• Proceedings of the KIPE Conference
• /
• 2017.07a
• /
• pp.74-75
• /
• 2017

This paper proposes a control scheme of the voltage ripple suppression for the permanent magnet exciter generator. The output voltage of the permanent magnet excitation generator is affected by the field current, load current and the engine speed. The engine speed can be controlled by the governor. But, the actual frequency is changed at the starting and a sudden load variation. As a result, output voltage overshoot and undershoot can decrease the power quality in the grid system. The proposed control scheme uses a frequency factor to control the field current of the generator for the voltage ripple reduction. Because of the linkage flux is proportional to the frequency, the instantaneous frequency can consider the linkage flux. The proposed control method shows the improved control performance for the permanent magnet excitation generator through simulation.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2017.06a
• /
• pp.184-184
• /
• 2017

Organic matter is very important and essential factor to maintain productivity of paddy field. But as meat consumption and the demand of grain increase, the demand of forage also increased gradually in Korea. So the amount of organic matter in paddy field have been declined gradually by the reduction of return of rice straw for the forage use for cattle. There is not enough alternative resources for forage, we guess this trend of organic matter decline in paddy field would continue for the time being in Korea. So this study was performed to confirm the variation of organic matter and change of rice yield to select suitable rice cultivars which yield reduction is small in condition of organic matter decrease in paddy field. To confirm the change of rice growth and yield in condition of organic matter decrease in paddy field, we transplanted 10 rice cultivars which yield reduction are small in low fertilizer condition. We transplanted it Buan where double cropping of winter barley continues several years on June 10. Planting density were $70plants/3.3m^2$ Fertilizer amount was $N-P_2O_5-K_2O=9-4.5-5.7kg/10a$ and fertilizer split application of nitrogen was basal-tillering stage-panicle initiation = 50-20-30%. And in the other cultivation management, we observed rice standard culture of NICS. In paddy field where withdraw straws of barley and rice, the organic matter content showed tendency to decrease as the years go on. During rice cultivation season, organic matter decreased little by little, but it increased again after rice harvest season. Rice yield was more in order of Sodami, Chunghaejinmi and Saenuri. We judge that there is an advantage in rice yield of rice cultivars which have later heading date because of suitable ripening temperature. Although Sobibyeo and Shindongjinbyeo showed high yield, head rice yield decreased severely owing to chalky and cracked rice.

• Korean Journal of Fisheries and Aquatic Sciences
• /
• v.56 no.3
• /
• pp.341-346
• /
• 2023

This study aimed to suggest an alternative income generation (AIG) for local artisanal fisheries communities in the southern coastal area of Bangladesh, which is vulnerable to climate change. To analyze the problems of local artisanal fisheries caused by climate change, field surveys and in-depth interviews with fishermen and government officials were conducted. Livelihood risk factor (LRF) in the marine fishing sector included reduction of fishing days and fish production and damage to fishing vessels and fishing gear due to cyclone and sea-level rise. LRF in the aquaculture sector included cultured fish escape, reduction of aquaculture production, and water pollution due to Monsoon flood. A common challenge for two sectors was high interest rate on commercial loans. Small-scale tank aquaculture is recommended as AIG for securing income of artisanal fisheries communities. In the early stages of dissemination of small-scale tank aquaculture technology, it is necessary to prevent fishermen from struggling to repay high-interest rate loans through technology transfer and facility support by official development assistance. The aquaculture training center, along with the technical education, will also contribute toward expansion of local distribution network and marketing support to establish a value chain for local artisanal fisheries communities.

• Journal of Climate Change Research
• /
• v.4 no.4
• /
• pp.349-358
• /
• 2013

In this study, the newest technology available to reduce GHG emissions, which can be applicable in energy industries of the future that has large reduction obligations by energy target management and large intensity of GHG emissions, has been investigated by searching the technical characteristics of each technology. The newest technology to reduce GHG emissions in the field of power generation and energy can be mainly classified into the improvement of efficiency, CCS, and gas combined-cycle technology. In order to improve the reliability of the GHG emission factor obtained from the investigation process, it has been compared to the technology-specific GHG emission factor derived from the estimated amount of emissions. Then the GHG abatement measures, using the derived estimation of factor, by using the newest technology to reduce GHG emissions have been predicted. As a result, the GHG reduction rate by technology of CCS development has been expected to be the largest more than 30%, and the abatement rate by technology of coal gasified fuel cell and pressurized fluidized-bed thermal power generation has been showed more than 20%. If the effective introduction of the newest technology and the study of its characteristics is continued, and properly applied for future GHG emissions, it can be prospected that the national GHG reduction targets can be achieved in cost-efficient way.

