• 반도체디스플레이기술학회지
• /
• 제18권2호
• /
• pp.53-57
• /
• 2019

In this study, we prepared sputtering cathode for large sputtering thin film in the facing targets sputtering(FTS) system. Before fabrication of cathode equipment, we investigated optimal magnetic flux in the sputtering cathode by using magnetic field stimulation(Comsol). According to the result of magnetic field stimulation, we manufactured the cathode. After we mounted laboratory-designed cathode on FTS system, the discharge properties were observed in vacuum condition. In addition, ITO films were deposited on glass substrate and their electrical and optical properties were investigated by various measurements (four-point probe, UV-VIS spectrometer, field emission scanning electron microscopy(FE-SEM), Hall-effect measurement).

• 한국지반환경공학회 논문집
• /
• 제12권9호
• /
• pp.63-69
• /
• 2011

본 연구에서는 펄스 전기장 처리장치를 이용하여 물, 계면활성제 그리고 휴믹산의 물리화학적 변화 특성을 검토하였다. 펄스 전기장 처리에 따른 물의 구조적 특성변화를 검토한 결과, FT-IR 분석에서 C-N 복합구조와 C=O 구조에서 변화가 일어나는 것으로 나타났으며, NMR 분석에서는 물분자의 운동속도 증가폭이 최소 2.3 Hz에서 9.9 Hz로 나타났다. 각각의 계면활성제를 펄스 전기장 처리 한 결과, 양이온 계면활성제와 음이온 계면활성제의 CMC는 각각 1.3%와 9.2% 낮아지는 것으로 나타났고, UV-vis 값은 증가하는 것으로 나타났다. 그러나 휴믹산은 펄스 전기장 처리를 할 경우 UV-vis 값이 감소하는 것으로 나타났다. 펄스 전기장 처리는 물과 유기화합물의 구조적 특성변화에 직접적인 영향을 미치는 것을 확인할 수 있었다.

• 드라이브 ㆍ 컨트롤
• /
• 제20권4호
• /
• pp.71-79
• /
• 2023

In the field of agricultural machinery, various on-field tests are conducted to measure design load for optimal design of agricultural equipment. However, field test procedures are costly and time-consuming, and there are many constraints on field soil conditions due to weather, so research on utilizing simulation to overcome these shortcomings is needed. Therefore, this study aimed to model agricultural soils using discrete element method (DEM) software. To simulate draft force, predictions are made according to travel speed and compared to field test results to validate the prediction accuracy. The measured soil properties are used for DEM modeling. In this study, the soil property measurement procedure was designed to measure the physical and mechanical properties. DEM soil model calibration was performed using a virtual vane shear test instead of the repose angle test. The DEM simulation results showed that the prediction accuracy of the draft force was within 4.8% (2.16~6.71%) when compared to the draft force measured by the field test. In addition, it was confirmed that the result was up to 72.51% more accurate than those obtained through theoretical methods for predicting draft force. This study provides useful information for the DEM soil modeling process that considers the working speed from the perspective of agricultural machinery research and it is expected to be utilized in agricultural machinery design research.

• Journal of Magnetics
• /
• 제19권4호
• /
• pp.340-344
• /
• 2014

An effective process was employed for synthesizing anisotropic magnetic $SmCo_7$-type alloy flakes with high coercivity, which is highly desirable for many applications. The highest coercivity of 16.3 kOe corresponds to a typical flake thickness of 200 nm for the 3-h ball-milled sample. The anisotropy field was calculated by measuring the parallel and perpendicular directions to the easy magnetization direction of the powders. The anisotropy field decreased with the increase of the ball milling time, thus indicating that the decrease of coercivity was mainly caused by the reduction of the anisotropy field. Microstructure analysis indicated that the morphology, grain size, and anisotropy field of these samples have a great influence on the magnetic properties.

