range, $5.749{\sim}5.853\;GHz$. The figure of merit(FOM) of this VCO is $-198.45{\sim}-194.77\;dBc$/Hz at 100 Hz in the same tuning range, respectively.

• Journal of Elementary Mathematics Education in Korea
• /
• v.16 no.3
• /
• pp.359-388
• /
• 2012

The study aims to extract the framework of sub-factors of spatial sense, to develop test instruments based on the framework to investigate the actual spatial sense ability of fourth to sixth graders in elementary school and to analyze the results. According to the framework of sub-factors of spatial sense of the study, spatial sense has two factors of spatial visualization and spatial orientation. Spatial visualization is divided into mental rotation, mental transformation and figure-ground perception while spatial orientation is categorized into direction sense, distance sense, and location sense. Based on the framework, the test instrument for spatial sense ability was developed and the test was conducted to 430 fourth to sixth students in five elementary schools in capital areas. The following conclusions were drawn from the results obtained in the study. Firstly, the higher school year gets, the more spatial sense grows. However, spatial visualization is developed much more than spatial orientation and their order is reversed with higher graders. Secondly, the most insufficient abilities among fourth to sixth elementary school students' spatial sense were mental transformation of spatial visualization and location sense of spatial orientation. Thirdly, the reasons of differences in sub-factors of spatial sense and graders seem to be from effects of students' learning experiences of spatial sense of mathematics curriculum and the complexities of test items.

• Geophysics and Geophysical Exploration
• /
• v.17 no.2
• /
• pp.104-113
• /
• 2014

Electric resistivity monitoring was applied to evaluate the soft ground in reclaimed land in order to figure out the applicability of physical prospecting. For this, electrical resistivity monitoring data were acquired for total three months and analyzed those data with independent inversion, time-lapse inversion, and 4D inversion methods. The result was compared for various inversion methods so as to figure out what showed the soft soil most properly. Moreover, drilling and CPT(Cone Penetration Test) data were also used in order to find out if each of those inversion methods could distinguish either bed rock or the soft soil clearly. And according to the result, time-lapse inversion showed less inversion artifacts than independent inversion, so it could indicate the soft soil better. If data gained for a longer period than three months are used, 4D inversion has been found to be a more efficient analysis method than the time-lapse inversion method. Electrical resistivity monitoring on the soft soil has been found to be a useful method that can analyze the spatio-temporal electric state of the ground serially.

• Journal of the Korean GEO-environmental Society
• /
• v.16 no.12
• /
• pp.5-12
• /
• 2015

Since blasting noise is impact noise, it will give a sudden shock to the human. In the case, such as the blast vibration, it has given aging buildings and livestock great damage to move the vibration along ground in nearby regions. In this study, the influence of the blasting generated during excavation was analyzed for effects on regional. A couple of field and laboratory surveys about geological were carried out to figure out the geological ratio in the study-performed area. Blast vibration noise was compared to the domestic and abroad case studies and each of the institutions permissible standards established the most appropriate criteria in site condition. The vibration velocity of blasting vibration exploits the values which were measured from test blasting on the ground in order to examine blasting effect. Considering the blasting point as the shortest distance from safety facilities (farms, private houses, etc.), the examination of the influence range, which was derived from the vibration velocity of blasting vibration, was performed to figure out how the point affected the safety facilities. Three-dimensional numerical analysis was performed a time history analysis in order to analyze the behavior of the structure for a dynamic blast load, which was determined in three directions of the blast vibration value. The results of three-dimensional numerical analysis and the blasting effect of blasting vibration estimation equation blasting vibration of impact circle with accompanying test blasting were compared. And the analysis confirmed similar results figures.

• Korean Journal of Remote Sensing
• /
• v.32 no.5
• /
• pp.529-538
• /
• 2016

This study, multispectral and hyperspectral sensors were utilized to use radiometric cross validation for the purpose of radiometric quality evaluation of a 'KOMPSAT-3'. Images of EO-1 Hyperion and Landsat-8 OLI sensors taken in PICS site were used. 2 sections that have 2 different types of ground coverage respectively were selected as the site of cross validation based on aerial hyperspectral sensor and TOA Reflectance. As a result of comparison between the TOA reflectance figures of KOMPSAT-3, EO-1 Hyperion and CASI-1500, the difference was roughly 4%. It is considered that it satisfies the radiological quality standard when the difference of figure of reflectance in a comparison to the other satellites is found within 5%. The difference in Blue, Green, Red band was approximately 3% as a comparison result of TOA reflectance. However the figure was relatively low in NIR band in a comparison to Landsat-8. It is thought that the relatively low reflectance is because there is a difference of band passes in NIR band of 2 sensors and in a case of KOMPSAT-3 sensor, a section of 940nm, which shows the strong absorption through water vapor, is included in band pass resulting in comparatively low reflectance. To overcome these conditions, more detailed analysis with the application of rescale method as Spectral Bandwidth Adjustment Factor (SBAF) is required.