• Journal of the Korean Geosynthetics Society
• /
• v.9 no.4
• /
• pp.75-84
• /
• 2010

In this study, the long-term performance tests, which have extensibility, creep deformation, installation resistance and durability characteristic, is conducted to apply geosynthetic strip in field. The strength reduction factors using the test results are evaluated in order to calculate long-term design tensile strength. First, the creep deformation was evaluated by both the stepped isothermal method(SIM) and the time-temperature superposition(TTS) method. The creep reduction factor is reasonable to apply 1.6. Second, the result of installation damage test had little damage of yarn, which affected strength of reinforcement. Therefore, it can be analyzed that the installation damage of geosynthetic strip has little effect of long-term design tensile strength. Finally, the durability reduction factor considering chemical, biological and outdoor exposure resistance is reasonable to apply 1.1, which is considered the stability and economic efficiency of reinforced earth wall using geosynthetic strip.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.11a
• /
• pp.425-428
• /
• 2006

In order to estimate the reduction of laodbearing capacity, followed by the attributive change of heat while high strength concrete structure is revealed on fire it is necessary to evaluate, it is necessary to evaluate the property of material under high temperature such as thermal conductivity, specific heat, compressive strength, modulus of rigidity and diminution figure. Therefore, this study is for the purpose of presenting evaluation data for the analysis of thermal behavior about the high strength concrete material under high temperature, through the experiment by manufacturing concrete(40, 50, 60, 80, 100 MPa) commonly used in the construction field. As a result of the study, in the case of physical attribute, it demonstrates a greater fluctuation of change than the one of 30 MPa concrete. In case of specific heat, the high strength concrete, shown the serious diminution between $500{\sim}600^{\circ}C$, presents the thermal change area corresponding to the change of high strength concrete. In compressive strength, regardless of intensity of concrete, all of them show the first intensity loss between normal temperature and $100^{\circ}C$, the dramatic loss beyond $400^{\circ}C$. The concrete weighing above 50 MPa shows a twice lower dramatic intensity loss than the one weighing $30{\sim}40MPa$. The concrete ranging from $60{\sim}80MPa$, shows the biggest diminution of modulus of elasticity under $400^{\circ}C$, which implies the structural unstability of temperature.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.6 no.1
• /
• pp.17-23
• /
• 2004

Prediction of lining loads is one of the key issues to be addressed in the design of a tunnel. The validity of the existing design methods is reviewed by comparing the loads calculated using the methods with the field measurements obtained from several tunnels in Edmonton, carada. However, the existing methods are determined not to be fully satisfactory for the prediction of primary lining loads. To account for the stress reduction occurring prior to lining installation, the stress reduction factor is used coupled with an analytical solution for calculation of lining loads. Typical values of dimensionless load factors nD/H for tunnels in Edmonton are obtained from parametric analyses and presented in a table. The loads calculated using the proposed method are compared with field measurements collected from tunnels in Edmonton to verify the method. The method can be used for other tunnels if the tunnels are built in stiff or dense soils, where good ground control is accomplished during the tunnel construction.

• Journal of Korean Tunnelling and Underground Space Association
• /
• v.10 no.4
• /
• pp.349-360
• /
• 2008

In this paper, the modeling procedure of random field with an elasto-plastic finite element algorithm and probability of failure on closely-spaced tunnel were investigated. Local average subdivision (LAS) method which can generate discrete random variables fast and accurately as well as change the resolution in certain region was used. And correlated value allocating and weighted average method were suggested to implement geometrical characteristics of tunnel. After the probability of failure on the test problem was thoroughly investigated using random finite element method, the results were compared with the deterministic strength reduction factor method and single random variable method. Of particular importance in this work, is the conclusion that the probability of failure determined by simplified probabilistic analysis, in which spatial variability is ignored by assuming perfect correlation, can be estimated from the safety factor determined by strength reduction factor method. Also, single random variable method can lead to unconservative estimates of the probability of failure.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.48 no.1
• /
• pp.13-18
• /
• 2024

The rice field grasshopper, Oxya chinensis sinuosa (OC), has traditionally been utilized in Korea for various purposes; however, its potential benefits in the context of osteoporosis remain unclear. The results revealed that OC ethanol extract (OCE) significantly inhibited the formation and activity of tartrate-resistant acid phosphatase (TRAP)-positive cells in receptor activator of nuclear factor-κB ligand (RANKL)-stimulated RAW264.7 cells. Furthermore, OCE, at concentrations ranging from 100 to 400 ㎍/mL, demonstrated a dose-dependent reduction in the protein expression of osteoclast-specific markers, including nuclear factor of activated T cell cytoplasmic 1, c-Src, and TRAP, when compared to RANKL stimulation alone. Additionally, OCE significantly inhibited RANKL-induced activation of p38 mitogen-activated protein kinase (MAPK) and c-Jun N-terminal kinase (JNK) but not the activation of extracellular signal-regulated kinase. Collectively, these results indicate that OCE suppresses osteoclastogenesis by attenuating the phosphorylation of p38 MAPK and JNK. Consequently, these findings suggest that OCE holds promise for the prevention of osteoporosis.

• The Journal of the Institute of Internet, Broadcasting and Communication
• /
• v.8 no.5
• /
• pp.43-49
• /
• 2008

Motivated by the Communication Broadcasting Convergence service, various technical approaches are being used to develop more efficient antenna models. This paper proposes a compact mobile antenna which is attachable to a cell phone and is applicable for Communication Broadcasting Convergence. In the design of the antennas for mobile handsets, size reduction is a crucial factor. In this paper, the compactness of a loop antenna is realized by bending a folded-dipole. A short planar dipole is transformed to a twice folded dipole and a loop antenna to produce a larger input resistance. The current distribution of the antenna is the same as a loop antenna, and its radiation patterns are omni-directional. We also analyze the performance of the RFID antenna by exploring the current-induced near field radiation patterns using a electro-optic field mapping system.