• E2M - 전기 전자와 첨단 소재
• /
• 제9권6호
• /
• pp.578-583
• /
• 1996

The magnetic properties have been investigated for the system of $Y_{1-x}$Yb$_{x}$Ba$_{2}$Cu$_{3}$F$_{y}$O$_{y}$ with x=0.0, 0.1, 0.2, 0.3, 0.4 and 0.5. In the magnetic hysteresis measurements, the values of the magnetic critical current densities are in the range of 10$^{4}$-10$^{5}$ A/cm$^{2}$ at the maximum external field 1.4 T. The upper critical field is over 100 T. The critical current density is estimated by the magnetization width .DELTA.M through the Bean critical state model. As the field strength is increased, the .DELTA.M diminishes slowly. The .DELTA.M for the fluorinated sample also decreases slowly with increasing field. It is considered that the large J, value results from this type is due to enhanced pinning center in grain boundary.y.ary.y.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2004년도 춘계학술대회 논문집 디스플레이 광소자분야
• /
• pp.185-188
• /
• 2004

A diode structure of field emission lamps based upon carbon-nanotube is studied. The single-walled carbon nanotubes(SWNTs) were produced by arc discharge method. We made the 1-inch diode type flat lamp using CNTs. We applied anode voltage gradually to refine the field emission behavior of emitter in dynamic vacuum system to study the emission current. the brightness and efficiency, etc. The field emission properties was estimated by varying gaps between the cathode and anode, contents of the glass frit. The good luminous efficiency is showed in the gap $900{\mu}m$, $1200{\mu}m$ and contents of the proper glass frit. For the upper conditions, the luminous efficiencies were respectively 23.30, 11.12 1m/W.

• 한국진공학회:학술대회논문집
• /
• 한국진공학회 2013년도 제44회 동계 정기학술대회 초록집
• /
• pp.430-430
• /
• 2013

Field effect transistor based on semiconductor nanowires has been attracting lots of concerns and studies of scientists because of its different characteristic comparing with other morphology like thin film. Nowadays, graphene is introducing a great promise as an active layer in field effect transistor due to its unique electronic and optoelectronic properties. Thus, a mix structure between etched graphene and semiconductor nanowires is believed to expose novel electrical characteristics. In this study, CuO nanowires (20~80 nm in diameter and $1{\sim}10{\mu}m$ length) were grown during oxidizing Cu foil at $450^{\circ}C$ for 24 h. Besides, 3-layersetched graphene was deposited on Cu foil at $1,000^{\circ}C$ using a feedstock of $CH_4$/$H_2$ mixed gas in CVD system. A structure of Ni/Au electrode + CuO nanowires + etched graphene was fabricated, afterward. Finally, field effect properties of the device was revealed and compared with individual devices of just nanowires and just graphene.

• 한국농공학회:학술대회논문집
• /
• 한국농공학회 1999년도 Proceedings of the 1999 Annual Conference The Korean Society of Agricutural Engineers
• /
• pp.192-199
• /
• 1999

In order to make the reasonable irrigation planin the reclaimed paddy fields, the estimation of irrigation water requirements by soil textures and water management methods for the normal growth of crops is very important. This study was carried out to determine leaching water requirements before cultivating crops. For the purposes of this study, the physical and chemical properties of soil sampels used in the desalinication experiments were analyzed and change of salinity by supplying water and leaching water were investigated in the experimental field with lysimeters.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2001년도 하계학술대회 논문집
• /
• pp.467-469
• /
• 2001

KAM200 which can be used electroluminescence binder is cyano material. In this study, we have fabricated KAM200 thin film by Spin-Coating method. And we have studied the electical properties of KAM200 thin films. In the I-V characteristics, the current decreases as the voltage overflow definite voltage immediately. And that definite voltage depend on thickness of KAM200 material. In the case of thickness is 1.9[$\mu\textrm{m}$], definite voltage is 7[V]. And that's electrical field 3.86[MV/m]. The dielectric properties of KAM200 thin film is investigated by measuring dielectric dispersion and absorption. KAM200's Relative dielectric constant is 10.25, and it has high permittivity compared with different materials.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 추계학술대회 논문집
• /
• pp.480-483
• /
• 2000

Polyimide is a well-known organic dielectric material, which has not only high chemical and thermal stability but also good electrical insulating and mechanical properties. In this research, the electrical properties of PI LB films were investigated at room temperature. At low electric field, ohmic conduction(I∝V) was observed and the calculated electrical conductivity was about 9.7$\times$10$^{-15}$ S/cm. At high electric field, conduction(I∝V$^2$) was observed and the conduction mechanism was explained by space charge limited region effect. The dielectric constant of LB film was about 7.5.