• Bulletin of the Korean Chemical Society
• /
• v.31 no.12
• /
• pp.3588-3592
• /
• 2010

Second-order rate constants ($k_N$) have been measured spectrophotometrically for nucleophilic substitution reactions of 2-pyridyl X-substituted benzoates 8a-e with a series of alicyclic secondary amines in $H_2O$ at $25.0{\pm}0.1^{\circ}C$. The $k_N$ values for the reactions of 8a-e are slightly smaller than the corresponding reactions of 4-nitrophenyl X-substituted benzoates 1a-e (e.g., $kN^{1a-e}/k_N^{8a-e}$ = 1.1 ~ 3.1), although 2-pyridinolate in 8a-e is ca. 4.5 $pK_a$ units more basic than 4-nitrophenolate in 1a-e. The Br$\o$nsted-type plot for the aminolysis of 8c (X = H) is linear with $\beta_{nuc}$ = 0.77 and $R^2$ = 0.991 (Figure 1), which is typical for reactions reported previously to proceed through a stepwise mechanism with breakdown of a zwitterionic tetrahedral intermediate $T^{\pm}$ being the rate-determining step (RDS), e.g., aminolysis of 4-nitrophenyl benzoate 1c. The Hammett plot for the reactions of 8a-e with piperidine consists of two intersecting straight lines (Figure 2), i.e., $\rho$ = 1.71 for substrates possessing an electron-donating group (EDG) while $\rho$ = 0.86 for those bearing an electron-withdrawing group (EWG). Traditionally, such a nonlinear Hammett plot has been interpreted as a change in RDS upon changing substituent X in the benzoyl moiety. However, it has been proposed that the nonlinear Hammett is not due to a change in RDS since the corresponding Yukawa-Tsuno plot exhibits excellent linear correlation with $\rho$ = 0.85 and r = 0.62 ($R^2$ = 0.995, Figure 3). Stabilization of substrates 8a-e in the ground state has been concluded to be responsible for the nonlinear Hammett plot.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.15 no.6
• /
• pp.29-41
• /
• 2012

This study was conducted in Ningxia Hui autonomous region, located at southern part of Mu Us sand land in China. To investigate relationships between windbreak effect and installation cost of sand barriers, plastic net is utilized by using four kind of heights (0.2, 0.3, 0.4 and 0.5m) and four kind of porosities (20, 30, 50 and 70%). These heights and porosities are measured for estimating distances for effective windbreak. It is shown that porosity and the distance have a positive relationship at same heights and porosity on ground indicates a constant figure when height reaches a certain level, regardless of the porosity. This implies that there is a difference of level of windbreak with different porosities; however, distance of windbreak effect is same at the same height of sand barrier. As a result of comparison between porosity of sand barrier on the ground and installation cost in each sand barrier with various heights and porosities (16 combinations), 0.4m and 0.5m height sand barriers describe highest economical efficiency. Within two variables, we concluded that height has a higher impact on windbreak effect than porosity.

• Asian Journal of Atmospheric Environment
• /
• v.10 no.4
• /
• pp.217-225
• /
• 2016

The purpose of the study was to initially investigate the concentration patterns of $PM_1$, $PM_{2.5}$ and $PM_{10}$ in the Seoul subway lines, and then to figure out the PM behaviors of internal and external sources inside subway tunnels. The PMs were monitored by a light scattering real-time monitor during winter (Jan. 8-26 in 2015) and summer (July 2-Aug. 7 in 2015) in tunnel air, in passenger cabin air, and in the ambient air. The daily average $PM_{10}$, $PM_{2.5}$, and $PM_1$ concentrations on these object lines were $101.3{\pm}38.4$, $81.5{\pm}30.2$, and $59.7{\pm}19.9{\mu}g/m^3$, respectively. On an average, the PM concentration was about 1.2 times higher in winter than in summer and about 1.5 times higher in underground tunnel sections than in ground sections. In this study, we also calculated extensively the average PM mass ratios for $PM_{2.5}/PM_{10}$, $PM_1/PM_{10}$, and $PM_1/PM_{2.5}$; for example, the range of $PM_{2.5}/PM_{10}$ ratio in tunnel air was 0.82-0.86 in underground tunnel air, while that was 0.48-0.68 in outdoor ground air. The ratio was much higher in tunnel air than in outdoor air and was always higher in summer than in winter in case of outdoor air. It seemed from the results that the in/out air quality as well as a proper amount of subway ventilation must be significant influence factors in terms of fine PM management and control for the tunnel air quality improvement.

• Journal of Sensor Science and Technology
• /
• v.26 no.2
• /
• pp.107-113
• /
• 2017

Energy source of a piezo-electric harvester is vibration. Sources of vibration are machineries operated with high frequencies, constructions and people operated with low frequencies and etc. In this study, we tried to figure out power generation properties over vibrations upon angles of a piezo-cantilever for applying them to movements of the construction and/or people, which are vibration sources at low frequencies. A uni-morph cantilever with a $59mm{\times}29mm{\times}0.2mm$ piezo-electric element attached on a $71mm{\times}46mm{\times}0.25mm$ copperplate was used. A spring was attached to the lower side of the cantilever and a mass was attached on the opposite side. Also, a structure with a specific angle which is an angle in between the ground and the cantilever was prepared and then, connected to a spring or the cantilever. Then, this structure was divided into the A-type and B-type and excited in the direction of z- axis. After that, the angle between the ground and the cantilever was changed and excited by 1 to 10 Hz upon the existence of a spring and/or a mass to compare power generation properties.